• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.258-260
• /
• 2008

Developed halftone exposure technique was successfully applied to the fabrication of narrow transistor channels below $4\;{\mu}m$ with conventional photolithography method. Asymmetric slits concept of photo mask was applied to make channel lengths (L) shorter for thin film transistor's (TFT) high performance. These short channel TFTs verified better quality transistor characteristics.

• Proceedings of the IEEK Conference
• /
• 2001.06b
• /
• pp.145-148
• /
• 2001

In this paper, polycrystalline silicon thin film transistor using by Solid Phase Crystallization(SPC) were fabricated, and these devices were measured and analyzed the electrical output and transfer characteristics along to DC voltage stress. The transfer characteristics of polycrystalline silicon thin film transistor depended on drain and gate voltages. Threshold voltage is high with long channel length and narrow channel width. And output characteristics of polycrystalline silicon thin film transistor flowed abruptly much higher drain current. The devices induced electrical stress are decreased drain current. At last, field effect mobility is the faster as channel length is high and channel width is narrow.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.25 no.6
• /
• pp.591-597
• /
• 1988

In this paper, we have studied a channel capacity affected by noise which produces burst errors in the ISDN(approx 140Kbps) data transmission using a existing PSTN. First, a digital communication system model to apply a subscriber line to a narrow band ISDN channel is presented. Second, the decision methodology of a channel capacity limitation whether the pdf of the noise generated by a waveform synthesizer is Pisson or Laplacian is described. As a result of the simulation, we have obtained that the Poission distributed noise is approached to the Guassian rather than the Laplacian under the same SNR condition.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.7 s.110
• /
• pp.629-637
• /
• 2006

It is important to design the high-speed communication system in the hostile channel. Due to the frequency diversity, FD-OFDM that can be used for the high-speed communication is more robust to the noise or interference than ordinary OFDM. However, even the FD-OFDM becomes degraded in th ε strong narrow band interference channel. In this paper, we propose an AFD-OFDM system and analyze the communication performances in order to find out the more robust communication system in the hostile channel. So, the AFD-OFDM system can cover the drawback of the FD-OFDM and improve the BER performance than FD-OFDM. From the simulation results, FD-OFDM shows better performance than the ordinary OFDM. Furthermore, AFD-OFDM shows more excellent performance than FD-OFDM in the strong narrow interference channel.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.13 no.4
• /
• pp.304-311
• /
• 2001

An experimental study on the countercurrent two-phase flow in narrow rectangular channels has been performed. The void fraction and the pressure gradient were investigated using air and water in 760 mm long, 100 mm wide. vertical test sections with 2, 3 and 5 mm channel gaps. Tests were systematically performed with downward liquid superficial velocities and upward gas velocities covering 0 to 0.08 and 0 to 2.5 m/s ranges. respectively. the experimental results were compared with the previous correlations, which were mainly for round tubes, and the qualitative trends were found to be in good agreements. However the quantitative discrepancies were hardly neglected. as the superficial gas velocities increased, the void fraction increased and the pressure gradient decreased, where the effects of the liquid superficial velocities were infinitesimal. as the gap width of the rectangular channel increased the void fraction and the 2-phase frictional pressure gradient approached those values for the round tubes. Equi-periphery diameter, rather than the hydraulic diameter, seemed to be more effective in the analysis of two-phase flow behavior.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.19 no.6
• /
• pp.441-446
• /
• 2007

An experimental study on the countercurrent two-phase flow in narrow rectangular channels has been peformed. Countercurrent flow limitation (CCFL) was investigated using air and water in 760mm long, 100mm wide, vertical test sections with 1 and 3mm channel gaps. Tests were systematically performed with downward liquid superficial velocities and upward gas velocities covering 0 to 0.125 and 0 to 3.5m/s ranges, respectively. As the gap width of rectangular channel increased the CCFL water superficial velocity decreased for the given air superficial velocity. Slight increase of the air superficial velocity resulted in the abrupt decrease of water velocity when $j_g=2{\sim}4m/s$. The critical superficial velocity of air, at which the downward flow of water was no longer allowed, also decreased with the increase of gap width. The experimental results were compared with the previous correlations, which were mainly for round tubes, and the qualitative trends were found to be partially acceptable. However the quantitative discrepancies were hardly neglected. New correlation of CCFL was developed and showed good agreement with the experimental data.

• Journal of Power System Engineering
• /
• v.20 no.6
• /
• pp.34-39
• /
• 2016

This paper is the numerical study on the correlation of leakage by the variation of inlet pressure and clearance in hydrostatic bearing. The main goal of this study is to apply to the design of hydro system the results that the pocket pressure and the leakage rate according to the inlet pressure and the clearance between piston and cylinder tube. Because the hydrostatic bearing in hydraulic cylinder has the narrow rectangular channel between piston and cylinder tube, so to verify the numerical scheme, it has been compared with the experimental results of Brackbill and Kandlikar. The pressure data of numerical results inside narrow rectangular channel correlate was showed a good agreement with experimental results, thereby the numerical scheme was applied to the real model that is a hydraulic cylinder with the hydrostatic bearing. In conclusion, the pressure differences between inlet and pocket were shown within 3%. Leakage rates were showed rapidly increased pattern between about 4.5 and 6.7 times because the section area to calculate the leakage rates were proportioned to a square of diameter. The correlation equation was calculated among the inlet pressure, the clearance and the leakage rate by using the linear regression.

• Nuclear Engineering and Technology
• /
• v.46 no.2
• /
• pp.195-206
• /
• 2014

Heat transfer characteristics in a narrow rectangular channel are experimentally investigated for upward and downward flows. The experimental data obtained are compared with existing data and predictions by many correlations. Based on the observations, there are differences from others: (1) there are no different heat transfer characteristics between upward and downward flows, (2) most of the existing correlations under-estimate heat transfer characteristics, and (3) existing correlations do not predict the high heat transfer in the entrance region for a wide range of Re. In addition, there are a few heat transfer correlations applicable to narrow rectangular channels. Therefore, a new set of correlations is proposed with and without consideration of the entrance region. Without consideration of the entrance region, heat transfer characteristics are expressed as a function of Re and Pr for turbulent flows, and as a function of Gz for laminar flows. The correlation proposed for turbulent and laminar flows has errors of ${\pm}18.25$ and ${\pm}13.62%$, respectively. With consideration of the entrance region, the heat transfer characteristics are expressed as a function of Re, Pr, and $z^*$ for both laminar and turbulent flows. The correlation for turbulent and laminar flows has errors of ${\pm}19.5$ and ${\pm}22.0%$, respectively.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.16 no.10
• /
• pp.977-983
• /
• 2004

An experimental study on saturated flow boiling heat transfer of R113 was peformed in a vertical narrow rectangular channel with offset strip fins. Two-phase pressure gradients and boiling heat transfer coefficients in an electrically heated test section were measured in the range of quality $0{\sim}0.6$, mass flux $17{\sim}43kg/m^{2}s$, and heat flux of $500{\sim}3,000W/m^2$ Two-phase friction multipliers were determined as a function of Lockhart-Martinelli parameter. Local boiling heat transfer coefficients were analysed in terms of mass flux, heat flux and local vapor quality. Correlation for boiling heat transfer coefficients was proposed, which was in good agreement with experimental data.

• Proceedings of KOSOMES biannual meeting
• /
• 2018.06a
• /
• pp.77-77
• /
• 2018