• 대한기계학회논문집B
• /
• 제34권12호
• /
• pp.1035-1042
• /
• 2010

HCCI 엔진연소에서 열적성층화 효과는 노킹을 회피하는 수단으로서 생각되고 있다. 본 연구에서는 DME 와 n-Butane 을 연료로 하는 HCCI 엔진연소의 열적성층화 효과를 조사하였다. 예혼합기가 연소실내부에 투입되고 부력의 효과를 이용하여 연소실 내부에 열적성층화를 형성한다. 그 뒤에 피스톤의 압축에 의해서 단열압축 시킨 후 연소실압력과 2 차원화학발광법을 계측하여 해석하였다. 열적성층화가 존재하는 경우에는, 저온산화반응과 고온산화반응의 시작시기가 균질한 경우에 비해서 진각되었고 연소기간은 길어졌다. 발광의 시작은 온도가 높은 곳에서부터 시작하여 온도가 낮은 곳으로 전파 되는 것을 확인하였고 발광기간도 길어짐을 확인하였다.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2007년도 추계학술대회 논문집
• /
• pp.89-92
• /
• 2007

Partail oxidation(POX) of n-butane was investigated in this research by employing ceria-promoted Ni/calcium hydroxyapatite catalysts ($Ce_xNi_{2.5}Ca_{10}(OH)_2(PO_4)_6$ ; x = $0.1{\sim}0.3$) which had recently been reported to exhibit good catalytic performance in POX of methane and propane. The experiments were carried out with changing ceria content, $O_2/n-C_4H_{10}$ ratio and temperature. As the $O_2/n-C_4H_{10}$ feed ratio increased up to 2.75, n-$C_4H_{10}$ conversion and $H_2$ yield increased and the selectivity of methane and other hydrocarbons decreased. But with $O_2/n-C_4H_{10}$ = 3.0, $n-C_4H_{10}$ conversion and $H_2$ yield decreased. This is considered due to that too much oxygen may inhibit the reduction of Ni or induce the oxidation of Ni, which results in poor catalytic activity. The optimum $O_2/n-C_4H_{10}$ ratio lay between 2.50 and 2.75. $Ce_{0.1}Ni_{2.5}Ca_{10}(OH)_2(PO_4)_6$ showed the highest $n-C_4H_{10}$ conversion and $H-2$ yield on the whole. In durability tests, higher hydrogen yield and better catalyst stability were obtained with the $O_2/n-C_4H_{10}$ ratio of 2.75 than with the ratio of 2.5.

• 대한전자공학회논문지
• /
• 제25권4호
• /
• pp.407-416
• /
• 1988

Thick film city gas sensors were fabricated using \ulcornerFe2O3 and \ulcorner-Fe2O3 as raw materials. Their electrical properties and sensitivity characteristics were investigated and the surface conditions for various firing temperatures were analyzed. The fabricated devices exhibited high sensitivity to butane gas(75~80% n 1, 000ppm butane ambient). Also they showed good selectivity and long-term stability. A city gas alarm system using fabricated sensors was made for the practical application.

• 한국안전학회지
• /
• 제31권3호
• /
• pp.60-67
• /
• 2016

The gas leak and explosion accident is able to give a fatal injury to nearby people from the explosion center and interest in effect of the explosion on the human body is increased. Accidents by Portable Butane Gas Range of a gas explosion accident occupy the most share. As a result, the injury on the human body frequently occur. However, It is situation that are experiencing difficulties in consequence analysis of explosion accidents owing to shortage of explosion power data and lack of research on the effect of the human body by the gas explosion. This paper acquire human injury data by performing the actual explosion experiment with Portable Butane Gas Range and evaluate power by explosion and effect of explosion on the human body to perform explosion simulation with LS-DYNA program. It is intended to contribute to the exact cause of the accident investigation and the same type of accident prevention.

• 한국가스학회지
• /
• 제4권3호
• /
• pp.46-52
• /
• 2000

Fireball로 인한 위험성 및 피해를 평가하기 위한 프로그램, FIRESTOR를 개발하여 Fireball로 인한 Thermal flux를 예측하였고, FIRESTOR 프로그램을 부천가스 충전소 사고를 모델로 하여, BLEVE ESTIMATOR와 상용프로그램인 Dupont 사의 SAFER와 비교 분석 하였 다. 용기압력이 일정시 Propane과 Butane의 경우 Thermal flux는 거리변화에 따라 지수함 수로 감소하였다. 거리변화에 따른 Thermal flux변화를 BLEVE ESTIMATOR, SAFER, FIRESTOR로 상호 비교한 결과 본 연구에서 연구개발한 FIRESTOR 프로그램은 SAFER 와 ESTIMATOR의 중간값으로 Dupont사의 상용프로그램인 SAFER에 근접하는 경향을 보이고 있어 우수한 프로그램으로 판단된다.

• International Journal of Automotive Technology
• /
• 제7권3호
• /
• pp.251-259
• /
• 2006

For practical application on the HCCI engine, the solution of subjects, such as control of auto-ignition timing and avoidance of knocking, is indispensable. This study focused on the technique of controlling HCCI combustion appropriately, changing the mixture ratio of two kinds of fuel. Methane and DME/n-Butane were selected as fuels. The influences, which the mixing ratio of two fuels does to ignition timing, ignition temperature, rate of heat release and oxidation reaction process, were investigated by experiment with 4-stroke HCCI engine and numerical calculation with elementary reactions.

• Journal of Mechanical Science and Technology
• /
• 제16권8호
• /
• pp.1127-1134
• /
• 2002

The effects of pressure and temperature on the autoignition of propane and n-butane blends were investigated using a rapid compression machine (RCM) , which is widely used to examine the autoignition characteristics. The RCM was designed to be capable of varying the compression ratio between 5 and 20 and minimize the vortex formation on the cylinder wall using a wedge-shaped crevice. The initial temperature and pressure of the compressed gas were varied in range of 720∼900 K and 1.6∼ 1.8 MPa, respectively, by adjusting the ratio of the specific heat of the mixture by altering the ratio of the non-reactive components (N$_2$, Ar) under a constant effective equivalence ratio (ø$\_$f/= 1.0) The gas temperature after the compression stroke could be obtained from the measured time-pressure record. The results showed a two-stage ignition delay and a Negative Temperature Coefficient (NTC) behavior which were the unique characteristic of the alkane series fuels. As the propane concentration in the blend were increased from 20% and 40% propane, the autoignition delay time increased by approximately 41 % and 55% at 750 K. Numerical reduced kinetic modeling was performed using the Shell model, which introduced some important chemical ideas, represented by the generic species. Several rate coefficients were calibrated based on the experimental results to establish an autoignition model of the propane and n-butane blends. These coefficients can be used to predict the autoignition characteristics in LPG fueled Sl engines.

• 한국응용과학기술학회지
• /
• 제28권2호
• /
• pp.140-145
• /
• 2011

Cationic gemini-surfactant, namely 1,4-butane-bis(N-alkanoyloxyethyl-N,Ndimethyl)-diammonium bromide was synthesized and their inhibition effect on corrosion of mild steel in 1 M HCl solution was tested by weight loss method. The synthesized product was confirmed by FT-IR and $^1H-NMR$ spectroscopy. Surface tensions were measured by surface tensiometer Sigma 70. Their c.m.c. values evaluated by surface tension method was $4.1{\times}10^{-5}{\sim}5.4{\times}10^{-5}$ mol/L. The Krafft point of the these surfactants were <0~$10.7^{\circ}C$. The emulsifying properties of synthesized cationic gemini surfactants and sodium dodecyl sulfate (SDS), tetradecyl trimethyl ammonium bromide (TTAB) was investigated. Of these, 1,4-butane-bis(N-lauroyloxyethyl-N,N-dimethyl)- diammonium bromide, CGL 14-4-14 has been confirmed as a good emulsifier. The inhibition efficiency increases by increasing cationic gemini surfactant concentration. As a result, these surfactants are expected to be applied as corrosion inhibitors.

• 한국결정성장학회:학술대회논문집
• /
• 한국결정성장학회 1997년도 Proceedings of the 12th KACG Technical Meeting and the 4th Korea-Japan EMGS (Electronic Materials Growth Symposium)
• /
• pp.67-71
• /
• 1997

Activated carbons are the microporous carbonaceous adsorbents which are prepared from carbon-containing source materials such as wood, coal, lignite, peteroleum and sometimes synthetic high polymers. [1-2] Activated carbons shows an ability to adsorbe hydrocarbons of the gas phase. Activated carbons are used in the purification of many kinds of gas phases like hexane, benzene, toluene, gasoline, phenol etc.[3] In this study, cokes from bitminous coal were activated for the purpose of preparing the activated carbons by steam activation. The effect of the activation temperature, time, steam concentration and flow rate on the n-butane adsorption, burn off, surface area and average pore size of the activated carbons, were investigated. The adsorption characteristics of the activated carbons for gasoline are indirectly estimated by n-butane adsorption.

• 대한화학회지
• /
• 제7권2호
• /
• pp.128-132
• /
• 1963

A study has been made on the applicability of gas-liquid partition chromatography to the qualitative and quantitative analysis of complex mixture of gaseous hydrocarbons. While phthalate columns are widely used for this $purpose^9$, they separates neither saturated hydrocarbons from the unsaturated nor n-butane from isobutene or butene-1, therefore combined columns such as phthalate and dimethylsulfolane have been used for the perfect separation of gaseous hydrocarbons. It is shown by this study, however, that hydrocarbons having $C_1$ through $C_4$ can be separated with a 2-meters tetraethyleneglycol dimethylether column except ethane from ethylene, and trans-from cis-2-butene especially operated at $15^{\circ}C$$ using helium as the carrier gas. The column effluents were in order of methane, (ethane, ethylene), propane, propylene, isobutane, n-butane, isobutylene, butene-1, (trans-& cis-2-butene, isopentane), (butadiene-1, 3, n-pentane). Two kinds of liquified petroleum gases in market are analysed qualitatively and quantitatively. The results indicate that use of this 2-meters TEGDE column permits the separation and identification of all the commonly encountered aliphatic gaseous hydrocarbons.