• Korean Journal of Applied Biomechanics
• /
• v.17 no.4
• /
• pp.9-16
• /
• 2007

The purpose of this study was to analyze the effects of after aquatic exercise on gait in the Falls Experienced elderly. There were one group : Fall Experienced Elderly Women(n=8). They were tested on their gait (Elapse time of each phase, Stance time of limb, Stride length, Velocity of segment). we took video and analyzed their movement using Ariel Performance Analysis System and compared gait parameters. For data analysis, mean and standard deviation scores were calculated, and correspondence sample t-test and pearson's correlation analysis were used. First, after exercise is short than before exercise on Elapse time of each phase, fall-experience subjects showed meaningful total time. Second, after exercise is short than before exercise on Stance time of limb and Stride length, fall-experience subjects showed meaningful Stride length. Third, after exercise is fast than before exercise on Velocity of segment.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38C no.5
• /
• pp.486-496
• /
• 2013

Time synchronization in underwater environment is challenging due to high propagation delay and mobility of sensor nodes. Previous researches do not consider practical issues affecting on the accuracy of time synchronization such as high-channel access delay and relative position between sensor nodes. Also, those protocols using bidirectional message exchange shorten the network lifetime and decrease the network throughput because numerous transmission, reception and unnecessary overhearing can be occurred. Therefore, in our research, we suggest enhanced time synchronization based on features of underwater environment. It controls the instant of transmission by exploiting the feature of an oceanic movement and node deployment. Moreover, the protocol uses more accurate time information by removing channel access delay from the timestamp. The proposed scheme is also practical on the underwater sensor network requiring low-power consumption because the scheme conducts time-synchronization with smaller transmission and reception compared with previous works. Finally, simulation results show that the proposed protocol deceases time error by 2.5ms and 0.56ms compared with TSHL and MU-Sync respectively, reducing energy consumption by 68.4%.

• Journal of Korean Elementary Science Education
• /
• v.34 no.1
• /
• pp.142-152
• /
• 2015

The purpose of this study was to identify the differences in eye movement pattern shown in shown in classification process between the scientifically gifted and general students in elementary schools. The subjects for the research consisted of 16 gifted students in special education center for the gifted at Seoul National University of Education and 22 general students at G elementary schools. The tasks consisted of four hierarchical biology classification tasks and one non-hierarchical tasks. SMI's Eye Tracker (iView $X^{TM}$ RED) was used to collect eye movement data while the Begaze software analyzed the task performing process and eye movements. The findings of this study were twofold. First, there was a significant difference in students' fixation duration by students' academic achievement level. Gifted students spent little time on scanning details and found the features successfully. Second, the process of the classification is different by students' academic achievement. General students spent more time to gaze the salient features not relevant features. They had a difficulty to find the element to classify.

• Journal of Korean Physical Therapy Science
• /
• v.8 no.2
• /
• pp.1059-1064
• /
• 2001

This study is aimed at diagnosing transmutation aspect with the respective of hemiplegia patient's static adaptation of posture which is influenced by anti-gravity excercise, center of gravity shifting movement and segmental movement adaption of the legs and arms by key-point control in the process of Bobatli's treatment approach. The patients for the investigation of this study were selected as a total 17 patients who were doing the physical-therapy in Tae-gu Rehabilitation Center, and diagnosed as hemiplegia patients by Rehabilitation Medicine department in Kyung-buk University hospital. And also, there investigated into temporal transition that keep the attitude with one-leg standing on the ground concerning static attitude adaption on the basis of the before of anti-gravity movement and the after of 4-weeks movement. The findings of this study were as follows: With the respective the time to keep standing pose by one-leg at static attitude transmutation, affected side showed meaningful differences as a l.86/sec, 2.62/sec at 4 weeks later considering the before and after of this experiment.(p<0.01), non-affected side at the aspect of attitude keeping time, but there didn't showed meaningful differences statistically.

• Textile Coloration and Finishing
• /
• v.17 no.5 s.84
• /
• pp.53-60
• /
• 2005

Fusing press m/c is used for heating and pressing the specimens that are fed into between the two moving belts. Therefore the belt movement, belt temperature, and the pressure between belts must be kept constant. Especially, the belts should move in a limited operation range. When the belts run far out of the operation point, the machine has to be stopped, which results in a product defect because the fusing conditions, e.g., temperature and pressure, change during the transient process time period. It is important to avoid the belt stopping by maintaining the belt movement in a limited range. This study reports about the movement of the endless fusing belt in a long-span roller fusing m/c. The belt position changes as the 1st-order system does; if the roller axes are slanting each other with a certain angle, the belt running around the two rolls shows a dynamic behavior with the time that deviates fastly at the beginning from the initial condion and slows down. Then it reaches at a final position. The skewer the axes, the greater the position change. The inital change rate of the belt becomes large as the skewness of the axes between the two rollers increases.

• The korean journal of orthodontics
• /
• v.44 no.6
• /
• pp.320-329
• /
• 2014

Objective: To investigate the involvement of ephrinB2 in periodontal tissue remodeling in compression areas during orthodontic tooth movement and the effects of compressive force on EphB4 and ephrinB2 expression in osteoblasts and osteoclasts. Methods: A rat model of experimental tooth movement was established to examine the histological changes and the localization of ephrinB2 in compressed periodontal tissues during experimental tooth movement. RAW264.7 cells and ST2 cells, used as precursor cells of osteoclasts and osteoblasts, respectively, were subjected to compressive force in vitro. The gene expression of EphB4 and ephrinB2, as well as bone-associated factors including Runx2, Sp7, NFATc1, and calcitonin receptor, were examined by quantitative real-time polymerase chain reaction (PCR). Results: Histological examination of the compression areas of alveolar bone from experimental rats showed that osteoclastogenic activities were promoted while osteogenic activities were inhibited. Immunohistochemistry revealed that ephrinB2 was strongly expressed in osteoclasts in these areas. Quantitative real-time PCR showed that mRNA levels of NFATc1, calcitonin receptor, and ephrinB2 were increased significantly in compressed RAW264.7 cells, and the expression of ephrinB2, EphB4, Sp7, and Runx2 was decreased significantly in compressed ST2 cells. Conclusions: Our results indicate that compressive force can regulate EphB4 and ephrinB2 expression in osteoblasts and osteoclasts, which might contribute to alveolar bone resorption in compression areas during orthodontic tooth movement.

• Journal of ILASS-Korea
• /
• v.22 no.4
• /
• pp.210-217
• /
• 2017

A gasoline direct injection engine has an intake air temperature can be lowered by the fuel vaporization in the combustion chamber increase the volume efficiency is high compression ratio. Therefore, study for injection rate and characteristics which influence mixture formation in combustion chamber is important. Movement of the injector needle has a direct effect on the injection of the fuel, such as formation of cavitation, the fuel injection rate, etc. Therefore, recent studies on the dynamic characteristics of the injector considering the movement of the needle have been reported, but it takes a lot of time and cost to experimentally confirm the movement of the needle inside the injector. In this study, AMESim, a commercial 1-D code, and Star-CCM+, a 3-D CFD code, were used to predict the dynamic performance of the injector with needle motion. In order to predict the movement of the needle under the high pressure, the result of the surface pressure distribution according to the movement of the needle was derived by using the morphing technique of flow analysis. In addition, we predicted the injection rate of the injector considering the movement of the needle in conjunction with the 1-D code. The injection rate of the injector was measured by the BOSCH's method and the results were similar to those of the simulation results. This method can predict the injection rate and injection characteristics and this result is expected to be used to predict the performance of gasoline direct injection engines with low cost and time in the future.

• International Journal of Fuzzy Logic and Intelligent Systems
• /
• v.12 no.2
• /
• pp.121-130
• /
• 2012

This paper proposes an intuitive real-time robot control system using human body movement. Recently, it has been developed that motion generation for humanoid robots with reflecting human body movement, which is measured by a motion capture. However, in the existing studies about robot control system by human body movement, the detailed structure information of a robot, for example, degrees of freedom, the range of motion and forms, must be examined in order to calculate inverse kinematics. In this study, we have proposed Associative Motion Generation as humanoid robot motion generation method which does not need the detailed structure information. The associative motion generation system is composed of two neural networks: nonlinear principal component analysis and Jordan recurrent neural network, and the associative motion is generated with the following three steps. First, the system learns the correspondence relationship between an indication and a motion using training data. Second, associative values are extracted for associating a new motion from an unfamiliar indication using nonlinear principal component analysis. Last, the robot generates a new motion through calculation by Jordan recurrent neural network using the associative values. In this paper, we propose a real-time humanoid robot control system based on Associative Motion Generation, that enables user to control motion intuitively by human body movement. Through the task processing and subjective evaluation experiments, we confirmed the effective usability and affective evaluations of the proposed system.

• Korean Journal of Applied Biomechanics
• /
• v.21 no.3
• /
• pp.289-296
• /
• 2011

The purpose of this study was to quantify the biomechanical characteristics of the ground reaction force(GRF) during the Taekwondo's Apkubi, one of the basic movement in Taekwondo and the walking. The GRF profiles under the stance foot of Apkubi movement and walking were directly measured in sample of 20 healthy older persons. In the anterior-posterior and vertical direction, the GRF of the Apkubi movement reached to the peak braking force at 10% of the normalized stance time percent and the peak driving force at 90% of stance time, but that of the walking reached to the peak braking force at 20% of stance time and the peak driving force at 80% of stance time. In vertical force, the GRF of the walking showed two peak values, but that of the Apkubi movement seemed three peak values. Moreover the first peak vertical force was significantly(t=6.085, p<.001) greater in the walking(about 1.8 times of body weight) than the Apkubi(about 1.4 times of body weight). The walking velocity was affected significantly(over p<.05) by the braking impulse, the peak braking force and the first peak vertical force. Futhermore the peak braking force in the Apkubi showed a significant effect on the Apkubi's stride length(p<.01). So, we concluded that the braking force after the right touch down, the stance foot on the ground contributed to move the leg forward.

• Physical Therapy Korea
• /
• v.15 no.3
• /
• pp.44-52
• /
• 2008

The purpose of this study was to investigate the effects of different objects and target location of dominant hand on the non-dominant hand movement kinematics in a bimanual reaching task. Fifteen right-handed volunteers were asked to reach from same starting point to the different target point of right and left hand with grasping the objects of different size. Independent variables were 1) three different object types (small mug cup, name pen, and PET bottle), and 2) three different target locations (shorter distance, same distance, and longer distance than the non-dominant hand) of the dominant hand. Dependent variables were movement time (MT), movement distance (MD), movement mean velocity ($MV_{mean}$), and movement peak velocity ($MV_{peak}$) of the non-dominant hand. Repeated measures two-way analysis of variance (ANOVA) was used to test for differences in the non-dominant hand movement kinematics during bimanual reaching. The results of this study were as follows: 1) MT of the non-dominant hand was increased significantly when traveling with grasping the mug cup and reaching the far target location, and was decreased significantly when traveling with grasping the PET bottle and reaching the near target location of the dominant hand. 2) MD of the non-dominant hand was significantly increased during reaching the far target location, and significantly decreased during reaching the near target location with dominant hand. 3) $MV_{mean}$ of the non-dominant hand was increased significantly when traveling with grasping the PET bottle, and was decreased significantly when traveling with grasping the mug cup of the dominant hand. Therefore, it can be concluded that the changes of the ipsilateral hand movement have influence on coupling of the contralateral hand movement in bimanual reaching.