• Journal of the Korea institute for structural maintenance and inspection
• /
• v.15 no.6
• /
• pp.219-225
• /
• 2011

Advanced composite structures are too difficult for such design engineers for construction and some simple but accurate enough methods are necessary. The simply supported laminated plates are analyzed by the specially orthotropic laminates theory. This method, however, may be too difficult for some practising engineers. In this paper, the result of analysis for such plate by means of the beam theory with unit width is reported. The plate aspect ratio considered is from 1 : 1 to 1 : 5. Most of the bridge and building slabs on girders have large aspect ratios. For such cases further simplification is possible by neglecting the effect of the longitudinal moment terms($M_x$) on the relevant partial differential equations of equilibrium. In this paper. the influence of the aspect ratio on the natural frequency of the specially orthotropic laminated plates is studied and it is concluded that the method used is sufficiently accurate for engineering purposes. The result of this paper can be used for simply supported laminated plates analysis.

• Journal of Conservation Science
• /
• v.6 no.2 s.8
• /
• pp.141-148
• /
• 1997

When we have entered high economic growth since 1970s, many archaeological excavations were performed all over the country. Excavated objects composed of variable materials are inevitably subjected to deformations owing to surrounding environments and storage conditions. Although the importance of conservation treatment of the objects is greatly increased, a few conservation laboratories are there comparing with excavation groups. The metallic objects excavated are very unstable and deformable state. So it is important not to allow iron objects, especially cast iron, to dry out once excavated. Because the corrosion reactions on the surface proceed rapidly, the objects may be destroyed at the moment. The conservation procedures of the excavated metallic objects are as follows: (1)It is stable on-site storage method for objects to keep vinyl film with envelop or to immerse alkaline solution to prevent the environmental changes. (2)The objects must be treated at once under suitable methods in the conservation laboratory after excavation. (3)The continued existence of objects depends on environmental factors such as relative humidities, regular inspection, light etc.

• Korean Institute of Interior Design Journal
• /
• v.17 no.4
• /
• pp.92-101
• /
• 2008

A new paradigm of design lays stress on the world of metaphysical concepts, and various attempts are being made to give meaning to psychological values. Hotel is a memorable place to remind of a special moment in one's life such as travel, marriage, meeting and so on. It also contains even more symbolism than other spaces as it is the place where the most primary and private act takes place apart from one's residence. As a result, it is also possible to communicate the message which a designer intends to convey through the user's recognition in the form of various symbolic expressions in space design. The designer communicates a meaning into a space through a symbolic system and creates a mutual consensus by means of the understanding structure of "designer-space-user". The user's diverse interpretations through a symbol are based on epistemology and consist of the primary, the secondary and the tertiary recognition structure system in the aspect of their contents. The primary structure depends on sensual perception, impressive idea and transcendental recognition based on metaphysical and perceptional association. The secondary structure includes casualty, continuous deduction and rational(integral) recognition. Finally, the tertiary structure is sublimation to the transcendental mental world beyond the boundary of emotion and it is classified into fundamental recognition structure on an object and archetypical recognition structure on an ego. These characteristics can derive systematic understandings and diverse interpretations on the symbol from the space of a hotel through the frame of analysis based on the artistic form of monosemous, polysemous and multidimensional frameworks and symbols. The framework of this analysis includes all the cases, and various methods which haven't been attempted in practice are presented. Therefore this study is not just a simple analysis of space but rather it will serve as a methodological tool for design that allows for various attempts of symbolic design concepts in the recognition structure system.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.9
• /
• pp.6160-6168
• /
• 2015

Hand hygiene(HH)of the health care personnels(HCPs) was the most effective method to prevent the transmission of healthcare associated infections. This study was conducted to measure and analysis the status of the HH compliance of HCPs. Data were collected by the direct observation methods of the World Health Organizations(WHO) using WHO's HH monitoring tool kits from 25th October to 31th December, 2010. Data were analyzed by descriptive statistics, cross analysis, multiple logistic analysis using the SPSS/PC 21 program. A total of 8,644 opportunities for HH were observed, and the overall HH compliance rate was 94.1%. HH rates of physicians was lowest(83.4%; OR: 0.209, 95%CI:0.174-0.252). HH rates were statistically different by the job titles(p<0.001), WHO's 5 moments(p<0.001). HH rates in registered nurses(p=0.003), and medical technicians(p<0.001) were statistically different by the WHO 5Moments. Jobs specific HH strategies and WHO 5Moments should be developed to increase the HH compliances of the HCPs.

• Journal of Korean Society of Steel Construction
• /
• v.19 no.4
• /
• pp.395-402
• /
• 2007

Probabilistic risk assessment was conducted on a hybrid cable-stayed bridge consisting of a steel-composite plate girder and a concrete girder with a long span, designed using the working stress design and strength design methods. The component reliabilities of the bridge's cables, pylons, girders, and steel-concrete conjunction were evaluated using the AFOSM(Advanced First Order Second Moment) algorithm and the simulation technique at the critical sections, based on the maximum axial force, shear, and positive and negative moments of the selected sections. For the analysis of system reliability, the hybrid cable-stayed bridge consisting of cables, pylons, and plate girders was modeled into combined failure modes, and for system reliability, the probabilities of failure and reliability index of the structural system were evaluated. Based on the results of this study, the critical failure modes of the hybrid cable-stayed bridge based on the bridge's structural characteristics are suggested, and the efficiency of the partial ETA technique for use in the risk assessment method was confirmed.

• Journal of Korea Water Resources Association
• /
• v.32 no.2
• /
• pp.99-110
• /
• 1999

The method of moments, a Lagrangian scheme, considers the zeroth, first, and second moments of the grid cell spatial distributions of the concentration and then advects the concentration by maintaining conservation of the moments. The reasonable inital description of the first and second moments as well as the mean concentration, the zeroth moments, in grid element is important in the method of moments. In this study, the description methods of each initial moment are reviewed, and the method of moments is extended to overcome the restrictions of Courant number. Its performance is compared with those of available Eulerian and Lagrangian schemes. As the results, the method is successfully extended to overcome the stability restriction and is an accurate scheme for the advection simulation of concentration distribution, especially of which the gradient is steep. In addition, the method is very promising scheme in terms of computational efficiency when the mixing is confined in a relatively small region to the entire domain in two-dimensional problem.

• Korean Journal of Clinical Laboratory Science
• /
• v.43 no.1
• /
• pp.1-5
• /
• 2011

The infection rate of syphilis is still increasing in the world especially in developing countries and the infection is often seen in large amounts of clinical specimens. For the diagnosis of this disease, Rapid Plasma Reagin (RPR)/Venereal Disease Research Laboratory (VDRL) has still been used as one of major primary methods to diagnose syphilis even though the test readings are somewhat subjective with high false positive rates. Recently, the automatic ARCHITECT Syphilis TP, which is based on the detection of the TP-specific antibodies, has been introduced in many laboratories. Therefore, the clinical assessment of the method is needed to provide primary diagnosis of syphilis at the moment. We evaluated 3 different manual rapid kits and ARCHITECT Syphilis TP comparing with RPR/FTA-ABS and analysed their diagnostic properties. From February 2006 to April 2008, 203 positive and 250 negative specimens, obtained from Chungbuk National University Hospital were used for the evaluation. In the evaluation between manual rapid kits, their specificities were as high as 99.2 ~ 99.6% while their sensitivities were observed with little differences; 98.0% (199/203) for Kit A, 96.6% (196/203) for Kit B, and 97.4% (197/203) for Kit S. In the case of ARCHITECT Syphilis TP test, it showed 100% specificity (250/250) and 98.5% sensitivity (249/250). Kappa values comparing with RPR/FTA-ABS were 0.978 for Kit A, 0.964 for Kit B and Kit S, and 0.987 for ARCHITECT Syphilis TP. From our evaluation, we found out that manual rapid tests and ARCHITECT Syphilis TP have very good clinical accuracies and high kappa agreements with RPR/FTA-ABS. Due to its automation and quick simultaneous diagnosis with another serological markers, we suggest that the ARCHITECT Syphilis TP is one of best suitable method for the primary diagnosis of syphilis and that it might be able to replace RPR method in the laboratories.

• Physical Therapy Rehabilitation Science
• /
• v.3 no.1
• /
• pp.38-42
• /
• 2014

Objective: In this study, we applied a neurodynamic sciatic nerve sliding technique to healthy adults to elucidate its effects on hamstring flexibility and postural balance. Design: Cross-sectional study. Methods: This study targeted twenty four healthy adults (16 men, 8 women). A neurodynamic sciatic nerve sliding technique was applied 5 times to all subjects' dominant leg. The subjects were asked to sit on the bed while performing cervical and thoracic flexion, as well as knee flexion with ankle plantar flexion. Then, they were asked to perform cervical and thoracic extension and knee extension with their ankle in dorsiflexion and maintain the position for 60 s. For postural balance, we measured postural sway while the subjects maintained a one-legged standing posture using the Good Balance System and measured the hip joint flexion range of motion using a standardized passive straight leg raise (SLR) test. Results: SLR test increased significantly from $79^{\circ}$ before the intervention to $91.67^{\circ}$ after the intervention (p<0.05). Regarding the participants' balance evaluated using the one-legged standing test, the X-speed decreased significantly from 18.61 mm/s to 17.17 mm/s (p<0.05), the Y-speed decreased from 22.28 mm/s to 20.52 mm/s (p<0.05), and the velocity moment was significantly decreased from $89.33mm^2/s$ to $74.99mm^2/s$ after the intervention (p<0.05). Conclusions: Application of the neurodynamic sciatic nerve sliding technique exhibited improved hamstring flexibility and postural balance of healthy adults.

• Journal of Magnetics
• /
• v.20 no.1
• /
• pp.31-39
• /
• 2015

Macroscopic hysteresis loops and microscopic magnetic moment distributions have been determined by a three-dimensional (3D) model for exchange-coupled Sm-Co/${\alpha}-Fe$/Sm-Co trilayers with in-plane collinear easy axes. These results are carefully compared with the popular one-dimensional (1D) micromagnetic models and recent experimental data. It is found that the results obtained from the two methods match very well, especially for the remanence and coercivity, justifying the calculations. Both nucleation and coercive fields decrease monotonically as the soft layer thickness $L^s$ increases while the largest maximum energy product (roughly 50 MGOe) occurs when the thicknesses of hard and soft layers are 5 nm and 15 nm, respectively. Moreover, the calculated angular distributions in the thickness direction for the magnetic moments are similar. Nevertheless, the calculated nucleation and pinning fields as well as the energy products by 3D OOMMF are systematically smaller than those given by the 1D model, due mainly to the stray fields at the corners of the films. These demagnetization fields help the magnetic moments at the corners to deviate from the previous saturation state and facilitate the nucleation. Such an effect enhances as $L^s$ increases. When the thicknesses of hard and soft layers are 10 nm and 20 nm, respectively, the pinning field difference is as large as 30%, while the nucleation fields have opposite signs.

• International Journal of Advanced Culture Technology
• /
• v.9 no.4
• /
• pp.180-187
• /
• 2021

This thesis explores the place and role of a performer's action from a perspective of a director and playwright David Mamet's concept for performer training. This thesis takes inspiration from the idea of Mamet's simple and practical investigation specifically in text-based approach with a performer's bodily function on stage. For Mamet, the writings and practices of many different body-centered training are not rooted in the principle and nature of acting/performance. Reconsidering complicated approaches particularly psychological-oriented theory, practice, and assumption draw on several practitioners takes us beyond the field of visible and/or outer appearance of a performer which in turn leads the performer's body to be as abstract therefore not to being in the moment on stage. Arming the points, we argue that whatever disciplines and/or methods necessarily need to meet the principles and demands of acting/performance/theatre to connect to the materials, an action/objective given by a specific playwright which the performer must inhabit through his/her body. Out of the context, any 'method' serves no purpose. That is, the mechanics of an action is an extension of addressing what a performer's specific needs which shifts his/her body to respond appropriately to the theatrical demands. Taking this argument further, we claim that the purpose of performer training should not be understood as learning and improving techniques or skills for his/her self-perfection. The research finding shows that this resembles to the phenomenon that the visible very often precedes the invisible where the performer's body lose a clarity with no more chance to happen and/or change the event(s). Rather, it is a process of learning what/how to learn which in turn brings us back to the central question of why we do training for what purpose in this contemporary era. Exploring and answering these questions is not only a way to employ the key materials applicable to the theatrical demands but also to achieve the identify as a professional performer/doer on stage.