• The Journal of the Korea institute of electronic communication sciences
• /
• v.8 no.6
• /
• pp.823-829
• /
• 2013

IEEE 802.16 standard specifies the broadband wireless access (BWA) system including sleep mode to minimize the power consumption by a mobile station (MS). This paper outlines the overall operation of sleep mode and proposes a method to improve the power saving efficiency of the IEEE 802.16 sleep mode. The proposed method not only decreases the number of bytes that a MS in sleep mode needs to receive during listening interval but allows to indicate a control-specific operation such as periodic ranging.

• Journal of the Microelectronics and Packaging Society
• /
• v.11 no.1
• /
• pp.7-11
• /
• 2004

In this paper, the wideband microstrip patch antennas for the Personal communications Service (PCS : 1750∼1870 MHz) and International Mobile Telecommunications-2000 (IMT-2000 : 1920∼2170 MHz) dual band are studied. Experimental and simulation results on the dual band antenna are presented. Simulation results are in good agreement with measurements. The experimental and simulation results confirm the wideband characteristics of the antenna. The studied antenna satisfied the wideband characteristics that are required characteristics for above 420 MHz impedance bandwidth for the PCS and IMT-2000 dual band antenna. In this paper, through the designing of a dual band antenna, we have presented the availability for PCS ＆ IMT-2000 base station antenna. An impedance bandwidth of 33% (VSWR<1.5, 650 GHz) and a maximum gain of 7dB can be achieved. The radiation pattern is stable across the passband.

• The Journal of the Korea Contents Association
• /
• v.8 no.4
• /
• pp.71-78
• /
• 2008

We propose the scheme that supports continuously service when a user tries to contact new target network in broadband convergence network even though the network resource for the service is not enough. The proposed scheme transforms original service capacity into suitable QoS for the target network using the scalable service techniques in the oncoding/decoding and supports handover for the user. We analyzed the handover blocking probability of two schemes using queueing system to show the improvement of performance by the proposed scheme. Subsequently, we showed that the handover blocking probability in the proposed scheme is lower than that in the existing scheme.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.9A
• /
• pp.878-883
• /
• 2006

New emerging wireless broadband internet can make many broadband multimedia services. The networked intelligent mobile robot service is one of the new services. In the networked robot control, both the on-line real-time control and the reliability of control data transmission are very important. Considering the real-time control and data reliability, an efficient transmission method based on UDP protocol is proposed. The proposed method allocates the priority to the robot control data and the transmission of the robot data at the base station is carried out in duplicate manner. NS-2 simulation results show that the proposed scheme has a very low packet delay and low packet errors.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.10
• /
• pp.1129-1136
• /
• 2008

In this paper, a dual polarized broadband antenna fed by L-shaped strip for the Korea PCS band and W-CDMA band is presented. To analyze the characteristics of the designed antenna, we used commercial simulation tool(HFSS). The designed antenna was fabricated and measured using HP8753D vector network analyzer. The measured impedance bandwidth(VSWR<1.5) is 560 MHz and the measured average gain is 6.56 dBi. The measured isolation characteristic between two ports is -14 dB(min.) $\sim$ -40 dB(max.). These results are proper for the mobile communication application and repeater antenna.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.12
• /
• pp.53-62
• /
• 2005

This paper presents an interface configuration between the Access Point(AP) of Wibro and Radio Over Fiber(ROF) transceivers for the wireless broadband internet system. The wireless internet could provides 60km/h mobility and 50Mbps IP based data services for each mobile terminal. Thus, low cost of each cell is inevitably required. This paper suggests an interface configuration between AP and Passive Integrated Picocell(PIP) involving ROF links. Characteristics of a typical Fabry-Perot ROF link and a PIP using a passive Electro-Absorption Modulator(EAM) are described and measured for wireless internet applications. In addition, results of RF coverage of a PIP have been shown.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.20 no.2
• /
• pp.23-32
• /
• 2010

WiBro(Wireless Broadband), the service based on IEEE 802.16e(mobile WiMAX) standard, is a wireless broadband Internet technology being developed by the domestic telecommunication industry. In this paper, we analyze security vulnerabilities of WiBro focusing on initial authentication phase and propose a specification-based intrusion detection system that can detect those vulnerabilities. We first derive a specification from the normally operational process of the initial authentication based on PKMv2 EAP-AKA and formalize the derived specification as a state transition diagram. Proposed system executes the intrusion detection based on those specification and state transition diagram. In this paper, to verify the detection capability of proposed system, we construct a test bed network and execute scenario-based test.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2018.05a
• /
• pp.449-452
• /
• 2018

In this paper, we design a Wibro / WiFi dual band microstrip antenna for wireless broadband communication. The proposed antenna is designed to have the characteristics of FR-4 (er = 4.3), size of $40[mm]{\times}40[mm]$, and usable in 2.31[GHz] and 5.8[GHz] bands of Wibro / WiFi. The simulation is performed by CST Microwave Studio 2014 The simulation result shows that the gain is 2.308[dB] at 2.31[GHz] and 2.985[dB] at 5.8[GHz]. S-parameters were also found to be less than -10[dB] (WSWR2: 1) in the desired frequency band, and a small number of parameters and a compact antenna were designed. It is expected that many users will use the mobile communication antenna for accurate and fast communication for smooth wireless broadband communication.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.3
• /
• pp.242-250
• /
• 2004

In this thesis, a new broadband PIFA(Planar Inverted-F Antenna) for PCS and IMP-2000 applications is designed. The dual-L antenna structure is adopted in order to improve the characteristics of PIFA which usually has a narrow band. The height of the antenna is fixed 6 mm considering terminal's thickness and the structure is deformed into the folded radiation patches to minimize the size of the antenna. The bandwidth of a realized antenna is 1.66∼2.35 ㎓(34.5 %) fur return loss below -10 ㏈ which contain the required bandwidth of PCS and IMT-2000. And Monopole antenna with λ/4 length is designed and compared with dual-L with folded patch in SAR. 1 g and 10 g averaged peak SAR of PIFA are about 25.7 %, 30.3 % lower than those of monopole antenna respectively.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.5
• /
• pp.1270-1276
• /
• 2010

In this paper, Quad-Band small antenna for GSM850, GSM900, DCS1800, DCS1900 is designed and fabricated. The antenna achieved the size reduction of over 67.9 % than the conventional PIFA(Planar Inverted-F Antenna) by using a MD(Magneto-Dielectric) material. A simple feeding microstrip line is used to feed the antenna from a $50{\Omega}$ coaxial line, which is capacitively coupled to the grounded patch structure for broadband characteristics. The impedance bandwidth the proposed antenna shows good results as broadband characteristics of 1341 MHz (801 ~ 2142 MHz) in VSWR < 3 (${\leq}\;-6\;dB$) and the gain is -6.67 ~ 4.25 dBi in the operating frequency.