• Journal of Korean Society of Water and Wastewater
• /
• v.22 no.6
• /
• pp.705-714
• /
• 2008

Three Mesh Screenning Reactors (MSRs) were operated in three different modes to investigate the effect of the mesh opening size and the filtrate flux on the removal of particulate matters and the production of soluble organic matters. The mesh opening size was $82{\mu}m$ (Mode 1), $61{\mu}m$ (Mode 2) and $38{\mu}m$ (Mode 3), respectively, and each mode has three different filtrate flux; $0.47m^3/m^2/d$, $0.95m^3/m^2/d$ and $1.42m^3/m^2/d$, respectively. TSS removal efficiency of mode 1, 2, and 3 fed with 191 mgTSS/L was 27%, 36%, and 60%, respectively. The SCOD concentration of 91mg/L in influent for the mode 1, 2, and 3 increased to 117 mg/L, 127 mg/L, and 155 mg/L, respectively. For the all MSRs, there was no significant effect of filtrate flux on the removal of particulate matters and the production of soluble organic matters. However, the mesh opening size greatly affected the removal of particulate matters and the production of soluble organic matters in wastewater. Three parallel A2O processes consisting of anaerobic, anoxic and aerobic reactors maintaining mixed liquor suspended solids (MLSS) of 3,000 mg/L were operated to investigate the effectiveness of MSR on the removal efficiencies of the organic matters, nitrogen, and phosphorus; MSR influent was introduced to System 1 (183 mgTSS/L, 324 mgTCOD/L, 87 mgSCOD/L, 45.2 mgTKN/L, and 6.6 mgTP/L) and MSR efluent was introduced to System 2 and 3(72 mgTSS/L, 289 mgTCOD/L, 141 mgSCOD/L, 40.2 mgTKN/L, and 4.2 mgTP/L). HRTs of the anaerobic reactors in systems 1, 2 and 3 were 1 h, 1 h and 0.6 h, respectively and anoxic reactors were 2 h in all systems. HRTs of the aerobic reactors in systems 1, 2 and 3 were 5 h, 3 h and 3 h, respectively. TSS concentration in effluent of both system 2 and 3 is about 8 mg/L and lower than that of system 1 effluent. Despite higher TCOD loading and SCOD loading, both Systems 2 and 3 had a greater TCOD and SCOD removal efficiency at 91% and 92% than System 1 was at 88% and 82%, respectively. The nitrification efficiency for system 2 was greater than observed for System 1 (99% verses 97%). The denitrification efficiency for systems 1, 2 and 3 was 78%, 88% and 87%, respectively. System 2 and 3 showed about 12% higher TN removal efficiency than system 1 (85% verses 73%). The effluent TP concentration for system 2 was less than observed for system 1 and 3.

• Korean Journal of Food Science and Technology
• /
• v.28 no.4
• /
• pp.736-742
• /
• 1996

This study was carried out to investigate the effect of the lactoperoxidase (LP) system on the acid production of gel type yogurt. The LP system was activated by adding freshly prepared solutions of 1 ppm (v/w) lactoperoxidase and three different concentrations (0.125 mM, 0.25 mM, 0.5 mM) in equimolar ratios of KSCN and $(H_{2}O_{2}$, In 0.25 mM treated samples for the 4 hr fermentation resulted in titratable acidity of $0.4{\%}$, pH of 5.06, lactic acid bacterial count of $3.0{\times}10^{8}\;CFU/ml and acetaldehyde concentration of 10.2 ppm, whereas the untreated samples were 1.0%, 4.54, $4.7{\times}10^{9}\;CFU/ml and 18.0 ppm, respectively. The residual amount of KSCN in 0.25 mM treated samples was determined during the experiments, which decreased to 4.4 ppm. There was no detectable $(H_{2}O_{2}$ for 6 hr fermentation. However, residual KSCN and $(H_{2}O_{2}$ concentrations in 0.5mM treated samples were 5.7 and 8.4 ppm, respectively. These results have indicated that the optimum concentration of $(H_{2}O_{2}$ and KSCN to activate the LP system was 0.25 mM each.

• Proceedings of the Korean Statistical Society Conference
• /
• 2003.10a
• /
• pp.189-194
• /
• 2003

We consider an M/G/1 queueing system under P$_{\lambda}^{M}$-service policy. As soon as the workload exceeds threshold ${\lambda}$ > 0, the service rate is increased from 1 to M ${\geq}$ 1 and is kept until the system becomes empty. After assigning several costs, we show that there exists a unique M minimizing the long-run average cost per unit time.

• Bulletin of the Korean Mathematical Society
• /
• v.46 no.5
• /
• pp.931-940
• /
• 2009

Given a system of smooth 1-forms $\theta$ = ($\theta^1$,...,$\theta^s$) on a smooth manifold $M^m$, we give a necessary and sufficient condition for M to be foliated by integral manifolds of dimension n, n $\leq$ p := m - s, and construct an integrable supersystem ($\theta,\eta$) by finding additional 1-forms $\eta$ = ($\eta^1$,...,$\eta^{p-n}$). We also give a necessary and sufficient condition for M to be foliated by reduced submanifolds of dimension n, n $\geq$ p, and construct an integrable subsystem ($d\rho^1$,...,$d\rho^{m-n}$) by finding a system of first integrals $\rho=(\rho^1$,...,$\rho^{m-n})$. The special case n = p is the Frobenius theorem on involutivity.

• Journal of Bio-Environment Control
• /
• v.8 no.3
• /
• pp.209-215
• /
• 1999

In order to develop facility for complex farming with aquaculture and vegetable nutrient culture and to investigate growth of tilapia and water quality in the channel type aquaculture system, these experiments were carried out. When tilapia(Tilapia nilotica) was reared in the channel type aquaculture system, Quality of culture water and growth of tilapia were normal. And the growth of tilapia in the channel type and round type aquaculture system was much the same. Channel type aquaculture facilities was applicable to the dual culture system for aquaculture and vegetable culture. Channel type integrated system was composed of aquaculture and sandculture bed, and it was thought that suitable size of the system was about 1.4m(width) $\times$ 1m(height) $\times$ 20m(length).

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.36S no.8
• /
• pp.8-16
• /
• 1999

In this paper, the performance of a hybrid DS/SFH-SS(direct-sequence/slow-frequency-hopped spread-spectrum) system with coherent BPSK modulation over Nakagami fading channel in the presence of multiple tone jamming is analyzed. Because the Nakagami m-distribution can describe not only Rayleigh fading but also more general fluctuations involving a specular component by adjusting the value of the fading index m. It is known that for m=1 corresponds to Rayleigh fading, for $1/2{\le}m{\le}1$ corresponds to the worst case fading condition, for m>1 corresponds to Rician fading, and for $m{\to}{\infty}$ corresponds to the nonfading condition. The bit error probability is derived over Nakagami model and numerical evaluations are presented for some combinations of system parameters. The results show that as m increases, the bit error probability is better. Also, at a low JSR(jamming-to-signal power ratio), a pure DS-SS system can achieve lower bit error probability than a hybrid DS/SFH-SS system. But at a high JSR, a hybrid DS/SFH-SS system is shown to be superior to a pure DS-SS system. Therefore, it is demonstrated that without increasing the total system bandwidth, the performance of a hybrid DS/SFH-SS is superior to that of a pure DS-SS system in the presence of multiple tone jamming.

• Journal of Bio-Environment Control
• /
• v.23 no.2
• /
• pp.144-147
• /
• 2014

It was intended to closely examine an effect that a change in the concentration of culture medium had on the potato(Solanum tuberosum L.) plantlet growth in the microponic system so as to mass-produce the virus-free plant of new variety 'Saebong' for potato processing. The adjusted concentration of potato culture medium was 0.2, 0.6, 1.0, 1.4, 1.8, and $14.0dS{\cdot}m^{-1}$. And potato seedling was cut into pieces of 1.5 cm in length, which included 2 growth points and leaves. And each was explanted in glass vial of 50 mL. And experiments were carried out twice for 18 days or 21days. Culture medium of 2ml was put in the container respectively. And 1 mL was added after 10 days. And in terms of cultivation environment, the experiment was carried out at the day length of 16 hours at the temperature of $23{\pm}1^{\circ}C$ under the white LED light of $40{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$. The concentration of culture medium in the experiment I was EC 0.2, 1.0, $14dS{\cdot}m^{-1}$ and was adjusted to 0.6, 1.0, 1.4, $1.8dS{\cdot}m^{-1}$ in the experiment II. The results showed that the survival rate of plantlet was 90% at $0.2dS^2m^{-1}$, 100% at $0.6dS^2m^{-1}$, 100% at $1.0dS^2m^{-1}$. 0% at $1.4dS{\cdot}m^{-1}$, 0% at $1.8dS{\cdot}m^{-1}$. and 0% at $14.0dS{\cdot}m^{-1}$ after 7 days. With regard to the explanted potato seedling, in case of the treatment where the electrical conductivity of culture medium was adjusted to $1.0dS{\cdot}m^{-1}$, root developed 2 days after transplantation. And the plantlet vigorously grew into strong plant that had 7 leaves, length of 5cm, and fresh weight of 0.5 g after 18 days. In case of the treatment where the concentration of culture medium was adjusted to $0.6dS{\cdot}m^{-1}$, the root plantlets developed 4 days after transplantation. And those grew into plant that had 7 leaves and fresh weight of 0.2 g after 21 days. Therefore, we found that it is effective to control potato culture medium by adjusting its electrical conductivity to $0.6{\sim}1.0dS{\cdot}m^{-1}$ for the mass production of virus-free potato seedling in the microponic system.

• East Asian mathematical journal
• /
• v.24 no.1
• /
• pp.45-55
• /
• 2008

We consider an M/G/1 queue with $P^M_{\lambda}$-service policy, which is a two-stage service policy. The server starts to serve with rate 1 if a job arrives to the sever in idle state. If the workload of the system upcrosses $\lambda$, then the service rate is changed to M and this rate continues until the system is empty. It costs to change the service rate to M and maintaining the rate. When the expectation of the stationary workload is supposed to be less than a given value, we derive the optimal value of M.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.37 no.1
• /
• pp.96-103
• /
• 2014

A steady-state controllable M/G/1 queueing model operating under the (TN) policy is considered where the (TN) policy is defined as the next busy period will be initiated either after T time units elapsed from the end of the previous busy period if at least one customer arrives at the system during that time period, or the time instant when Nth customer arrives at the system after T time units elapsed without customers' arrivals during that time period. After deriving the necessary system characteristics such as the expected number of customers in the system, the expected length of busy period and so on, the total expected cost function per unit time in the system operation is constructed to determine the optimal operating policy. To do so, the cost elements associated with such system characteristics including the customers' waiting cost in the system and the server's removal and activating cost are defined. Then, the optimal values of the decision variables included in the operating policies are determined by minimizing the total expected cost function per unit time to operate the system under consideration.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.6 no.1
• /
• pp.90-98
• /
• 1998

A Dual Mass Flywheel(D.M.F.) system is an evolution to the reduction of torsional vibration and impact noise occurring in powertrain when a vehicle is either moving or idling. The D.M.F. system has two flywh-eels, which is different from the conventional clutch system. One section belongs to the mass moment of in-ertia of the engine-side. The other section increases the mass moment of inertia of the transmission-side. These two masses are connected via a spring/damping system. This reduces the speed at which the dreaded resonance occurs to below idle speed. Since 1984m D.M.F. system has been developed. However, the processes of development of D.M.F. system don't have any difference from the trial and error method of conventional clutch system. This paper present the method for systematical design of D.M.F. system with dimensionless design varia-bles of D.M.F. system, mass ratio between two flywheels, natural frequency rate of two flywheels, and visc-osity coefficient. And expermental results are used to prove these theoretical results.