• 전력전자학회논문지
• /
• 제26권5호
• /
• pp.349-356
• /
• 2021

Permanent magnet synchronous motors are mainly used in the traction of electric vehicle and home application products including air-conditioners and refrigerators. For sensorless control without rotor position sensors, I-F control is applied for initial starting at low speeds, and mode is changed to sensorless control when the rotor speed is sufficiently accelerated for estimating rotor position. When the mode is changed to the sensorless control from the open-loop starting, the initial integral value of the speed controller should be considered by load condition; otherwise, the transition to sensorless control may fail. The sensorless transfer algorithm of PM synchronous motor based on load condition for smooth transition is proposed. The performance of the proposed sensorless transfer algorithm was verified by experiments.

• 한국전산구조공학회논문집
• /
• 제36권3호
• /
• pp.155-163
• /
• 2023

원전 구조물의 실시간 모니터링 기술이 요구되고 있지만, 현재 운영 중인 지진 감시계통으로는 동특성 추출 등 시스템 식별이 제한된다. 전역적인 거동 데이터 및 동특성 추출을 위해서는 다수의 센서를 최적 배치하여야 한다. 최적 센서배치 연구는 많이 진행되어 왔지만 주로 토목, 기계 구조물이 대상이었으며 원전 구조물 대상으로 수행된 연구는 없었다. 원전 구조물은 미미한 신호대잡음비에도 강건한 신호를 획득하여야 하며, 모드 기여도가 저차 모드에 집중되어 있어 모드별 잡음 영향을 고려해야 하는 등 구조물 특성을 고려해야 한다. 이에 본 연구에서는 잡음에 대한 강건도와 모드별 영향을 평가할 수 있는 최적 센서배치 방법론을 제시하였다. 활용한 지표로서 auto MAC(Modal Assurance Criterion), cross MAC, 노드별 모드형상 분포를 분석하였으며, 잡음에 대한 강건도 평가의 적합성을 수치해석으로 검증하였다.

• 한국음향학회지
• /
• 제23권5호
• /
• pp.376-382
• /
• 2004

구조물의 의해 방사되는 음향파워는 구조물의 진동특성에 의해 결정된다. 방사소음을 저감하는 가장 간단명료한 방법으로는 구조물의 진동을 최소화하는 방법이 있다. 하지만 구조물의 진동모드 각각은 방사효율이 다르기 때문에 이를 고려하여 진동모드를 제어하면 효율적으로 방사소음을 저감할 수 있다. 본 연구에서는 피드포워드 제어를 적용하여 구조물의 고유특성을 변화시켜 진동 모드의 방사효율을 저감하는 방법을 제안한다. 단순지지 빔에 대한수치모사를 통해 진동모드의 체적속도를 최소화하는 제어 변수를 결정하였고, 이러한 제어를 적용하면 저주파 영역에서 방사소음을 크게 줄일 수 있다는 것을 보여 준다.

• 드라이브 ㆍ 컨트롤
• /
• 제19권3호
• /
• pp.32-38
• /
• 2022

The in-wheel drive gearbox for military special vehicles converts the high-speed & low-torque output generated by the electric servomotor, into low-speed & high-torque mechanical power. As the vehicle is remotely maneuvered in mountainous terrain, wet fields, rough terrain, etc., the gearbox must generate a maximum input speed exceeding 5,000 rpm, a maximum torque of 245 Nm, and MTBF of 9,600 km. The purpose of this study was to analyze the failure mode of the gearbox, to ensure the durability of the in-wheel drive gearbox. Also, the field load test data of the vehicle was analyzed, the acceleration durability test standards were established, the acceleration durability test was conducted, and the durability test results were analyzed as well.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2004년도 하계종합학술대회 논문집(2)
• /
• pp.469-472
• /
• 2004

In this paper a current mode sense amplifier suitable for 30nm SONOS flash memories read operation is presented. The proposed sense amplifier employs cross coupled latch type circuit and current mirror to amplify signal from selected memory cell. This sense amplifier provides fast response in low voltage and low current dissipation. Simulation results show the sensing delay time and current dissipation for power supply voltages Vdd to expose limitations of the sense amplifier in various operating conditions.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 하계학술대회 논문집 F
• /
• pp.2016-2019
• /
• 1997

To solve the low efficiency problem of low-voltage power supplies, it has been studied to replace the schottky barrier diode with the MOSFET synchronous rectifier. In this paper, Phase Shift-Controlled Clamp Mode Zero Voltage Switching-Multi Resonant Converter with Synchronous Rectifier (PSC CM ZVS-MRC with SR) is presented to achieve high efficiency in low-voltage power supplies. The characteristics analysis of synchronous rectifier is established by using the MOSFET equivalent circuit and efficiency comparison is established between the Synchronous Rectifier and the schottky barrier diode. To verify the validity of the analysis, 33W(3.3V, 10A) PSC CM ZVS-MRC with self-driven synchronous rectifier at switching frequency of 1MHz is designed and tested. And it is confirmed that the experimental results are well consistent with the theoretical results. The maximum efficiency of the converter is 83.4% at full load, which is 3.3% higher than conventional schottky diode rectification.

• 전자공학회논문지C
• /
• 제34C권6호
• /
• pp.51-57
• /
• 1997

Low-voltage, low-power gm-C filter utilizing newly dveloped operational transconductance amplifier (OTA) is described in this paper. The OTA has only two MOS transistors in saturation region between $V_{DD}$ and GND, and thus low voltage operation is possible. To improve the linearity, the OTA is made differential. Common mode feedback, essential in differential circuit, requires no additional implemented in $0.8\mu\textrm{m}$ CMOS process, and the center frequency can be controlled from 15MHz with 3.0V single power supply.

• 한국전기전자재료학회논문지
• /
• 제24권5호
• /
• pp.416-421
• /
• 2011

Nowadays, the increasing demands upon mobile devices such as wireless sensor networks and the recent advent of low power electrical devices such as MEMS make such renewable power sources attractive. A vibration-driven MEMS lead zirconate titanate $Pb(Zr,Ti)O_3$ (PZT) cantilever device is developed for energy harvesting application. This paper presents a piezoelectric based energy harvester which is suitable for power generating from conventional vibration and has in providing energy for low power electron ic devices. The PZT cantilever is used d33 mode to get the electrical power. The PZT cantilever based energy harvester with the dimension of 7 mm${\times}$3 mm${\times}$0.03 mm is fabricated using micromachining technologies. This PZT cantilever has the mechanical resonance frequency with a 900 Hz. With these conditions, we get experimentally the 37 uW output power from this device with the application of 1g acceleration using the 900 Hz vibration. From this study, we show the feasibility of one of energy harvesting candidates using PZT based structure. This PZT energy harvester could be used for various applications such a batteryless micro sensors and micro power generators.

• Journal of Power Electronics
• /
• 제18권4호
• /
• pp.997-1006
• /
• 2018

This paper proposes a transformerless photovoltaic (PV) power converter system based on the DC/AC boost inverter, which can solve the leakage current and second-order ripple power issues in single-phase grid-connected PV inverters. In the proposed topology, the leakage current can be decreased remarkably since most of the common-mode currents flow through the output capacitor, by-passing parasitic capacitors, and grounding resistors. In addition, the inherent ripple power component in the single-phase grid inverter can be suppressed without adding any extra components. Therefore, bulky electrolytic capacitors can be replaced by small film capacitors. The effectiveness of the proposed topology has been verified by simulation and experimental results for a 1-kW PV PCS.

• 전력전자학회논문지
• /
• 제8권6호
• /
• pp.519-526
• /
• 2003

본 논문은 단상 SRM 구동을 위한 1단 방식의 역률 보상형 컨버터에 관한 연구이다. 기존의 SRM 구동에서의 역률 보상회로는 2단 방식의 구조로 구성이 복잡하고 소자의 수가 증가하여 경제적으로 불리한 단점을 가진다. 따라서, 부가적인 회로의 추가 없이 1단 방식의 단위 역률이 가능한 단상 SRM 구동회로를 제안한다. 제안된 회로에 대한 타당성을 시뮬레이션과 실험으로 검증한다.