• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.41 no.4
• /
• pp.296-305
• /
• 2005

Acoustic target strength (TS) of 12 commercially important fish species caught in the Korean waters had been investigated and their results were presented. Laboratory measurements of target strength on 12 dominant fish species were carried out at a frequencies of 75 kHz by single beam method under the controlled condition of the water tank with the 241 samples of dead and live fishes. The target strength pattern on individual fish of each species was measured as a function of tilt angle, ranging from $-45^{\circ}$ (head down aspect) to $45^{\circ}$ (head up aspect) in $0.2^{\circ}$ intervals, and the averaged target strength was estimated by assuming the tilt angle distribution as N ($-5.0^{\circ}$, $^15.0{\circ}$). The 75 to fish length relationship for each species was independently derived by a least - squares fitting procedure. Also, a linear regression analysis for all species was performed to reduce the data to a set of empirical equations showing the variation of target strength to fish length and fish species. An empirical model for fish target strength(TS, dB) averaged over the dorsal aspect of 158 fishes of 7 species and which spans the fish length(L, m) to wavelength(${\lambda}$, m) ratio between 6.2 and 21.3 was derived: TS: 27.03 Log(L)-7.7Log(${\kanbda}$)-17.21, ($r^2$=0.59).

• ETRI Journal
• /
• v.37 no.1
• /
• pp.66-76
• /
• 2015

In this work, we propose an efficient selective retransmission method for multiple-input and multiple-output (MIMO) wireless systems under orthogonal frequency-division multiplexing (OFDM) signaling. A typical received OFDM frame may have some symbols in error, which results in a retransmission of the entire frame. Such a retransmission is often unnecessary, and to avoid this, we propose a method to selectively retransmit symbols that correspond to poor-quality subcarriers. We use the condition numbers of the subcarrier channel matrices of the MIMO-OFDM system as a quality measure. The proposed scheme is embedded in the modulation layer and is independent of conventional hybrid automatic repeat request (HARQ) methods. The receiver integrates the original OFDM and the punctured retransmitted OFDM signals for more reliable detection. The targeted retransmission results in fewer negative acknowledgements from conventional HARQ algorithms, which results in increasing bandwidth and power efficiency. We investigate the efficacy of the proposed method for optimal and suboptimal receivers. The simulation results demonstrate the efficacy of the proposed method on throughput for MIMO-OFDM systems.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.7 s.110
• /
• pp.615-622
• /
• 2006

DVB-S2 offers various coding rate and modulation schemes. Therefore this paper proposes bit split methods to applying to multilevel modulation. Log-likelihood ratio method splits multilevel symbols to soft decision symbols using the received in-phase and quadrature component based on Gaussian approximation. However it is too complicate to calculate and to implement hardware due to exponential and logarithm calculation. Therefore this paper presents Euclidean, MAX and Sector method to reduce the high complexity of LLR method.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.16 no.3
• /
• pp.365-372
• /
• 2013

The multibeam surveillance radar is a state-of-art of 3D radar technology. It applies the stacked beams realized by a digital beamformer. In this paper, a hybrid compensation technique on elevation angle errors for low elevation angle targets over the sea in multipath radar environments is proposed. The proposed method can be applied to stacked beam radars. Double null algorithm based on maximum likelihood method in 3-D beamspace domain works well unless the phase difference between the two rays(direct and specular path) is close to $0^{\circ}$ and the magnitude of reflection coefficient is close to 0. To overcome these problems, we propose a hybrid compensation technique which uses the selective double null algorithm and the beam-ratio compensation technique for low-elevation errors on a log scale. Results of computer simulation show that the proposed method outperform conventional monopulse method and double null algorithm only under various multipath environments.

• Journal of Environmental Impact Assessment
• /
• v.24 no.5
• /
• pp.407-419
• /
• 2015

The unit load of paddy field was estimated by several methods and compared in this study. Four year field study was conducted at the paddy fields located in Yeongsan river and Sumjin river basins. The unit load was estimated by four methods; (1) averaging field monitored load; (2) NIER (National Institute of Environmental Research) method which use EMC(Event Mean Concentration) and runoff ratio of rainfall groups with rainfall weighting factors; (3)method using EMC determined by best fit probability distribution; (4)method using arithmetic mean EMC and runoff ratio. The result of this study showed that the unit loads of water quality constituents by field monitoring was similar to those of NIER method whereas those by probability distribution(log-normal, gamma) method were less than unit loads of NIER method. The unit loads by arithmetic mean EMC and runoff ratio were larger than those by NIER method. The unit load by NIER method showed higher BOD, COD, SS, lesser T-N, and similar T-P values when compared to unit loads determined by MOE in 1995.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.4
• /
• pp.31-37
• /
• 2008

Conventional cooperative communications can attain gain of spatial diversity and path loss reduction because destination node independently received same signal from source node and relay node located between source node and destination node. However, these techniques bring about decreased spectral efficiency with relay node and increased complexity of receiver by using maximal ratio combining (MRC). This paper has proposed cooperative ARQ protocol that can improve the above problems and can get the better performance. This method can increase the spectral efficiency than conventional cooperative communication because if the received signal from source node is satisfied by the destination preferentially, the destination transmits ACK message to both relay node and source node and then recovers the received signal. In addition, if ARQ message indicates NACK relay node operates selective retransmission and we can increase reliability of system compared with that of general ARQ protocol in which source node retransmits data. In the proposed protocol, the selective retransmission and ARQ message are to be determined by comparing log-likelihood ratio (LLR) computation of received signal from source node with predetermined threshold values. Therefore, this protocol don't waste redundant bandwidth with CRC code and can reduce complexity of receiver without MRC. We verified spectral efficiency and BER performance for the proposed protocol through Monte-Carlo simulation over Rayleigh fading plus AWGN.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.17 no.4
• /
• pp.26-35
• /
• 2003

For the recognizing system to be classified the same or different images in the nature the rotation, scale and transition invariant features is to be necessary. There are many investigations to get the feature for the recognition system and the log-polar transform which is to be get the invariant feature for the scale and rotation is used. In this paper, we suggested the character recognition methods which are used the centroid method and the log-polar transform with the interpolation to get invariant features for the character recognition system and obtained the results of the above 50% differential ratio for the character features. And we obtained the about 90% recognition ratio from the suggested character recognition system using the BPEJTC which is used the invariant feature from the Mellin transform method for the reference image. and can be recognized the scaled and rotated input character. Therefore, we suggested the image character recognition system using the Mellin transform method and the BPEJTC is possible to recognize with the invariant feature for rotation scale and transition.

• Journal of Korean Society of Forest Science
• /
• v.85 no.3
• /
• pp.453-461
• /
• 1996

Three Phyllostachys stands of P. pubescens, P. bambusoides and P. nigra var, henonis in Sunchon were studied to investigate biomass, net production and nutrient distribution. Five $10m{\times}10m$ quadrats were set up and 20 sample culms of 2 years and over were harvested for dimension analysis in each stand. One year old culms and subterranean parts were estimated by the harvested quadrat method. The largest mean DBH, height and basal area were shown in P. pubescens stand, and followed by P. nigra var. henonis stand and P. bambusoides stand. There was little difference in accuracy among three allometric biomass regression models of logWt=A+B1ogD, $logWt=A+BlogD^2H$ and logWt=A+BlogD+ClogH, where Wt, D and H were dry weight, DBH and height, respectively. Analysis of covariance showed that there were significant differences in intercept among the linear allometric biomass regressons of three Phyllostachys species. Biomass included subterranean parts was the largest in P. pubescens stand(103.621t/ha), and followed by P. nigra var. henonis stand(86.447t/ha) and P. bambusoides stand(36.767t/ha). Leaf biomass was 6.3% to 7.8% of total biomass in each stands. The ratio of aboveground biomass and subterranean biomass in each stand was 1.87 to 2.26. Net production included subterranean parts was the greatest in P. pubescens stand(6.115t/ha/yr), and followed by P. nigra var. henonis stand(5.609t/ha/yr) and P, bambusoides stand(3.252t/ha/yr). The highest net assimilation ratio was estimated in P. pubescens stand(2.979), and followed by P. nigra var. henonis stand(2.752) and P. bambusoides stand(2.187). Biomass accumulation ratio of each stand was 2.679 to 5.358. Concentrations of N, P and Mg were the highest in leaves, and followed by subterranean parts, and culms+branches in all three species. Concentration of Ca was the highest in leaves, and followed by culms+branches, and subterranean parts in all three species. The difference in biomass among three species stands was caused by their culm size, leaf biomass, net assimilation ratio, and efficiency of leaves to produce culms.

• Speech Sciences
• /
• v.10 no.2
• /
• pp.35-43
• /
• 2003

General speaker verification systems improve their recognition performances by normalizing log likelihood ratio, using a speaker model and its background speaker model that are required to be verified. So these systems rely heavily on the availability of much speaker independent databases for background speaker model design. This constraint, however, may be a burden in practical and portable devices such as palm-top computers or wireless handsets which place a premium on computations and memory. In this paper, new approach for the GMM-based background model design used in portable speaker verification system is presented when the enrollment data is available. This approach is to modify three parameters of GMM speaker model such as mixture weights, means and covariances along with reduced mixture order. According to the experiment on a 20 speaker population from YOHO database, we found that this method had a promise of effective use in a portable speaker verification system.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2009.01a
• /
• pp.450-455
• /
• 2009

Amplitude-only logarithmic Radon transform (ALR transform) for pattern matching is proposed. This method provides robustness for object translation, scaling, and rotation. An ALR image is invariant even if objects are translated in a picture. For the object scaling and rotation, the ALR image is merely translated. The objects are identified using a phase-only matched filter to the ALR image. The ratio of size, the difference of rotation angle, and the position between the two objects are detected. Our pattern matching procedure is described, herein, and its simulation is executed. We compare matching scores with the Fourier-Mellin transform, and the general phase-only matched filter.