• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.24 no.3
• /
• pp.35-40
• /
• 2024

In this paper, the design, implementation, and analysis of a device capable of transmitting and receiving millimeter-wave signals and performing channel sounding measurements in atmospheric conditions at distances of up to approximately 10km outdoors are presented. The device is expected to be instrumental in studying the propagation characteristics of millimeter-wave frequencies. Utilizing data such as received power levels and power delay profiles (PDPs), comparisons with predicted values using path loss, K-factor, and other propagation models are facilitated. The mobile transceiver unit, integrated onto a vehicle platform, allows for flexible adjustment of transmitter and receiver positions, while synchronization issues with distance are mitigated using a rubidium atomic clock. Furthermore, automatic boresight alignment using scanning techniques is employed to locate the main sector of the antenna.

• ETRI Journal
• /
• v.46 no.2
• /
• pp.323-332
• /
• 2024

Receiver and transmitter monolithic microwave integrated circuit (MMIC) multifunction chips (MFCs) for active phased-array antennas for Ka-band satellite communication (SATCOM) terminals have been designed and fabricated using a 0.15-㎛ GaAs pseudomorphic high-electron mobility transistor (pHEMT) process. The MFCs consist of four-channel radio frequency (RF) paths and a 4:1 combiner. Each channel provides several functions such as signal amplification, 6-bit phase shifting, and 5-bit attenuation with a 44-bit serial-to-parallel converter (SPC). RF pads are implemented on the bottom side of the chip to remove the parasitic inductance induced by wire bonding. The area of the fabricated chips is 5.2 mm × 4.2 mm. The receiver chip exhibits a gain of 18 dB and a noise figure of 2.0 dB over a frequency range from 17 GHz to 21 GHz with a low direct current (DC) power of 0.36 W. The transmitter chip provides a gain of 20 dB and a 1-dB gain compression point (P1dB) of 18.4 dBm over a frequency range from 28 GHz to 31 GHz with a low DC power of 0.85 W. The P1dB can be increased to 20.6 dBm at a higher bias of +4.5 V.

• Korean Journal of Ecology and Environment
• /
• v.53 no.3
• /
• pp.286-294
• /
• 2020

The Chironomus(Diptera: Chironomidae) is a freshwater benthic invertebrate that is an important indicator organism used for environmental pollution and water quality monitoring. In this study, we performed morphological classification and genetic species identification using the cytochrome c oxidase subunit I (COI) gene on mitochondrial DNA for an accurate species classification of Chironomus larvae found in tap water purification plants in Incheon, Korea. Twenty larvae in six water purification plants consist of four species, including twelve Chironomus kiiensis, six Chironomus flaviplumus, one Chironomus dorsalis, and one Polypedilum yongsanensis (not included Genus Chironomus). Morphological characteristics of each larvae were identified based on the head capsule, the mentum, the mandible, the antenna, and the claw. Based on the COI sequences of 21 individuals of 17 Chironomus species registered in NCBI Genbank, phylogenetic analysis indicated that the 20 individuals investigated in this study consist of the same clade with corresponding species of the high homology (99~100%) including C. kiiensis, C. flaviplumus, C. dorsalis, and P. yongsanensis. These results will be used as main classification indicator for monitoring freshwater ecosystems by providing integrated morphological and genetic information for the species identification of Korean Chironomus.

• Journal of Korean Society for Geospatial Information Science
• /
• v.21 no.4
• /
• pp.95-100
• /
• 2013

Several observation equipments are being used for determination of the water vapor content and precipitable water vapor (PWV) because the water vapor is highly variable temporally and spatially. In this study, we used GNSS systems such as GPS and GLONASS in standalone and combined modes to compute PWV and validated their accuracy with respect to the results of other water-vapor monitoring systems. The other systems used were radiosonde and microwave radiometer, and the comparisons were convenient because all three systems were collocated at the test site. The differences of PWW were in the range of 0.6-3.4 mm in the mean sense, and their standard deviations were 1.0-3.8 mm. The relatively large difference of GNSS compared with the other two systems were believed to be caused by the fact that the GNSS antenna used in this study was the kind for which the international standard of phase center variations (PCV) calibration is not available. We expect better accuracy of PWV determination and improved availability of it through integrated data processing of GPS/GLONASS when an appropriate antenna with PCV correction model is used.

• Journal of Satellite, Information and Communications
• /
• v.3 no.1
• /
• pp.41-47
• /
• 2008

Line-of-sight communications cannot easily support korean armed forces because of mountainous terrain. ADD(Agency for Defense Development) introduced ANASIS(Army Navy Air-force Satellite Information System) to meet the Korean warfighter's operational needs. Currently, army's military satcom terminal is designed for either fixed site or on-the-pause operation. The US army is under development of multi-band integrated on-the-move satellite terminals to let the army's communication capability to keep pace with globally deployable Joint Task Force for network-centric application. In this paper we analyzed X-band and Ka-band link and subsystem requirement. Our focus here is to describe key technical issues. Especially, On the basis of 3dB beam width of 0.9m antenna, Tracking accuracy and disturbances compensation signal processing on-the-move of Antenna Tracking system is analyzed. Also, protocol is analyzed that minimize blockage on the move due to an obstacle. when the received signal blocked, it stop to transmit burst signal and retransmit when blockage removed through received synchronization signal monitoring. Analyzed specification will be used to make prototype terminal to analyze risk for mass production

• Korean Journal of Ecology and Environment
• /
• v.54 no.3
• /
• pp.240-246
• /
• 2021

The Chironomidae is a benthic macroinvertebrate commonly found in freshwater ecosystems, along with Ephemeroptera and Trichoptera, which can be used for environmental health assessments. There are approximately 15,000 species of Chironomidae worldwide, but there are limited studies on species identification of domestic Chironomidae larvae. In the present study, we carried out species classification of the Chironomidae larvae that found in Jeju's tap water purification plants using morphological characteristics and genetic identification based on cytochrome c oxidase subunit I (COI) gene of the mitochondrial DNA. Body shape, mentum, antenna, mandible in the head capsule, and claws were observed in the larvae for morphological classification. Analysis of 17 larvae collected from faucets and fire hydrants of domestic tap water purification plants revealed the presence of two species, including 14 Orthocladius tamarutilus and 3 Paratrichocladius tammaater. These results will aid the use of the criteria information about species classification of the Chironomidae for water quality management in water purification plants and diversity monitoring of freshwater environments.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.3
• /
• pp.299-309
• /
• 2013

A comprehensive SAR(Synthetic Aperture Radar) simulation is considered to be a complicated task since a full knowledge of the signal propagation characteristics, antenna pattern, system internal errors and interference noises should be taken into account. In high resolution target application modes, the time varying nature of target RCS(Radar Cross Section) strongly affects the generated SAR images. In this paper, in-depth SAR simulations are performed and analyzed incorporating the STK tools and MATLAB software. STK provides realistic orbit parameters while its radar module helps to extract accurate radiometric parameters of ground targets. SAR raw data corresponding to a given target is generated and processed using MATLAB simulator. The performance is measured by PSLR(Peak Sidelobe Ratio) and ISLR(Integrated Sidelobe Ratio) for a point target, which can be used as reference parameters for accurate radiometric calibration. Finally, high resolution target simulations are performed by adopting time varying target RCS characteristics.

• Aerospace Engineering and Technology
• /
• v.11 no.2
• /
• pp.1-11
• /
• 2012

This paper describes the transmit/receive(T/R) module for the space based X-band active phased array radar. T/R module is the integrated module which is assembled by the transmitting and receiving RF semiconductor devices to enable the electronically beam steering of the phased array antenna and the key component of the SAR payload. T/R module can selectively receive the polarization signals by the switch according to the established technology but now the technological trend of the T/R module is to receive the horizontal and vertical polarization signal simultaneously. Therefore the research and development of the dual polarization receiving channel T/R module is actively in progress. In this study, as the prior research for the next generation SAR payload, the technological trend of the active phased array radar T/R module and the result of the preliminary design of the dual receiving channel T/R module were described.

• Journal of Broadcast Engineering
• /
• v.2 no.1
• /
• pp.24-35
• /
• 1997

Basic and transmission video quality testing was performed in real-time mode using hardware video codec based on MPEG-2 MP@ML standard including subsequent transmitting and receiving satellite simulator unit. The double-stimulus Impairment scale method and the double-stimulus continous quality scale method based on CCIR 500-5 were used as an evaluation method. The whole digital broadcasting satellite system consisting of MPEG-2 codec, system mux/demux, channel codec, channel, modem, antenna, etc. was put into the overall video quality testbed and the basic and transmission error quality assessment was performed at various bitrates and BER for an integrated system performance evaluation. In transmission error video quality testing, transmission error video quality maintained on average above 3.9 point on the 5-point scale. The low-bit rate quality such as film mode(@2Mbps) highly depended on the statitical characteristics of video source and maintained on average around 2.7 point.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.11 no.4
• /
• pp.229-237
• /
• 2011

In this paper, a 60 GHz LTCC SiP with low-power CMOS OOK modulator and demodulator is presented. The 60 GHz modulator is designed in a 90-nm CMOS process. The modulator uses a current reuse technique and only consumes 14.4-mW of DC power in the on-state. The measured data rate is up to 2 Gb/s. The 60 GHz OOK demodulator is designed in a 130nm CMOS process. The demodulator consists of a gain boosting detector and a baseband amplifier, and it recovers up to 5 Gb/s while consuming low DC power of 14.7 mW. The fabricated 60 GHz modulator and demodulator are fully integrated in an LTCC SiP with 1 by 2 patch antenna. With the LTCC SiP, 648 Mb/s wireless video transmission was successfully demonstrated at wireless distance of 20-cm.