• 대한의용생체공학회:의공학회지
• /
• 제32권3호
• /
• pp.185-190
• /
• 2011

The purpose of this study is to investigate the influence of organism vigor information solution(OVIS) on the animal cell growth and to set up a condition for cell culture. We investigated the reactions on the MG-63 and MCF-7 cell line in mixture culture media with various amount of REVIEW solution, which is an example among various OVIS. DMEM-HG was used as basic media. The concentration range of the mixture was limited from 0% to 15%. MTT assay is used for cell viability test. The cell was incubated for 14days and the MTT assay was performed on day 1, 3, 7, 10 and 14 throughout the experiment. We used the ELISA reader to measure the Optical Density(O.D) at 595 nm wavelength filter. MCF-7 was linearly proliferated according to culture time and concentrations of OVIS. On the other hand, MG-63 cells were measured the highest O.D value at 12%. The growth rates of both cells cultured in mixed culture media with OVIS are much higher than those in only basic media, DMEMHG, after 14days. It was confirmed that cell cultured at OVIS grows rapidly at certain period although cells showed a negative effect in initial stage.

• 대한금속재료학회지
• /
• 제56권12호
• /
• pp.893-899
• /
• 2018

In the present study, we investigated the sulfur poisoning of the Ni anode in solid oxide fuel cells (SOFCs) as a function of operating conditions. Anode supported cells were fabricated, and sulfur poising tests were conducted as a function of current density, $H_2S$ concentration and humidity in the anode gas. The voltage drop was significant under the higher current density (${\sim}714mA/cm^2$) condition, while it was much reduced under the lower current density (${\sim}389mA/cm^2$) condition, at 100 ppm of $H_2S$. A secondary voltage drop, which occurred only at the high current density, was attributed to Ni oxidation in the anode. Thus, operation at high current density with high $H_2S$ concentration may lead to permanent deterioration in the anode. The effect of water content (10%) on the sulfur poisoning was also investigated through a constant current test (${\sim}500mA/cm^2$) at 10 ppm of $H_2S$. The cell operating with 10% wet anode gas showed a much smaller initial voltage drop, in comparison with a dry anode gas. The present study indicates that operating conditions, such as gas humidity and current density, should be carefully taken into account, especially when fuel cells are operated with $H_2S$ containing fuel.

• 한국생물공학회:학술대회논문집
• /
• 한국생물공학회 2003년도 생물공학의 동향(XIII)
• /
• pp.374-377
• /
• 2003

본 연구에서 hybridoma 세포는 $K^+$농도를 80 mM까지 높인 배지에 적응시켰다. $K^+$ 80 mM에 적응된 세포는 높은 삼투압과 낮은 pH에서 내성을 가졌다. 적응되지 않은 세포와 $K^+$ 80 mM에 적응된 세포는 Erlenmeyer flask에서 강화 배지로 회분 식으로 배양되었다. 배지의 삼투압이 450 $mOsm/kgH_2O,$일 때 적응되지 않은 세포의 최대 세포 농도가 $4.8{\times}10^5$ cells/ml로 낮은 성장을 보였고, 적응된 세포는 $1.1{\times}10^6$ cells/ml까지 성장하였다. 또한 배지의 초기 pH가 7.0일 때 적응되지 않은 세포는 $5.3{\times}10^5$ cells/ml인 반면, $K^+$ 80 mM에 적응된 세포 농도는 $7.8{\times}10^5$ cells/ml였다. 따라서, 동물세포의 높은 $K^+$농도에의 적응은 세포배양의 한계조건에서 적응되지 않은 세포가 받는 성장 저해를 줄여줄 것이다.

• 한국전기전자재료학회논문지
• /
• 제11권11호
• /
• pp.1049-1054
• /
• 1998

The LiCo$O_2$ powder was synthesized by a solution phase reaction. This shows a high (003) peak intensity and low (104) or (101) peak intensities in X-ray diffraction spectra. The LiCo$O_2$/Li cell shows an initial discharge capacity of 102.9mAh/g and an average discharge potential or 3.877V at a current density of 50mA/g between 3.0~4.2V. The peaks of dQ/dV plot are associated with Li ion intercalation/deintercalation reaction. To evaluate the cycleability of an actual battery system, cylindrical lithium ion cell was manufactured using graphitized MPCF anode and LiCoO$_2$ cathode. After 100th cycle, this cel maintains 80% capacity of 10th cycle value. The LiCoO$_2$/MPCF cell has a high discharge voltage of 3.6~3.7V and a good cycle life performance on cycling between 4.2~2.7V.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2005년도 춘계 학술발표회 논문집
• /
• pp.982-989
• /
• 2005

In this study, a series of laboratory tests based on 'Unit-cell concept' are performed to investigate improvement characteristics of clay ground in sand compaction pile method. Settlement reduction characteristics of composite ground and improvement characteristics of clay part could be qualified. In these procedure, the new strain-compression index($C_{\epsilon}$) of composite ground are adopted to show compressibility of composite ground according to the area replacement ratio, which is similar to the compression index($C_c$) in pure clay ground. Also, using normalization of reduction of water content in composite ground to the initial water content, improvement characteristics of clay part are investigated.

• Current Photovoltaic Research
• /
• 제8권1호
• /
• pp.6-11
• /
• 2020

The power conversion efficiency (PCE) of a two-terminal tandem solar cell depends upon the tunnel-recombination junction (TRJ) between the top and bottom sub-cells. An optimized TRJ in a tandem cell helps improve its open-circuit voltage (V_oc), short-circuit current density (J_sc), fill factor (FF), and efficiency (PCE). One of the parameters that affect the TRJ is the buffer layer thickness. Therefore, we investigated various TRJs by varying the thickness of the buffer or intermediate layer (TRJ-buffer) in between the highly doped p-type and n-type layers of the TRJ. The TRJ-buffer layer was p-type nc-Si:H, with a doping of 0.06%, an activation energy (E_a) of 43 meV, an optical gap (E_g) of 2.04 eV, and its thickness was varied from 0 nm to 125 nm. The tandem solar cells we investigated were a combination of a heterojunction with intrinsic thin layer (HIT) bottom sub-cell and an a-Si:H (amorphous silicon) top sub-cell. The initial cell efficiency without the TRJ buffer was 7.65% while with an optimized buffer layer, its efficiency improved to 11.74%, i.e., an improvement in efficiency by a factor of 1.53.

• E2M - 전기 전자와 첨단 소재
• /
• 제7권4호
• /
• pp.317-324
• /
• 1994

In this study, new preparation method of LiCoO$_{2}$ was applied to develop cathode active material for Li rechargeable cell, and followed by X-ray diffraction analysis, electrochemical properties and initial charge/discharge characteristics as function of current density. HC8A72- and CC9A24-LiCoO$_{2}$ were prepared by heating treatment of the mixture of LiOH H$_{2}$O/CoCO$_{3}$(1:1 mole ratio) and the mixture of Li$_{2}$CO$_{3}$/CoCO$_{3}$(1:2 mole ratio) at 850 and 900.deg. C, respectively. Two prepared LiCoO$_{2}$s were identified as same structure by X-ray diffraction analysis. a and c lattice constant were 2.816.angs. and 14.046.angs., respectively. The electrochemical potential of CFM-LiCoO$_{2}$(Cyprus Foote Mineral Co.'s product), HC8A72-LiCoO$_{2}$ and CC9A24 LiCoO$_{2}$ electrode were approximately between 3.32V and 3.42V vs. Li/Li reference electrode. Stable cycling behavior was obtained during the cyclic voltammetry of LiCoO$_{2}$ electrode. According as scan rate increases, cathodic capacity decreases, but redox coulombic efficiency was about 100% at potential range between 3.6V and 4.2V vs. Li/Li reference electrode. Cathodic capacity of HC8A72-LiCoO$_{2}$ was 32% higher than that of CFM-LiCoO$_{2}$ and that of CC9A24-LiCoO$_{2}$ was 47% lower than that of CFM-LiCoO$_{2}$ at 130th cycle in the condition of lmV/sec scan rate. Constant cur-rent charge/discharge characteristics of LiCoO$_{2}$/Li cell showed increasing Ah efficiency with initial charge/discharge cycle. Specific discharge capacities of CFM and HC8A72-LiCoO$_{2}$ cathode active materials were about 93mAh/g correspondent to 34% of theretical value, 110mAh/g correspondent to 40% of theretical value, respectively. In the view of reversibility, HC8A72-LiCoO$_{2}$ was also more excellent than CFM- and CC9A24-LiCoO$_{2}$.

• Korean Chemical Engineering Research
• /
• 제61권1호
• /
• pp.26-31
• /
• 2023

고분자 전해질 연료전지(Polymer electrolyte membrane fuel cell, PEMFC) 고분자막의 내구성 향상을 위해서 빠른 시간에 내구성을 평가할 수 있는 가속 내구 평가법들이 연구 개발되었다. 그러나 트럭, 버스 등 대형 상용차용 연료전지 수명은 승용차보다 3배 이상 요구되어 화학적 가속 내구 평가(Accelerated stress test, AST) 시간도 길어져서 1,500 시간 이상이 되었다. 그래서 본 연구에서는 단 시간내에 고분자막의 화학적 내구성을 평가하기 위한 방법으로 막 초기 특성으로 내구성을 예측할 수 있을지 검토하였다. 초기 특성으로 수소투과전류밀도(Hydrogen crossover current density, HCCD)와 단락 저항(Short resistance, SR)을 그리고 3시간의 셀 밖 실험으로 가능한 Fenton 실험을 통해 AST 시간을 예측하였다. HCCD와 불소 이온 유출 농도가 증가하면 AST 시간이 선형적으로 짧아지는 경향을 보였으나 편차가 있었다(R² ≒0.65). SR이 감소하면 AST 시간이 선형적으로 증가하는 상관관계를 보였으며 정확도가 높아(R² =0.93) 고분 자막 초기 SR로 AST 시간을 예측할 수 있었다.

• Biotechnology and Bioprocess Engineering:BBE
• /
• 제6권3호
• /
• pp.194-199
• /
• 2001

Chlorella kessleri cultivated in artificial wastewater using diurnal illumination of 12h light/12h dark (L/D) cycles. The inoculum density was 10(sup)5 cells/mL and the irradiance in light cycle was 45$\mu$mol㎡s(sup)-1 at the culture surface. As a control culture, another set of flasks was cultivated under continuous illumination. Regardless of the illumination scheme, the total organic carbon (TOC) and chemical oxygen demand (COD) was reduced below 20% of the initial concentration within a day. However, cell concentration under the L/D lighting scheme was lower tan that under the continuous illuminating scheme. Thus the specific removal rate of organic carbon under L/D cycles was higher than that under continuous illumination. This result suggested that C. kessleri grew chemoorganotrophically in the dark periods. After 3 days, nitrate was reduced to 136.5 and 154.1mg NO$_3$-N/L from 168.1mg NO$_3$-N/L under continuous illumination and under diurnal cycles, respectively. These results indicate nitrate removal efficiency under continuous light was better than that under diurnal cycles. High-density algal cultures using optimized photobioreactors with diurnal cycles will save energy and improve organic carbon sources removal.

• Korean Journal of Chemical Engineering
• /
• 제35권11호
• /
• pp.2290-2295
• /
• 2018

An acceleration stress test (AST) was performed to evaluate the durability of a polymer membrane in a polymer electrolyte membrane fuel cell (PEMFC) for 500 hours. Previous studies have shown that hydrogen crossover measured by linear sweep voltammetry (LSV) increases when the polymer membrane deteriorates in the AST process. On the other hand, hydrogen crossover of the membrane often decreases in the early stages of the AST test. To investigate the cause of this phenomenon, we analyzed the MEA operated for 50 hours using the AST method (OCV, RH 30% and $90^{\circ}C$). Cyclic voltammetry and transmission electron showed that the electrochemical surface area (ECSA) decreased due to the growth of electrode catalyst particles and that the hydrogen crossover current density measured by LSV could be reduced. Fourier transform infrared spectroscopy and thermogravimetric/differential thermal analysis showed that -S-O-S- crosslinking occurred in the polymer after the 50 hour AST. Gas chromatography showed that the hydrogen permeability was decreased by -S-O-S- crosslinking. The reduction of the hydrogen crossover current density measured by LSV in the early stages of AST could be caused by both reduction of the electrochemical surface area of the electrode catalyst and -S-O-S- crosslinking.