• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.18 no.9
• /
• pp.738-744
• /
• 2006

In order to utilize the condensation heat of refrigerants in condenser on the absorption chiller system, the solution cooled condenser (SCC) was proposed using the weak solution of absorber as a cooling medium. The increase of COP with the increase of UA of the solution cooled condenser was approximately 0.009 in maximum with single effect one, and is about maximum 0.008 in occasion of double effect one with series flow compared to that without. In the case of heat exchanger, effectiveness is about 0.85, it's increments are 0.008 and 0.0072, respectively. And solution cooled condenser is more effective device in the single effect absorption system than double effect system for the principle of operation. On the other hand, as the solution split ratio increases when the value of UA is fixed, COP is increased and as the solution split ratio increases when the value of UA is fixed, COP is increased. If the flow rate of cooling water or the value of UA is reduced in order to increases the heat recovery of solution cooled condenser, heat recovery of solution cooled condenser is increased a little but COP is decreased as the system pressure is increased.

• Journal of agriculture & life science
• /
• v.46 no.2
• /
• pp.43-48
• /
• 2012

This study was investigated on the properties of board made from Miscanthus sinensis var. purpurascens particles differed in density of board and mixed ratio of powder type- and liquid type-phenolic resin. As the board density increase, thickness swelling and bending strength increased while water absorption decreased. With increasing the resin content, water absorption and thickness swelling decreased while MOR and internal bond strength increased. The board made of liquid type phenol-formaldehyde resin was low in water absorption and thickness swelling, and there were similar bending strengths between power type- and liquid type-phenol resin in resin cont of 11% and 13% at the board density $0.4g/cm^3$ and internal bond strength was higher with liquid type-phenolic resin in its bending strength.

• Advances in concrete construction
• /
• v.15 no.6
• /
• pp.419-430
• /
• 2023

In this study, the effect of two types of aggregates (fly ash aggregate and shale aggregate) on the density, strength, and durability of preplaced lightweight aggregate concrete (PLWAC) was studied. The results showed that the 7 - 28 days strength of concrete prepared with fly ash aggregates (high water absorption rate) significantly increased, which could attribute to the long-term water release of fly ash aggregates by the refined pore structure. In contrast, the strength increase of concrete prepared with shale aggregates (low water absorption rate) is not apparent. Although PLWAC prepared with fly ash aggregates has a lower density and higher strength (56.8 MPa @ 1600 kg/m³), the chloride diffusion coefficient is relatively high, which could attribute to the diffusion paths established by connected porous aggregates and the negative over-curing effect. Compared to the control group, the partial replacement of fly ash aggregates (30%) with asphalt emulsion (20% solid content) coated aggregates can reduce the chloride diffusion coefficient of concrete by 53.6% while increasing the peak load obtained in a three-point bending test by 107.3%, fracture energy by 30.3% and characteristic length by 103.5%. The improvement in concrete performance could be attributed to the reduction in the water absorption rate of aggregates and increased energy absorption by polymer during crack propagation.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.29 no.7
• /
• pp.360-365
• /
• 2017

Recently, development efforts of triple-effect absorption chiller have been increased in order to improve the efficiency of double-effect absorption chiller. However, triple-effect absorption chiller has some disadvantages, including high corrosion characteristic of LiBr solution at high temperature of $200^{\circ}C$. Moreover, it is necessary to develop new components for operation under high pressure of 2 bars even though COP is increased to 1.6 or 1.7. The objective of this study was to introduce a new system by combining double effect absorption chiller with single effect absorption chiller with multi-generators using bypass flow of LiBr dilute solution to $3^{rd}$ generator to overcome the disadvantages of triple-effect chiller and improve energy efficiency. Results indicate that the new absorption cycle had a much higher efficiency than double-effect chiller system, showing significant improvement when bypass solution flow rate of 25% was applied to the $3^{rd}$ generator using the main dilute solution of the absorber. The COP of the new chiller system was found to be 1.438, which was 21.7% higher than that (1.18) of the present double-effect system. The COP was decreased when solution by-pass rate to the $3^{rd}$ generator was increased. In addition, lower cooling water temperature caused higher COP. Therefore, the multi-generator system with by-pass solution might be an excellent chiller alternative to triple-effect absorption chiller with higher efficiency.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.21 no.8
• /
• pp.433-438
• /
• 2009

Experimental results for performance characteristics of small $NH_3$ absorption chiller/ heater are presented. The apparatus consists of 7RT water-cooled absorption system, solution pump, boiler, cooling tower and peripheral devices. The effect of experimental parameters, such as refrigerant mass flow rate, solution mass flow rate and cooling water temperature have been investigated in view of the system performance. The capacity of each heat exchanger increased as refrigerant mass flow rate increased in cooling mode. Also, a cooling capacity increased as a strong solution mass flow rate increased. The cooling and heating COP show 0.5, 1.5 regardless of refrigerant mass flow rate, respectively. The results focus on the evaluation for performance characteristics of system with respect to variation of refrigerant mass flow rate under standard design conditions.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.8
• /
• pp.2732-2736
• /
• 2011

In pH 4.2 HAc-NaAc buffer solution, horseradish peroxidase (HRP) catalyzed $H_2O_2$ oxidation of nanosilver to form $Ag^+$. After centrifugation, $Ag^+$ in the supernatant can be measured by graphite furnace atomic absorption spectrophotometry (GFAAS) at the silver absorption wavelength of 328.1 nm. When HRP concentration increased, the $Ag^+$ concentration in the supernatant increased, and the absorption value enhanced. The HRP concentration in the range of 0.84-50 $ng{\cdot}mL^{-1}$ was linear to the enhanced absorption value (${\Delta}A$), with a regression equation of ${\Delta}A$=0.012C+0.11, correlation coefficient of 0.9988, and detection limit of 0.41 $ng{\cdot}mL^{-1}$ HRP. The proposed GFAAS method was used to detect HRP in waste water samples, with satisfactory results.

• Membrane Journal
• /
• v.19 no.4
• /
• pp.341-347
• /
• 2009

Nanohybrid based on environmentally friendly and biodegradable polymer, poly propylene carbonate (PPC) and cloisite 20B (PPC/C-20B) have been synthesized by solution blending method and their morphology, thermal and water absorption properties have been evaluated. The structure of PPC/C-20B nanohybrid was confirmed by X-ray diffraction (XRD). The thermal property of PPC and PPC/C-20B nanohybrid were investigated by thermal gravimetric analysis (TGA) and differential scanning calorimetric (DSC). The experimental results demonstrated that nanohybrid showed the highest thermal stability in TGA and DSC. TGA tests revealed that the thermal decomposition temperature ($T_{d50%}$) of the nanohybrid increased significantly, being $23^{\circ}C$ higher than that of pure PPC while DSC measurements indicated that the introduction of 5 mass% of clay increased the glass transition temperature from 21 to $30^{\circ}C$. Further the water absorption capacity of the PPC was significantly decreased by the incorporation of clay. Water absorption cause degradation of the coating by the moistures and affect the physical and mechanical performance. This result indicates that organic modifiers have effect on thermal and water absorption capacity of PPC and are of importance for the practical process and application of PPC.

• Preventive Nutrition and Food Science
• /
• v.12 no.4
• /
• pp.217-221
• /
• 2007

Within the elderly population, the use of calcium supplements and the intake of calcium from food are on the rise in order to maintain health. Calcium is absorbed as an ion in vivo, leading to speculation that absorption efficiency is affected by the solubility of the calcium consumed. In our study, the bioavailability of two types of calcium supplements with different solubilities was evaluated. Experimental animals were fed water-soluble or insoluble calcium supplements for 6 weeks. We found that blood alkali phosphatase activity, osteocalcin content, and urine crosslinks values were not different between the groups. Similarly, the degree of apparent calcium absorption between the two calcium supplements was not significantly different. The bone mineral density and bone mineral content of the femur and the tibia increased in the group that consumed insoluble calcium compared with those of the water-soluble calcium supplemented group. However, when considering body weight, the bone mineral density value for all areas, including the spine, was significantly higher in the group that consumed the water-soluble calcium supplement.

• Microbiology and Biotechnology Letters
• /
• v.50 no.4
• /
• pp.477-487
• /
• 2022

Probiotics provide a symbiotic relationship and beneficial effects by balancing the human intestinal microbiota. The relationships between microbiota changes and various diseases may predict health abnormalities and diseases. Treatment with vitamins and probiotics is one therapeutic approach. To evaluate the effect of probiotics on vitamin absorption, we chose Lactobacillus rhamnosus CBT-LR5 treatment, which has resistance to vitamin C-inducible toxicity, with vitamins in high-fat diet (HFD)-induced obesity models. CBT-LR5 affected the absorption of micronutrients, such as ionic minerals and water-soluble vitamins. An increase in vitamin C absorption by CBT-LR5 enhanced the antioxidant response in HFD-induced obesity models. Increased vitamin B absorption by CBT-LR5 regulated lipid metabolism in HFD-induced obesity models. These favorable effects of CBT-LR5 on the absorption of vitamins should be investigated as candidate therapeutic target treatments for metabolic diseases.

• Korean Journal of Plant Resources
• /
• v.11 no.3
• /
• pp.272-278
• /
• 1998

This study was carried out to investigate the functional properties such as nitrogen solubility, emulsifying property , foaming capapcity , water and oil absorption of Camellia (Camellia japonica .) seed protein isolate in condition of distilled water and 0.5M NaCl solution at pH 2.0∼10.0. Nitrogen solubility of Camellia protein isolate in distilled water showed the minimum value at pH 4.0 and increased at pH lower or higher than the isoelectric point(pH 4.0). It was 90.0 %at pH 10.0 Nitrogen solubility of 0.5M NaCl solution showed a similar pattern with that of distrille dwater but was higher than that of distilled water except pH 2.0 and pH 10.0. Emulsifying activity of Camellia seed protein islate showed the minimum value at pH 4.0, but was higher at ether value of pH. Emulsifying stability of protein isolate was stable by heat treatment for 30min, at 80℃ and increased in 0.5M NaCl solution more than that of distille dwater. Foaming capacity of Camellia seed protein isolate in distill3ed water showed the minimum value near the isoelectric point, While it changed little at other values of pH. Foaming stability slowly decreased as, but didn't make a significant difference as time was delayed . Oil absorption was 1.4ml per a sample of 1g and water absorption was 0.9ml per a sample of 1g. The former was higher than the latter . The content of total amino acid of Camellia protein isolate was 43.67% and the major total amino acid of Camellia protein isolate was 43.67% and the major total amino acid was in the order of glutamic acid , arginine, aspartic acid, and leucine.