• 한국정보통신학회논문지
• /
• 제16권12호
• /
• pp.2682-2688
• /
• 2012

본 논문은 스파크 점화방식의 엔진에서 차량의 주행상태에 따른 점화코일의 전류량을 측정하여 추가적인 전류를 공급하는 충전 전류제어장치를 설계 및 구현하였다. 1차 점화코일의 전류를 실시간 측정하여 차량 상태에 따른 안정적 전원 공급 및 과전류를 방지함으로써 차량 엔진의 출력증대 및 효율적인 연소가 가능하도록 점화에너지를 증가시켜 엔진 성능을 향상코자 하였다. 제안하는 장치의 유효성 실험을 위해 정상적으로 운행되는 차량에 장착 후 출력과 토크에 대한 성능평가를 하였으며, 다이나모 장비를 이용한 장치 실험결과는 장착전 후 출력과 토크 성능 대비 평균 10% 이상 증가함을 보여주었다.

• 제어로봇시스템학회논문지
• /
• 제13권2호
• /
• pp.179-186
• /
• 2007

This paper presents new ignition method and ignition recognition logic for a microturbine. New ignition method is designed by constant speed control of a microturbine with pre-determined time during a ignition period. It make more accurate air-fuel ratio as well as give enough time to ignition system to have full performance under cold temperature. And ignition recognition logic is designed by observing output current change of inverter by generating output torque of a microturbine in the instant of ignition. For filtering a output torque current of inverter with high frequency, we applied a moving average method. So far, ignition recognition is usually implemented by measuring of exhausted gas temperature(EGT) of microturbine. The proposed logic can give more accurate judgement of ignition as well as keep a good working of starting system under out of order a temperature measuring system and biased initial value of EGT sensor. Finally, the two proposed logics are proved by field operating a microturbine under various conditions.

• 전기학회논문지
• /
• 제67권9호
• /
• pp.1159-1164
• /
• 2018

Vacuum circuit breakers(VCB) are widely used for current interruption of high-voltage inductive loads such as induction motors. This VCB can be chopped off before the current zero due to its high arc-extinguishing capability. One of the outstanding features of VCB is that it can cut off high frequency re-ignition current more than other circuit breakers. If the transient recovery voltage generated in the arc extinguishing is higher than the dielectric strength of the circuit breaker, a re-ignition phenomenon occurs. The surge voltage of the re-ignition is very high in magnitude and the steepness of the waveform is so severe that it can act as a high electrical stress on the winding. If the high frequency current of one phase affects the other two phases when the re-ignition occurs, it may cause a high surge voltage due to the virtual current chopping. If the magnitude of the voltage allowed in the motor winding is high or the waveform level is too severe, it may lead to insulation breakdown. Therefore, it is necessary to reduce the voltage to within a certain range. In this study, we briefly explain the various phenomena at the time of interruption, analyzed the magnitude of the dielectric strength and the transient recovery voltage at the simultaneous three-phase interruption that can give the greatest influence to the inductive load, proposed a method to reduce the impact.

• 한국가스학회지
• /
• 제1권1호
• /
• pp.106-112
• /
• 1997

본 연구는 직류 저항회로의 개폐불꽃에 의한 폭발성 가스의 점화한계를 실험적으로 고찰하였다. 실험은 IEC형 불꽃점화 시험장치의 폭발용기에 폭발성 가스(메탄-공기 프로판-공기, 에틸렌-공기, 수소-공기)를 각각 넣고 텅스텐 전극과 카드뮴 전극사이에서 발생하는 3,200회의 개폐불꽃에 의한 점화유무를 확인하므로서 점화한계를 구하였다. 또한 실험장치의 점화감도교정을 실험한 후에 실시하므로서 실험의 정확성을 기하였다. 실험결과 최소 점화 전류값을 갖는 최소점화한계농도는 메탄-공기 8.3 [$Vol\%$], 프로판-공기 5.25[$Vol\%$], 에틸렌-공기 7.8[$Vol\%$], 수소-공기 21[$Vol\%$]로서 기존의 실험결과와 유사한 결과를 나타내었다. 또한 최소점화한계농도에서 전압과 최소점화잔류와의 관계를 구한 결과 최소점화한계는 메탄, 프로판, 에틸렌, 수소가스의 순서로 낮아졌고 점화전류의 크기는 전원전압의 크기와 반비례하고, 전극의 과열현상으로 인하여 전압 약 20(V)이하에서는 최소점화전류가 2(A)를 넘으면서 심화한계곡선이 급격히 상승한다는 것 등을 알 수 있었다.

• 한국안전학회지
• /
• 제13권3호
• /
• pp.74-79
• /
• 1998

To establish measuring method for minimum ignition energy of explosive powders caused by electrostatic discharge, A measuring method(Hartman) using a very small quantity of pine tree testing powder was proposed, and the influence of discharge current limiting resistance connected in series into a capacitive discharge circuit on ignition energies of explosive powders was investigated. As a result the minimum ignition energy was 42.25mJ when discharge current limiting resistance 300 $k\Omega$.

• 전기학회논문지
• /
• 제57권3호
• /
• pp.409-415
• /
• 2008

This paper proposed a new optimal design method of the electronic ballast with stable run-up current for Metal Halide lamp during the ignition condition. In order to avoid operation in the acoustic resonance frequency band and to supply the optimal ignition current without demage of inverter switching components during the ignition period, the values of the series inductor Ls, the series capacitor Cs, and the parallel capacitor Cp were determined by analysis of characteristics of inverter transfer function depend on Lamp operating power and resistance of ignition condition and steady state operating condition. For the prototype ballast for a 400W Metal Halide Lamp, experimental results are presented in order to validate the proposed method.

• 한국정보전자통신기술학회논문지
• /
• 제14권6호
• /
• pp.467-472
• /
• 2021

본 논문에서는 가스보일러에 사용되는 점화트랜스를 제작하여 전류와 역률, 소비전력을 측정하였다. 역률을 측정한 결과, 자체 제작된 점화트랜스는 외국제품에 비해 높았으며 소비전력은 낮게 측정되었다. 점화봉 간격을 2mm로 고정을 시키고 점화봉 길이가 30cm,500cm,1000cm일 때 3.45A, 14.5A, 16.2A로 측정되었다. 점화봉 간격을 4mm로 고정을 시키고 점화봉 길이가 30cm, 500cm, 1000cm일 때, 2.8A, 10.1A, 13.2A로 측정되었다. 점화봉 간격이 6mm로 고정시키고 점화봉 길이가 30cm, 500cm, 1000cm일 때 2.73A1, 0.2A, 32.6A로 측정되었다. 점화봉 간격이 8mm로 고정시키고 점화봉 길이가 30cm, 500cm, 1000cm일 때 3.13A, 9.37A, 21.4A로 측정되었다. 점화봉 간격이 10mm로 고정을 시키고 점화봉 길이가 30cm일 때는 3.4A, 14.4A, 25.6A로 측정되었다. 결론적으로 점화봉 길이가 증가 하면 전류도 증가되었다.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2004년도 춘계학술대회
• /
• pp.2088-2093
• /
• 2004

Harmful elements from the exhaust gases are caused by incomplete combustion of mixture inside the engine cylinder and this abnormal combustion like misfire or partial burning is the direct cause of the air pollution and engine performance degradation. In this study, I obtain the shapes of spark, voltage and current generated when changing the experimental parameters such as grounded electrode shapes, electrode gap and the material of center electrodes. After that, I produce ignition energy by using the voltage and current and classify ignition energy into capacitive discharge energy and inductive discharge energy.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 제37회 하계학술대회 논문집 C
• /
• pp.1611-1612
• /
• 2006

We are using the Faraday's electromagnetic law so as to improve our life in various industry fields. However, the side effect of the Faraday's law can be occurredin the sensors of the vehicle due to the high current flow such as Ignition. This effect is mainly caused by the shape of the wiring harness between sensor and high current load in the vehicle. To minimize the side effect by Faraday's law, three methods shall be considered in this paper (1) Pin definition of the sensor, (2) Pin definition of the high current load, (3) Wiring harness shape.

• 전기의세계
• /
• 제22권2호
• /
• pp.23-27
• /
• 1973

An initial starting voltage, ignition time, glow current and blink of the flow starter are changed rapidly in initial using. therefore an ageing is required to stabilize the initial characteristics. According to the experiments, it is proved that the ageing time for the starting voltage and glow current takes 3 minutes and 5 minutes for ignition time and blink.