• Journal of East Asia Management
• /
• 제4권2호
• /
• pp.39-62
• /
• 2023

Online and offline mixed teaching mode has become an important way to promote the connotative development of higher education. Under the background that offline teaching has become mature, in order to further promote the development of online education, and promote the implementation of the mixed teaching mode, to mix and to provide basis for the construction of the mixed teaching mode, this study takes the online learning effect as the evaluation basis, adopts the online questionnaire survey to conduct statistical analysis of the online learning behavior of 2213 college students, and discusses the differentiation phenomenon of online learning groups from the micro, meso and macro perspectives. It is found that there are significant differences in the online learning effect of college students in terms of the type of learning platform, whether the school implements the online offline mixed teaching mode, education background, grade (bachelor's degree), and region. Colleges and universities should strengthen the promotion of online and offline mixed teaching mode; The online learning platform should improve the platform function and strengthen the functional differentiation design of learning resources for students. Education departments pay attention to the learning effect of online learners in different regions, and bridge the gap in regional education.

• Journal of Food Hygiene and Safety
• /
• 제20권1호
• /
• pp.22-35
• /
• 2005

A survey was conducted to investigate the perception of food sanitation officers toward the Genetically Modified Foods. They were mainly from Regional Agencies of KFDA, City/Province office, and National quarantine station. Some of them were professors of university and researchers of research institute. Most of respondents had experiences of hearing or reading GM foods (over $95\%$) and over $90\%$ of respondents much needed the label of GM foods. Although some of officers of city/province office and national quarantine station showed less knowledge than other respondent groups, most of respondents had basic knowledge about biology. The frequency of respondents worked over 20 years and worked in the general administration was higher than that of other groups in the question of unsafe of GM foods. The answer frequency of careless treatment of foods was highest in the question of risk factor, and the frequency of GM foods was lowest ($4.4\%$). It was concluded that food sanitation officers had positive opinion about GM foods, but there were some differences in the knowledge among agencies. Therefore, it is necessary more educations and informations are needed for food sanitation officers.

• Journal of Distribution Science
• /
• 제12권11호
• /
• pp.77-83
• /
• 2014

Purpose - The National Agricultural Cooperative Federation of Korea and National Fisheries Cooperative Federation of Korea have prosecuted both financial and retail businesses. As cooperatives are public institutions and receive government support, their sound management is required by the Financial Supervisory Service in Korea. This is mainly managed by CAEL, which is changed by CAMEL. However, NFFC's business section, managing the finance and retail businesses, is unified and evaluated; the CAEL model has an insufficient classification to evaluate the retail industry. First, there is discrimination power as regards CAEL. Although the retail business sector union can receive a higher rating on a CAEL model, defaults have often been reported. Therefore, a default prediction model is needed to support a CAEL model. As we have the default prediction model using a subdivision of indexes and statistical methods, it can be useful to have a prevention function through the estimation of the retail sector's default probability. Second, separating the difference between the finance and retail business sectors is necessary. Their businesses have different characteristics. Based on various management indexes that have been systematically managed by the National Fisheries Cooperative Federation of Korea, our model predicts retail default, and is better than the CAEL model in its failure prediction because it has various discriminative financial ratios reflecting the retail industry situation. Research design, data, and methodology - The model to predict retail default was presented using logistic analysis. To develop the predictive model, we use the retail financial statements of the NFCF. We consider 93 unions each year from 2006 to 2012 to select confident management indexes. We also adapted the statistical power analysis that is a t-test, logit analysis, AR (accuracy ratio), and AUROC (Area Under Receiver Operating Characteristic) analysis. Finally, through the multivariate logistic model, we show that it is excellent in its discrimination power and higher in its hit ratio for default prediction. We also evaluate its usefulness. Results - The statistical power analysis using the AR (AUROC) method on the short term model shows that the logistic model has excellent discrimination power, with 84.6%. Further, it is higher in its hit ratio for failure (prediction) of total model, at 94%, indicating that it is temporally stable and useful for evaluating the management status of retail institutions. Conclusions - This model is useful for evaluating the management status of retail union institutions. First, subdividing CAEL evaluation is required. The existing CAEL evaluation is underdeveloped, and discrimination power falls. Second, efforts to develop a varied and rational management index are continuously required. An index reflecting retail industry characteristics needs to be developed. However, extending this study will need the following. First, it will require a complementary default model reflecting size differences. Second, in the case of small and medium retail, it will need non-financial information. Therefore, it will be a hybrid default model reflecting financial and non-financial information.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• 제18권2호
• /
• pp.243-253
• /
• 2017

This study aims to compare Jeju Island, Shanghai, and Yokohama cruise ports and to investigate the relative strengths and weaknesses of Jeju Island. This study conducted comparative evaluation of 8 factors [airport, berth, expenses, distance, access to town, shopping facilities, source market (background market), and tourism] through a cruise network analysis. Comparative evaluation results find that Jeju Island, which secured 2 berths (berthing capacity) by completion of the civil-military complex port, has ascendancy over Shanghai cruise port and will have ascendancy over Yokohama cruise port once construction of the new airport is completed. Therefore, it will qualify as the best cruise port in Northeast Asia in the future. Results obtained from the cruise network analysis provide insights for administrative policy. Study limitations include only eight factors are used for evaluating the cruise-ship harbor area and surrounding hinterlands, and thus cannot sufficiently evaluate the complex conditions of the sites. In the future, it is necessary to reexamine the evaluation factors of the cruise ship harbor in detail. Furthermore, future research will need to consider the economic effects of the cruise ship industry, and its relevance to related industries as a possible fusion or hybrid industry.

• Restorative Dentistry and Endodontics
• /
• 제27권4호
• /
• pp.403-410
• /
• 2002

Several ways of curing are being tried to improve material's properties and reduce marginal gap. However, all are considering about the pattern of light intensity. It was noted from the preliminary study the change of light wavelength from filter changing may give an impact on material's property and microleakage. The object of this study was to verify the effect of filters with various wavelength width on the microhardness and microleakage of composite resin ; hybrid type of DenFil and submicron hybrid type of Esthet X. Composite resins were cured using 3 kinds of filter; narrow-banded(465-475 nm), mid-banded(430-470 nm), wide-banded(400-500 nm). After the estimation of microhardness. degree of dye penetration and the maximum gap from SEM evaluation were done between 4 groups that showed no difference in microhardness value of the lower surface . The results were as follows : 1 Adequate microhardness could not be gained with a narrow-banded filter irrespective of curing time. At the upper surface, DenFil should be polymerized with middle or wide-banded filter for 20 seconds at least, while Esthet X be col$.$ed with middle or wide-banded filter for 30 seconds at least to get simitar hardness value to control group. 2. There was little dye penetration in enamel margin, but all dentin margins skewed much more dye penetration irrespective of curing conditions. Although there was no statistical difference, groups cured with mid-banded filter for 40 seconds and with wide-width filter for 20 seconds showed relatively less dye penetration. 3. It was revealed from the SEM examination that group cured with wide-banded filter had the smallest gap without statistical significance. Spearman's rho test showed that the correlation between the results of dye penetration and SEM examination was very low. From these results, it could be concluded that curing with wide-width filter would be better than the other techniques, even though the curing technique using mid-width filter seems to have its own unique advantage.

• Journal of the Institute of Convergence Signal Processing
• /
• 제9권4호
• /
• pp.313-320
• /
• 2008

The dynamic clustering technique has some problems regarding energy consumption. In the cluster configuration aspect the cluster structure must be modified every time the head nodes are re-selected resulting in high energy consumption. Also, there is excessive energy consumption when a cluster head node receives identical data from adjacent cluster sources nodes. This paper proposes a solution to the problems described above from the energy efficiency perspective. The round-robin cluster header(RRCH) technique, which fixes the initially structured cluster and sequentially selects duster head nodes, is suggested for solving the energy consumption problem regarding repetitive cluster construction. Furthermore, the issue of redundant data occurring at the cluster head node is dealt with by broadcasting metadata of the initially received data to prevent reception by a sensor node with identical data. A simulation experiment was performed to verify the validity of the proposed approach. The results of the simulation experiments were compared with the performances of two of the must widely used conventional techniques, the LEACH(Low Energy Adaptive Clustering Hierarchy) and HEED(Hybrid, Energy Efficient Distributed Clustering) algorithms, based on energy consumption, remaining energy for each node and uniform distribution. The evaluation confirmed that in terms of energy consumption, the technique proposed in this paper was 29.3% and 21.2% more efficient than LEACH and HEED, respectively.

• Korean Journal of Construction Engineering and Management
• /
• 제17권3호
• /
• pp.52-60
• /
• 2016

This study investigates and analyzes the total amount of energy consumption and $CO_2$ emission during the material manufacturing, transportation, construction, operation, and disposal phases of eight elementary school buildings in South Korea. Toward this ends, the hybrid LCA model is proposed. The life cycle energy consumption and $CO_2$ emission of eight case buildings are assessed using the hybrid LCA model with an assumption that the operation period is 40 years. As a result, the embodied(sum of the energy consumption in the material manufacturing, transportation and construction phases), operational and disposal energy were 2,279, 11,182, $228Mcal/m^2$, respectively, on average. The average embodied, operational, and disposal $CO_2$ emission were 604, 2,708, 60 kg-$CO_2/m^2$, respectively, on average. This result indicates that about 17% of life cycle energy (or $CO_2$ emission) is consumed in the material manufacturing, transportation and construction phases. Thus, it is necessary to consider the embodied energy and $CO_2$ emission to reduce the life cycle energy and $CO_2$ emission of school buildings. In addition, while the insulation standard of building have been provided based on the climate zone, energy consumption in operation phase still varied depending on the regions in this study. Thus, the insulation standard of building needs to be improved through considering the climate of regions in detail.

• Journal of Korean Society of Steel Construction
• /
• 제16권4호통권71호
• /
• pp.397-406
• /
• 2004

This paper presents the test and evaluation results on the shear strength and stiffness of a light steel stud wall from a lightweight foamed mortar (lightweight hybrid wall). The use of a lightweight foamed mortar was aimed at improving structural performance, thermal performance, and finish. Studiesshowed that it did not affect thermal performance, but it contributed to structural performance and finish when the unit weight was more than 0.8 (Editor's note: Please indicate the unit of measurement.). In this study, 14 specimens-whose parameters included the specific gravity of the lightweight foamed mortar (0.6, 0.8, 1.0, 1.2), the spacing of the stud (450 mm, 600 mm, or 900 mm), finishing materials (such as lightweight foamed mortar, OSB, and gypsum board), and bracing-were manufactured. Three typical, steel house-framing specimens were added to compare the test results with the 14 specimens. The results of in-plane shear tests show that the use of lightweight foamed mortar (1.15~5.38 times stronger, 1.45~13.7 times stiffer) results in ultimate strength and initial stiffness. In addition, it was possible to widen the stud spacing to up to 900 mm without decreasing shear strength. It was very important to prevent the lightweight foamed mortar from shrinking and to secure the adhesion between the steel stud and the lightweight foamed mortar to improve structural performance.

• Journal of Animal Science and Technology
• /
• 제44권5호
• /
• pp.625-632
• /
• 2002

Livestock farmers face several limitations when using the government recommended sorghum cultivars for forage because of the limited seed supply. Therefore, the objective of the this study is to evaluate, select, and recommend the best high-yielding hybrid as the government recommended cultivars. The agronomic characteristics and forage yield of three cultivars (cv. P947, cv. KF429 and cv. SS405) of forage sorghum were evaluated at two locations (Suwon and Sunghwan) for 2 years (1999${\sim}$2000). 'KF429' was susceptible to foliar disease, while 'SS405' had less lodging resistance among the sorghum cultivars tested. When compared with 'P947' (recommended cultivar), dry matter yield of 'KF429' and 'SS405' cultivars increased by 16% and 75%, respectively. The crude protein of 'P947'(9.4%) was higher than other cultivars. The percentage of ADF and NDF were the lowest in 'KF429' cultivar. The results of forage performance experiment indicate that 'KF429' and 'SS405' are recommended as the government recommended sorghum cultivars due to a high lodging tolerance, disease resistance, and high dry matter yield.

• Journal of Advanced Navigation Technology
• /
• 제6권1호
• /
• pp.17-26
• /
• 2002

In this paper, we have analyzed the BER (Bit Error Rate) performance of multi-user detectors employing SIC(Successive Interference Cancellation) and PIC (Parallel Interference Cancellation) which are the representative schemes in the subtractive interference cancellation. We have considered the MUD structure employing HIC (Hybrid Interference Cancellation) which combines SIC with PIC scheme, and then analyzed the BER performance. We have evaluated the BER performance of SIC and HIC schemes which execute the soft decision to generate the tentative data bit for the purpose of the interference cancellation in MAI and noise environments. Through the numerical analysis and computer simulation, it is shown that HIC can remove the effect of MAI more efficiently than the others, that improve the BER performance and increase the capacity of DS-CDMA systems regardless of the power control conditions. The reason is that the SIC scheme in front of HIC can solve the near-far problem caused by the imperfect power control and PIC scheme in the rear of it can improve the performance much more.