• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2005년도 추계 학술논문 발표대회
• /
• pp.71-74
• /
• 2005

The viscosity of high-flowability paste is very high compared to normal concrete for the low water-binder ratio(W/B). Therefore, high-flowability concrete is positively necessary to high-range water reducing agent. High-Flowability paste can make much higher fluidity with no occurrence of segregation, by its higher viscosity and lower yield value than normal concrete. The flowability of high-flowability paste must be evaluated not only by convention consistency test such as slump test but also by the base of the rheological properties of the fresh concrete. The purpose of this study is to analyze the fluidity of high-flowability paste according to the addition ratio of the Melamine Sulphonate high-range water reducing agent.; high-flowability paste is considered as Bingham plastic fluid with the rheology parameters of the plaste viscosity and yield value.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2007년도 춘계학술대회A
• /
• pp.467-472
• /
• 2007

A modern MEMS resonator is a micro-scale structure operated over a high frequency range. In order to predict its resonant behavior in a design process, High-frequency response analysis (Hi-FRA) is demanded. Algebraic substructuring (AS) is known as a fast numerical technique to construct an eigenspace for FR and frequency sweep (FS) algorithm efficiently solves the frequency response system projected on the eigenspace. However, the existing FS algorithm using AS is developed for low-FRA, say over the range 1Hz-2KHz. In this work, we extend the FS algorithm using AS for FRA over an arbitrary frequency range. Therefore, it can be efficiently applied to systems operated at a high frequency, say over the range 230MHz-250MHz. The success of the proposed method is demonstrated by Hi-FRA of a checkerboard resonator.

• Journal of Power Electronics
• /
• 제18권4호
• /
• pp.975-984
• /
• 2018

This work presents a high efficiency phase shifted full bridge (PSFB) DC-DC converter for use in the second stage of a battery charger for neighborhood electrical vehicle (EV) applications. In the design of the converter, Lithium-ion battery cells are preferred due to their high voltage and current rates, which provide a high power density. This requires wide range output voltage regulation for PSFB converter operation. In addition, the battery charger works with a light load when the battery charge voltage reaches its maximum value. The soft switching of the PSFB converter depends on the dead time optimization and load condition. As a result, the converter has to work with soft switching at a wide range output voltage and under light conditions to reach high efficiency. The operation principles of the PSFB converter for the continuous current mode (CCM) and the discontinuous current mode (DCM) are defined. The performance of the PSFB converter is analyzed in detail based on wide range output voltage and load conditions in terms of high efficiency. In order to validate performance analysis, a prototype is built with 42-54 V / 15 A output values at a 200 kHz switching frequency. The measured maximum efficiency values are obtained as 94.4% and 76.6% at full and at 2% load conditions, respectively.

• 한국주거학회논문집
• /
• 제15권4호
• /
• pp.1-8
• /
• 2004

This study assumes that though buildings have identical color of the outer walls, their colors and images make the difference according to neighboring environmental factors and visual range. Based on the assumption, it carries a quantitative analysis of physical and image difference, targeting colors of the outer walls of high-rise apartment buildings within apartment complex. As a result, it is identified that the outer colors of the buildings on the streetside of high-rise residential complexes are significantly different according to neighboring environmental factors and viewers' visual range. And, it is suggested that in planning colors of outer wall, colors should be arranged in consideration of color difference according to visual range.

• 한국방송∙미디어공학회:학술대회논문집
• /
• 한국방송공학회 2009년도 IWAIT
• /
• pp.154-157
• /
• 2009

High dynamic range image can describe the real world scenes that have a wide range of luminance intensity. To display high dynamic range (HDR) image into conventional displayable devices such as monitors and printers, we proposed the logarithmic based global mapping algorithm that consider the features of image using mapping parameters. Based on characteristics of image, we first modify input luminance values for reproducing perceptually tuned images and then displayable output values are obtained directly. The experimental results show that the proposed algorithm achieves good subjective results while preserving details of image, furthermore proposed algorithm has fast simple and practical structure for implementation.

• 한국군사과학기술학회지
• /
• 제13권1호
• /
• pp.140-146
• /
• 2010

The multi-function radar can detect and track the low RCS targets. For this purpose the multi-function radar uses the pulse train waveform. because this waveform has high dynamic range and good SNR(Signal to Noise Ratio). But the spurious signals can also be detected by processing the pulse train waveform. Thus the multi-function radar signal processor must have the high SFDR(Spurious Free Dynamic Range). This paper describes the development of the multi-function radar signal processor having the high SFDR.

• Journal of Mechanical Science and Technology
• /
• 제20권7호
• /
• pp.1019-1029
• /
• 2006

The ballistic range has long been employed in a variety of engineering fields such as high-velocity impact engineering, projectile aerodynamics, creation of new materials, etc, since it can create an extremely high-pressure state in very short time. Of many different types of ballistic ranges developed to date, two-stage light gas gun is being employed most extensively. In the present study, a theoretical work has been made to develop a new type of ballistic range which can easily simulate a flying projectile. The present ballistic range consists of high-pressure tube, piston, pump tube, shock tube and launch tube. The effect of adding a shock tube in between the pump tube and launch tube is investigated. This improvement is identified as the reduction in pressures in the high pressure tube and pump tube while maintaining the projectile velocity. Equations of motions of piston and projectile are solved using Runge-Kutta methods. Dependence of projectile velocity on various design factors such as high pressure tube pressure, piston mass, projectile mass, area ratio of pump tube to launch tube and type of driver gas in the pump tube are also analyzed. Effect of various gas combinations is also investigated. Calculations show that projectile velocities of the order 8 km/sec could be achieved with the present ballistic range.

• 한국재료학회지
• /
• 제24권11호
• /
• pp.625-631
• /
• 2014

To investigate the deformation properties of TiC-(5-20) mol% Mo solid solution single crystals at high temperature by compression testing, single crystals of various compositions were grown by the radio frequency floating zone technique and were deformed by compression at temperature from 1250K to 2270K at strain rates from $5.1{\times}10^{-5}$ to $5.9{\times}10^{-3}/s$. The plastic flow property of solid solution single crystals was found to be clearly different among a three-temperature range (low, intermediate and high temperature ranges) whose boundaries were dependent on the strain rate. From the observed property, we conclude that the deformation in the low temperature range is controlled by the Peierls mechanism, in the intermediate temperature range by the dynamic strain aging and in the high temperature range by the solute atmosphere dragging mechanism. The work softening tends to become less evident with an increasing experimental temperature and with a decreasing strain rate. The temperature and strain rate dependence of the critical resolved shear stress is the strongest in the high temperature range. The curves are divided into three parts with different slopes by a transition temperature. The critical resolved shear stress (${\tau}_{0.2}$) at the high temperature range showed that Mo content dependence of ${\tau}_{0.2}$ with temperature and the dependence is very marked at lower temperature. In the higher temperature range, ${\tau}_{0.2}$ increases monotonously with an increasing Mo content.

• 한국통신학회논문지
• /
• 제35권4C호
• /
• pp.350-357
• /
• 2010

본 논문에서는 iCAM06의 HDR (High Dynamic Range) 영상 렌더링을 위한 적응적 표준 편차를 이용한 자동레인지 고속 양방향 필터 (auto-range fast bilateral filter, FBF)를 제안한다. 다양한 노출 시간으로 촬영한 여러영상들은 전체 다이나믹 레인지를 포함한 한 장의 HDR 영상으로 만들어진다. HDR 영상 렌더링의 대표적인 알고리즘은 iCAM06이며, 이는 국부 백색 적응 (local white point adaptation), 색 순응 (color adaptation), 및 영상 처리 변환 (image processing transformation, IPT) 같은 iCAM 구조를 기초로 한다. iCAM06의 고속 양방향 필터는 레인지 필터에서 고정 표준 편차를 사용한다. 이는 넓고 낮은 분포를 가지는 고 자극치 영역에서 불필요한 고속 양방향 필터 계산의 원인이 된다. 이를 해결하기 위하여 XYZ 각 자극치 영상을 경계값에 의해 저 자극치 영상 및 고 자극치 영상으로 나눈 후, 각 자극치 영역에 대하여 히스토그램 분포에 기초한 가변 표준 편차를 이용한다. 실험 결과에서 제안한 방법이 기존의 고속 양방향 필터보다 계산 속도가 개선되었음을 확인하였다.

• 방송공학회논문지
• /
• 제14권4호
• /
• pp.428-437
• /
• 2009

A high dynamic range (HDR) image can represent real world scenes that have a wide range of luminance intensity. However, compared with the range of real world luminance, conventional display devices have a low dynamic range (LDR). To display HDR images onto conventional displayable devices such as monitors and printers, we propose the logarithmic based global reproduction algorithm that considers the features of the image using reproduction parameters. Based on the characteristics of the image, we first modify the input luminance values for reproducing perceptually tuned images and then obtain the displayable output values directly. The experimental results show that the proposed algorithm achieves good subjective results while preserving details of the image; furthermore, the proposed algorithm has a fast, simple and practical structure for implementation.