• Fashion & Textile Research Journal
• /
• v.12 no.4
• /
• pp.500-507
• /
• 2010

In this study, physical properties were studied by using latent stretching yarn in order to develop the texturing yarn technique for super bulky yarn, which is better in bulkiness and handle than natural wool and also adds property of synthetic fiber to natural wool. In order to obtain textured conditions by analysing basic properties for manufacturing DTY yarn with super bulky property, DTY 50d/12 after spinning latent yarn spined POY 80d/12 was obtained under the two conditions of (i) false twist(T/M) level 3 in DTY texturing and (ii) draw ratio level 4 in draw texturing. For DTY texturing yarn, Elongation rate increased as the heat treatment time and temperatures increased. In addition, shrinkage became higher as false twist was higher, so that elongation rate became lower. When annealing became longer in time and higher in temperature, initial modulus increased. In addition, as the count of false twist increased, the initial modulus showed higher values. For draw texturing yarn, under the conditions of heat temperature 180 and heating time 30 minutes, shrinkage rate in draw ratio 1.55 and 1.6 draw ratio was 7%, and that in 1.65 and 1.7 draw ratio was 8.5%. High draw ratio samples' tenacity was much influenced by heating time and temperature, but low draw ratio samples' tenacity was influenced not by treated time, but by treated temperature.

• Journal of the Korean institute of surface engineering
• /
• v.36 no.5
• /
• pp.406-412
• /
• 2003

FT-IR and thermography were used to investigate the infrared radiation characteristic of SiO$_2$ film and SiO$_2$/Fe$_2$O$_3$film coated on aluminum. Through FT-TR spectrum, SiO$_2$film showed high infrared absorption in accordance with the stretching vibration of Si-O-Si, and as$ Fe_2$$O_3$was mixed additional absorption band appeared resulting from the stretching vibration of Fe-O at $590cm^{-1}$ and the bond of Si-O-Fe at $900 cm^{-1}$ The two kinds of film measured by the integration method and the reflective method coincided with each other in the wavelength area of infrared absorption and radiation, and corresponded well with Kirchhoff's law as the infrared emissivity is high in wavelength where infrared absorption rate is high. The emissivity of $SiO_2$ film was 0.65 and that of $SiO_2$/Fe$_2$$O_3$film was 0.77, so the addition of$ Fe_2$$O_3$ raised the infrared emissivity by approximately 13%.$ SiO_2$$Fe_2$$O_3$ film is efficient as an infrared radiator at below $100^{\circ}C$. The temperature of heat radiation after 7 minutes was 117$^{\circ}C$ in aluminum plate and $155^{\circ}C$ in $SiO_2$$Fe_2$$O_3$ film, $38^{\circ}C$ higher than the former.

• Journal of Oral Medicine and Pain
• /
• v.47 no.4
• /
• pp.198-205
• /
• 2022

Purpose: The first-line treatment of temporomandibular joint disorders (TMDs) should include self-management and education. Self-management techniques include moist heat application, stretching, diet control, and mandibular rest position adjustment. Although the effectiveness of video educational resources has been studied in multiple sectors, their application in TMD management has not yet been explored. This study seeks to assess how effective media education was at motivating TMD patients to self-management and improve symptoms. Methods: Data were obtained from the hospital records of TMD patients who visited the Department of Oral Medicine, Yonsei University Dental Hospital, between May 2020 and December 2021. First, without any differences between groups, a significance analysis was conducted between the degree of self-management and symptom improvement over time. At the second visit, one group received media education (n=31) linked to TMD management, while the other received written-oriented education (n=45). At the third visit, the number of precautions taken by the patients was determined and contrasted to that recorded in the previous visit between the groups. Generalized estimated equation multivariate models were applied for statistical analysis. Results: In the media education group, the frequency of stretching and the number of patients on pain-free diets increased substantially. Taking precautions improved daily pain intensity, maximum mouth opening, and pain intensity during the maximum unassisted opening. Conclusions: Media education could be beneficial for TMD patients because it allows them to take self-management precautions. The symptoms of the media education group improved, with no considerable distinction between both groups.

• Carbon letters
• /
• v.16 no.2
• /
• pp.121-126
• /
• 2015

Carbon fibers are prepared by stabilizing pitch fibers accompanying electron beam (E-beam) irradiation. The carbon fibers pretreated by E-beam irradiation achieve a higher stabilization index than the carbon fibers that are only heat-stabilized. In addition, the carbon fibers subjected to E-beam irradiation in the stabilization step exhibit a comparable tensile strength to that of general purpose carbon fibers. The carbon fibers pretreated with an absorbed dose of 3000 kGy have a tensile strength of 0.54 GPa for a similar fiber diameter. Elemental, Fourier-transform infrared spectroscopy, and thermogravimetric analyses indicate that E-beam irradiation is an efficient oxidation and dehydrogenation treatment for pitch fibers by showing that the intensity of the aliphatic C-H stretching and aromatic $CH_2$ bending (out-of-plane) bands significantly decrease and carbonyl and carboxylic groups form.

• Journal of the Korean Wood Science and Technology
• /
• v.47 no.3
• /
• pp.299-310
• /
• 2019

This study was carried out to investigate the effect of heat-treatment and particle size on the crystalline properties of the wood cellulose. The color of wood flours was changed from light yellow in control sample to dark yellow or deep brown by heat treatment at $100^{\circ}C$ to $200^{\circ}C$. Relative crystallinity of the heat treated wood cellulose decreased with decreasing particle size from wood chips to 200 mesh, and there was little change in the crystal width. As the temperature was increased, relative crystallinity of the wood increased and crystal width was not changed. As a result of the FT-IR analysis, it was confirmed that the peaks were gradually decreased at -OH elongation as the heat-treated temperature was increased. The lignin C-H bending of $1425cm^{-1}$ and the hemicellulose C-H bending of $1370cm^{-1}$ did not change with the increase of the heat treatment temperature. In addition, it was revealed that C-C stretching of carbohydrate near $1031cm^{-1}$ decreased with increasing heat treatment temperature. Consequently, it is suggested that particle size and heat treatment affected the crystalline properties of wood cellulose.

• Applied Chemistry for Engineering
• /
• v.10 no.4
• /
• pp.603-607
• /
• 1999

The polarization characteristics of poly(vinyl alcohol)-iodine complex, (PVA-KI system) prepared by the oxidation process of PVA film containing a potassium iodide (KI) were investigated. The UV-visible spectrum of the PVA-KI system polarizing film showed avsorption bands corresponding to $I^{-}$, $I{_3}{^-}$ and $I{_5}{^-}$ chromophoric species at 220 nm, 290~360 nm, respectively. The polarization efficiency and transmittance of PVA-KI system film were significantly influenced by oxidation time, stretching ratio and concentration of KI. The prepared polarizing film exhibited a high polarization efficiency(99.5%) and transmittance(45%). Especially, the heat resistance of the polarizing film was higher than that of a commercial PVA-$I_2$ polarizing film. It may be argued that the result should come from a difference in oxidation process of PVA polarizing film.

• Journal of the Microelectronics and Packaging Society
• /
• v.31 no.1
• /
• pp.7-15
• /
• 2024

In the trend of the multi-functionalization, miniaturization, and increased power output trends of flexible and stretchable electronic devices, the development of materials or structures with superior heat transfer characteristics has become a pressing issue. Traditional thermal interface materials (TIM) fail to meet the heat dissipation requirements of flexible and stretchable electronic devices, which must endure rapid bending, twisting, and stretching. To address this challenge, there is a demand for the development of TIM that simultaneously possesses high thermal conductivity and stretchability. This paper examines the research trends of liquid metal, carbon, and ceramic-based stretchable thermal interface materials and explores effective strategies for enhancing their thermal and mechanical properties.

• Journal of Haehwa Medicine
• /
• v.15 no.1
• /
• pp.59-69
• /
• 2006

Objectives & Methods : I investigated 45 literature of Oriental and Western medicine about the treatment of pain in shoulder and arm. Result and Conclusion : 1. The etiological causes of Pain in Shoulder and Arm based on literatures of Oriental medicine are attack of wind-heat on the lung, wind cold, damp-heat struggle between the vital energy and pathogenic factor and six pathogenic factors. And all these causes are the conception of blockage syndrome, Qi and blood stagnating in meridian system. 2. The treatment of Pain in Shoulder and Arm based on Oriental medicine is mainly composed of both medical therapy for Bi syndrome due to pathogenic wind, deficiency of both Qi and blood, consumption of the liver and the spleen, and also acupuncture and moxibustion treatment by selection for acupoint. And those treatments are for treating etiology. And also there are treatments using the meridian system and Twelve Muscle Region and Ashihyeol for the purpose of treating the symptoms. 3. The etiological causes of Pain in Shoulder and Arm based on literatures of Western medicine are degenerative cut of tendon and nerve symptoms caused by tendonitis, bursitis, calcification, ruptured cervical disc and thoracic outlet syndrome. 4. The treatment of Pain in Shoulder and Arm based on Western medicine is for alleviation of pain, such as giving an anodyne, steroid products, local anesthetic injection and stretching and strengthening the muscles.

• Journal of IKEEE
• /
• v.20 no.4
• /
• pp.412-415
• /
• 2016

In this study, we fabricated the wearable film-heaters used in thermotherapy for senior citizens and investigated the heat generation characteristics. The wearable film-heaters embedded into eco-flex were constructed with indium tin oxide (ITO) nanoparticles coated on glass fibers. Under a stretching strain of 30%, the wearable film-heaters stably operated with temperature variation of 10%. In addition, the wearable film-heater worn on the wrist increased the temperature of the wrist from $35^{\circ}C$ to $43^{\circ}C$ within 2 min.

• International Journal of Aeronautical and Space Sciences
• /
• v.7 no.1
• /
• pp.13-26
• /
• 2006

When the stagnation temperature of a perfect gas increases, the specific heat for constant pressure and ratio of the specefic heats do not remain constant any more and start to vary with this temperature. The gas remains perfect: its state equation remains always valid, with exception that it will be named by calorically imperfect gas. The aim of this research is to develop the relations of the necessary thermodynamics and geometrical ratios. and to study the supersonic flow at high temperature. lower than the threshold of dissociation. The results are found by the resolution of nonlinear algebraic equations and integration of complex analytical functions where the exact calculation is impossible. The dichotomy method is used to solve the nonlinear equation. and the Simpson algorithm for the numerical integration of the found integrals. A condensation of the nodes is used. Since. the functions to be integrated have a high gradient at the extremity of the interval of integration. The comparison is made with the calorifcally perfect gas to determine the error made by this last. The application is made for the air in a supersonic nozzle.