• 한국항공우주학회지
• /
• 제35권12호
• /
• pp.1082-1088
• /
• 2007

고속 및 고효율의 해양 수송수단에 대한 필요성이 점차 증가되면서 위그선(WIG: Wing in Ground effect)이 차세대 수송수단으로 관심이 집중되고 있다. 이러한 고속 해양 수송선의 구조설계 시 수면에 대한 충격하중은 중요하게 고려되어야 할 하중요소 중의 하나이며 착수하중에 의한 동적거동은 손상을 초래하는 중요한 요소이다. 본 연구에서는 위그선 착수 시 수면 충격하중에 대한 수치해석을 통해 선체의 동적거동을 평가하였다. 착수환경에서의 수면충격하중을 ALE (Arbitrary Lagrangian-Eulerian) 유한요소법을 적용하여 해석을 수행하였으며 3차원 쉘요소를 적용한 전기체 모델을 개발하여 위그선의 착수환경에서 선체의 동적거동을 모사하였다. 착수환경은 정상 착수조건과 측풍에 의한 비정상 착수조건 두 가지를 고려하여 해석을 수행하였으며 이러한 착수환경이 위그선 구조의 정적 구조 안정성에 미치는 영향을 평가하였다

• 한국지반공학회지:지반
• /
• 제7권3호
• /
• pp.43-50
• /
• 1991

굴착 중 slurry로 지대되고 있는 상태에서 지하수와 상재하중의 영향을 고려한 diaphragm wall 의 안정도를 해석하기 위하여 Belt Piaskowski/kowalewski, Washbourne의 모델을 확장하고, 확장된 이론으로 프로그램 SL3D를 개발하였다. Washbourne의 모델에서는 Bell, Piaskowski / Kowalewski의 모델에 비해, 굴착깊이가 증가함에 따라 안정도가 매우 큰 폭으로 증가하고, 비교적 초기굴착단계에서 부터 안전측에 속한다. 또한 slurry의 밀도, 지하수위, 흙의 내부마찰각, trench의 길이,상재단위하중등이 안정도에 미치는 영향을 분석하였고, 이것을 근거로 nomogram을 작성하였다.

• 한국운동역학회지
• /
• 제23권3호
• /
• pp.245-252
• /
• 2013

The purpose of this study was to analyze the effect that various loads have on the lower limb biomechanics. The following variables were measured and analyzed; performance time for each phase, lower limb moments and joint angles, and ground reaction forces. The kinematic and kinetic data was recorded by 2 force platforms and a motion capture system while 12 healthy adults in their twenties stepped down three steps under loads of 0%, 10%, 20% BW. Results are as follows. First, the different loading conditions did not seem to significantly affect the performance times and the joint angles. Second, the largest ground reaction forces were observed at the 1 step at the 10% BW condition. Finally, at the 0% BW loading condition the right hip extension moment was the smallest and the left hip flexion moment was the largest. The results show that there are not any significant changes in the biomechanics of the lower limbs under loading conditions up to 20% BW. Further investigations including more loading conditions with more weights and more additional steps analyzed are needed.

• 산업기술연구
• /
• 제26권B호
• /
• pp.93-99
• /
• 2006

Centrifuge model experiments were performed to investigate the confining effects of the sheet piles, installed to the sides of soft clay ground treated with sand compaction piles, on the bearing capacity and concentration ratio of composite ground. For the given g-level in the centrifuge model tests, replacement ratio of SCP and the width of surcharge loads on the surface of ground with SCP, the confining effects of installing the sheet piles on the edges of SCP ground on the bearing capacity, change of stress concentration ratio and failure mechanism were investigated. Kaolin, one of typical clay mineral, and Jumunjin standard sand were used as a soft clay ground and sand compaction pile irrespectively. As results of experiments, lateral confining effect by inserting the model sheet piles fixed to the loading plate was observed. For the strip surcharge loading condition, the yielding stress intensity in the form of the strip surcharge loads tends to increase with increasing the embedded depth of sheet piles. The stress concentration ratio was found not to be influenced consistently with the embedded depth of sheet piles whereas the effect of stress intensity on stress concentration ratio shows the general trend that values of stress concentration ratio are relatively high at the initial stage of loading and tend to decrease and converge to the certain values. For the failure mechanism in the case of reinforced with sheet piles, displacement behavior related to the punching failure, settlement right beneath the loading plate occurred since the soil was confined with sheet piles, was observed.

• 한국지구물리탐사학회:학술대회논문집
• /
• 한국지구물리탐사학회 2003년도 Proceedings of the international symposium on the fusion technology
• /
• pp.109-114
• /
• 2003

It is the common practice to reinforce excessively the secondary tunnel lining due to the lack of rational insights into the ground loosening loads. The main load of the secondary lining for drained-type tunnels is the ground loosening. The main cause of the load for secondary tunnel lining is the deterioration of the primary support members such as shotcrete, steel ribs, and rockbolts. Accordingly, the development of the analysis model to consider the ground-primary supports-secondary lining interaction is very important for the rational design of the secondary tunnel lining. In this paper, the interaction is conceptually described by the simple mass-spring model and the load transfer from the primary supports to the ground and the secondary lining is showed by the characteristic curves including the secondary lining reaction curve for the theoretical solution of a circular tunnel. And also, the application of this model to numerical analysis is verified in order to review the potential tool for practical tunnel problems with the complex conditions like non-circular shaped tunnels, multi-layered ground, sequential excavation and so on.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2000년도 학술대회논문집
• /
• pp.77-81
• /
• 2000

The purpose of this paper is to describe a new measuring method of ground resistance for the grounding system in energized power equipment and substations. It is very difficult to measure the accurate ground resistance in energized power equipment and substations because of the noise conducted from all external connections to the grounding system and harmonics components caused by unbalanced loads and overloads. The ground resistance that is measured with existing methods includes not only the effect of desired signals but also noise components for the measurement period in grounding system. The measured value of ground resistance can entirely be different from actual value. In this paper, to eliminate 60[Hz] power system interference and harmonic components the low-pass filter method was used in the measurement of ground resistance.

• 한국지반환경공학회 논문집
• /
• 제24권10호
• /
• pp.41-49
• /
• 2023

산악지역 및 경사지반과 같은 비대칭지반에 설치된 교각과 같은 구조물은 바람, 온도, 지진등의 다양한 하중을 받게 된다. 비대칭지반에 설치된 교각과 같은 구조물을 안정적으로 지지하기 위해 보편적으로 말뚝기초가 많이 사용되고 있다. 교각을 지지하는 말뚝기초의 거동은 다양한 하중조건에 의해 변화하게 된다. 특히 지진과 같은 동적하중이 작용하는 교각을 지지하는 말뚝기초의 거동을 분석하기 위해서는 지반-말뚝-구조물 상호작용이 검토되어야 한다. 지진이 작용하는 비대칭지반에 설치된 말뚝기초는 지반경사, 진동방향에 따른 지반저항력 차이, 지반 변위 등에 의해 말뚝기초와 지반의 동적 상호작용은 매우 복잡해진다. 본 연구에서는 비대칭지반으로 경사사모래지반의 소단에 설치된 상부구조물을 지지하는 무리말뚝의 동적거동에 경사지반의 기울기가 미치는 영향을 확인하기 위해 1g 진동대 모형실험을 수행하였다. 그 결과, 경사지반의 기울기가 증가함에 따라 말뚝캡, 상부구조물의 가속도는 감소하는 것으로 확인되었으며, 말뚝의 동적 p-y 곡선의 할선기울기는 감소하는 것으로 확인되었다.

• 국제초고층학회논문집
• /
• 제1권1호
• /
• pp.21-28
• /
• 2012

Diagrid system has been in the spotlight for its superiority in terms of the resistance to lateral force when applied to skyscrapers. In diagrid system, most of columns can be eliminated because vertical loads (gravity loads) and horizontal loads (lateral loads) are delivered simultaneously thanks to the triangular shape of diagrid. However, lack of studies on connection shape and node connection details makes it hard to employ the system to the buildings. In this study, the structural safety of the node connections in circular steel tube diagrid system which has been considered in the Cyclone Tower in Korea (Seven stories below and fifty-one above the ground) was evaluated using the 4 full-scale specimens. The parameters are the extended length (20 mm, 40 mm & 60 mm), thickness (40 mm & 50 mm).

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2001년도 봄 학술발표회 논문집
• /
• pp.89-96
• /
• 2001

A concrete lining of NATM tunnel is the final product of a process that involves planning and evaluation of user needs, geotechnical investigations, analysis of ground-lining interaction, construction, and observations and modifications during construction. The designer must consider the lining in context of the many function, construction, and geotechnical requirements. Also, the loss of supporting capacity of shotcrete lining due to poor rock qualities and shotcrete erosion must be considered. The values, shapes, and estimating methods of rock load and water pressure are very different with every designers. Estimating methods of rock loads used in the design of NATM tunnel concrete lining are investigated. Numerical analyses are done in various conditions. And the rock loads estimated from radial stress and plastic zone are compared respectively.

• Earthquakes and Structures
• /
• 제11권6호
• /
• pp.1061-1076
• /
• 2016

Prefabricated Modular Buildings are increasingly becoming popular in the construction industry as a method to achieve financially economical buildings in a very short construction time. This increasing demand for modular construction has expanded into multi-storey applications where the effect of lateral loads such as seismic loads becomes critical. However, there is a lack of detailed scientific research that has explored the behaviour of modular buildings and their connection systems against seismic loads. This paper will therefore present the nonlinear time history analysis of a multi-storey modular building against several ground motion records. The critical elements that need special attention in designing a modular building in similar seismic conditions is discussed with a deeper explanation of the behaviour of the overall system.