• Korean journal of applied entomology
• /
• v.46 no.3
• /
• pp.349-356
• /
• 2007

Three active components (Z8-12:Ac, E8-12:Ac, and Z8-12:OH) are known in sex pheromone of the oriental fruit moth, Grapholita molesta, and have been commercially available to apply for population monitoring and mating disruption. However, there have been variation among commercial products in pheromone composition and amount impregnated in each pheromone releaser. This study was performed to optimize factors influencing on pheromone monitoring of G. molesta by analyzing pheromone composition/amount, effective period of releaser, and trap type/placement in apple trees. High purity of Z8-12:Ac component was effective to attract males, in which 96% or more of cis acetate isomer component appeared to be optimal composition. Pheromone amounts ($0.01-1\;{\mu}g$) impregnated in each rubber dispenser did not give significant effect on monitoring during 90 days from June to August. "Delta" trap was much more efficient than "cone" trap to collect males. Trap installation was another factor, in which placing traps at canopy level was much efficient than at trunk or ground levels. Pheromone trap monitoring with these optimal factors indicated three to four adult peaks from June to September in addition to high overwintering population from April to May in pesticide-applied orchards in Andong, Korea.

• Applied Biological Chemistry
• /
• v.39 no.5
• /
• pp.398-402
• /
• 1996

This study was carried out to compare the fermentation rates of Dongchimi as affected by fermentation temperature and salt concentration of brining solution. The Dongchimi was prepared by fermentation of the radish in salt solutions of 2.0, 3.2 and 5.1% NaCl respectively with addition of garlic, green onion, ginger at $4^{\circ}C,\;10^{\circ}C,\;20^{\circ}C$. The fermentation was classified into 3 steps of initial, intermediate and final stages according to pH changes and the rates of fermentation and color change were calculated from intermediate stage. The time reached equilibrium in hardness of radish and salt concentration and their equilibrated values were also compared. Fermentation rate became more rapid as fermentation temperature and salt concentration increased. The rates of Hunter color change of Dongchimi liquid were increased as the temperature increased. The 'L' values decreased slowly, and 'a' and 'b' values increased rapidly to maximum at the intermediate stage. The time required to reach equilibrium was reduced for both salt concentration and hardness of radish as the fermentation temperature increased. The equilibrated values of salt concentration were increased while those of hardness of radish were decreased as the temperature and salt concentration increased. The data obtained can be used for prediction of some of the major characteristics of Dongchimi during fermentation.

• Applied Biological Chemistry
• /
• v.47 no.2
• /
• pp.202-207
• /
• 2004

This study was performed to investigate the inhibitory effect of the water-extract from fermented compositions containing Inonotus obliquus with added Houttuynia cordata on the growth of either human AGS gastric and HCT-15 colon cancer cells or NIH3T3 normal mouse fibroblast cells. Cytotoxic activity on cancer cells was investigated by viable cell count, MTT assay and morphological observation. Mixtures of Inonotus obliquus with added Houttuynia cordata were fermented at $30{\sim}37^{\circ}C$, $50{\sim}60%$ humidity for 30 days, extracted with water, freeze dried, powered, and then dissolved in water for the experiment. In MTT assay, the fermented compositions exhibited inhibitory effects of 13, 25, 40, 67 and 78% for AGS and 22, 40, 50, 69 and 76% for HCT-15 at 0.16, 0.4, 0.8, 1.6 and 4.0 mg/ml, respectively. However, normal NIH3T3 cells were exhibited 86% survival under the same experimental condition. Fermented compositions showed highly inhibitory effect against human cancer cell line HCT-15 and AGS, but not on normal cell line NIH3T3.

• Applied Chemistry for Engineering
• /
• v.32 no.5
• /
• pp.569-573
• /
• 2021

In this study, high-density carbon blocks were manufactured using coke, binder pitch, and impregnated pitch, then the effect of pitch fluidity on the densification of carbon blocks during the impregnation process was investigated. A green block was manufactured through high-pressure figuration of coke and binder pitch, and a carbon block was obtained through a heat treatment process. An impregnation process was performed to remove pores generated by volatilization of the binder pitch during the heat treatment process. The impregnation process was carried out the high-pressure reaction step of impregnating the pitch into the carbon block followed by the pretreatment step of melting the impregnation pitch. Melting of the impregnation pitch was carried out at 140~200 ℃, and the viscosity of the impregnation pitch decreased as the heat treatment temperature increased. The decrease in the viscosity of the impregnation pitch improved the fluidity and effectively impregnated the pores inside the carbon block, reducing the porosity of the carbon block by 83% and increasing the apparent density by 5%.

• Applied Chemistry for Engineering
• /
• v.32 no.4
• /
• pp.409-416
• /
• 2021

Dimensionally stable electrodes are one of the important components in electrochemical water treatment processes. In the manufacturing of the dimensionally stable electrodes, the type of metal catalyst coated on the surface of the metal substrate, the coating and sintering methods substantially influence their performance and durability. In this study, using Ir-Ru-Ta ternary metal coating, various electrodes were prepared depending on the coating method under the same pre-treatment and sintering conditions, and its performance and durability were studied. As a coating method, brush and spray coating were used. As a result, the reduction in the amount of catalyst ink was achieved because more amount of metal could be coated for the electrode using spraying with the same amount of catalyst ink. In addition, the spray_2.0_3.0 electrode prepared by a specific spray coating method shows the phenomenon of cracking and the uniform coating of the ternary metal on the surface of the coating layer, and results in a high electrochemically active specific surface area, and the decomposition performance of 4-chlorophenol was superior to the other electrodes. However, it was found that there was no significant difference in durability depending on the coating method.

• Applied Chemistry for Engineering
• /
• v.32 no.3
• /
• pp.332-339
• /
• 2021

Recently, due to concerns about the depletion of fossil fuels and the emission of greenhouse gases, the importance of hydrogen energy technology, which is a clean energy source that does not emit greenhouse gases, is being emphasized. Water electrolysis technology is a green hydrogen technology that obtains hydrogen by electrolyzing water and is attracting attention as one of the ultimate clean future energy resources. In this study, the surface properties of the porous transport layer (PTL), one of the cell components of the proton exchange membrane water electrolysis (PEMWE), were controlled using a sandpaper to reduce overvoltage and increase performance and stability. The surfaces of PTL were sanded using sandpapers of 400, 180, and 100 grit, and then all samples were finally treated with the sandpaper of 1000 grit. The prepared PTL was analyzed for the degree of hydrophilicity by measuring the water contact angle, and the surface shape was observed through SEM analysis. In order to analyze the electrochemical characteristics, I-V performance curves and impedance measurements were conducted.

• Applied Chemistry for Engineering
• /
• v.33 no.2
• /
• pp.151-158
• /
• 2022

In this paper, parameter characteristics such as pH effect, isotherm, kinetic and thermodynamic parameters and competitive adsorption of dyes including malachite green (MG), direct red 81 (DR 81) and thioflavin S (TS), which have different functional groups, being adsorbed onto activated carbon were investigated. Langmuir, Freundlich and Temkin isotherm models were employed to find the adsorption mechanism. Effectiveness of adsorption treatment of three dyes by activated carbon were confirmed by the Langmuir dimensionless separation factor. The mechanism was found to be a physical adsorption which can be verified through the adsorption heat calculated by Temkin equation. The adsorption kinetics followed the pseudo second order and the rate limiting step was intra-particle diffusion. The positive enthalpy and entropy changes showed an endothermic reaction and increased disorder via adsorption at the S-L interface, respectively. For each dye molecule, negative Gibbs free energy increased with the temperature, which means that the process is spontaneous. In the binary component system, it was found that the same functional groups of the dye could interfere with the mutual adsorption, and different functional groups did not significantly affect the adsorption. In the ternary component system, the adsorption for MG lowered a bit, likely to be disturbed by the other dyes meanwhile DR 81 and TS were to be positively affected by the presence of MG, thus resulting in much higher adsorption.

• Journal of Applied Biological Chemistry
• /
• v.65 no.2
• /
• pp.113-120
• /
• 2022

We examined the anti-inflammatory properties of Nostoc commune HCW0811 in lipopolysaccharide-stimulated RAW264.7 macrophage cells. The anti-inflammatory activity of HCW0811 on viability of treated cells was assessed by measuring the level of expression of NO, prostaglandin E₂ and pro-inflammatory cytokines, namely interleukin-1β, interleukin-6, and tumor necrosis factor-α in HCW0811 treated RAW 264.7 macrophages. HCW0811 was non-toxic to cells and inhibited the production of cytokines in a concentration-dependent manner. In addition its treatment suppressed the production of pro-inflammatory cytokines in a dose-dependent manner, and concomitantly decreased the protein expressions of inducible NO synthase and cyclooxygenase-2. Moreover, the levels of the phosphorylation of mitogen-activated protein kinase family proteins such as extracellular signal-regulated kinase, c-Jun N-terminal kinase, p38, and nuclear factor kappa B were reduced by HCW0811. These findings suggest that the HCW0811 collected from Daejeon National Cemetery have anti-inflammatory effects, and demonstrated its efficacy in cell-based in vitro assays.

• Applied Chemistry for Engineering
• /
• v.34 no.1
• /
• pp.36-44
• /
• 2023

Core-shell TiO₂/Ag nanoparticles were synthesized by a modified sol-gel process and the reverse micelle method using acetoxime as a reducing agent in water/dodecylbenzenesulfonic acid (DDBA)/cyclohexane. The structure, shape, and size of the TiO₂/Ag nanoparticles were investigated using X-ray diffraction (XRD), UV-visible spectroscopy, scanning electron microscope (SEM), transmission electron microscope (TEM), and thermogravimetric analysis (TGA). The size of TiO₂/Ag nanoparticles could be controlled by changing the [water]/[DDBA] molar ratio values. The size and the polydispersity of TiO₂/Ag nanoparticles increased when the [water]/[DDBA] molar ratio rose. The resultant Ag nanoparticles over the anatase crystal TiO₂ nanoparticles exhibited a strong surface plasmon resonance (SPR) peak at about 430 nm. The SPR peak shifted to the red side with the increase in nanoparticle size. Conductive pastes with 70 wt% TiO₂/Ag nanoparticles were prepared, and the pastes were coated on the PET films using a screen-printing method. The printed paste films of the TiO₂/Ag nanoparticles demonstrated greater surface resistance than conventional Ag paste in the range of 405~630 μΩ/sq.

• BMB Reports
• /
• v.55 no.2
• /
• pp.98-103
• /
• 2022

Increased mRNA levels of cancer upregulated gene (CUG)2 have been detected in many different tumor tissues using Affymetrix microarray. Oncogenic capability of the CUG2 gene has been further reported. However, the mechanism by which CUG2 overexpression promotes cancer stem cell (CSC)-like phenotypes remains unknown. With recent studies showing that pyruvate kinase muscle 2 (PKM2) is overexpressed in clinical tissues from gastric, lung, and cervical cancer patients, we hypothesized that PKM2 might play an important role in CSC-like phenotypes caused by CUG2 overexpression. The present study revealed that PKM2 protein levels and translocation of PKM2 into the nucleus were enhanced in CUG2-overexpressing lung carcinoma A549 and immortalized bronchial BEAS-2B cells than in control cells. Expression levels of c-Myc, CyclinD1, and PKM2 were increased in CUG2-overexpressing cells than in control cells. Furthermore, EGFR and ERK inhibitors as well as suppression of Yap1 and NEK2 expression reduced PKM2 protein levels. Interestingly, knockdown of β-catenin expression failed to reduce PKM2 protein levels. Furthermore, reduction of PKM2 expression with its siRNA hindered CSC-like phenotypes such as faster wound healing, aggressive transwell migration, and increased size/number of sphere formation. The introduction of mutant S37A PKM2-green fluorescence protein (GFP) into cells without ability to move to the nucleus did not confer CSC-like phenotypes, whereas forced expression of wild-type PKM2 promoted such phenotypes. Overall, CUG2-induced increase in the expression of nuclear PKM2 contributes to CSC-like phenotypes by upregulating c-Myc and CyclinD1 as a co-activator.