• 한국대기환경학회지
• /
• 제26권3호
• /
• pp.265-275
• /
• 2010

Mass and ion concentrations of $PM_{10}$ and $PM_{2.5}$ were measured in Yongin, downwind of the Seoul metropolitan area. Twenty-four hour average samples were collected daily for a month or so in spring and fall of both 2007 and 2008. Asian dust occurred twice in each period except in the fall of 2007. During the Asian dust period, nitrate in fine particles decreased since large amount of cations in coarse particles of Asian dust absorbed it. In spring 2008, sulfate as well as ammonium also increased in coarse particles. In spite of occasional Asian dust events, the influence of secondary formation was dominant over the period. Excessive ammonium over sulfate was enough to neutralize nitrate as well. High correlation coefficients between $K^+$ and sulfate, nitrate, and ammonium indicate a close relationship between secondary formation and biomass burning. Biomass burning and open burning are considered to be important sources of chloride.

• 한국환경과학회지
• /
• 제30권9호
• /
• pp.727-739
• /
• 2021

Measurements on mass size distribution of roadside aerosols were obtained in downtown Jeju City from July 2018 to May 2020 using an 8-stage cascade impactor sampler and the compositions of aerosols were analyzed. The mass size distribution of total aerosols was bimodal with aerosols existing in both the fine and coarse modes. The mass size distributions of Na⁺, Mg²⁺, Ca²⁺, Cl^-, NH₄⁺ and SO₄^2- were unimodal, whereas that of K⁺ was bimodal. For NO₃^-, the size distribution in winter and spring was bimodal with the peaks in both fine and coarse modes, whereas for summer and autumn the distribution was unimodal with a peak in the coarse mode. NH₄⁺ was found to co-exist with SO₄^2- in the fine mode with an average molar ratio of [NH₄⁺]/[SO₄^2-] equal to 2.05. Good correlation was observed between NO₃^- and NH₄⁺ in the fine mode particles in spring and winter. Based on the value of the marine enrichment factor for Cl^-, Mg²⁺, K⁺, Ca²⁺ and SO₄^2-, it may be inferred that a major part of the roadside aerosols in downtown Jeju City was largely contributed by terrigenous sources, although the influence of sea salt was normally present.

• 한국환경과학회지
• /
• 제8권2호
• /
• pp.183-187
• /
• 1999

The purpose of this study is providing basic data to control the air pollutants from solid waste incinerator. Incinerating the waste wood, the electrostatic precipitator had the best collection efficiency. The leather incineration had the same collection efficiency as synthetic resin incineration. And the coarse particle collection efficiency was high. As you know in correlation of leather incineration. pollutants produced a from incinerator are mostly fine particles. If the scrubber used only in the process produced a lot of fine particles. It is adequate to use the above control devices, together with high efficiency collector like bag-filter. To select the adequate control devices, it is required to investigate the size distribution before establishing control devices.

• 소성∙가공
• /
• 제31권5호
• /
• pp.253-260
• /
• 2022

In this study, the microstructural characteristics of a high-speed-extruded Mg-5Bi-3Al (BA53) alloy and its tensile, compressive, and high-cycle fatigue properties are investigated. The BA53 alloy is successfully extruded at a die-exit speed of 16.6 m/min without any hot cracking using a large-scale extruder for mass production. The homogenized BA53 billet has a large grain size of ~900 ㎛ and it contains fine and coarse Mg₃Bi₂ particles. The extruded BA53 alloy has a fully recrystallized microstructure with an average grain size of 33.8 ㎛ owing to the occurrence of complete dynamic recrystallization during high-speed extrusion. In addition, the extruded BA53 alloy contains numerous fine lath-type Mg₃Bi₂ particles, which are formed through static precipitation during air cooling after exiting the extrusion die. The extruded BA53 alloy has a high tensile yield strength of 175.1 MPa and ultimate tensile strength of 244.4 MPa, which are mainly attributed to the relative fine grain size and numerous fine particles. The compressive yield strength (93.4 MPa) of the extruded BA53 alloy is lower than its tensile yield strength, resulting in a tension-compression yield asymmetry of 0.53. High-cycle fatigue test results reveal that the extruded BA53 alloy has a fatigue strength of 110 MPa and fatigue cracks initiate at the surface of fatigue test specimens, indicating that the Mg₃Bi₂ particles do not act as fatigue crack initiation sites. Furthermore, the extruded BA53 alloy exhibits a higher fatigue ratio of 0.45 than other commercial extruded Mg-Al-Zn-based alloys.

• 한국분말재료학회지
• /
• 제24권5호
• /
• pp.384-388
• /
• 2017

The effect of the mixing method on the characteristics of hybrid-structure W powder with nano and micro sizes is investigated. Fine $WO_3$ powders with sizes of ${\sim}0.6{\mu}m$, prepared by ball milling for 10 h, are mixed with pure W powder with sizes of $12{\mu}m$ by various mixing process. In the case of simple mixing with ball-milled $WO_3$ and micro sized W powders, $WO_3$ particles are locally present in the form of agglomerates in the surface of large W powders, but in the case of ball milling, a relatively uniform distribution of $WO_3$ particles is exhibited. The microstructural observation reveals that the ball milled $WO_3$ powder, heat-treated at $750^{\circ}C$ for 1 h in a hydrogen atmosphere, is fine W particles of ~200 nm or less. The powder mixture prepared by simple mixing and hydrogen reduction exhibits the formation of coarse W particles with agglomeration of the micro sized W powder on the surface. Conversely, in the powder mixture fabricated by ball milling and hydrogen reduction, a uniform distribution of fine W particles forming nano-micro sized hybrid structure is observed.

• 한국환경과학회지
• /
• 제19권3호
• /
• pp.331-342
• /
• 2010

Aerosol physical properties have been measured at Pusan National University by using the 16-channel LPC(Laser Particle Counter), and particle characteristics have been examined for the period from Aug. 4 2007 to Dec. 30, 2008. Annual total average, seasonal average, and other averages of the meteorologically classified four categories such as Asian dust, precipitation, foggy, and clear days are respectively described here. Both annually and seasonally averaged number concentration show three peaks at the particle diameter of 0.3, 1.3, and $4{\mu}m$, respectively. However, the first peak for summer season tends to be shifted toward smaller size than other seasons, implying the strong fine particle generation. Meteorological condition shows strong contrast in aerosol concentrations. In Asian dust case, relatively lower number concentrations of fine particles (i.e., smaller than $0.5{\mu}m$) were predominant, while higher concentrations of coarse particles were found particularly for the size bigger than $0.5{\mu}m$. In precipitation day, number concentrations were decreased by approximately 30% due to the removal process of precipitation. Foggy day shows significantly higher concentrations for fine particles, implying the importance of the aerosol condensation process of micro-fine-particle growing to fine-particle. Finally the regressed particle size distribution function was fitted optimally with two log-normal distribution, and discussed the similarities and differences among four categorized cases of the Asian dust, precipitation, foggy, and clear days.

• 한국수산과학회지
• /
• 제37권4호
• /
• pp.323-329
• /
• 2004

In situ particle size and volume concentration of suspended sediment was measured at the mouth of Seomjin River Estuary In February 2001, using an optical instrument, 'LISST-100'. Time variation of in situ particle size and concentration shows: (1) during ebb tide, Seomjin River supplies relatively fine-grained particles with less-fluctuated, compared to during flood tide, and well-behaved concentrations following the tidal cycle; and (2) during flood tide, relatively coarse-grained particles with highly variable in size distribution and concentration flow upstream from Kwangyang Bay. This explains a poor correlation $(r^{2}=0.10)$ between sediment concentration and beam attenuation coefficient during flood and a high degree of correlation $(r^{2}=0.80)$ during ebb tide. Relatively fine grained and well defined, monotonous size distribution may promote the correlation between concentration and beam attenuation coefficient due to optical homogeneity of particles during ebb tide. Abundance of large aggregates with time-varying size and shape distributions may be mainly responsible for variations in optical properties of the sediment during flood tide, and thus may confound the relationship between the two variables. The difference in particle sizes and shapes between flood and ebb tides can also be observed on SEM images.

• 분석과학
• /
• 제17권3호
• /
• pp.230-239
• /
• 2004

2002년 겨울철 서울과 부산지역에서 채취한 PM2.5와 PM10 입자를 이용하여, 입자를 구성하는 주요 무기성 이온성분의 농도를 입경영역별로 비교하고, 이를 토대로 양 지역 입자의 조성경로와 관련된 여러 가지 화학적 특성을 비교분석하였다. 특히 이들 결과를 미세와 조대영역으로 구분할 경우, 상당히 뚜렷한 차이를 확인할 수 있었다. 인위적 오염원의 영향이 큰 서울지역의 경우, 미세입자의 절대농도가 조대입자 영역에 비해 약 3배 이상 높은 것으로 나타났다. 반면 부산지역의 경우, 큰 차이가 나타나지 않았다. 서울이나 부산지역 모두 미세영역에서는 $NH{_4}^+$, $NO{_3}^-$, NSSS와 같은 성분이 양적으로 절대적인 부분을 차지하는 것으로 나타났다. 반면 조대영역의 경우, 양지역 간에는 큰 차이가 뚜렷하게 보였다. 서울의 경우, $NH{_4}^+$, $Ca^{2+}$과 같은 양이온과 $NO{_3}^-$, NSSS와 같이 인위적인자의 영향을 반영하는 성분들이 중요한 것으로 나타났다. 반면, 부산의 경우, 음이온의 경우 $NO{_3}^-$의 양적인 기여도가 여전히 크게 나타났지만, 해양성 기원의 역할을 확인시켜 주는 $Cl^-$와 $Na^+$의 기여도가 절대적으로 중요한 것으로 나타났다. 이러한 입경영역별 조성의 특성은 여러 가지 통계적인 분석에서도 일관성있게 확인되었다.

• 약학회지
• /
• 제34권3호
• /
• pp.206-211
• /
• 1990

Total suspended particles were collected and size-fractionated by an Andersen high-volume air sampler at Chungang University located near the Han River, Seoul, Korea, during the period form March, 1986 to August, 1986 and from March, 1987 to February, 1988. The concentrations and the particle size distributions of anions such as chloride, nitrate and sulfate were determined by ion chromatography. The averages of concentrations were $125.43\;{\mu}g/m^3$ in 1986 and $189.19\;{\mu}g/m^3$ in 1987 for total suspended particles (TSP), $2.12\;{\mu}g/m^3$ in 1986 and $4.14\;{\mu}g/m^3$ in 1987 for chloride, $4.39\;{\mu}g/m^3$ in 1986 and $5.95\;{\mu}g/m^3$ in 1987 for nitrate and $11.98\;{\mu}g/m^3$ in 1986 and $19.29\;{\mu}g/m^3$ in 1987 for sulfate. Size distribution of TSP was found to be generally bimodal. Chloride exhibited a seasonal variation in the distribution; fine particles were predominant in the winter whereas the concentration of coarse ones was almost same through four seasons. Nitrate showed a distribution similar to that of chloride. Such variation was less significant for sulfate. For chloride and nitrate, the relationship between the monthly averaged distribution pattern and air temperature was analyzed in terms of fine fraction (FF). The FF decreased with increasing air temperature.

• 한국분말재료학회지
• /
• 제10권5호
• /
• pp.325-332
• /
• 2003

The effect of extrusion temperature on the microstructure and mechanical properties was studied in gas atomized TEX>$Al_{81}Si_{19}$ alloy powders and their extruded bars using SEM, tensile testing and wear testing. The Si particle size of He-gas atomized powder was about 200-800 nm. Each microstructure of the extruded bars with extrusion temperature (400, 450 and 50$0^{\circ}C$) showed a homogeneous distribution of primary Si and eutectic Si particles embedded in the Al matrix and the particle size varied from 0.1 to 5.5 ${\mu}m$. With increasing extrusion temperature from 40$0^{\circ}C$ to 50$0^{\circ}C$, the ultimate tensile strength (UTS) decreased from 282 to 236 ㎫ at 300 K and the specific wear increased at all sliding speeds due to the coarse microstructure. The fracture behavior of failure in tension testing and wear testing was also studied. The UTS of extrudate at 40$0^{\circ}C$ higher than that of 50$0^{\circ}C$ because more fine Si particles in Al matrix of extrudate at 40$0^{\circ}C$ prevented crack to propagate.