• Journal of the Semiconductor & Display Technology
• /
• v.14 no.2
• /
• pp.9-16
• /
• 2015

In this paper, selection criterions on selection diversity are researched. The diversity is applied to the multiple antenna system based on wireless access in vehicular environment (WAVE) standard for rapid varying channel. Least squares (LS) based decision feedback equalizer (DFE) are used for channel equalization. Received signal is regenerated by means of the decision feedback path. In the selection diversity, the regenerated signal as well as the received signal is selected according to selection criterion. The decision feedback algorithm can follow the fast speed of WAVE fading channel. To control the tracking speed of the time-varying channel, simple low pass filter is used. Finally, the estimated channel value recovers the distorted payloads. Signal power before automatic gain control (AGC) in analog stage can be used as a selection criterion. In the digital stage, signal power after AGC, noise power after AGC, signal to noise ratio after AGC and cross-correlation method can be used as selection criterions. According to the simulation results, the performance of the selection diversity is improved in comparison with that of the combining diversity for the WAVE fading channel.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.14 no.5
• /
• pp.385-393
• /
• 2004

This paper proposes a swing-arm type dual-stage actuator, which consists of a PZT actuator for fine motion and a VCM(voice coil motor) for coarse motion, for an SFF ODD(small form factor optical disk drive), in order to achieve fast access speed and precise track-following control. Over the past few decades there have been a lot of researches related to the VCM and dual-stage actuator. In this paper, we focus our attention on the design and control of the PZT actuator. Due to the dual cantilever structure. the PZT actuator can generate precise translational tracking motion at its tip to which an optical pickup is attached. and the effect of hysteric behavior of the PZT element is reduced. The dynamic model of the PZT actuator is derived by using the Hamilton's principle, and verified by comparing it with the experimental frequency response. The sliding mode control is designed in order to be robust against modeling uncertainties. Simulations and experimental results confirm the effectiveness of the suggested control scheme.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.33B no.1
• /
• pp.6-14
• /
• 1996

In this paper we present an algorithm to discriminate an underwater target under track against an acoustic counter-measure(ACM) source, based on a sequential hypothesis test. The ACM source is separated from the target under track and generates, while drifting, measurements with false range and Doppler information. The purpose of the ACM is to mislead the target-tracking and to help the true target evade a pursuer. The algorithm uses as a test statistic a function of the innovation sequences from extended Kalman filters to estimate the target dynamics and the drifting position of the ACM source. Numerical experiments on various scenarios show that the proposed algorithm discriminates the target against an ACM source very fast with a high probability of success.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.3
• /
• pp.331-338
• /
• 2016

In this paper, we propose a GRNN(: Generalized Regression Neural Network) algorithms for new eyes and face recognition identification system to solve the points that need corrective action in accordance with the existing problems of facial movements gaze upon it difficult to identify the user and. Using a Kalman filter structural information elements of a face feature to determine the authenticity of the face was estimated future location using the location information of the current head and the treatment time is relatively fast horizontal and vertical elements of the face using a histogram analysis the detected. And the light obtained by configuring the infrared illuminator pupil effects in real-time detection of the pupil, the pupil tracking was - to extract the text print vector.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2009.01a
• /
• pp.341-345
• /
• 2009

We present an augmented reality (AR) application for cell phone where users put a virtual pet on their palms and play/interact with the pet by moving their hands and fingers naturally. The application is fundamentally based on hand/palm pose recognition and finger motion estimation, which is the main concern in this paper. We propose a fast and efficient hand/palm pose recognition method which uses natural features (e.g. direction, width, contour shape of hand region) extracted from a hand image with prior knowledge for hand shape or geometry (e.g. its approximated shape when a palm is open, length ratio between palm width and pal height). We also propose a natural interaction method which recognizes natural motion of fingers such as opening/closing palm based on fingertip tracking. Based on the proposed methods, we developed and tested the AR application on an ultra-mobile PC (UMPC).

• Journal of Soil and Groundwater Environment
• /
• v.10 no.3
• /
• pp.24-31
• /
• 2005

This study presents a contaminant transport model suitable for a 2-dimensional heterogeneous aquifer with multiple contaminant sources. It uses a streamline simulation, which transforms a multi-dimensional problem into multiple 1dimensional problems. It runs flow simulation, streamline tracking, and calculation of contaminant concentrations by turns. The model is verificated with a Visual MODFLOW by comparing contaminant concentration distributions and breakthrough curves at an observation well. Due to its fast simulation, it can be applied to time consuming simulations such as in a fine-grided aquifer, an inverse modeling and other applications.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2003.11a
• /
• pp.424-429
• /
• 2003

This paper proposes a swing-arm type dual-stage actuator, which consists of a PZT actuator for fine motion and a VCM(Voice Coil Motor) for coarse motion, for SFF ODD(Small Form Factor Optical Disk Drive), in order to achieve fast access speed and precise track following control. We focus our attention on the design and control of the PZT actuator, because there have been a lot of previous researches related to the VCM and dual-stage actuators. Due to the dual cantilever structure, the PZT actuator can generate precise translational tracking motion at its tip where optical pickup is attached at, and the effect of hysteric behavior of the PZT element is reduced. The dynamic model of the PZT actuator is derived by using the Hamilton's principle, and verified by comparing with the experimental frequency response. The sliding mode control is designed in order to be robust against modeling uncertainties. Simulations and experimental results confirm the effectiveness of the suggested control scheme.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 1996.11a
• /
• pp.759-763
• /
• 1996

This paper presents a new approach to the design of neural control system using digital signal processors in order to improve the precision and robustness. Robotic manipulators have become increasingly important in the field of flexible automation. High speed and high-precision trajectory tracking are indispensable capabilities for their versatile application. The need to meet demanding control requirement in increasingly complex dynamical control systems under significant uncertainties, leads toward design of intelligent manipulation robots. The TMS320C31 is used in implementing real time neural control to provide an enhanced motion control for robotic manipulators. In this control scheme, the networks introduced are neural nets with dynamic neurons, whose dynamics are distributed over all the network nodes. The nets are trained by the distributed dynamic back propagation algorithm. The proposed neural network control scheme is simple in structure, fast in computation, and suitable for implementation of real-time control. Performance of the neural controller is illustrated by simulation and experimental results for a SCARA robot.

• Journal of the Korean Society of Manufacturing Technology Engineers
• /
• v.21 no.6
• /
• pp.878-884
• /
• 2012

In this paper, we consider the sway suppression control problem for container cranes with the frictions between the trolley and the rail. If the friction effects in the system can be modelled, there is an improved potential to design controllers that can cancel the effects. The proposed control improves the trolley positioning and sway suppressing against various frictions. The proposed synthesis combines a variable structure control and the adaptive control to cope with various frictions including the unknown constants. First, the variable structure control with the simple switching action is designed, which is based on a class of feedback lineariztion methods for the fast stabilization of the under-actuated sway dynamics of container. Second, the adaptive control with a parameter estimation is designed, which is based on Lyapunov stability methods for suppressing the oscillation of the trolley travelling, especially due to Coulomb friction in the vicinity of the target position. The asymptotic stability of the overall closed-loop system is assured irrespective of variations of rope length. Simulation are shown under initial sway, external wind disturbances, and various frictions.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.6 no.3
• /
• pp.835-854
• /
• 2012

In this paper, we propose a novel positioning system for indoor navigation which helps a user navigate easily to desired destinations in an unfamiliar indoor environment using his mobile phone. The system requires only the user's mobile phone with its basic equipped sensors such as a camera and a compass. The system tracks user's positions and orientations using a vision-based approach that utilizes $360^{\circ}$ panoramic images captured in the environment. To improve the robustness of the vision-based method, we exploit a digital compass that is widely installed on modern mobile phones. This hybrid solution outperforms existing mobile phone positioning methods by reducing the error of position estimation to around 0.7 meters. In addition, to enable the proposed system working independently on mobile phone without the requirement of additional hardware or external infrastructure, we employ a modified version of a fast and robust feature matching scheme using Histogrammed Intensity Patch. The experiments show that the proposed positioning system achieves good performance while running on a mobile phone with a responding time of around 1 second.