• Korean Journal of Organic Agriculture
• /
• v.20 no.3
• /
• pp.399-409
• /
• 2012

Effects of pretreatment and extraction conditions on total polyphenol yield from licorice root were investigated using statistical method. For pretreatment, heat treatment at $121^{\circ}C$ for 10 min was applied. Licorice root content in solvent (10, 20, and 30%) ethanol concentration (20, 40, and 60%) and reaction time (1, 2, and 3 h) were used as variables for extraction conditions. Two experiments, with heat treated and no treated licorice, were prepared with same experimental design. Box behnken design was employed and produced a total of 15 trials. Total polyphenol yield from licorice root was not affected by heat treatment. Among variables, licorice content in solvent showed most significant effect regardless of other variables (p<0.05). Finally, optimum conditions for the extraction of total polyphenol from licorice root was detected as following: 10% of licorice in solvent, 52% ethanol as solvent, 2 h of reaction time and non-heat treatment and the extraction yield from optimized condition was 17.6 mg/g licorice root.

• Applied Chemistry for Engineering
• /
• v.8 no.6
• /
• pp.967-972
• /
• 1997

Recovery of aromatics in extract phase which was obtained by batch equilibrium extraction between light cycle oil(LCO) and dimethylsulfoxide(DMSO) solution as solvent was investigated by re-extraction. To select the most suitable re-extraction solvent for recovery of aromatics in extract phase, distribution equilibrium was measured between extract phase and solvents. The solvents used were benzene(B), toluene(T), m-Xylene(mX), n-hexane(Hx) and n-hexane(Hx) and n-Octane(Ot). From the distribution coefficients and yields of aromatics, Hx seemed to be the most suitable. Furthermore, effects of operation parameters for re-extraction of aromatics in the extract phase were studied by batch equilibrium re-extracion with Hx as solvent. Yields of aromatics were found to increase with increasing solvent/feed (extract phase) mass ratio(S/F), while distribution coefficients of aromatics were fixed irrespective of S/F used. Operating temperature did not affect distribution coefficients and yields of aromatics. Distibution coefficients and yields of naphthalene group(carbon numer : 10~12) increased with increasing cabon number. Mass transfer rates of aromatics were also measured with a batch stirred vessel.

• Food Science and Preservation
• /
• v.8 no.4
• /
• pp.456-461
• /
• 2001

To develop the use of natural pigment for food, carotenoids from wasted persimmon peel were extracted with seven organic solvents. Among the solvents, acetone was a high yielding solvent of carotenoids. Extraction trends depending on process variables(temperature, time, solvent ratio to persimmon peel) were explained through response surface which was made by central composite experimental design. Carotenoid contents were increased with the extraction time and solvent ratio but it decreaed in the higher experimental design. Carotenoid contents were increased with the extraction time and solvent ratio but it decreased in the higher extraction temperature. The optimum conditions of extraction process variables were predicted as 29$\^{C}$, 93min. at fixed solvent ratio(1:27).

• Bulletin of the Korean Chemical Society
• /
• v.27 no.4
• /
• pp.563-567
• /
• 2006

The application of a synergistic solvent extraction by the formation of ternary complex with pyrocatechol violet (PV) and benzalkonium chloride (BC) was studied for determination of trace Zn(II) in water samples. The pH of sample solution and the amount of PV and BC added were optimized for the formation of the stable complex, a proper solvent was selected for the effective extraction, and the concentration of nitric acid was fixed for the back extraction of the complex from the solvent. After the ionic strength of 100 mL sample solution was adjusted to 0.1 M by adding NaCl and the pH was fixed at 9 with a carbonate buffer, 1.0 mL of 2% PV solution was added to form Zn(II)-PV complex then the Zn(II)-PV/BC ternary complex was made by adding 1.0 mL of 10% BC solution. The ternary complex was extracted into 10 mL of MIBK. And the ternary complex was back-extracted with 10 mL of 1.0 mol/L nitric acid to determine Zn(II) by a flame atomic absorption spectrophotometer (flame-AAS). The interference of concomitant ions on the extraction of Zn(II) was investigated. This procedure was applied to the analysis of three real samples such as Dalbang-dam water, laboratory tap water and Jungnajin seawater. The recoveries of Zn(II) in spiked samples were 86.58-104.1%.

• Journal of Environmental Health Sciences
• /
• v.25 no.3
• /
• pp.103-107
• /
• 1999

Even if odorous compounds remain very low concentration in water, it cause strong odor. Because Geosmin and most of odorous compound had very low vaporization, those were difficult to analyze with GC/MSD and Purge & Trap. So, we needed pre-treatment method for decreasing amounts of extracting solvents, improving recovery efficiencies and increasing analytical efficiencies. This study developed efficient technology for analyzing odorous compounds, using various adsorbents and extracting solvents. The optimum adsorbent was XAD resins. Especially, XAD-2, XAD-7 and XAD-2010 were superior, but XAD-2 of these and the optimum extraction solvent is MTBE. Other extraction solvents' efficiency is in order of MTBE>Dichloromethane>n-Hexane>Diethylether. The optimum NaCl dosage for increasing efficiency is 5 g in liquid-liquid extraction method. The shaking time(0~24hr) has no concern with adsorption efficiency. The optimum adsorbent is XAD-2 resin and extraction solvent is MTBE. Dosing NaCl, adsorption efficiency is increased in liquid-liquid extraction method, but NaCl has no effect on liquid-solid extraction method. In this experimental results, this algae toxins(Mycrocystin, Anatoxin etc.).

• Bulletin of the Korean Chemical Society
• /
• v.24 no.10
• /
• pp.1495-1500
• /
• 2003

Equilibria and applications of a synergistic extraction were studied for the determination of a trace lithium by using thenoyltrifluoroacetone (TTA) and trioctylphosphine oxide (TOPO) as ligands. Several equations were derived for the extraction of lithium into m-xylene as a phase of Li-TTA·mTOPO adduct. Distribution coefficients and extraction constant were determined together with a stability constant of the adduct. The adduct was quantitatively extracted from the basic solution of higher than pH 9 by shaking for 30 minutes. m-Xylene was selected as an optimum solvent by comparing the extraction efficiency among several kinds of organic solvents. The stability constant (${\Beta}_2$) for Li-TTA/2TOPO was 150 times higher than Li-TTA/TOPO. The distribution coefficient of Li-TTA/2TOPO into m-xylene was 9.12 and the logarithmic extraction constant (log $K_{ex}$) was 6.76. Trace lithium of sub-ppm level in seawater samples could be determined under modified conditions and a detection limit equivalent to 3 times standard deviation for background absorption was 0.42 ng/mL.

• Journal of Industrial Technology
• /
• v.27 no.B
• /
• pp.161-167
• /
• 2007

The objetives of this study are to set up optimum extraction temperature, time and organic solvent for propolis extraction, to investigate chemical properties, and to develop health foods from propolis preparation. In this study, ethanol and ultrasonic extracts method performed to optimum extraction temperature was at 60, $20^{\circ}C$, optimum extraction time was at 12, 4 hours and optimum extraction amount of solvent was at 20, 15 times of propolis weight. When various ethanol solutions were used, whereas flavonoid content was highest in 70, 80% aqueous ethanol, respectively. So the ultrasonic extracts method used gave better results than the ethanol extracts method in this work. Extraction of propolis with etanol and ultrasonic extracts method was performed by using the water and various concentrations of aqueous ethanol as solvent. Sensitivity of propolis samples to Staphylococcus aureus was investigated and the results were shown. Samples of water extract did not inhibit microbial growth, where as 50% aqueous ethanol extract the largest inhibitory zone for Staphylococcus aureus, then decreased inhibition with increasing ethanol concentrations.

• Analytical Science and Technology
• /
• v.34 no.4
• /
• pp.153-159
• /
• 2021

In this study, we describe the development of a new high-performance liquid chromatography (HPLC) method for the simultaneous analysis of six bioactive compounds (including gallic acid, epicatechin 3-gallate, quercitrin, afzelin, quercetin, and kaempferol) from Orostachys japonicus. The extraction method was investigated and optimization of the extraction time (min), solvent composition (%), and solvent to material ratio were conducted. As a result, 30 min extraction with 50% methanol and 40:1 mL/g of solvent: material ratio achieved the highest extraction efficiency with a yield of 3.32 mg/g. Furthermore, the developed HPLC method was validated and the correlation coefficient (R) values were within the satisfactory range of 0.9995-0.9999 over the linearity range of 1.53-417 ㎍/mL. The limit of detection and limit of quantification for the six active components were between 0.03-0.08 ㎍/mL and 0.08-0.26 ㎍/mL, respectively. With these newly optimized and developed methods, four batches of O. japonicus were analyzed to confirm the high extraction efficiency of the method and the feasibility of an application.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.9
• /
• pp.2711-2716
• /
• 2014

The high content of potassium in molasses limits its usage as a raw material for stock feed. Moreover, its high viscosity makes it difficult to develop an efficient removal process. In this study, ion exchange and solvent extraction experiments have been performed to investigate the removal of potassium from a mixture of molasses with water. Cationic exchange resins (AG50W-X8 and Diphonix) showed a high loading percentage of potassium but the occurrence of breakthrough in few bed volumes was a drawback to the industrial application. Among the cationic extractants (D2EHPA, PC 88A, Cyanex 272) tested in this study, saponified PC 88A was found to be the best extractant for the removal of potassium. Batch simulation studies on a three stage counter current extraction confirmed that 85% of potassium was removed from 50 wt % molasses solution in water by using saponifed PC 88A.

• Applied Chemistry for Engineering
• /
• v.26 no.2
• /
• pp.234-238
• /
• 2015

The separation of nitrogen heterocyclic compound (NHC) contained in a model coal tar fraction was compared by the methanol and formamide extraction. The model coal tar fraction comprising four kinds of NHC (NHCs : quinoline, iso-quinoline, indole, quinaldine) and three kinds of bicyclic aromatic compound (BACs : 1-methylnaphthalene, 2-methylnaphthalene, dimethylnaphthalene), biphenyl and phenyl ether was used as a raw material. The aqueous solution of methanol and formamide were used as solvents. A batch-stirred tank was used as the raw material - a solvent contact unit of this work. Independent of the solvent used, the distribution coefficient of NHCs sharply increased by decreasing the initial volume ratio of water to the solvent and increasing the equilibrium operation temperature, whereas, the selectivity of NHCs in reference to BACs decreased. Decreasing the initial volume ratio of solvent to feed resulted in deteriorating distribution coefficients, but the selectivity of NHCs in reference to BAC was almost the constant. The distribution coefficient of NHCs by the methanol extraction was 3~5 times higher than that of NHCs by the formamide extraction, inversely, the selectivity of NHCs based on BACs by the formamide extraction was 3~7 times higher than that of NHCs by the methanol extraction. Furthermore, two different solvent extraction methods by adding the extraction processing speed to the balance between solvency and selectivity of NHCs were compared.