• Journal of KIISE:Information Networking
• /
• v.34 no.1
• /
• pp.62-72
• /
• 2007

Mobile Virtual Private Network (MVPN) provides VPN services without geographical restriction to mobile workers using mobile devices. Coexistence of Mobile IP (MIP) protocol for mobility and IPsec-based VPN technology are necessary in order to provide continuous VPN service to mobile users. However, Problems like registration failure or frequent IPsec tunnel re-negotiation occur when IPsec-based VPN Gateway (GW) and MIP are used together. In order to solve these problems, IETF proposes a mechanism which uses external home agent (x-HA) located external to the corporate VPN GW. In addition, based on the IETF proposal, a mechanism that assigns x-HA dynamically in the networks where MN is currently located was also proposed with the purpose to reduce handover latency as well as end-to-end delay. However, this mechanism has problems such as exposure of a session key for dynamic Mobility Security Association (MSA) or a long latency in case of the handover between different networks. In this paper, we propose a new MVPN protocol in order to minimize handover latency, enhance the security in key exchange, and to reduce data losses cause by handover. Through a course of simulation, the performance of proposed protocol is compared with the existing mechanism.

• Tunnel and Underground Space
• /
• v.26 no.4
• /
• pp.304-315
• /
• 2016

In this study, the current horizontal stress characteristics of the Tertiary rock formations in the Pohang Basin are investigated on the basis of the in-situ rock stress measurements at depths from 75 m to 716 m of the 3 test boreholes in the Doumsan area, Pohang. The deep hydraulic fracturing stress measurement results indicated that the horizontal stress components in the test site appear far lower than the average ones by the linear fit for the data set measured from the other domestic sites. But, borehole scanning revealed clearly that lots of small and large scale borehole failures occurred due to the low strength characteristics of the existing rocks. To obtain more accurate and overall information on the horizontal stress direction, the integrated analysis combining the hydraulic fracturing stress measurement and borehole scanning data set were additionally carried out. The analysis results showed that in the upper sedimentary and the lower volcanic rock formation, the dominant orientations of the current maximum horizontal stress components were appeared in the range of $80^{\circ}{\sim}100^{\circ}$ (N80E~N80W) and $120^{\circ}{\sim}140^{\circ}$ (N60W~N40W), respectively. From this study result it was found that the maximum horizontal stress directions have a tendency to rotate in a clockwise direction as the rock formation changes with depth in the test site.

• Tunnel and Underground Space
• /
• v.26 no.5
• /
• pp.396-408
• /
• 2016

Rock fracture mechanics has been widely applied to various fields of rock and civil engineering. But most researches covered mode I behavior, though mode II behavior is dominant in rock engineering. Until now, there is only one ISRM suggested method for mode II toughness of rock. A new SCC (Short Core in Compression) mode II toughness test method was developed considering 1) application of confining pressure, 2) easiness of notch creation, 3) utilization of existing equipment, 4) simple test procedure. The stress intensity factors were determined by 3D finite element method considering line and distributed loading conditions. The tests with granite specimens were carried out using MTS 815 rock test system with a loading rate of 0.002 mm/s. The mean value of mode II fracture toughness of granite showed $2.33MPa{\sqrt{m}}$. Mode I toughness of the same granite was $1.12MPa{\sqrt{m}}$, determined by Brazilian disk test and $K_{IIC}/K_{IC}=2.08$. The smooth fracture surface with rock powder formation also supported mode II behavior of SCC method. The SCC method can be used for the determination of mode II fracture toughness of rocks based on the current results.

• Korean Journal of Human Ecology
• /
• v.17 no.4
• /
• pp.661-677
• /
• 2008

The purpose of this study is to develop the playground environment model for child care center by analyzing user needs of playground environment. To systemize the playground environment design factors and guidelines, we reviewed the previous research, actual measurement and observation were used as the research methodology. And to recognize the needs of users, the survey and picture survey was conducted to the staffs and children. The scope of survey included child care centers in Seoul and Daejeon, ultimately selecting 12 places in Seoul and 13 places in Daejeon. In terms of the survey period, actual measurement was conducted from June of 2006 to February of 2007, survey and picture survey was conducted from August to September of 2006. For analysis, we used SPSS 10.0 to check the frequency and percentage, as well as to perform cluster analysis. The findings of research can be summarized as below: 1. In playground environment, we observed the area of play ground and ground cover, the independence of play area, play equipment, and the composition of play area. The result of observation showed that while playground area varied widely, ground cover, play equipment, and the composition of play area turned out to be identical, regardless of the playground's area. Therefore, in order to classify various playground environments, we categorized them into 5 types, using the number of children and the area of play ground as a category. Type A had large facilities and small playground area. Type B had small sized facilities and large playground area. Type C had medium sized facilities and small playground area. Type D had medium sized facilities but large playground area. Type E had large sized facilities and large playground area. 2. On the other hand, staffs wanted a tunnel, playhouse, comprehensive play equipment, and a maze to be installed as play facilities, and there were requests for adventure play area and carpenter play area. The picture survey to children showed that they wanted equipments that can provide more thrill, adventure and challenge to them than the ones they see now. Therefore, existing child care center play environments must change from the monotonous and identical environments to the ones that can provide diversities, challenges, and adventures. In the contexts of 5 playground types suggested by this research, type B and D, E where the area of playground were larger than the legally required, should include various play areas and install appropriate play equipments and facilities. Type A and C where the area were small, should provide multipurpose play area to attract the various play behaviors of children.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.17 no.3
• /
• pp.353-362
• /
• 2015

Platform screen door (PSD) installed at underground subway station has reduced the safety accident, but it may cause poor air ventilation condition due to the isolated exhaust duct in the subway tunnel area. In this study, the additional ventilation system was suggested, which can be installed at a void space (i.e., storage room under stairs) of platform in order to improve efficiency of air ventilation rate. Exhausted air from platform was directed to underneath of platform and joined with existing ventilation duct of train exhaust system (TES). One subway station in Seoul city was selected to predict the effectiveness of the suggested lower exhaust system by using the computational fluid dynamics (CFD) analysis. The predicted mean age of air was decreased by 16.5% which proves the improvement of air ventilation efficiency when the suggested lower exhaust system was applied.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.21 no.6
• /
• pp.849-860
• /
• 2019

This paper is a study on the development of equipment system to obtain data on stability in excavation of sharp curve section of Shield TBM. Shield TBM equipment is being used a lot recently for tunnel excavation. Excavation may result in inevitable detours by buildings above the ground or existing underground structures. Preconstruction simulation is required to verify the stability of the construction in case of this. Therefore, it is necessary to establish an automated control system through the development of this equipment system and conduct simulation through simulation of excavation model in the sharp curve section. A system shall be developed to control the left and right angles and thrust of the equipment, and to view data on the earth pressure and propulsion pressure of the equipment in real time during excavation. With this system, the necessary data can be collected for field testing through excavation method and excavation simulation by angle. It is expected that it will be very useful in assessing the actual Shield TBM by conducting a scale-down model experiment.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.18 no.2
• /
• pp.155-164
• /
• 2016

The changes in earth pressure and ground settlement due to the underground excavation nearby the existing retaining wall according to the separation distance between underground excavation and retaining wall, were studied experimentally. A soil tank having 160 cm in length and 120 cm in height, was manufactured to simulate the underground excavation like tunnel by using 5 separated bottom walls. The variation of earth pressure was measured according to the excavation stages by using 10 separated right walls simulating the retaining wall. The results showed that the earth pressure was changed by the lowering of first bottom wall(B1), however the earth pressure was not changed significantly by the lowering of third bottom wall(B3) since B3 had sufficient separation distance from retaining wall. Lowering of first bottom wall(B1) induced the decrease of earth pressure in lower part of retaining wall, on the contrary, lowering of first bottom wall(B1) induced the increase of earth pressure in middle part of retaining wall proving the arching effect.

• Journal of the Korean GEO-environmental Society
• /
• v.15 no.11
• /
• pp.67-75
• /
• 2014

In this study, the staged seismic performance evaluations were conducted to the 91 high speed railway tunnels in use for checking whether to comply with the recent design criteria or not. In addition, the seismic fragility functions of the tunnels were developed to allow the probabilistic risk assessment. The results of the staged seismic performance evaluations which consist of a preliminary assessment and a detailed assessment, show that the tunnels comply with the recent design criteria. With reference to the results of previous studies, a form of the proposed seismic fragility functions was set as a log-normal distribution by PGA, and the parameters of the functions were determined by using the probability of damage for the design PGA level. The seismic fragility functions were developed for each types (Cut & Cover, NATM) of tunnels. The seismic fragility functions from this study and the existing research results (FEMA, 2004) were compared to evaluate the seismic performance level of the tunnels, as a result the tunnels of this study were relatively superior to the ASSM tunnels on the seismic performance.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.10
• /
• pp.169-177
• /
• 2007

Existing wireless access (mobile) routers are based commonly on the network address and port translation (NAPT) technique which permits simultaneously sharing a subscriber's connection to the network with multiple users. However, the NAPT architecturally makes the users invisible on the network side, thus becoming a user-oriented connection technique. In this paper, we propose a novel service provider-oriented unlicensed nomadic access relay station (WiNNERS) for helping wireless broadband network service providers to make their business more lucrative by accommdating unlicensed band users as subscribers into their network. The WiNNERS offers service providers the capability to directly manage each of the unlicensed band users at the network side. This direct management allows the service providers to flexibly and simply handle QoS, access control, and billing for each user. In order to distinguish each of the unlicensed band users the WiNNERS constructs a virtual tunnel from each user's terminal to the network access router using connection identifiers which is defined for service flow management within the WiBro system, Consequently, our proposed service provider-oriented relay station can be included into the WiBro network system with minimum modifications.

• Tunnel and Underground Space
• /
• v.16 no.2 s.61
• /
• pp.179-188
• /
• 2006

The vibration or/and noise generated by blast operations might cause not only structural damage to properties but mentally also to humans and animals. For that reason, maximum permitted vibration and noise levels are set by sensitivities of structures and they are used for the management of blast vibration. It is known that the fish lived in water are more sensitive to vibration than land animals, and thus the adverse impact of the blasting on fish farms should be very concerned. This study investigated the vibration and noise levels at a large eel farm located some 840 meters of the blasting site through the large real-scale experiments of blastings, prior to conducting the actual blasting. As a result, it was found that the noise met the requirement to be within maximum permitted level, while the ground vibration exceeded the permitted vibration. Accordingly, the impact of the excess vibration was investigated by an existing empirical method and verified by a new three dimensional numerical analysis. In this study, such an inspection process was briefly described, and a method was suggested for the examination of possible adverse effects from blasting on vibration-sensitive structures like the eel farm. The study also introduced a design method that controls the blast effects - ground vibration and noise.