• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.6 no.1
• /
• pp.35-44
• /
• 2008

Long-term degradation of coment barrier by diffusion was studied with reactive transport modeling. The result of modeling showed that cement barrier was altered about 30cm thickness after 50,000 years. The pH decreased from 13.0 to 11.9 because of depletion of alkali ions, and dissolution/precipitation of portlandite and CSH (Calcium Silicate Hydrate). In addition, porosity increased about 0.3 because of dissolution of portlandite and $CSH2.0(Ca_2SiO_3(OH)_2:0.17H_2O)$. The solubility of uranium also increased with the increase of pe value The results of this study indicate that long-term degradation of comet can enhance the transport of nuclide by changing pH, pe, porosity in barrier.

• Solar Energy
• /
• v.13 no.2_3
• /
• pp.151-156
• /
• 1993

The comparison of solar energy technologies with conventional technologies involves more than just comparing the costs of supplying energy and provding capacity. Solar technologies supply energy in a sustainable manner while having minimal effects on the environment. When choosing between solar energy technologies and conventional technologies, first cost is a important factor. The environmental and other social benifits of using solar energy technologies contrasts sharply with the environmental degradation and social costs resulting from the use of conventional technologies. These hidden costs, sometimes called "social cost", are not included in conventional economics. This paper is emphasized that the consideration of social costs effects comparisons between renewable and conventional energy technologies is of importance.

• Journal of Korean Society of Water and Wastewater
• /
• v.12 no.1
• /
• pp.96-101
• /
• 1998

Substrate inhibition of 2,4-dinitrophenol (DNP) degradation was investigated using activated sludge which had been adapted to mineralize DNP. DNP is a metabolic uncoupler, preventing cells from making energy for growth and it has been suggested that pH may be important in mitigating effects of uncouplers. After acclimation of the activated sludge, the effect of pH on toxicity of DNP at high concentration (75 mg/L) was investigated, over a pH range of 5 to 9. DNP inhibition was found to be strongly dependent on mixed liquor pH. The DNP degradation rate was highest in the pH range of 6.95 to 7.84; at pH 5.94 degradation of 75 mg/L DNP was significantly inhibited; at pH < 5.77, DNP degradation was completely inhibited after approximately 30% of the DNP was degraded. By comparison, no significant effect of pH variation in the same range was seen on glucose uptake by the activated sludge culture.

• IE interfaces
• /
• v.12 no.3
• /
• pp.448-457
• /
• 1999

Accelerated degradation is concerned with models and data analyses for degradation of product performance over time at overstress and design conditions. Although there have been numerous studies with accelerated degradation theory in reliability, very few actually apply to parametric statistical analyses. This paper shows how to analyze degradation data, provides tests for how well the assumptions hold. Reel sensors, a sort of photointerrupters in home VCR, hive been tested, and least-square analyses are used to illustrate our approach. Tests for linearity of the performance-time relationship, dependence of the lognormal distribution, and the standard deviation on time are performed. The mean life of tested sensors is assessed at about 414,000 hours, and the Arrhenius activation energy of this reaction is concluded to be 0.39 eV as results.

• Journal of Environmental Science International
• /
• v.11 no.12
• /
• pp.1315-1320
• /
• 2002

Since the enzymatic degradation of microbial poly[(R)-3-hydroxybutyrate-co-3-hydroxyvalerate] (P(3HB-co-3HV)) initially occurs by a surface erosion process, a degradation behavior could be controlled by the change of surface property. In order to control the rate of enzymatic degradation, plasma gas discharge and blending techniques were used to modify the surface of microbial P(3HB-co-3HV). The surface hydrophobic property of P(3HB-co-3HV) film was introduced by CF$_3$H plasma exposure. Also, the addition of small amount of polystyrene as a non-degradable polymer with lower surface energy to P(3HB-co-3HV) has been studied. The enzymatic degradation was carried out at 37 $^{\circ}C$ in 0.1 M potassium phosphate buffer (pH 7.4) in the presence of an extracellular PHB depolymerase purified from Alcaligenes facalis T1. Both results showed the significant retardation of enzymatic erosion due to the hydrophobicity and the enzyme inactivity of the fluorinated- and PS-enriched surface layers.

• Journal of the Korean Chemical Society
• /
• v.8 no.2
• /
• pp.43-46
• /
• 1964

Quenching constants, q, determined for N,N-dimethylanilines by liquid scintillation counting indicate that the quenching involves an energy transfer process to these compounds causing strong n-${\pi}$ interaction within the quencher molecule, which is then followed by an non-radiative degradation of the excitation energy to ground state.

• Journal of Soil and Groundwater Environment
• /
• v.20 no.6
• /
• pp.95-102
• /
• 2015

The purpose of this study is to compare the degradation characteristics by subcritical water of RDX contaminated soil using batch mode and dynamic mode devices. First, upon application of RDX contaminated soil, RDX treatment efficiency was increased with increasing the temperature in both modes. At 150℃, the treatment efficiency was 99.9%. RDX degradation efficiency got higher with lower ratio of solid to liquid. However, the treatment efficiency in the dynamic mode tended to be decreased at a certain ratio of solid to liquid or lower. The treatment efficiency was increased when it took longer time for the reactions in both modes. As the results of analysis on concentration of treated water after subcritical water degradation, the RDX recovery rate of dynamic and batch modes at 150℃ was 10.5% and 1.5%, respectively. However, both modes showed very similar recovery rates at 175℃ or higher. RDX degradation products were analyzed in treated water after it was treated with subcritical water. According to the results, RDX degradation mechanism was mostly oxidation reaction and reduction reaction was partially involved. Therefore, it suggested that most of RDX in soil was degraded by oxidation of subcritical water upon extraction. According to this result, it was found that both batch and dynamic modes were very effectively applied in the treatment of explosive contaminated soil.

• Journal of Conservation Science
• /
• v.31 no.2
• /
• pp.87-94
• /
• 2015

Plastic artwork can be appeared crack, change of color and whitening event by various environment conditions. A large scale plastic artwork often exhibits in outside it will be directly degraded by physical and chemical degradation factor such as strong sunlight, high humidity and rainfall. We should know degradation characteristic of plastics to prevent these damages. In this study, we studied degradation characteristic of plastics (5 types of wide use plastics; polypropylene, polystyrene, polyethylene, polyvinyl chloride, polyurethane) depending on various artificial degradation conditions such as high temperature, ultraviolet and these complex conditions (high temperature and ultraviolet). As a result, polypropylene, polystyrene and polyethylene show the most visible change especially polypropylene, polystyrene. Polypropylene didn't show a great change degree of tensile strength and contact angle, on the other hand polystyrene did. Polypropylene and polystyrene weakened by photo degradation, polyvinyl chloride and polyurethane had relatively good light stability. Also the high temperature and complex conditions were most degradation characteristic. High temperature worked for degradation catalyst because its energy can not enough worked for cut off binding energy of plastics while ultraviolet condition effected as directly degradation condition. Though following results, we expect it can be applied to investigation of degradation factor depending on plastic artwork materials and basic result of plastic artworks conservation.

• 한국신재생에너지학회:학술대회논문집
• /
• 2009.11a
• /
• pp.132-132
• /
• 2009

To achieve the commercialization of PEM fuel cell, the durability problem must be solved. Recently, many researchers have focused on this durability problem and degradation studies about membrane and electrode have been reported. But durability characteristics of gas diffusion layer is not much reported yet. Durability of GDL is very important to maintain the performance of PEM fuel cell because the main function of GDL is a path of fuel and water and the GDL degradation causes the loss of the GDL function. In this study, the degradation of GDL, especially, the mechanical degradation process was investigated with the leaching test. The effect of water dissolution was observed through the test and the amount of GDL degradation was measured with various measurement methods such as weight measurement, static contact angle measurement, scanning electron microscope. After 2,000 hours test, the GDL showed structural damage and loss of hydrophobicity.

• Current Photovoltaic Research
• /
• v.4 no.2
• /
• pp.68-79
• /
• 2016

The power conversion efficiency of perovskite solar cells has remarkably increased from 3.81% to 22.1% in the past 6 years. Perovskite solar cells, which are based on the perovskite crystal structure, are fabricated using organic-inorganic hybrid materials. The advantages of these solar cells are their low cost and simple fabrication procedure. Also, they have a band gap of about 1.6 eV and effectively absorb light in the visible region. For the commercialization of perovskite solar cells in the field of photovoltaics, the issue of their long term stability cannot be overlooked. Although the development of perovskite solar cells is unprecedented, their main drawback is the degradation of the perovskite structure by moisture. This degradation is accelerated by exposure to UV light, temperature, and external bias. This paper reviews the aforesaid reasons for perovskite solar cell degradation. We also discuss the research directions that can lead to the development of perovskite solar cells with high stability.