• 한국연소학회:학술대회논문집
• /
• 대한연소학회 2003년도 제27회 KOSCO SYMPOSIUM 논문집
• /
• pp.257-262
• /
• 2003

Engine-out HC emissions were investigated during engine start. The tests were conducted on a 1.5L, 4-cylinder, 16 valve, multipoint-port-fuel-injection gasoline engine at different coolant temperatures and fuel injection-skip methods; no skip, 1 cycle-skip and 3 cycle-skip. To understand the characteristics of engine-out HC emissions, HC concentration was measured at a exhaust port using a Fast Response Flame Ionization Detector (FRFID). The result show that HC emissions were emitted at the cold coolant temperature much higher than those of the hot coolant. In additions, the fuel injection skip highly reduced engine-out HC emissions. It is convinced that optimized fuel injection skips according to coolant temperatures could be applied to reduce HC emissions during SI engine start.

• 한국자동차공학회논문집
• /
• 제10권2호
• /
• pp.73-79
• /
• 2002

The NO emissions at the exhaust manifo1d were investigated with a fast NO analyzer to investigate the cycle-by-cycle variations on NO emissions level and the dependence of NO emissions on combustion. The measurement was performed with a part load condition with respect to the mixture ratios and the changes in loads at 1800rpm. The averaged values were obtained during 200 cycles. We found that there is characteristic pattern in 70 emissions from exhaust port and it was possible to set a representative value with the data sampled during specific period. As the load increased, the characteristics of NO emissions were more dependent on combustion pressures. It was also analyzed that the correlation between combustion pressures and NO emissions for different equivalence ratios tends to increase as the mixture goes leaner, Furthermore, this correlation for the lean mixture near the lean limit seemed to be kept.

• 한국자동차공학회논문집
• /
• 제12권6호
• /
• pp.9-15
• /
• 2004

The characteristics of combustion and emissions were investigated in a single cylinder DI diesel engine equipped with a common rail injection system. This study presents an experimental study of the effect of engine speed, injection timing, injection pressure and pilot injection timing on the combustion and exhaust emissions. The engine speeds were 1000 and 2000rpm and the corresponding injection pressures were 50 and 100MPa. Experimental results show that NOx emissions decrease with retarded injection timing, while HC and CO emissions increases. Higher injection pressure increases NOx with lower soot emissions. For the case with the pilot injection prior to main injection, the ignition delay is shortened and the premixed combustion ratio decreases. Also NOx and soot emissions are decreased with increase of pilot injection advance.

• Environmental Engineering Research
• /
• 제21권1호
• /
• pp.74-83
• /
• 2016

The purpose of this study is to identify the driven factors affecting the changes in energy-related $CO_2$ emissions in Hebei Province of China from 1995 to 2013. This study confirmed that energy-related $CO_2$ emissions are correlated with the population, urbanization level, economic development degree, industry structure, foreign trade degree, technology level and energy proportion through an improved STIRPAT model. A reasonable and more reliable outcome of STIRPAT model can be obtained with the introducing of the Ridge Regression, which shows that population is the most important factor for $CO_2$ emissions in Hebei with the coefficient 2.4528. Rely on these discussions about affect abilities of each driven factors, we conclude several proposals to arrive targets for reductions in Hebei's energy-related $CO_2$ emissions. The method improved and relative policy advance improved pointing at empirical results also can be applied by other province to make study about driven factors of the growth of carbon emissions.

• 국제초고층학회논문집
• /
• 제7권2호
• /
• pp.153-159
• /
• 2018

The greenhouse effect caused by human activities is becoming increasingly serious. The building industry, which is directly related with carbon emissions, has the responsibility and potentiality to reduce carbon emissions. Recently, Chinese and foreign academics have achieved some research results with respect to building carbon emissions. This paper tries to examine these issues in the context of climate conditions in the Shanghai area. Based on the typical floor plans of high-rise office buildings, analysis was performed via software simulation and data analysis; the paper explores the relationship between different design methods of typical floor plans and carbon emissions. The objective is to deliver results beneficial to typical floor-design methods with respect to the reduction of carbon emissions, so as to provide a reference for architects.

• 한국기후변화학회지
• /
• 제8권1호
• /
• pp.57-62
• /
• 2017

Greenhouse gas (GHG) emissions of private industry of Chungcheongbuk-do were estimated. GHG emissions were classified by industry and GHG emissions ratio of each industry of Chungcheongbuk-do was found. Characteristics of GHG emissions of Chungcheongbuk-do and GHG mitigation technology were analyzed. To calculate GHG emissions, equations proposed through GHG emissions calculation guidelines published by Korean Energy Agency in 2009 were used. As a result, GHG emissions ratio of cement, semiconductor, paper and petrochemical industry was about 73%, 16%, 5%, and 2% respectively. GHG mitigation technologies of cement, semiconductor and waste were investigated. For cement, amine technology, for semiconductor, scrubber system and for waste, land fill gas utilization were analyzed.

• Advances in Energy Research
• /
• 제6권1호
• /
• pp.1-15
• /
• 2019

The objective of the study is to examine the relationship between water resources, energy demand, food production, and environmental pollutants in selected SAARC nations, namely, Bangladesh, India, Pakistan, and Sri Lanka, during the period of 1990-2016. The results show that water, energy, and food (WEF) resources substantially affected air quality in the form of high mass carbon emissions, fossil fuel energy demand, methane discharges, nitrous oxide emissions, and greenhouse gas emissions in these countries. Food production and food deficit largely increase $CO_2$ emissions due to unsustainable production and malnutrition, while land use under cereal production increases $CH_4$ and $N_2O$ emissions. Electricity production escalates $CO_2$ emissions and fossil emissions across countries. The results support the carbon EKC hypothesis, while monotonic increasing function exists in case of fossil fuel energy. The study emphasizes the need to ensure environmental sustainability agenda by adopting cleaner production technologies in WEF resources.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2023년도 봄 학술논문 발표대회
• /
• pp.215-216
• /
• 2023

As the introduction of new climate system, efforts to change carbon neutrality, efforts to convert carbon neutrality. In Korea, we are setting up carbon emissions through greenhouse gas and energy target management system for business and companies that emit carbon emissions. The construction industry quantitatively predict the carbon emissions, but it is struggling to set up the amount of carbon emissions before construction stage, but it is suffering from lack of data. Therefore, this study was conducted by collecting data on the energy usage amount of carbon emissions according to the energy usage of the construction phenomenon and low-capacity prediction of the construction phenomenon. Through collected data, the average energy usage amount by building users and evaluated the average carbon emissions. It also evaluated the contribution of carbon emissions by energy sources.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2017년도 춘계 학술논문 발표대회
• /
• pp.193-194
• /
• 2017

Effect of variable factors on carbon emissions in construction industry is hard to analysis. Therefore this study analyzies effect of variable factors on carbon emissions. This study shows importance of variable factors and emphasizes need of estimation of carbon emissions considering variable factors.

• 한국자동차공학회논문집
• /
• 제8권4호
• /
• pp.51-58
• /
• 2000

It is well known that the majority of the emissions measured from vehicle exhaust in the US Federal Test Procedure(FTP-75) are emitted during the first 60 seconds. This paper describes an experimental study on SI engine emissions reduction after cold start with interval secondary air injection and coolant control. Secondary air injection after cold start to reduce exhaust emissions causes an exothermic reaction at the exhaust port and gives sufficient air to the catalyst. For that reason engine-out emissions oxidized in the exhaust port and the rapid heating of a catalytic converter after cold start with CSAI and ISAI are estimated. The influence of the coolant temperature on SI engine emissions has been estimated. In the present studycoolant control of the cylinder head tempeature is used to investigate the effect of coolant temperature on SI engine emissions. The results show that engine-out hydrocarbon and carbon monoxide emissions are considerably reduced with interval secondary air injection and coolant control.