• 한국응용과학기술학회지
• /
• 제18권3호
• /
• pp.191-196
• /
• 2001

Organic semiconductors based on vacuum-deposited films of fused-ring polycyclic aromatic hydrocarbon have great potential to be utilized as an active layer for electronic and optoelectronic devices. In this study, pentacene thin films and electrode materials were deposited by Organic Molecular Beam Deposition (OMBD) and vacuum evaporation respectively. For the gate dielectric layer, photoacryl (OPTMER PC403 from JSR Co.) was spin-coated and cured at $220^{\circ}C$. Electrical characteristics of the device were investigated, where the channel length and width was 50 ${\mu}m$ and 5 mm. It was found that field effect mobility was 0.039 $cm^{2}V^{-1}s^{-1}$, threshold voltage was -8 V, and on/off current ratio was $10^{6}$. Further details will be discussed.

• 대한전자공학회논문지SD
• /
• 제41권10호
• /
• pp.17-22
• /
• 2004

본 논문에서는 진폭 변조와 펄스 폭 변조를 모두 사용하는 새로운 AMOLED 디스플레이 구동 방식을 개발하였다. 펄스 폭 변조를 위해서 다섯 개의 서브 프레임으로 화상 프레임을 나누었고 진폭 변조를 위해 TFT 게이트 전압에 의해 제어되는 3가지의 OLED 휘도(전류) 레벨을 사용하였다. 이 두 종류의 변조를 조합하여 35(=243) 계조를 얻었다. 그리고 DAC를 사용하지 않고 2개의 쉬프트 레지스터를 갖는 새로운 데이터 전극 구동 회로를 설계하였다. 회로 동작은 6㎛ 채널 길이 다결정 TFT의 전류-전압 특성에서 추출된 TFT 파라미터를 이용한 HSpice 시뮬레이션을 통하여 검증하였다. 시뮬레이션 결과로부터 320×240, 이중 스캔, 243 계조 AMOLED 디스플레이를 구현할 수 있음을 확인하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 심포지엄 논문집 정보 및 제어부문
• /
• pp.471-472
• /
• 2007

The scalp is skin tissue for skull-protection and roots for hair growth. Therefore continuous monitoring of scalp condition is essential for hair management. However, the equipments for existent are inconvenient to use because of focus tremor and external factors(Hair Gel, Wax, accessories and so on). Furthermore there is a problem to use an expensive optical devices like CCD (Charge Coupled Device) camera or lens of 200 - 1000 magnification. It causes a difficulty of using those equipment. We design the special electrode(length 5.65mm, diameter 0.8mm of needle shape) and the impedance system(1kHz, 78uA). Tn this paper, we can measure scalp impedance with our system. Moreover, we find the possibility of classifying scalp condition with measured impedance values. For the classification of scalp condition, we used ARAMO-TS as an imaging system. In conclusion, the problem of existent devices could be improved using these method. It also has a benefit of continuous monitoring of scalp condition.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 하계학술대회 논문집 C
• /
• pp.1850-1852
• /
• 2000

In this paper, new Partial Discharge (PD) detection technique using Pockels cell was proposed and considerable apparent chaotic characteristics were discussed. For this purpose, PD was generated from needle-plane electrode in air and detected by optical measuring system using Pockels cell, based on Mach-Zehnder interferometer, consisting of He-Ne laser, single mode optical fiber, 50/50 beam splitter and photo detector. A qualitative analysis was carried out by drawing Return map for the normalized time series of the detected PD signals. The results are as follows:(a) Fixed points, between 0.7 and 1.0, are appeared clearly in the right upper area of the return map as the increase in the number of obtained data.(b) Considerable periodicity have been remarked even though exact period and length can not be determined.(c) The self-similarity can be also observed inasmuch as the late paths do not follow the previous ones. Accordingly, exact quantitative analysis such as embedding dimension, fractal dimension, and Lyapunov exponents should be carried out for deducing the quantitative properties regarding PD phenomena.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 추계학술대회 논문집 전기물성,응용부문
• /
• pp.34-35
• /
• 2006

Transparent ZnO thin film transistor (TFT) is fabricated on the glass substrates. The device consists of a high mobility intrinsic ZnO as a semiconductor active channel, Ga doped ZnO (GZO) as an electrode, $HfO_2$ as a gate insulator. GZO and $HfO_2$ layers are prepared by using a pulsed laser deposition and intrinsic ZnO layers are fabricated by using an rf-magnetron sputtering, respectively. The transparent TFT is highly transparent (> 87 %) and exhibits n-channel, enhancement mode behavior with a field-effect mobility as large as $11.7\;cm^2/Vs$ and a drain current on-to-off ratio of about $10^5$.

• 한국생산제조학회지
• /
• 제19권3호
• /
• pp.370-375
• /
• 2010

본 연구에서는 전해가공을 이용해서 직경이 균일한 텅스텐 카바이드 미세축을 제작하는 실험을 수행하였다. 전해가공을 통해 미세축으로 사용 가능한 형상을 얻기 위한 최적의 가공 조건에 대해 고찰하였다 이 과정에서 미세축의 형상에 영향을 주는 여러 인자들을 적절하게 조절하여 최적의 형상을 얻을 수 있었다. 그리고 가공된 미세축을 이용하여 적절한 조건으로 2차, 3차 가공을 수행하여 초미세축을 가공할 수 있음을 보였다. 그리하여 실험 결과 직경 $30{\mu}m$, 길이 $500{\mu}m$의 텅스텐 카바이드 미세축을 제작하였다.

• 한국세라믹학회지
• /
• 제53권5호
• /
• pp.511-520
• /
• 2016

Electrolyte-supported symmetric Ni-YSZ cermet electrodes of ca. $23{\mu}m$ were prepared by screenprinting and the impedance was measured as a function of humidity from 2% to 90% balanced in $H_2$ at a total flow rate of 50 sccm. The Ni felt current collector of 1 mm thickness exhibited a Gerischer-like gas concentration impedance in the low frequency range, which was similarly observed in the cermet-supported solid oxide cells, while the Pt paste collector exhibited only electrochemical polarization. The electrochemical polarization of both samples was modeled by a non-ideal diffusion-reaction transmission line model including CPEs with ${\alpha}$= 0.5. In the case of the Pt paste collector, all the Bisquert parameters exhibited humidity dependence to the -1/2 power, supporting a non-faradaic chemical reaction mechanism at three phase boundaries. Consequently, the surface diffusivity and reaction rate increased linearly with humidity. Less pronounced humidity dependence and somewhat lower utilization length with an Ni felt collector can be attributed to the diffusion-limited gas flow through the collector.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제51권6호
• /
• pp.253-259
• /
• 2002

This paper deals with the effects of grounding conductors for metal oxide surge arresters. When surge arresters are improperly installed, the results can cause costly damage of electrical equipments. In particular, the route of surge arrester connection is very important because bends and links of leads increase the impedances to lightning surges and tend to nullify the effectiveness of a grounding conductor. Therefore, there is a need to know how effective installation of lightning surge arresters is made in order to control voltage and to absorb energy at high lightning currents. The effectiveness of a grounding conductor and 18 [㎸] metal oxide distribution line arresters was experimentally investigated under the lightning and oscillatory impulse voltages. Thus, the results are as follows; (1) The induced voltage of a grounding conductor is drastically not affected by length of a connecting line, but it is very sensitive to types of grounding conductor. (2) The coaxial cable having a low characteristic impedance is suitable as a grounding conductor. (3) It is also clear from these results that bonding the metal raceway enclosing the grounding conductor to the grounding electrode is very effective because of skin effect. (4) The induced voltages of grounding conductors for the oscillatory impulse voltages are approximately twice as large as those for the lightning impulse voltages.

• 조명전기설비학회논문지
• /
• 제22권5호
• /
• pp.7-12
• /
• 2008

부싱의 형상에 따라 전계 분포를 비교하여 가장 효율적인 형상을 설계하고자 하였다. 본 연구에서 형상 변화는 12 조건이며 전극 길이의 변화로 벡터 분포도는 0.7[%], 전계 분포도는 약 $21{\sim}26[%]$의 절연 성능을 향상시킬 수 있었다. 그리고 고압부 절연물 두께의 변화는 벡터 분포도는 2[%], 전계 분포도는 약 $23{\sim}43[%]$의 절연 성능을 향상시킬 수 있었다. 따라서 조건변화에 따라 절연성능이 향상되는 것을 알 수 있으므로 부분방전 개시전압 소멸전압을 향상시킬 수 있을 것으로 사료된다.

• 한국전기전자재료학회논문지
• /
• 제33권6호
• /
• pp.500-504
• /
• 2020

Heating films were prepared with composites of poly (methyl methacrylate) and conductive graphite. The as-prepared composite was deposited on a PET film and then fabricated using a bar coater to produce a film with uniform thickness. Copper electrodes were attached to both ends of the as-prepared film, and the heating characteristics of the film were analyzed while applying a DC voltage. The electrical conductivity and heating temperature of the heating films depended on the size, structure, content, and the dispersion characteristics of the graphite in the composite. The thermal energy was adjusted by controlling the electrical energy, based on the Joule heating theory. The electrical resistance of the film was altered in proportion to Ohm's law, and the heating temperature was changed according to the structure of the film (interelectrode spacing or electrode length) and the conductive graphite content. When the content of conductive graphite in the film increases, the electrical resistance decreases, and the heating temperature increases; however, there is no significant change above a certain content (50%).