• Journal of Electrical Engineering and Technology
• /
• v.7 no.4
• /
• pp.524-529
• /
• 2012

This paper proposes a novel control strategy of a PV tracking system considering the shadow influence. If distance of between PV arrays is not enough, shadow can be occurred to PV module. In PV system, if shadow is occurred to PV modules then PV modules operates reverses bias, and will eventually cause hot-spot and loss. To reduce loss by shadow influence, this paper proposes shadow compensation algorithm using distance between arrays and shadow length of array. The distance between arrays is calculated by using azimuth of solar, and length of array shadow is calculated using by altitude of solar. The shadow compensation algorithm proposed in this paper compares distance between arrays and length of array shadow. When the shadow length is longer than the distance between arrays, the algorithm adjusts altitude of array to avoid the shadow effects. The control algorithm proposed in this paper proves validity through compared with conventional algorithm and proposes experiment result.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.25 no.9
• /
• pp.44-49
• /
• 2011

Due to increase of fault current, various superconducting fault current limiter (SFCL) are researched. We studied a power distribution system with SFCL. Along the way, we knew characteristics of fault current according to a distance from substation to fault point. Fault current is reduced by distance`s increase from substation. Also, SFCL.s effects are decreased by distance too. Therefore, we analyzed the fault current by a distance from substation to fault point when a SFCL was applied into a power distribution system. We simulated using a PSCAD/EMTDC.

• Journal of Korea Multimedia Society
• /
• v.5 no.3
• /
• pp.272-280
• /
• 2002

In this paper, we present a method to extract a moving object and to measure the distance to it by using the stereo vision system. The moving factor is to be extracted through a match of a pixel unit for the moving object where the adaptive threshold is effectively dealt with to remove changes in the brightness of the image. The distance to moving object is measured by using a stereo vision system which employs a parallel camera. The experimental results show that the proposed algorithm could be effectively applied to distance measurement to moving object because it has an average error of one percent.

• Proceedings of the KIEE Conference
• /
• 2008.07a
• /
• pp.207-208
• /
• 2008

In this paper, it is simulated the line fault in the renweable energy pilot system and the distance is calculated using a modified fault distance calculation algorithm and the measurement data. The modified fault distance calculation algorithm calculate fault distance using the measurement data from power quality monitors (PQM) and the topology of the distribution networks. This algorithm is applied to PSCAD/EMTDC and the renewable energy pilot system. And these results are compared and analyzed.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.29 no.2
• /
• pp.58-66
• /
• 2006

This paper addresses the analysis of the travel distance and the number of storage location for storage location allocation methods in a warehouse system. The dedicated, randomized, combined and limited storage methods are considered. The combined and the limited storage methods are suggested here, which the combined storage method is to divide the storage locations into the dedicated storage area and the randomized storage area, and the limited storage method is to restrict the storage area of each product. Through a numerical example, the average travel distance between input/output point and the storage locations, and the number of storage location needed in the warehouse are compared between storage location allocation methods. The nearest randomized storage method is shown as the reasonable one in the travel distance and the number of storage location.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.33 no.3
• /
• pp.189-193
• /
• 1997

We make an ultrasonic system as a trial to measure the distance between trawl doors, and carried out a water tank ($24{\times} 24$m, water depth 1 m) experiment for confirming the practical use of the system in October 1996. This system calculates the distance between the pinger (50 kHz) and the transponder (50 kHz/70 kHz) attached each one on the trawl door by measuring the time-difference of receiving with two channels receiver on the trawler. This paper assums that both the length of the warp from the stern to the trawl door is same. At results the system shows a good relation between the distance and the time-difference of receiving while the location of the pinger is moved in variously in the water tank, and it was found that the method of measuring techniques on the prototype system could be applied to the measurement of the trawl door opening in the field experiment.

• Current Optics and Photonics
• /
• v.7 no.4
• /
• pp.354-361
• /
• 2023

We present the optical design and experimental verification of resolving performance of a 3× long wavelength infrared (LWIR) zoom camera for drones. The effective focal length of the system varies from 24.5 mm at the wide angle position to 75.1 mm at the telephoto position. The design specifications of the system were derived from ground resolved distance (GRD) to recognize 3 m × 6 m target at a distance of 1 km, at the telephoto position. To satisfy the system requirement, the aperture (f-number) of the system is taken as F/1.6 and the final modulation transfer function (MTF) should be higher than 0.1 (10%). The measured MTF in the laboratory was 0.127 (12.7%), exceeds the system requirement. Outdoor targets were used to verify the comprehensive performance of the system. The system resolved 4-bar targets corresponding to the spatial resolution at the distance of 1 km, 1.4 km and 2 km.

• Journal of applied mathematics & informatics
• /
• v.32 no.5_6
• /
• pp.783-790
• /
• 2014

Most distance functions, including taxicab distance, are defined on Cartesian plane, and recent studies on distance functions have been mainly focused on Cartesian plane. However, most streets in cities include not only straight lines but also curves. Therefore, there is a significant need for a distance function to be defined on a curvilinear coordinate system. In this paper, we define a new function named polar taxicab distance, using polar coordinates. We prove that this function satisfies the conditions of distance function. We also investigate the geometric properties and classifications of circles in the plane with polar taxicab distance.

• The Journal of Korean Association of Computer Education
• /
• v.4 no.1
• /
• pp.27-34
• /
• 2001

Recently. The web-based distance education system becomes generalized so that learners can study without being under the control of time and space. This shows that it is more widely used through Internet in education field. But the previous developed methodology for distance-lecture system has some problems, on the Distance Education. It takes much time and cost. In this paper, the need of the Distance-lecture system to apply component-based developing methodology is suggested to overcome these problems. Also, you can save lots of time and cost because it has the reuse, the convenient availability, and the transplantation of distance-educaton system through component-based developing methodology.

• Journal of Korea Game Society
• /
• v.16 no.3
• /
• pp.109-116
• /
• 2016

Distance learning systems that teacher and learner(s) are located at remote have been in progress in a way that directly transfer the video and audio. To get the interest of learners and effectiveness of education or to overcome the poor network environment, various methods utilizing computer graphics in the distance learning system have been attempted. This paper describes a design and implementation of a distance learning system using 3D animation control technology based on Kinect and network game technology. Distance learning system designed and implemented in this paper is a good example of combining education and game technology. And I expect to be used at various educational contents in the future.