• 한국세라믹학회지
• /
• 제37권2호
• /
• pp.128-133
• /
• 2000

In this work, soft carbons produced by pyrolysis of petroleum and coal-tar pitch were used as the negative electrode for Li-ion batteries. We studeid the charge/discharge capacity and the interfacial reaction of these electrodes by constructing a half cell. Charge/discharge property was studied by a constant-current step and the interfacial reaction between the electrolyte and the surface of a carbon electrode was studied by the cyclic voltammetry. The initial charge/discharge capacity for the coal-tar pitch carbon increased exceedingly with the heat treatment temperature. On hte other hand, the capacity of the petroleum pitch carbon increased with temperature up to 1000$^{\circ}C$, thereafter decreased continuously. While the charge capacity decreased with the cycle number, the reversibility increased above 90%. In addition, the thermal stability and crystallization of petroleum and coal-tar pitches were analyzed by TGA and XRD, respectively.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2005년도 International Meeting on Information Displayvol.I
• /
• pp.171-174
• /
• 2005

Experimental measurements are reported and compared with the results of a two-dimensional fluid simulation for the investigation of the discharge characteristics regarding the change of the mixture ratio of Ne-Xe-He noble gases. The increase of Xe contents results in the increases of luminance and luminous efficiency while it also results in the increase of the breakdown voltage and the discharge time lag. The addition of He gas increases the brightness and the luminance efficiency. When Xe partial pressure is low, the luminance efficiency increases with the amount of He at the same total pressure. When Xe partial pressure is high, however, the luminance efficiency has a maximum value when the partial pressure of He is about 10% of the total pressure for a standard AC PDP cell with Xe fraction of $10{\sim}30%$.

• Journal of Electrochemical Science and Technology
• /
• 제13권3호
• /
• pp.323-338
• /
• 2022

Heat generation and temperature of a battery is usually presented by an equation of current. This means that we need to adopt time domain calculation to obtain thermal characteristics of the battery. To avoid the complicated calculations using time domain, 'state of charge (SOC)' can be used as an independent variable. A SOC based calculation method is elucidated through the comparison between the calculated results and experimental results together. Experiments are carried for rapid resistive discharge of a large-capacitive lithium secondary battery to evaluate variations of cell potential, current and temperature. Calculations are performed based on open-circuit cell potential (SOC,T), internal resistance (SOC,T) and entropy (SOC) with specific heat capacity.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2004년도 하계학술대회 논문집 C
• /
• pp.1751-1754
• /
• 2004

Effects of delay on the discharge time lag and the controllability of weak discharge mode were studied under single cell driving circumstances of ac PDP. It was found that sufficient number of priming particle is necessary for inducing weak discharge in ramp voltage driving. Discharge time lag was reduced dramatically under priming condition. It is speculated that the increasement of strong discharge is related to the reduction of the $Xe^*(^3P_1)$ particles during the after glow.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 하계학술대회 논문집 C
• /
• pp.1581-1583
• /
• 2000

In this paper, we proposed a surface discharge FFL with the new electrode structure like the needle shaped electrode as the variation of cell structure to high luminance and low power consumption. In comparison with different electrode structure it has low discharge voltage and current and good optical characteristics. So it has better discharge characteristics than different surface discharge FFL and can be fungible of backlight as a lighting source in LCDs.

• 한국안전학회지
• /
• 제33권2호
• /
• pp.21-27
• /
• 2018

The expansion and stable operation of electric power facilities are important factors with development of industrial facilities in modern society. In high-voltage equipment such as GIS, the insulation characteristics may be deterioated by environment-friendly gas adaption and miniaturization. There is also the possibility of accidents due to insulation breakdown due to the deterioration of power facilities. Therefore, it is necessary to extend the diagnosis system to continuously monitor the danger signals of these power equipment and to prevent accidents. Most of the internal defects in the GIS system are conductive particles, floating electrode defects, protrusion defects, and the like. In this case, a partial discharge phenomenon is accompanied. These partial discharge signals occur irregularly and various noise signals are included in the field, so it is difficult to evaluate the reliability in the development of the diagnostic system. In this paper, a study was made on equipment capable of generating a partial discharge simulated signal that can be adjusted in size and frequency to be applied to a diagnostic device by electromagnetic wave detection method. The PD simulated pulse generator consists of a user interface module, a high-voltage charging module, a pulse forming circuit, a voltage sensor and an embedded controller. In order to simulate the partial discharge phenomenon similar to the actual GIS, a discharge cell was designed and fabricated. The application of the prototype pulse generator to the commercialized PD diagnosis module confirmed that it can be used to evaluate the performance of the diagnostic device. It can be used for the development of GIS diagnosis system and performance verification for reliability evaluation.

• 분석과학
• /
• 제7권4호
• /
• pp.483-492
• /
• 1994

Glow Discharge를 이용한 고체 시료의 극미량 원소분석은 흡광, 방출, 형광 그리고 질량 분석 방법들이 특히 금속 시료들의 분석을 위해 많이 연구되어지고 있다. 본 연구에서는 자체 제작한 Gas-Jet-assisted Glow Discharge(GJGD)를 이용하여 각 실험변수에 따른 영향을 비교하여 보았다. 제작한 글로우 방전의 특성화 실험에 사용한 실험 변수로는 전류, 방전 가스의 흐름 속도, 압력 등이었고 시료는 황동을 사용하였다. 시료의 주원소인 구리(Cu)와 아연(Zn)의 방출선세기와 방전가스인 아르곤(Ar)의 상대적인 세기를 비교하여 보았는데, 대체적으로 전류의 증가는 튕겨나옴(Sputtering) 현상을 촉진시켜 방출선의 세기가 증가하였고 가스 흐름 속도는 플라즈마 속으로의 수송과 확산에 관여하여 증가될수록 방출선의 세기를 감소시켰다. 글로우 방전 내의 압력의 증가는 튕겨나옴 현상을 감소시킴과 더불어 시료 표면으로의 재부착을 증가시켜 방출선의 세기가 급격히 감소함을 보여 주었다.

• 대한화학회지
• /
• 제42권3호
• /
• pp.323-327
• /
• 1998

• 기술사
• /
• 제15권3호
• /
• pp.12-18
• /
• 1982

단추형 제 2신화은전지의 고주파형 방전용량의 변화를 음극의 구조, 합제배합, 음극 소제의 모양, 격리막, 전해액농도와 연결지어 조사하였다.

• 기술사
• /
• 제15권1호
• /
• pp.36-40
• /
• 1982

This study is to characterize Ago stability useful for manufacturing silver oxide button cell, and deter mined by test tube gassing evaluations and by cell expansion and further discuss en the effectiveness of pellet reduction treatments to obtain single plateau discharge Profile and relevent performance.