• Journal of Digital Convergence
• /
• v.15 no.8
• /
• pp.203-212
• /
• 2017

The National Housing Bond Information Relay System is a representative financial information relay system in which institutions are connected with center system. A centralized structure is expensive to construct and operate center, and there is a problem that all networks are disconnected when a failure occurs in the center system. In this paper, we propose the national housing bond information relay system model based on Blockchain technology that can process information safely and efficiently. The proposed model constructs a Blockchain network so that each institution that processes the national housing bond information can transmit information safely, and each institution manages the same distributed ledge by a smart contract. The proposed model can reduce the cost because it can process complicated national housing bond transaction information without a relay center, and a network usage and disk usage decreased by 1.7% and 8.53%.

• Journal of Institute of Control, Robotics and Systems
• /
• v.5 no.7
• /
• pp.868-875
• /
• 1999

In this paper, digital motor control center using protection relay is developed in order to protect power systems by means of timely fault detection and diagnosis during operation for induction motor which have various load environments and capacities in power systems. Digital motor control center is employed by power supervisory control systems without separate remote terminal unit and transducers adding communicational ability. Also we develope a maximum demand controller to control the load effectively at peak status and a power factor controller to minimize real power losses and improve the power factor. Therefore, when using the developed controller, real time computation is possible by loading DSP in hardware and applying real-time kernel which can convert each algorithm to task module.

• Proceedings of the KIEE Conference
• /
• 2002.07a
• /
• pp.12-15
• /
• 2002

Korea Power System Protection Setting Rule was used from the rectify 1990's. Thereafter transmission voltage is raised the voltage into 765kV, and introduction to new technology of Power System, and was many of variation but, it is using. The present is using Digital type distance relay for 765kV transmission line protection. If impedance value of transmission line were to value lower than setting, this would be operating and relay setting rule is for 85% into Zone 1 self section, and Zone 2 is a 125%, Zone 3 is a 225%. Which's $15{\sim}25%$ include current transformer error 5%, potential transformer 5%, relay calculation error 5% and margin factor from the field experience. This paper is discussed transmission protective relay and relay setting rule of high voltage power system and we verify the correctness relay setting rule with distance relay using Matlab simulation.

• Proceedings of the KSR Conference
• /
• 2006.11b
• /
• pp.606-615
• /
• 2006

This study identifies the comparison of Technical specification and Characteristics of DC Protection Relay(ETCPU200) used in DC Distribution System in Korea. ETCPU200 has completed Field Test and approved its capability by finding out causes of recent operations through lately developed digital DC protection relay in parallel operation at Maebong-Substation, Nakseongdae-Substation, Euljirosaga-Substation, Jegi-Substation and Chongryangri T/P area. It also examines additional features for efficient System Analysis and Operations.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.8
• /
• pp.1444-1454
• /
• 2000

The implementation of IF group delay equalizer and its performance are presented for radio relay system applications, and measured results are in good agreement with the simulated ones based upon analytical formulations. For waveguide filter of 40㎒ channel spacing, equalized delay accuracy of about +/- 2.0nsec can be obtained only by constructing 4 stage delay circuits, which provides good performance in system BER curves compared with no filter case, and the difference is less than 1.0㏈ at $10^{-12}$ BER. So this scheme with simple hardware design can be used for correcting the distorted group delays mainly caused by wavegiude filters. To evaluate the designed group delay equalizer, various simulated and experimental results are shown here in conjunction with STM-1 signal of co-channel 64-QAM digital radio relay system.

• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.49 no.10
• /
• pp.516-523
• /
• 2000

In this paper, intelligent methods using digital protective relay in power supervisory control system is developed in order to protect power systems by means of timely fault detection and diagnosis during operation for induction motor which has various load environments and capacities in power systems. The spectrum pattern of input currents was used to monitor to state of induction motors, and by clustering the spectrum pattern of input currents, the newly occurrence of spectrums pattern caused by faults were detected. For diagnosis of the fault detected, the fuzzy fault tree was derived, and the fuzzy relation equation representing the relation between an induction motor fault and each fault type, was solved. The solution of the fuzzy relation equation shows the possibility of each fault's occurring. The results obtained are summarized as follows: 1) The test result on the basis of KEMC1120 and IEC60255, show that the operation time error of the digital motor protective relay is improved within ${\pm}5%$. 2) Using clustering algorithm by unsupervisory learning, an on-line fault detection method, not affected by the characteristics of loads and rates, was implemented, and the degree of dependency by experts during fault detection was reduced. 3) With the fuzzy fault tree, fault diagnosis process became systematic and expandable to the whole system, and the diagnosis for sub-systems can be made as an object-oriented module.

• ETRI Journal
• /
• v.36 no.1
• /
• pp.183-186
• /
• 2014

In this letter, we consider a cooperation system with multiple untrusted relays (URs). To keep the transmitted information confidential, we obtain joint channel characteristics (JCCs) through combining the channels from the source to the destination. Then, in the null space of the JCCs, jammers construct artificial noise to confuse URs when the source node broadcasts its data. Through a distributed implementation algorithm, the weight of each node can be obtained from its own channel state information. Simulation results show that high-level security of the system can be achieved when internal and external eavesdroppers coexist.

• Proceedings of the KIEE Conference
• /
• 2001.07a
• /
• pp.237-239
• /
• 2001

This paper describes the digital relay simulator system using digital signal processor. The simulator system has two parts, one is software and the other is hardware part. The simulation software has variety calculation engines ; EMTP simulation data file conversion, user define simulation data generation, sequence data generation, data analysis engines. etc, these are designed upon GUI. And simulator software provides easy control interface for users, the simulator software performs on every MS Windows OS. The simulator hardware design uses 32bit floating point DSP(TMS320C32) architecture to achieve flexibility and high speed operation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.12
• /
• pp.2317-2323
• /
• 2015

In this paper, we analyze the performance of dual-hop amplify-and-forward (AF) relaying in cooperative networks with partial relay selection. An AF relay gain considered in this paper includes channel-noise-assisted relay gain. Leveraging a received signal-to-noise ratio (SNR) model, we derive exact closed-form expressions for the probability density function (pdf) and cumulative distribution function (cdf) of the end-to-end SNR. Moreover, an exact closed-form expression of the ergodic capacity for dual-hop AF relaying with channel-noise-assisted relay gain and partial relay selection is investigated. The analytical results shown in this paper are confirmed by Monte-Carlo simulations.

• The Journal of the Korea Contents Association
• /
• v.17 no.10
• /
• pp.334-342
• /
• 2017

Due to the development of telecommunication technology, the relay broadcasting system is changing rapidly. The introduction of the wireless mobile communication relay (DMNG) method has enabled the one-man relay, which has resulted in absolute reductions in terms of equipment and manpower. However, it is a reality that the basic level of broadcasting such as broadcasting stability and image quality is becoming less complete. This paper analyzes wireless telecommunication relay equipment and broadcasting system called 'backpack', and discusses future development plan. To do this, we analyze the success and failure cases of backpack relay broadcasting and present concrete plans.