• 한국전자파학회논문지
• /
• 제11권5호
• /
• pp.755-762
• /
• 2000

본 논문에는 유전체 도파관 모델을 이용하여 육면체 유전체 공진기 안테나의 공진주파수, Qrad 및 임파던스 대역폭에 대한 근사 결과를 넓은 종횡비에 대하여 3D 그래프로 제시하고 시뮬레이션 및 측정 결과와 비교 분석하였다. 이러한 비교를 위해 상대 유전율이 37.84와 90인 유전체를 개구 결합 및 동축선로 급선하였는데 공진주파수는 약 8% 정도의 예측오차를 갖는 것이 확인되었고 임피던스 대역폭도 급전방식에 따라 차이가 날수 있음을 확인하였다. 본 논문에서 제시된 데이터들은 유전체 공지기 안테나 설계시 주어진 공진주파수와 대역폭에 대한 종횡비 선정시 유용하게 사용될 수 있다.

• 한국초전도ㆍ저온공학회논문지
• /
• 제14권1호
• /
• pp.25-29
• /
• 2012

The novel type of cable under consideration is cooled by gaseous Helium at elevated pressure. Helium is known for having poor electric breakdown strength; therefore the dielectric capabilities of this type of cable must be tested under conditions similar to the envisaged operation. In order to study the dielectric performance we have designed and built a novel high pressure cryostat rated at 2.17 MPa which has been used for testing model cables of lengths of up to 1 m. The cryostat is an open system where the gas is not re-circulated. This allows maintaining a high purity of the gas. The target temperature range is between 40 K and 70 K. This substantially increases the critical current density of the HTS compared to 77 K, which is the typical temperature of cables cooled by liquid nitrogen. The cryostat presented allows for adjusting the temperature and keeping it constant for the time necessary to run a complete dielectric characterization test. We give a detailed description of the cryostat. Measurements of partial discharge inception voltages as well as the temperature distribution along the model cables as a function of time are presented.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1994년도 추계학술대회 논문집 학회본부
• /
• pp.270-273
• /
• 1994

The capacitive current breaking capability as well as the short circuit current breaking capability is a very important factor in the performance of a circuit breaker. The dielectric recovery capability between poles should be considered in the desist of a circuit breaker because approximately two times of the maximum power system voltage might be applied between poles after the capacitive current be interrupted. The electric field and flow field analyses were utilized in the calculation of dielectric recovery characteristics between poles of 800kV model interrupter. The results show that the separation between moving main contact and moving arcing contact will affect to decrease significantly the electric field strength of a moving arcing contact and an insulation cover, to increase slightly the electric field strength of a fixed arcing contact and to decrease consequently the dielectric recovery capability between poles of the interrupter.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2010년도 하계학술대회 논문집
• /
• pp.23-23
• /
• 2010

The $Bi_2Mg_{2/3}Nb_{4/3}O_7$ (BMNO)-Bi composite films sandwiched by an $Al_2O_3$ protection layer exhibited a linear increase of a dielectric constant with increasing thickness and the 1000nm-thick BMNO-Bi composite films showed a dielectric constant (~220) higher than that of its bulk material (~210), keeping a low leakage current density of about $0.1{\mu}A/cm^2$. An enhancement of the dielectric constant in the BMNO-Bi composite films was attributed to the hybrid model combined by a space charge polarization, dipolar response, and nano-capacitors. On the other hand, 1000nm-thick BMNO-Bi composite films sandwiched by 40nm-thick BMNO layer exhibited a dielectric constant of about 450 at 100 kHz and a leakage current density of $0.1{\mu}A/cm^2$ at 6V.

• Smart Structures and Systems
• /
• 제12권5호
• /
• pp.523-545
• /
• 2013

Piezoelectric and dielectric behaviors of a piezoceramic patch adhesively centered on a carbon composite plate are identified using a robust multi-objective optimization procedure. For this purpose, the patch piezoelectric stress coupling and blocked dielectric constants are automatically evaluated for a wide frequency range and for the different identifiable behaviors. Latters' symmetry conditions are coded in the design plans serving for response surface methodology-based sensitivity analysis and meta-modeling. The identified constants result from the measured and computed open-circuit frequencies deviations minimization by a genetic algorithm that uses meta-model estimated frequencies. Present investigations show that the bonded piezoceramic patch has effective three-dimensional (3D) orthotropic piezoelectric and dielectric behaviors. Besides, the sensitivity analysis indicates that four constants, from eight, dominate the 3D orthotropic behavior, and that the analyses can be reduced to the electromechanically coupled modes only; therefore, in this case, and if only the dominated parameters are optimized while the others keep their nominal values, the resulting piezoelectric and dielectric behaviors are found to be transverse-isotropic. These results can help designing piezoceramics smart composites for various applications like noise, vibration, shape, and health control.

• 한국세라믹학회지
• /
• 제50권1호
• /
• pp.87-91
• /
• 2013

The doping effect of Sn on the microstructure evolution and dielectric properties was studied in $CaCu_3Ti_{4-x}Sn_xO_{12}$ polycrystals. Samples were produced by a conventional solid-state reaction method. Sintering was carried out at $1115^{\circ}C$ for 2-16 h in air. The dielectric constant and loss were examined at room temperature over a frequency range between $10^2$ and $10^6$ Hz. The microstructure was found to evolve into three stages. Addition of $SnO_2$ led to an increase in density and advanced formation of abnormal grains. The formation of coarse grains with a reduced thickness of the boundary brought about an enhanced dielectric constant and a lower dielectric loss below ~1 kHz. EDS data showed the Cu-rich phase along the grain boundary, which should contribute to the improved dielectric constant according to the internal barrier layer capacitor model. After all, $SnO_2$ was an effective dopant to elevate the dielectric characteristics of $CaCu_3Ti_{4-x}Sn_xO_{12}$ polycrystals as a promoter for abnormal grain growth.

• 대한전자공학회논문지SD
• /
• 제41권6호
• /
• pp.91-98
• /
• 2004

본 논문은 일반적인 SPICE 시뮬레이터에서 사용 가능한 PCB 평판 해석 모형을 제안한다. 제안된 모형은 주파수에 따라 증가하는 두 가지 손실, 즉, 표피 손실과 유전 손실의 영향을 반영한다. 평판은 메시(mesh) 구조로 조각을 낸 후, 각각의 단위모형은 전송선 소자와 손실 모형을 이용하여 모형화된다. 손실 모형은 DC 손실을 위해서 하나의 저항이 요구되고, 표피 손실을 위해 직렬 RL ladder 회로, 유전 손실을 위해서 직렬 RC ladder 회로가 요구된다. 제안된 모형의 검증을 위해 주파수 가변저항을 사용한 SPICE ac 해석결과를 통해 비교하고, 전형적인 데스크탑 PC용 FR4 4층 PCB 적층 구조를 만들어 VNA 측정치와도 비교할 것이다. 이 모형은 RLGC 수동 소자들로만 구성되므로 주파수 영역 및 시간 영역에서도 다양한 선형/비선형 소자들과 결합하여 과도 해석이 가능하다.

• 폴리머
• /
• 제25권1호
• /
• pp.98-107
• /
• 2001

팬텀 모델 제작을 위해 도전체로서 전도성 카본블랙을, 유전체로서 (Ba, Ca)$(Sn, Ti)O_3$ 와 $SrTiO_3$를 적용한 SBS 복합재료의 유전 특성과 형상 회복 특성을 조사하였다. 카본블랙만을 첨가한 복합재료는 카본블랙 함량이 증가함에 따라 복소유전율과 도전율이 증가하였으며, 주파수가 증가함에 따라 유전율이 감소하고 도전율은 증가하는 주파수 의존 특성을 보였다. 카본블랙과 유전체를 동시에 적용한 3상 복합재료는 동일한 카본블랙 함량에 대해서 유전체의 함량이 증가할수록 복소유전율과 도전율이 증가하는 특성을 나타냈으며, 카본블랙의 영향으로 주파수가 증가함에 따라 유전율이 감소하였고 도전율은 증가하였다. 유전체/SBS 복합재료의 유전성질과 도전체/SBS 복합재료의 주파수 의존도를 조절하여 현재 이동전화 사용 주파수 대역인 775 MHz~2 GHz 범위에서 인체의 뇌와 두개골 조직의 유전율, 도전율과 상응하는 비흡수율 측정용 팬텀 모델 재료를 제작할 수 있었다. 열기계적 반복시험에서는 충전재의 함량이 증가함에 따라 잔류변형량이 증가하였으나, 인체 조직을 모사한 SBS 복합재료는 우수한 형상 회복 성능을 보였다.

• 전자공학회논문지A
• /
• 제30A권7호
• /
• pp.26-31
• /
• 1993

We have analyzed shielding characteristics of the spherical multilayered dielectric, with the assumption that the inner part of the model is filled with the perfect conductor whose radius is varied from 0.2.lambda. to 1.0.lambda. and the outer part of the conducting sphere is covered by a lossy multilayered dielectric. Variation of shielding effects have been examined as the function of parameter of the dielectric layer and the radius of the conducting sphere.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 추계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.12-14
• /
• 2003

This paper presents the small current interruption capability of $SF_6$ puffer circuit breaker considering pre-condition. Firstly, the change of dielectric strength of the 3 breakers was compared with testing breakers as clean contacts and eroded contacts after 3 shots of 760 according to new IEC 62271-100 standard. Also the dielectric strength curve of each model was calculated through flow and electric field simulations. From these results, we could modify the empirical equation, being used to predict the dielectric strength of small current interruption capability, considering the effects of pre-condition.