• Journal of the Korea institute for structural maintenance and inspection
• /
• v.24 no.3
• /
• pp.57-62
• /
• 2020

Among the sewage pipes installed in Korea, the length of concrete pipes exceeding 20 years is 66,334 km (42.5%). Deteriorated concrete sewer pipes need to be repaired due to the leakage of internal sewage, which causes problems such as sink holes by expanding the cavity around the pipeline. In this study, we tried to apply anti-washout underwater mortar with ultra rapid hardening cement and segregation reducing agent to sewage pipe repair. As a result of the setting time test, the final set time was delayed by up to 172% by incorporating segregation reducing agent. In the test for measuring the degree of mortar segregation in water, it was measured at pH 12 or less under all mixing conditions. In addition, the suspension amount was measured to be 50 mg / l or less to satisfy the KCI-AD102 standard by incorporating a segregation reducing agent. In terms of the average value of mortar compressive strength, by incorporating segregation reducing agent, the strength of the specimens produced in air was more than 80% of that of the specimens produced in water. Conversely, the bond strengths of the specimens produced in water were measured to be higher than those of the specimens produced in air. Water resistance was evaluated by measuring water absorption and water permeability. Water absorption and water permeability were reduced by 42.6% and 36.6%, respectively, by mixing segregation reducing agent.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.5
• /
• pp.1470-1474
• /
• 2012

The pharmacokinetics of prunasin after oral administration of amygdalin or a decoction of peach seeds was determined and compared in rats. A $C_{18}$ column was used for separation at a column temperature of $25^{\circ}C$. The mobile phase consisted of 20% aqueous acetonitrile, and the flow rate was 0.5 mL/min. After oral administration of a decoction of peach seeds, prunasin was absorbed rapidly, reaching a maximum plasma concentration ($C_{max}$) of 62.1 mg/L within 45 min. After oral administration of amygdalin, the absorption of prunasin was delayed. The $C_{max}$ of prunasin was 42.9 mg/L and was reached at 60 min. Values for the pharmacokinetic parameters of prunasin, including $T_{max}$, $C_{max}$, AUC, $T_{1/2}$, CL/F, and V1/F, were significantly different for the oral administration of amygdalin compared with that of a decoction of peach seeds.

• Korean Journal of Food Science and Technology
• /
• v.47 no.1
• /
• pp.81-86
• /
• 2015

Intense pulsed light (IPL), a nonthermal technology, has attracted increasing interest as a food processing technology. However, its efficacy in inactivating microorganisms has not been evaluated thoroughly. In this study, we investigated the influence of IPL treatment on the inactivation of Escherichia coli O157:H7 depending on light intensity, treatment time, and pulse number. Increased light intensity from 500 V to 1,000 V, raised the inactivation rate at room temperature. At 1000 V, the cell numbers were reduced by 7.1 log cycles within 120 s. In addition, increased pulse number or decreased distance between the light source and sample surface also led to an increase in the inactivation rate. IPL exposure caused a significant increase in the absorption at 260 nm of the suspending agent used in our experiments. This indicates that IPL-treated cells were damaged, consequently releasing intracellular materials. The growth of IPL-irradiated cells were delayed by about 5 h. The degree of damage to the cells after IPL treatment was confimed by transmission electron microscopy.

• Journal of Korean Society for Atmospheric Environment
• /
• v.19 no.6
• /
• pp.647-661
• /
• 2003

For continuous monitoring of atmospheric visibility in the city of Kwanaju, Korea, a transmissometer system consisting of a transmitter and a receiver was installed at a distance of 1.91 km across the downtown Kwanaju. At the transmitter site an integrating nephelometer and an aethalometer were also installed to measure the scattering and absorption coefficients of the atmosphere, respectively. At the receiver site. an URG PM$_{2.5}$ cyclone sampler and an URG-VAPS (Versatile Air Pollutant Sampler) with three filter packs and two denuders were used to collect both PM$_{2.5}$ and PM$_{10}$ samples at a 2-hour or 12-hour sampling interval for aerosol chemical analysis. Sulfate, organic mass by carbon (OMC), nitrate, elemental carbon (EC) components of fine aerosol were the major contributors to visibility impairment. Diurnal variation of visibility during best-case days showed rapid improvement in the morning hours, while it was delayed until afternoon during the worst-case days. Aerosol mass concentration of each aerosol component for the worst-case was calculated to be 11.2 times larger than the best-case for (NH$_4$)$_2$SO$_4$(NHSO), 19.0 times for NH$_4$NO$_3$ (NHNO), 2.2 times for OMC, respectively. Also result shows that elemental carbon and fine soil (FS) were 3.7 and 2.2 times more than those of best-case. respectively- Sum of total contributions of wet NHSO and NHNO to light extinction was calculated to be 301 Mm$^{-1}$ for the worst-case. However, sum of contributions by dry NHSO and NHNO was calculated to be 123 Mm$^{-1}$ for the best case. Mass extinction efficiencies of fine and coarse particles were calculated to be 5.8$\pm$0.3 $m^2$/g and 1.8$\pm$0.1 $m^2$/g, respectively.ely.

• Journal of the Korea Concrete Institute
• /
• v.17 no.5 s.89
• /
• pp.703-708
• /
• 2005

The effects of polymer-cement ratio and antifoamer content on the setting time and durability of high-fluidity polymer-modified mortars using redispersible polymer powder are examined. As the result, the setting time of the polymer-modified mortars using redispersible polymer powder tends to be delayed with increasing polymer-cement ratio, regardless of the antifoamer content. The water absorption, chloride ion penetration depth and carbonation depth of the high-fluidity polymer-modified mortars using redispersible polymer powder decrease with increasing polymer-cement ratio and antifoamer content. The resistance of freezing and thawing and chemicals improvement is attributed to the improved bond between cement hydrates and aggregates because of the incorporation of redispersible polymer powder

• Journal of Pharmaceutical Investigation
• /
• v.23 no.3
• /
• pp.145-153
• /
• 1993

Retaining a drug in the stomach by some means is sometimes necessary to extend the G1 absorption time of the drug more than 6-8 hrs. Hydrogel has often been examined for its feasibility as a dosage form, so called platform, that could be retained in the stomach due to its excellent swelling properties in the gastric fluid. In this study, polyvinylpyrrolidone (PVP) hydrogel crosslinked by albumin or acrylated albumin was synthesized in a tablet form and evaluated for its possibility as the platform. The synthesis of the hydrogel was performed by $^{60}Co\;{\gamma}-ray$ irradiation of N-vinyl-2-pyrrolidone (monomer) in the presence of a crosslinking agent: aqueous solution of albumin or acrylated albumin. Synthetic conditions such as radiation dose, dose rate and concentration of crosslinking agent were varied in order to optimize the swelling and mechanical properties of the hydrogels. Degree of swelling of albumin-crosslinked PVP (Al-PVP) was highly dependent on radiation dose, dose rate and albumin concentration: it was decreased as they increased. On the other hand, that of acrylated albumin-crosslinked PVP (Acryl-PVP) was almost independent on them except dose rate: it was decreased as the radiation dose rate increased. The compressive strength of the two hydrogels was decreased as the dose rate increased. Digestion of both PVP in artificial gastric fluid containing pepsin was delayed by the ${\gamma}-ray$ irradiation. In conclusion, Al-PVP and Acry-PVP with diverse swelling and mechanical properties could be obtained by controlling synthetic conditions, mainly the irradiation dose rate.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.05b
• /
• pp.316-319
• /
• 2000

In the case of immobilizing of glucose oxidase into polypyrrole (PPy) using electrosynthesis, the glucose oxidase (GOx) forms a coordinate bond with the polymer's backbone. However, because of intrinsic insulation and net-chain of the enzyme, the charge transfer and mass transport are obstructed during the film growth. Therefore, the film growth is dull. We synthesized the enzyme electrode by electropolymerization added some organic solvent, A formative seeds of film growth is delayed by adding the solvent. The delay is induced by radical transfer between the solvent and pyrrole monomer. In the case of adding ethanol, the radical transfer shares the contribution of dopant between electrolyte anion and GOx polyanion. This may lead to increase amount of immobilized the enzyme in ppy. However, adding tetrahydrofuran (THF), the radical transfer is more brisk, resulting in short chained polymer. Therefore, the doping level is lowered and then amount of immobilized of enzyme is decreased. For the UV absorption spectra of synthetic solution before synthesis and after, in the case of ethanol added, the optical density was slightly decreased for the GOx peaks. It suggests amount of GOx in the solution was decreased and amount of GOx in the film was increased. We established qualitatively that amount of immobilization can be improved by adding a little ethanol in the synthetic solution. It is due to radical transfer reaction. The radical transfer shares the contribution of dopant between small and fast electrolyte anion and big and slow GOx polyanion.

• Horticultural Science & Technology
• /
• v.17 no.6
• /
• pp.758-760
• /
• 1999

This experiment was carried out to investigate the effect of pretreatments and holding solutions on quality and vase life of cut 'Saphir' rose (Rosa hybrida L.). Pulsing with aluminum sulfate or NaOCl prolonged vase life held in HQS+sucrose+ethionine. Solution absorption held in distilled water were more increased than held in HQS+sucrose+ethionine. Holding solution with 8-hydroxyquinoline sulfate (HQS)+sucrose+ethionine increased fresh weight compared with distilled water except pulsing with STS+sucrose. Pulsing with aluminium sulfate delayed bent-neck held in HQS+sucrose+ethionine. Flower diameter and dry weight of petal held in HQS+sucrose+ethionine were more increased than held in distilled water except pulsing with STS+sucrose. There were no significance in Hunter color value 'L' and value 'a', but value 'b' was decreased held in distilled water.

• Nuclear Engineering and Technology
• /
• v.44 no.4
• /
• pp.369-378
• /
• 2012

A load-following operation in APR+ nuclear plants is necessary to reduce the need to adjust the boric acid concentration and to efficiently control the control rods for flexible operation. In particular, a disproportion in the axial flux distribution, which is normally caused by a load-following operation in a reactor core, causes xenon oscillation because the absorption cross-section of xenon is extremely large and its effects in a reactor are delayed by the iodine precursor. A model predictive control (MPC) method was used to design an automatic load-following controller for the integrated thermal power level and axial shape index (ASI) control for APR+ nuclear plants. Some tracking controllers employ the current tracking command only. On the other hand, the MPC can achieve better tracking performance because it considers future commands in addition to the current tracking command. The basic concept of the MPC is to solve an optimization problem for generating finite future control inputs at the current time and to implement as the current control input only the first control input among the solutions of the finite time steps. At the next time step, the procedure to solve the optimization problem is then repeated. The support vector regression (SVR) model that is used widely for function approximation problems is used to predict the future outputs based on previous inputs and outputs. In addition, a genetic algorithm is employed to minimize the objective function of a MPC control algorithm with multiple constraints. The power level and ASI are controlled by regulating the control banks and part-strength control banks together with an automatic adjustment of the boric acid concentration. The 3-dimensional MASTER code, which models APR+ nuclear plants, is interfaced to the proposed controller to confirm the performance of the controlling reactor power level and ASI. Numerical simulations showed that the proposed controller exhibits very fast tracking responses.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 1998.10a
• /
• pp.313-335
• /
• 1998

If the atmospheric concentrations of greenhouse gases double, the annual temperature increase in mean surface temperature relative to 1990 will be about 2.0 to $2.5^{\circ}C$ and the annual precipitation increase about $15{\%}$ by 2100 in Korea. When the temperature rises $2^{\circ}C$, the annual temperature will be $13^{\circ}C,\;15^{\circ}C,\;and\;16^{\circ}C$ in Western Central, Yeongnam Basin, and Southern Coastal respectively. Consequently the crop period could be prolonged $10{\~}29$ days. In the case of gradual global warming, annual crops could be adapted to the changed environment by breeding, and the perennial crops should be shifted to ether area. If global warming happens suddenly over the threshold of atmospheric greenhouse gases concentration, then we shall have disturbance of ecosystem. When $2^{\circ}C$ higher than present, the optimum flowering date of rice plant delayed about 10 days, so it may not possible to adopt the fate with present japonica rices, therefore, the recommended characteristics of rice varieties are longer basic vegetative period, more late maturing and higher ripening temperature. Barley and wheat crops could be shifted to northern coastal areas and apple production areas should be shifted to those areas under $13.5^{\circ}C$ in annual mean temperature at global warming. Ideotypes of crops under climate changes should have such ecological characteristics that are indispensable to accomplish the sustainable agriculture under increased $CO_{2}$ and temperature condition as the diversification of genetic resources from yield-oriented to biomass-oriented characteristics with the higher potentials of $CO_{2}$ absorption and Primary production. In addition, a heat-tolerance, a pest resistance, an environmental adaptability and a production stability should be also incorporated collectively into our integrated agroecosystem.