• Explosives and Blasting
• /
• v.16 no.3
• /
• pp.16-24
• /
• 1998

Methods of Rock fragmentation are used rock of housing repair development at KU-SAN DONG area in seoul Youn-Pyong Ku. So, Theorical analyses of the effect of vibration and frequency on structural damage around old housed also discussed. The results can be summarized as follows: 1. A area(Rock area not more than 15m Ku-San Mention) Some Empirical equations were obtained $V=K\{{\frac{D}{W}}1/3\}^{-n}$ where the values for n and K are estimated to be -1.64 and 94 respectively, this values were obtained only theorical analyses. If we have 125g charge this area is impossible blasting operation, so this area must be worked by SRS(Super Rock Splitter) method. 2. B area(Rock area from 15m to 25m in a boundary line from Ku-San Mention) This area charge is about 125g in a delay time by some empirical equation s. So, this area can be blasting operations by small charge. 3. C area(Rock area from 25m to 35m in a boundary line from Ku-San Mention) This area charge is about 500g in delay time by some empirical equation s. So, this area can be blasting operations by middle charge. 4. D area(Rock area more then 35m in a boundary line from Ku-San Mention) This area charge is about 1000g in a delay time by some empirical equation s. So, this area can be blasting operations by middle charge.

• Current Optics and Photonics
• /
• v.2 no.1
• /
• pp.27-33
• /
• 2018

We report the physical implementation of a tunable photonic microwave delay line filter based on injection locking of a single Fabry-Perot laser diode (FP-LD) to a reflective semiconductor optical amplifier (RSOA). The laser generates equally spaced multiple wavelengths and a single tapped-delay line can be obtained with a dispersive single mode fiber. The filter frequency response depends on the wavelength spacing and can be tuned by the temperature of the FP-LD varying lasing wavelength. For amplitude control of the wavelengths, we use gain saturation of the RSOA and the offset between the peak wavelengths of the FP-LD and the RSOA to decrease the amplitude difference in the wavelengths. From the temperature change of total $15^{\circ}C$, the filter, consisting of four flat wavelengths and two wavelengths with slightly lower amplitudes on both sides, has shown tunability of about 390 MHz.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.2
• /
• pp.147-151
• /
• 2009

A wideband correlator, with 45% relative bandwidth is proposed at the frequency range of 3.1-5.1GHz. The structures of the correlator components such as the delay line and the Wilkinson power divider are designed to be realized in transmission line form using the Agilent's Advanced Design System (ADS). The correlator made by using three unique wideband 3-dB couplers, rat-race coupler and one 3-dB wilkinson power divider to reach the required bandwidth. The insertion loss, amplitude imbalance and phase imbalance between ports are presented. The proposed correlator makes compact size better than correlator of conventional structure.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.8
• /
• pp.1376-1385
• /
• 2000

The phase characteristic of delay line in feedfarward linearizer has been changed due to variation of operating temperature. In this paper, design method of fixed phase control circuit of group delay line using adaptive vector control is derived. To maintain transfer characteristics of nominal operating temperature, the error correlated signals, which are changed adaptively due to changing of temperature, are added to main signals. The proposed method maintains transfer characteristics under 0.06dB of insertion loss and 0.36$^{\circ}$ of phase variation in case of 1-tone(880 MHz) and under 0.07 dB of insertion loss and 0.35$^{\circ}$ of phase variation in case of 2-tones(877 MHz, 882 MHz) for 10dB input power dynamic range and +/-10$^{\circ}$ phase variation respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.2
• /
• pp.99-108
• /
• 2018

This paper presents a design study of a solid state power oscillator to replace the conventional magnetron. The operational conditions of a single-stage 300 W LDMOS power amplifier were fully characterized. The power module consisted of two amplifiers connected in parallel. A delay-line feedback loop was designed for self-oscillation. A phase shifter was inserted in the delay-line feedback loop for adjusting the round-trip phase. Experiments performed using the power oscillator showed an output power of 800 W and a DC-RF conversion efficiency of 58 % at 2.327 GHz. The measured results were in good agreement with those predicted by numerical simulations.

• Nuclear Engineering and Technology
• /
• v.55 no.2
• /
• pp.484-492
• /
• 2023

Time-to-digital converters (TDCs) based on the tapped delay line (TDL) architecture have been widely used in various applications requiring a precise time measurement. However, the poor uniformity of the propagation delays in the TDL implemented on FPGA leads to bubble error and large nonlinearity of the TDC. The purpose of this study was to develop an advanced TDC architecture capable of minimizing the bubble errors and improving the linearity. To remove the bubble errors, the decimated delay line (DDL) architecture was implemented on the UltraScale + FPGA; meanwhile, to improve the linearity of the TDC, a histogram uniformization (HU) and multi-chain TDL (MCT) methods were developed and implemented on the FPGA. The integral nonlinearities (INLs) and differential nonlinearities (DNLs) of the plain TDCs with the 'HU method' (HU TDC) and with 'both HU and MCT methods' (HU-MCT TDC) were measured and compared to those of the TDC with 'DDL alone' (plain TDC). The linearity of HU-MCT TDC were superior to those of the plain TDC and HU TDC. The experiment results indicated that HU-MCT TDC developed in this study was useful for improving the linearity of the TDC, which allowed for high timing resolution to be achieved.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.11
• /
• pp.960-965
• /
• 2015

In this paper, a coupled line directional coupler using an LUC(Low-pass filter Unit Cell) of artificial transmission line is presented. The conventional coupled line coupler is limited in length by the ${\lambda}/4$ transmission line while the proposed coupling structure is implemented smaller than $90^{\circ}$ by inserting the phase delay line between two coupled line, reduced in physical size by configuring a phase delay line with an LUC having the characteristics of a typical transmission line in a particular frequency. A coupler having -10 dB coupling factor at the center frequency of 700 MHz is designed, fabricated. The measured result agrees well with that of conventional one. The length of the fabricated coupled line coupler has about 45 % in length compared to the conventional one.

• Proceedings of the Korean Institute of Intelligent Systems Conference
• /
• 2000.05a
• /
• pp.187-190
• /
• 2000

Chua's circuit is a simple electronic network which exhibits a variety of bifurcation and attractors. The circuit consists of two capacitors, an inductor, a linear resistor, and a nonlinear resistor. In this paper, a transmitter and a receiver using two identical Chua's circuits are proposed and synchronizations of a power line are investigated. Since the synchronization of the power line system is impossible by coupled synchronization, theory having both the drive-response and the coupled synchronization is proposed. As a result, the chaos synchronization has delay characteristics in the power line transmission system caused by the line parameters L and C.

• 제어로봇시스템학회:학술대회논문집
• /
• 1996.10b
• /
• pp.335-338
• /
• 1996

In this paper, we are going to design an iterative learning controller with the robust properties for initial error. For this purpose, the PID-type learning law will be considered and the design guide-line will be presented for the selection of the learning gain. Also, we are going to suggest a condition for the convergence of control input for a plant with input delay. Several simulation results are presented, which shows the effectiveness of the proposed algorithms.

• Proceedings of the KIEE Conference
• /
• 2004.07d
• /
• pp.2662-2664
• /
• 2004

레이저 시스템의 정밀한 동작시점 제어를 위해서 초정밀 동기용 시간 지연 발생기(time delay generator)를 제작하였다. 제작된 장치는 8 비트 delay line IC를 조합하여 구현하였으며 사용자 프로그램에서 지연 시간과 펄스폭을 설정할 수 있도록 하였다. 또한 RS232 통신 방식으로 설정 값을 전달할 수 있도록 하였고 모듈 단위로 2 개의 채널을 사용할 수 있도록 하였으며 7 비트 어드레싱 방식의 $I^2C$(Inter IC Bus)를 이용할 경우 최대 127 개의 모들을 동작시킬 수 있도록 하였다.