• Journal of Environmental Health Sciences
• /
• v.26 no.3
• /
• pp.86-91
• /
• 2000

The purpose of this was to investigate the degradation efficiency of phenol compounds(catechol, ferulic acid, protocatechuic acid, syringic acid, vanillic acid) by Streptomyces halstedii scabies SAI-36, Streptomyces avendulas SA2-14, and Strptomyces badius(ATCC 39117, control group). The results were as follows: Catechol showed the degradation efficiency that is lower than 50% in three strains. Ferulic acid and vanillic acid showed high degradation efficiency of 98.8% and 94.5% respectively by Streptomyces lavendulas SA2-14. protocatechuic acid and syringicacid showed high degradation efficiency of 89.6% and 77.9%. The degradation efficiency of catechol by Streptomyces halstedii scabies SAI-36, Streptomyces lavendulas SA2-14 and Streptomyces badius(ATCC 39117) was low as 49.2%, 40.2% and 20.2% respectively. But the degradation of other phenolic compoumds except catechol by Streptomyces laven-dulas SA2-36 and Streptomyces badius(ATCC 39117). The results demonstrated that two experimental strains are superior ability to control group in degradation of phenol compounds and Streptomyces lavendulas SA2-14 was superior of two experimental strain. This results were consistent with previous research results that Streptomyces lavendulas SA2-14 was the best strain in degradation ability for lignin, decoloration abilities for variousdyes, and various enzyme production abilities. Therefore, it is suggested that lignin can be used as a indicator when selecting Actinomycetes for degradation of non-degradable materials such as phenol compounds.

• Journal of Urban Science
• /
• v.8 no.2
• /
• pp.13-18
• /
• 2019

Using self-made coil dielectric barrier discharge reactor, the removal efficiency of ethyl acetate under simulated experimental parameters such as initial concentration of waste gas, total flow rate, relative humidity and voltage was investigated. The results show that the degradation rate of ethyl acetate increases with the increase of output voltage. When other conditions remain unchanged, the degradation rate decreases with the increase of initial concentration of ethyl acetate; with the increase of total flow rate, the degradation rate of ethyl acetate decreases; with the increase of relative humidity, the degradation rate first increases and then decreases, and when the relative humidity is 64%, the degradation efficiency is the highest.

• Journal of Korean Society of Water and Wastewater
• /
• v.38 no.1
• /
• pp.17-27
• /
• 2024

This paper aims to study the degradation process for refractory azo dye namely Reactive Black 5(RB5) by potassium ferrate(VI) synthesized using the wet oxidation method. The process of degradation of azo dyes by Ferrate was studied with several parameters such as pH, different Ferrate(VI) dosage, different azo dye initial concentration, and temperature. A second-order reaction was observed in all degradation processes for RB5 having the highest degradation efficiency. The highest k_app value of RB5 degradation was 190.49 M^-1s^-1. In the pH experiments, the neutral condition has been identified as the optimum condition for the degradation of RB5 with 63.2% of dye removal. The efficiency of degradation also depends on the amount of ferrate(VI) available in the reactor. Degradation efficiency increased with an increase in Potassium Ferrate(VI) dosage or a decrease of RB5 initial concentration. The temperature has been reported as one of the most important parameters. From the results, increasing the temperature(up to 45℃) will increase the degradation efficiency of azo dye by Ferrate(VI) and if the temperature exceeds 45℃, the degradation efficiency will be decreased.

• Mass Spectrometry Letters
• /
• v.5 no.3
• /
• pp.89-93
• /
• 2014

Lincomycin is one of the major species among the Pharmaceuticals and Personal Care Products (PPCPs) detected from the four major rivers in Korea. The structure characterization was performed of six degradation products of lincomycin formed under the irradiation of electron beam, and the degradation efficiency as a function of the various irradiation dose and sample concentration was investigated. Electron beam (10 MeV, 0.5 mA and 5 kW) experiments for the structural characterization of degradation products that are fortified with lincomycin, were performed at the dose of 10 kGy. The separation of degradation products and lincomycin was carried out using a C18 column ($2.1{\times}100$ mm, $3.5{\mu}m$), using gradient elution with 20 mM ammonium acetate and acetonitrile. The structures of six degradation products of lincomycin were proposed by interpretation of mass spectra and chromatograms by LC-MS/MS. The mass fragmentation pathways of mass spectra in tandem mass spectrometry were also proposed. Experiments were performed of the degradation efficiency as a function of the irradiation dose intensity and the initial concentration of lincomycin in an aqueous environment. In addition, increased degradation efficiency was observed with a higher dose of electron beam and lower concentration.

• Environmental Engineering Research
• /
• v.22 no.3
• /
• pp.245-254
• /
• 2017

This study investigates methyl orange (MO) degradation by an ultrasonically dispersed nano-metallic particle (NMP) assisted advanced Fenton process. The NMPs were synthesized from the leachate of automobile-shredder residue. X-ray photoelectron spectroscopy and Fourier-transform infrared spectroscopy were performed for the prepared NMPs. Various parameters, such as the effects of the NMP dosage, the pH value of the solution, the initial concentration of MO, and the amount of $H_2O_2$ on the degradation efficiency of MO were studied. The MO degradation efficiency could be increased by approximately 100% by increasing the dosages of the NMPs and $H_2O_2$ to certain limits, after which in both cases the degradation efficiency was reduced when an excess amount was added. The MO degradation efficiency was found to be 100% at pH 2.0 and 2.5 with the 10 mg/L of initial concentration of the MO. The degradation of MO by ultrasonically dispersed NMPs was appropriate with the pseudo-first-order kinetics.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.06a
• /
• pp.28-29
• /
• 2006

When photovoltaic module is used for a long time, its performance decreases due to several reasons. In this paper, we focus on the possibilities mainly contributing to the degraded efficiency of the polycrystalline silicon photovoltaic modules. The analysis is based on the modules that have been used for 15 years. These are two main reasons that cause the efficiency degradation, the corrosion and thermal decomposition. The former phenomenon of electrode is mainly due to the moisture from damaged back sheet in some module. However the other reason of the degraded efficiency comes from the thermal decomposition, which can not be observed from the outside but only by experiment. In this study, the comparison between the efficiency of normal modules and degradation modules is presented. Module having degraded cell was seen to cause increase of series resistance by about 80%, in comparison to normal samples efficiency which reduce by about 20%. This study shows that the effects of series resistances on module performance are critical. These effects must be understood and taken into consideration when analyzing performance degradation.

• Journal of Korean Society of Water and Wastewater
• /
• v.35 no.1
• /
• pp.27-37
• /
• 2021

Tetracycline is one of the most commonly used as antibiotics for the livestock industry and it is still widely used nowadays. Tetracycline and its metabolites are excreted with excrement, which is difficult to completely removed with conventional sewage treatment, therefore it is apprehended that the tetracycline-resistant bacteria occurs. In this study, the oxidant named ferrate(VI) was used to degrade the tetracycline and investigate the reaction between ferrate(VI) and tetracycline under various aqueous conditions. The highest degradation efficiency of tetracycline occurred in basic condition (pH 10.1 ± 0.1) because of the pKa values of tetracycline and ferrate(VI). The results also showed the effect of water temperature on the degradation of tetracycline was not significant. In addition, the dosage of ferrate(VI) was higher, the degradation of tetracycline and the self-degradation of ferrate(VI) also higher, finally the efficiency of ferrate(VI) was lower. The results said that the various mechanisms effects the reaction of ferrate(VI) oxidation, it required the consideration of the characteristics of the target compound for optimal degradation efficiency. Additionally, intermediate products were detected with LC/MS/MS and three degradation pathways were proposed.

• Journal of Korean Society of Water and Wastewater
• /
• v.25 no.5
• /
• pp.643-649
• /
• 2011

Degradation of benzothiophene(BT) in the aqueous phase by potassium ferrate(VI) was investigated. Potassium ferrate(VI) was prepared by the wet oxidation method. The degradation efficiency of BT was measured at various values of pH, ferrate(VI) dosage and initial concentration of BT. BT was degraded rapidly within 30 seconds by ferrate(VI). While the highest degradation efficiency was achieved at pH 5, the lowest degradation efficiency was achieved at pH 9. Also, the initial rate constant of BT increased with decreasing of the BT initial concentration. In addition, the intermediate analysis for the reaction of BT and ferrate(VI) has been conducted using GC-MS. Benzene, styrene, benzaldehyde, formaldehyde, benzoic acid, formic acid, and acetic acid were identified as reaction intermediates, and ${SO_4}^{2-}$ was identified as an end product.

• Journal of Korean Society of Water and Wastewater
• /
• v.25 no.1
• /
• pp.63-74
• /
• 2011

The degradation characteristics of 2-chlorophenol(2-CP) by Ferrate(VI) were studied. The degradation efficiency of 2-CP in aqueous solution was investigated at various values of pH, Fe(VI) dosage, initial concentration and aqueous solution temperature. The maximum degradation efficiencies of 2-CP were obtained at pH 7.0 and aqueous solution temperature of 25$^{\circ}C$. The degradation efficiency was proportional to dosage of Fe(VI). Also, the initial rate constant of 2-CP degradation increased with decreasing of the 2-CP initial concentration. In addition, the degradation pathway study for 2-CP was conducted with GC-MS analysis. Acetic acid, formic acid, benzaldehyde and benzoic acid were identified as reaction intermediates of the 2-CP degradation by Ferrate(VI).

• Journal of Korean Society on Water Environment
• /
• v.26 no.5
• /
• pp.747-753
• /
• 2010

A series of experiments with a laboratory scale ultrasound treatment system for MTBE polluted groundwater was performed to increase the efficiency of MTBE degradation in groundwater. This study evaluated several factors to increase the efficiency of MTBE treatment for artificial and natural groundwater. The treated volume of groundwater, ultrasound frequency and power, and pollutant concentrations have been changed to evaluate its effects on the degradation efficiency of MTBE in batch and continuous flow reactor. For the specific experimental conditions on this paper, MTBE degradations are more efficient at 580 kHz than those at 1 MHz. The efficiency of MTBE degradation is proportional to the intensity of ultrasound power per unit volume of MTBE polluted groundwater. The concentration of ions in groundwater does not much affect the efficiency of MTBE degradation. The $1^{st}$ order degradation constant of MTBE for different power per unit volume at 580 kHz shows linear relationship at same concentration. The $1^{st}$ order degradation constant for 0.1 mM MTBE solution is higher than that for 1 mM MTBE solution. These experimental results could be helpful to seek optimal conditions for relatively large volume of polluted groundwater treatment.