• Journal of Korean Society of Disaster and Security
• /
• v.12 no.2
• /
• pp.47-56
• /
• 2019

Recently, in order to overcome the difficulty of entering a fire source due to the occurrence of a large amount of smoke in the event of a fire in a parking lot, it has used that a method of discharge smoke using air supply, exhaust fans and jet fans installed for ventilation of parking lots. In this study, the variation of flow in the smoke layer was observed using CCTV under two conditions, in which only the air supply fan operates and the manned fan operates together, and the temperature around the plume was compared to Albert eq. to assess its suitability as a parking lot ventilation performance evaluation method. As a result, it was found that the smoke layer could be disturbed if the Jet Fan was operated at the same time, which could lead to the possibility of an initial evacuation disturbance. However, the additional operation of the Jet Fan has been confirmed by the observation CCTV that the emission performance is improved, which is believed to help conduct the suppression operation. The temperature around the plume was measured and compared to Alpert eq, and was analyzed to be about $2^{\circ}C$ lower at the center axis of the plume and $9.0^{\circ}C$ higher at 8 m in the direction of the discharge of smoke. The results of temperature measurements around the plume were lower than the maximum temperature expected in AS 4391 and did not exceed the expected temperature risk caused by the experiment. As with these results, the temperature risk from the progression of hot smoke tests is foreseeable, so it will be available as one of the general evaluation methods for assessing smoke control performance in a parking lot without relevant criteria.

• Journal of Biomedical Engineering Research
• /
• v.44 no.6
• /
• pp.363-376
• /
• 2023

According to the COVID-19, development of various medical software based on IoT(Internet of Things) was accelerated. Especially, interest in a central software system that can remotely monitor and control ventilators is increasing to solve problems related to the continuous increase in severe COVID-19 patients. Since medical device software is closely related to human life, this study aims to develop central monitoring system that can remotely monitor and control multiple ventilators in compliance with medical device software development standards and to verify performance of system. In addition, to ensure the safety and reliability of this central monitoring system, this study also specifies risk management requirements that can identify hazardous situations and evaluate potential hazards and confirms the implementation of cybersecurity to protect against potential cyber threats, which can have serious consequences for patient safety. As a result, we obtained medical device software manufacturing certificates from MFDS(Ministry of Food and Drug Safety) through technical documents about performance verification, risk management and cybersecurity application.The purpose of this study is to conduct a usability assessment to ensure that ergonomic design has been applied so that the ventilator central monitoring system can improve user satisfaction, efficiency, and safety. The rapid spread of COVID-19, which began in 2019, caused significant damage global medical system. In this situation, the need for a system to monitor multiple patients with ventilators was highlighted as a solution for various problems. Since medical device software is closely related to human life, ensuring their safety and satisfaction is important before their actual deployment in the field. In this study, a total of 21 participants consisting of respiratory staffs conducted usability test according to the use scenarios in the simulated use environment. Nine use scenarios were conducted to derive an average task success rate and opinions on user interface were collected through five-point Likert scale satisfaction evaluation and questionnaire. Participants conducted a total of nine use scenario tasks with an average success rate of 93% and five-point Likert scale satisfaction survey showed a high satisfaction result of 4.7 points on average. Users evaluated that the device would be useful for effectively managing multiple patients with ventilators. However, improvements are required for interfaces associated with task that do not exceed the threshold for task success rate. In addition, even medical devices with sufficient safety and efficiency cannot guarantee absolute safety, so it is suggested to continuously evaluate user feedback even after introducing them to the actual site.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.7
• /
• pp.1-8
• /
• 2017

As the IT environment becomes more sophisticated, various threats and their associated serious risks are increasing. Threats such as DDoS attacks, malware, worms, and APT attacks can be a very serious risk to enterprises and must be efficiently managed in a timely manner. Therefore, the government has designated the important system as the main information communication infrastructure in consideration of the impact on the national security and the economic society according to the 'Information and Communication Infrastructure Protection Act', which, in particular, protects the main information communication infrastructure from cyber infringement. In addition, it conducts management supervision such as analysis and evaluation of vulnerability, establishment of protection measures, implementation of protection measures, and distribution of technology guides. Even now, security consulting is proceeding on the basis of 'Guidance for Evaluation of Technical Vulnerability Analysis of Major IT Infrastructure Facilities'. There are neglected inspection items in the applied items, and the vulnerability of APT attack, malicious code, and risk are present issues that are neglected. In order to eliminate the actual security risk, the security manager has arranged the inspection and ordered the special company. In other words, it is difficult to check against current hacking or vulnerability through current system vulnerability checking method. In this paper, we propose an efficient method for extracting diagnostic data regarding the necessity of upgrading system vulnerability check, a check item that does not reflect recent trends, a technical check case for latest intrusion technique, a related study on security threats and requirements. Based on this, we investigate the security vulnerability management system and vulnerability list of domestic and foreign countries, propose effective security vulnerability management system, and propose further study to improve overseas vulnerability diagnosis items so that they can be related to domestic vulnerability items.

• Journal of the Korean Institute of Gas
• /
• v.24 no.3
• /
• pp.33-39
• /
• 2020

In general, in a batch reaction process in which products are made using flammable liquids, splash filling is used to clean the walls of the reactor by spraying flammable liquids, which are raw materials used for product, during cleaning of the reactor after work. During this process, mist of flammable liquid is generated, the lower limit of explosion is lowered, and fire·explosion may occur due to discharges caused by various types of complex charges, such as flow charge, collision charge, and ejection charge. Therefore, based on the recent accident case, to identify the risk when working in the form of splash filling with toluene in a batch process and perform an explosion impact analysis using the TNT equivalent method After that, we will analyze the accident results and suggest preventive measures such as constant purge system, improvement of cleaning method, and use of tantalum to prevent such accident.

• THE INTERNATIONAL COMMERCE & LAW REVIEW
• /
• v.24
• /
• pp.25-49
• /
• 2004

English contract law has traditionally taken the view that it is not the duty of the parties to a contract to give information voluntarily to each other. In English law, one of the principal distinctions between insurance contract law and general contract law is the existence of the duty of disclosure in insurance law. This article is, therefore, designed to analyse the scope or extent of the duty of disclosure and the remedy for breach of the duty in English marine insurance law. The main purpose of this article is also to seek the alternative remedy for the breach. The results of analysis are as following : First, the scope of the duty of disclosure is closely related to the test of materiality and the concept of a hypothetical prudent insurer. The assured is required to disclose only material circumstances subject to MIA 1906, s. 18(1). The test of materiality, which had caused a great deal of debate in English courts over 30 years, was finally settled by the House of Lords in Pan Atlantic and the House of Lords rejected the 'decisive influence' test and the 'increased risk' test, and the decision of the House of Lords is thought to accept the 'mere influence' test in subsequent case by the Court of Appeal. Secondly, an actual insurer is, in order to avoid contract, required to provide proof that he is induced to enter into the contract by reason of the non-disclosure of the assured. But this subjective test of actual inducement is somewhat meaningless in sense that English court takes the test of materiality as a starting point and assumes the presumption of inducement even in case of no clear proof on the inducement. Finally, MIA 1906, s. 18 provides expressly for the remedy of avoidance of the contract for breach of the duty of disclosure. This means rescission or retrospective avoidance of the entire contract, and the remedy is based upon a fairly crude 'all-or-nothing' approach. The remedy of rescission is too draconian from the point of view of the assured, because he can be deprived of all cover despite he is innocent perfectly. An inadvertent breach from an innocent mistake is as fatal as wilful concealment. What is, therefore, needed in English marine insurance law with respect to remedy for the breach is to introduce a more sophisticated or proportionate remedy ascertaining degrees of fault.

• The Journal of the Korea Contents Association
• /
• v.20 no.9
• /
• pp.448-460
• /
• 2020

The purpose of this study is to examine the effects of negative experiences on social capital in order to see if the adverse functions of social media could be a barrier to the promotion of social capital through the use of social media. The study verified the moderating effect of perceived performance from social media and negative experiences(victim experience and offender experience) on social capital. The online survey was conducted in November 2019, and a total of 846 responses were used for the final analysis. As a result of the two-step regression analysis using the mean-centering technique first, it was found that the victim experience had no significant effect on the bridge social capital, but the perceived performance and the victim experience had negative moderating effect on the bridge social capital. Second, the victim experience showed a significant positive effect on the binding social capital, but showed a negative moderating effect with the perceived performance indicating positive influence on the binding social capital of the perceived performance could reduce through victim experience. Accordingly it is necessary to educate social media users on the cyber ethics, and regulation is required to mitigate risk factors for trust.

• The Journal of the Convergence on Culture Technology
• /
• v.6 no.2
• /
• pp.327-331
• /
• 2020

In that this study is a subject and character of risk, emerging security covers non-military areas in addition to traditional military security: environmental security, human security, resource security, and cyber security. The rise of these risks is not only changing the phenomenon of the new expansion of security areas, but also the expansion of the number and scope of security entities and the aspect of security world politics. These risks are transnational security issues at the global level in terms of their nature and extent of the damage, as well as multi-layered ones that affect local and personal security issues at the regional and national levels. In addition to national actors, non-state actors such as international organizations, multinational corporations, and global civil society, and furthermore, technology and social systems themselves are causing risks. Therefore, to solve the new security problem, it is necessary to establish a middle-level and complex governance mechanism that is sought at the regional and global levels beyond the fragmented dimension of the occurrence of new security issues that have been overlooked in the existing frame of perception, and to predict and find ways to respond to new security paradigms that have been identified in a broader sense.

• Journal of the Korean Institute of Gas
• /
• v.24 no.2
• /
• pp.15-21
• /
• 2020

Currently, in KS C IEC 60079-10-1, the leakage hole radius of secondary leakage is expressed as a recommendation. Underestimation of leak hole size can lead to underestimation of the calculated values for leak rates, and conservative calculations of leak hole sizes, which are considered for safety reasons, can be overestimated, resulting in an overestimated risk range. This too should be avoided. Therefore, a careful and balanced approach is necessary when estimating the size of leaking holes.Based on this logic, this study examines the stability by grasping the concentration inside the gas box when leaking dangerous substances as a result of experiments based on SEMI S6, an international safety standard applied in the semiconductor industry and The scope of explosion hazardous area was determined by applying the formula of KS C IEC 60079-10-1 according to SEMI F15 leak rate criteria and SEMI S6 leak rate criteria. Based on this, we will examine whether the exhaust performance needs to be improved as an alternative to FAB facilities that are difficult to apply to explosion hazards such as semiconductor industry.

• Korean Journal of Social Welfare
• /
• v.57 no.4
• /
• pp.343-370
• /
• 2005

This study is to find out factors that protect social workers in a medical setting from burnout. It is differentiated from the existing studies, which focused on factors or process causing burnout. The participants of the study were ten social workers, who have been working in a medical setting for at least seven years and were recognized as competent social workers by at least five other colleagues. The data were collected through intensive interviews. The contents of the interviews were analyzed by using Nvivo2, a computer software program for use qualitative study analysis. The result of this study categorized coping strategies that kept the social workers from burnout. Among such factors were their own admissions of having professional competency, feeling worthwhile and sense of accomplishment, having a firm belief system and value about their profession, teamwork, and their overall disposition. Additionally, they said that the support by their agency and the recognition and support by family contributed to their overall coping ability. Through this study, it was found that the social workers in medical setting were reducing risk factors related to burnout and overcoming them with various protective factors. These protective factors reflected the unique characteristics that social workers encounter in a medical setting. It was remarkable that 'developing and managing their professional competency' was emphasized most as a protective factor.

• Journal of Distribution Research
• /
• v.15 no.4
• /
• pp.87-117
• /
• 2010

'Entrepreneurship' which means spirit or activity seeking new value by challenging boldly the uncertainty is one of the most important concept in 21st century business environment. Franchise Industry taking a relationship with distribution industry also needs entrepreneurship. As franchise industry consists of small and medium enterprises, the entrepreneurship of franchisor's CEO is important for the franchisor's growth. The purpose of this study is to analyze the factors influencing on the entrepreneurship of franchisor's CEO, and the effect of the CEO's entrepreneurship on franchisor's performance. For this purpose, this study set CEO's psychological characteristics, market characteristics, and social-institutional characteristics as independent variables, CEO's entrepreneurship as parameter variables, and franchisor's performance as dependent variables. And to analyze this study model, this study collected questionnaires from 152 franchisors' CEOs, and uses SEM(Structural Equation Modeling). As the result, 'CEO's Entrepreneurship' influenced on both 'Franchisor's Financial Performance' and 'Franchisor's Non Financial Performance'. The results of this study provide some guides for franchisor's CEO and government policies.