• Korean Journal of Optics and Photonics
• /
• v.26 no.2
• /
• pp.110-114
• /
• 2015

We propose a reflective cholesteric liquid crystal cell with reduced color shift, using dichroic dyes. Color-shifted light is absorbed by dye molecules in the proposed dye-doped cholesteric liquid crystal (DDCLC) cell. We have shown that the color shift can be reduced by increasing the concentration of dye molecules in the proposed DDCLC cell.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.11a
• /
• pp.549-552
• /
• 1999

We have developed an novel vertical-alignment (VA) - $\pi$ cell mode that provides a wide viewing angle and fast response times for negative dielectric anisotropy nematic liquid crystal (NLC) on a homeotropic polyimide (PI) surfaces. We had the good voltage-transmittance curves and low driving voltages were achieved with the novel VA - $\pi$ cell mode without negative compensation film. Iso-viewing angle characteristics using the novel VA - $\pi$ cell mode without negative compensation film of NLC was also successfully observed. As well a fast response time of 31.7ms for the novel VA - $\pi$ cell mode was measured. Consequently, It is seen that by using the novel VA - $\pi$ cell mode the iso-viewing angle, fast response time, and low driving voltage characteristics can be achieved.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.7 no.2
• /
• pp.315-323
• /
• 1997

The sing1e crystal of cadmium sulfide was grown by vertical sublimation method. The lattice constants of CdS single crystal by extrapolation method are $a_0=4.139\AA$ and $c_0=6.719\AA$, respectively. The $Cu_2$S/CdS solar cell was fabricated using the single crystal of cadmium sulfide and the CuCl solution. The light- to- dark JV cross over effect of the $Cu_2$S/CdS solar cell was measured after annealing for 2 minutes at $250^{\circ}C$ in air atmosphere. The values of Voc, Jsc, Vop, FF, and efficiency are 0.40 volt, $4.2mA/\textrm{cm}^2$, 0.31 volt, $3.8mA/\textrm{cm}^2$, 0.68 and 3.8 %, respectively. The spectral response of the solar cell shows the peaks at 498 nm (2.49 eV) and 585 nm (2.12 eV).

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 1998.10a
• /
• pp.183-188
• /
• 1998

A quartz crystal analyzer is utilized to monitor the cmsion process of an aluminum surface of a quartz crystal by sea water. A quartz crystal having 2000${\AA}$ of aluminum layer is installed in a spedally designed cell and is in contact with an electrolyte solution. While a constant potential is applied to the cell, the resonant frequency and resonant resistance are simultaneously measured using the quartz crystal analyzer. In addition, surface topographs are taken with an atomic force microscope(AFM) and the element analysis of the surface is conducted using an energy dispersive X-ray spectrornetedEDX). The simultaneous measurement of resonant frequency and resonant resistance during the corrosion process explains the change of surface structure caused by the corrosion. The variation of resonant frequency addresses the amount surface metal dissolution. As a conclusion, it is found that a simple measurement using the quartz crystal analyzer can replace the complex monitoring employing large equipments in the investigation of a corrosion process of metal surface.

• Coupled systems mechanics
• /
• v.5 no.4
• /
• pp.341-353
• /
• 2016

Manufactures of multi-crystalline silicon ingots by means of the directional solidification system (DSS) is important to the solar photovoltaic (PV) cell industry. The quality of the ingots, including the grain size and morphology, is highly related to the shape of the crystal-melt interface during the crystal growth process. We performed numerical simulations to analyze the thermo-fluid field and the shape of the crystal-melt interface both for steady conditions and transient processes. The steady simulations are first validated and then applied to improve the hot zone design in the furnace. The numerical results reveal that, an additional guiding plate weakens the strength of vortex and improves the desired profile of the crystal-melt interface. Based on the steady solutions at an early stage, detailed transient processes of crystal growth can be simulated. Accuracy of the results is supported by comparing the evolutions of crystal heights with the experimental measurements. The excellent agreements demonstrate the applicability of the present numerical methods in simulating a practical and complex system of directional solidification system.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2004.08a
• /
• pp.479-482
• /
• 2004

We report a method for simultaneous measurements of cell gap, twist angle, birefringence dispersion of liquid crystal (LC) material and alignment directions in filled reflective LC cells. The method is based on spectral measurements of the LC cell reflectivity for three orientations ($0^{\circ},45^{\circ},90^{\circ}$) of the exit polarizer and may be applied for LC cells with low and high gaps.

• Textile Coloration and Finishing
• /
• v.6 no.1
• /
• pp.44-48
• /
• 1994

Cellulose triacetate(CTA) liquid crystal solutions obtained via dissolution of CTA in solvent mixture of triflucroacetic acid and methylene chloride were spun and saponified in various chemicals. Among chemicals, methanol/sodium hydroxide mixture endowed highest tenacity as well as modulus to regenerated cellulosic fiber and the fiber thereof showed Cell I or Cell IV morphology, or mixed morphology of Cell I and IV.

• Proceedings of the Korea Crystallographic Association Conference
• /
• 2002.11a
• /
• pp.24-24
• /
• 2002

HtrA (high temperature requirement A), a periplasmic heat shock protein, is known to have molecular chaperone function at low temperatures and proteolytic activity at elevated temperatures. To investigate the mechanism of functional switch to pretense, we have determined the crystal structure of the N-terminal protease domain (PD) of HtrA from Thermotoga maritima. HtrA PD shares the same fold with chymotrypsin-like serine professes. However, crystal structure suggests that HtrA PD is not an active pretense at current state since its active site is not formed properly and blocked by an additional helical lid. On the surface of the lid, HtrA PD has hydrophobic patches that could be potential substrate binding sites for molecular chaperone activity. Present structure suggests that the activation of the proteolytic function of HtrA PD at elevated temperatures might occur by the conformational change.

• Journal of Microbiology and Biotechnology
• /
• v.32 no.1
• /
• pp.37-45
• /
• 2022

The fungal cell wall and membrane are the principal targets of antifungals. Herein, we report that myricetin exerts antifungal activity against Candida albicans by damaging the cell wall integrity and notably enhancing the membrane permeability. In the presence of sorbitol, an osmotic protectant, the minimum inhibitory concentration (MIC) of myricetin against C. albicans increased from 20 to 40 and 80 ㎍/ml in 24 and 72 h, respectively, demonstrating that myricetin disturbs the cell wall integrity of C. albicans. Fluorescence microscopic images showed the presence of propidium iodide-stained C. albicans cells, indicating the myricetin-induced initial damage of the cell membrane. The effects of myricetin on the membrane permeability of C. albicans cells were assessed using crystal violet-uptake and intracellular material-leakage assays. The percentage uptakes of crystal violet for myricetin-treated C. albicans cells at 1×, 2×, and 4× the MIC of myricetin were 36.5, 60.6, and 79.4%, respectively, while those for DMSO-treated C. albicans cells were 28.2, 28.9, and 29.7%, respectively. Additionally, myricetin-treated C. albicans cells showed notable DNA and protein leakage, compared with the DMSO-treated controls. Furthermore, treatment of C. albicans cells with 1× the MIC of myricetin showed a 17.2 and 28.0% reduction in the binding of the lipophilic probes diphenylhexatriene and Nile red, respectively, indicating that myricetin alters the lipid components or order in the C. albicans cell membrane, leading to increased membrane permeability. Therefore, these data will provide insights into the pharmacological worth of myricetin as a prospective antifungal for treating C. albicans infections.

• The Korea Journal of Herbology
• /
• v.23 no.2
• /
• pp.25-31
• /
• 2008

Objectives : In order to distinguish morphological characteristics of trunk bark and root bark of Ulmus davidiana var. japonica (Rehder) Nakai and the trunk bark and root bark of Hemiptelea davidii Planchon were sampled and compared in terms of their external and internal features with flour states according to their medical use, through microscopic examination. Methods : The slice of the tested material made by paraffin section technique was colored with Safranine Malachite Green contrast methods, and the flour of it was mounted by the liquid made by the same ratio of each of glycerin, acetic acid, and water, and then observed and photographed by olymphus-BHT. Results : 1. Internal Features 1) A large parenchymatous cell was observed in the phloem of the slice of both trunk bark and root bark of Ulmi Cortex, However, both of the trunk bark and root bark of Hemipteleae Cortex did not have parenchymatous cell in the phloem; instead, stone cells including much square crystal of calcium oxalate were distributed around fiber bundle, and the parenchymatous cell included much druse crystal of calcium oxalate. 2) In both the Ulmi Cortex and Hemipteleae Cortex, rhytidome was observed in trunk bark, but not in root bark, but in the parenchymatous cell of the root bark of the Ulmi Cortex contained starch grain. 2. Flour States 1) In the flour of root bark of the Ulmi Cortex, a large parenchymatous cell was observed. However, in the flour of trunk bark and root bark of Hemipteleae Cortex, no parenchymatous eel was found; instead, stone cell including square crystal of calcium oxalate and druse crystal of calcium oxalate were observed. 2) There was no remarkable difference between the trunk bark and root bark of Hemipteleae Cortex. However, starch grain was contained in the parenchymatous cell of the root bark of Ulmi Cortex but not in the trunk bark of it. Conclusions : There were some morphological differences in external, internal, and flour parts of Ulmi Cortex and Hemipteleae Cortex. In particular, there was a morphological difference in flour states between the trunk bark and root bark of Ulmi Cortex, it is possible to use microscope to distinguish their flour states.