• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38C no.10
• /
• pp.928-936
• /
• 2013

3D crosstalk is one of the disturbing things to recognize 3D images. This is caused by the phenomenon that input image for left eye is transferred at the right eye and right eye is transferred at the left eye because of the imperfect isolation by the device characteristics. In this paper, we review the 3D PDP (Plasma Display Panel) operation using active shutter glasses and crosstalk measurement method and investigate the major cause of 3D crosstalk and extend conventional 3D crosstalk using full white and full black image input to Gray-to-Gray (GtoG) 3D crosstalk. We suggest a specific method to reduce Gray-to-Gray 3D crosstalk by using Look up Table (LUT) and sub-field mapping in PDP. And then, we verify the method by measuring GtoG 3D crosstalk rate through specific test images and numerical results.

• Journal of Information Display
• /
• v.13 no.2
• /
• pp.83-89
• /
• 2012

The crosstalk evaluation of multiview autostereoscopic three-dimensional (3D) displays is discussed, with both the human and technical factors investigated via image quality assessment. In the imaging performance measurements and analysis for a multiview autostereoscopic display prototype equipment, it was inferred that crosstalk would have both a positive and a negative effect on the imaging performance of the equipment. The importance of the attached diaphragm in the crosstalk evaluation was proposed and then experimentally verified, using the developed prototype equipment. The luminance distribution and crosstalk situation were given, with two different diaphragm arrays applied. The analysis results showed that the imaging performance of this 3D display system can be improved with minimum changes to the system structure.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.18 no.9
• /
• pp.943-951
• /
• 2008

In this paper, the mathematical model on crosstalk effect between acoustic noise sources is presented. Based on this model, a theoretical value to quantitate crosstalk effect of sources can be defined on the authority of reverberation property of surrounding which sources are located, relative magnitudes of sources and phase deference between acoustic wave transferred from all of sources. In order to verify crosstalk effect factor, experiments are made for two cases, weak and strong crosstalk effect condition, by using toro representative transfer path analysis(TPA) methods.

• Proceedings of the KIEE Conference
• /
• 2009.07a
• /
• pp.2211_2212
• /
• 2009

본 논문에서는 GaAs-Transistor가 접합된 전송선로 사이에서 발생되는 Crosstalk의 영향에 관한 연구를 하였다. 이 모델의 해석을 위해 인접선에서의 Crosstalk의 이론적인 접근을 하고, 3D Full Wave 시뮬레이션과 Circuit 시뮬레이션을 통해 해석하는 Crosstalk의 해석방법에 대한 모델을 제시하고자 한다. 또한 Coupling 된 Solder Bump의 Equivalent Circuit Model을 제시함으로써 Solder Bump의 Coupling이 Crosstalk의 영향에 미치는 영향에 대해 규명하고자 한다.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.10
• /
• pp.61-70
• /
• 1996

In this paper, we find the values of near-end crosstalk coefficient in striplines of a FR-4 multilayer PCB by an analytic method and a HSPICE simulation method, and define calcualtion errors in an analytic method and define the application range, and simualte near-end crosstalk coefficients of the FCT (fast CMOS TTL) in complicated striplines by HSPICE and analyze near-en crosstalk coefficients in relation to dielectric thickness and trace spaces of striplines. As a result, we analyze coupling structure of the near-end crosstalk in the coplicated sstriplines that are impedance matched and define a coupling formula of near-end crosstalk coefficients in general complicated striplines. Especially, it is approximated in the layout grade rule.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.31A no.8
• /
• pp.16-25
• /
• 1994

The prediction of crosstalk in one of important problems in estimating the EMC of a system for high speed digital signal transmission. Crosstalk curves are shown in terms of characteristic impedance of lines spacing between lines and rise time of pulse by using general multiple coupled transmission line equation and harmonic-balance method. The coupled symmetrical two-line on dielectric material epoxy-glass FR 4(${\varepsilon}_r$), is fabricated to measure crosstalk occuring at the near end and far end of the passive line. The inter-line is inserted to reduce crosstalk between two microstrip lines. The simulation results and the measurement results are shown and found to be very close.

• Proceedings of the Korean Information Science Society Conference
• /
• 2007.10b
• /
• pp.264-268
• /
• 2007

연결선(interconnect) 사이의 간섭으로 발생하는 crosstalk 지연시간(delay)을 제거하기 위한 두 가지의 방법을 제안 한다. (1) 체계적인 코드를 생성해내는 방법으로 crosstalk 지연시간(delay) 유발 경우를 두 가지의 종류로 분류하여 각각에 대해 버스(bus) 비트 수의 증가에 따른 analytic 한 코드 생성 공식을 유도하였다; (2) 부-버스(sub-bus) 간에 발생하는 crosstalk 지연시간(delay)을 기존의 방법에 비해 보다 효율적으로 제거하는, 즉 추가적인 차단 라인 (또는 complement 비트 라인)를 감소시키는 방법을 제안 한다. 두 연구 결과는 연결선 상의 데이터 전송에 따른 신뢰성, 지연시간 및 전력 소모 증가를 유발하는 crosstalk를 차단하는 엔코딩 기법으로 유용하게 사용될 것으로 보인다.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.11 no.3
• /
• pp.13-19
• /
• 2007

This paper described design method to minimize the crosstalk effect of multiaxis thrust measurement stand which can measure the thrust vector control performance of Solid Rocket Motor. This paper presents a theoretical solution for predicting the magnitude of crosstalk and calculates design sensitivity. The results indicate that the most important parameter of crosstalk is the displacement of flexure-loadcell-flexure assembly. And shape, dimension and mechanical properties of flexure and loadcell can also influence the magnitude of crosstalk.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.12B
• /
• pp.1548-1555
• /
• 2011

In ultra-deep submicron technology, minimization of propagation delay and power consumption on buses is one of the most important design objectives in system-on-chip (SOC) design. Crosstalk between adjacent wires on the bus may create a significant portion of propagation delay. Elimination or minimization of such faults is crucial to the performance and reliability of SOC designs. Most of the previous works on bus encoding are targeted either to minimize the bus switching or minimize the crosstalk delay, but not both. This paper proposes a new bus encoding scheme which can adaptively select one of functions "invert" and "logic-convert" according the number of bus switching on an encoded 4-bit cluster. This scheme leads to minimization of both crosstalk and bus switching. In experiment result, our proposed encoding technique consumes about 25% less power over the previous, while completely eliminating the crosstalk delay.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.42 no.5 s.335
• /
• pp.47-54
• /
• 2005

In this paper, novel test patterns and on-chip data are presented to indicate that the variation of coupling capacitance, ${\Delta}Cc$ by crosstalk can be larger than static coupling capacitance, Cc. It is also shown that ${\Delta}Cc$ is strongly dependent on the phase of aggressive lines. for anti-phase crosstalk ${\Delta}Cc$ is always larger than Cc while for in-phase crosstalk ${\Delta}Cc$ is smaller than Cc. HSPICE simulation shows good agreement with the measurement data.