• Journal of the Korean Society of Safety
• /
• v.25 no.6
• /
• pp.9-13
• /
• 2010

An experimental study for characteristics of soot were conducted at the post-flame region in jet diffusion flames, where carbon dioxide was used as additives in oxidizer stream. Light-extinction method was performed using He-Ne laser with wave length at 632.8nm for the measurement of relative soot density and soot volume fraction with dimensionless extinction coefficient, $K_e$ and mass specific extinction coefficient, ${\sigma}_s$. To increase of resolution, laser light was modified for sheet-form using concave, convex lenses and slit. C/H ratio was introduced for quantitative analysis of soot growth which is expressed by carbonization and dehydrogen. Also transmission electron microscopy(TEM) was used for observation of morphological shape. The results show that the relative soot density in the post-flame region was lower when carbon dioxide was added in oxidizer stream because of reduction of flame temperature.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.6 no.6
• /
• pp.113-131
• /
• 1998

The objective of the present study is to investigate the characteristics of the dividing flow in the laminar flow region. Using glycerine water solution(wt43%) for Newtonian fluid and the polymer of viscoelastic fluid(500wppm) for non-Newtonian fluid, this research investigates the flow state of the dividing tube in steady laminar flow region of the two dimensional dividing tube by measuring the effect of Reynolds number, dividing angle, and the flow rate ratio on the loss coefficient. In T- and Y-type tubes, the loss coefficients of the Newtonian fluid decreases in constant rate when the Reynolds number is below 100. The effect of the flow rate ratio on the loss coefficients is negligible. But when the Reynolds number is over 100, the loss coefficient with various flow rate ratios approach an asymptotic value. The loss coefficient of the non-Newtonian fluid for different the Reynolds number shows the similar tendency of the Newtonian fluid. And when the Reynolds number is over 300, the loss coefficient is approximately 1.03 regardless of flow rate ratio or the dividing angle. The aspect ratio does hardly influence the reattachment length and the loss coefficient of both Newtonian and non Newtonian fluid. The loss coefficient decreases as the Reynolds number increases. The loss coefficient of Newtonian fluid is larger than that of non-Newtonian fluid.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.27 no.5
• /
• pp.75-83
• /
• 2023

As part of a study to analyze the excessive camber occurring in prestressed concrete railway bridges, this paper presents a calculation method and analysis results for the creep coefficient which defines the increase in camber of a concrete structure over time. Using the creep coefficient formula of the design code, the coefficient is obtained by applying the climatic conditions (relative humidity and temperature) of 12 regions in Korea. The effects of differences in climatic conditions by region and starting time of load on the creep coefficient are analyzed. In order to properly calculate the creep, most of which occurs in the early stages of loading, a detailed analysis is performed by applying a time step analysis method to consider varying climate conditions through loaded period. The creep coefficient obtained by applying the average climate conditions of the region is similar to the average of the creep coefficients obtained by time step analysis. Through time step analysis, it is shown that the offset and overlap effects of relative humidity and temperature on the creep coefficient and the climate effect at the time of initial loading can be appropriately represented.

• Proceedings of the Acoustical Society of Korea Conference
• /
• autumn
• /
• pp.183-186
• /
• 2004

Biot's theory and a modified Biot-Attenborough (MBA) model are applied to predict the dependences of acoustic characteristics on frequency and porosity in cancellous bone. The phase velocity and the attenuation coefficient predicted by both theories are compared with previous in vitro experimental measurements in terms of the mixed, the fast, and the slow waves. Biot's theory successfully predicts the dependences of phase velocity on frequency and porosity in cancellous bone, whereas a significant discrepancy is observed between predicted and measured attenuation coefficients. The MBA model is consistent with reported measurements for both dependences of phase velocity and attenuation coefficient on frequency and porosity. Based on the theoretical predictions from the MBA model, it is suggested that the attenuation coefficient of the mixed wave is dominated by the fast wave in the low-porosity region while it is dominated by the slow wave in the high-porosity region. This provides a qualitative explanation for the nonlinear relationship of attenuation of the mixed wave with porosity in cancellous bone.

• Journal of the Korea Society of Computer and Information
• /
• v.3 no.3
• /
• pp.73-81
• /
• 1998

In this paper suggest for methods disease region feature extraction of medical image using wavelet. In the preprocessing, the shape informations of medical image are selected by performing the discrete wavelet transform(DWT) with four level coefficient matrix. In this approach, based on the characteristics of the coefficient matrix, 96 feature parameters are calculated as follows: Firstly. obtaining 32 feature parameters which have the characteristics of low frequency from the parameters according to the horizontal high frequency are calculated from the coefficient matrix of horizontal high frequency. In the third place, 16 vertical feature parameters are also calculated using the same kind of procedure with respect to the vertical high frequency. Finally, 32 feature parameters of diagonal high frequency are obtained from the coefficient matrix of diagonal high frequency. Consequently, 96 feature aprameters extracted. Using suggest algorithm in this paper will, implamentation can automatic recognition system, increasing efficiency of picture achieve communication system.

• Proceedings of the SAREK Conference
• /
• 2007.11a
• /
• pp.241-246
• /
• 2007

The present paper dealt with an experimental study of boiling heat transfer characteristics of $CO_2$. Heat transfer coefficients of the refrigerant flow inside horizontal smooth microchannel were obtained with inner tube diameter of 0.3mm and length of 300mm. The direct electric heating method was applied for supplying the heat uniformly to the refrigerant. The experiments were conducted with $CO_2$ purity of 99.99%, at saturation temperature of $10^{\circ}C$, mass flux ranges of $300{\sim}900\;kg/m^2s$, and heat flux ranges of $15{\sim}45\;kW/m^2$. While heat transfer coefficient increased with the increase of heat flux in the low quality region, the heat transfer coefficient decreased with the increase of quality in the high quality region. The heat transfer coefficients were compared with seven existing correlations with the Gungor-Winterton's(1986) correlation gave the best prediction. A new corelation to predict the two-phase flow heat transfer coefficient was developed based on the Chen(1966) correlation. The new correlation predicted the experimental data well with a mean deviation of 9.69% and average deviation of -3.03%.

• Proceedings of the IEEK Conference
• /
• 2000.11d
• /
• pp.53-56
• /
• 2000

In progressive image coding, if object region that have main contents in image are transmitted prior to the remained region, this method will be very useful. In this paper, the progressive image coding based on SPIHT using object region transmission method by priority is proposed. First, an original image is transformed by wavelet. Median filtering is used about wavelet transformed coefficient region for extracting object region. This extracted object region encoded by SPIHT. Then encoded object region are transmitted in advance of the remained region. This method is good to a conventional progressive image coding about entire original image. Experimental results show that the proposed method can be very effectively used for image coding applications such as internet retrieval and database searching system.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.11a
• /
• pp.170-170
• /
• 2009

From the analysis of current density-luminance-voltage characteristics of the double layered device in ITO/N,N'-diphenyl-N-N'bis(3-methylphenyl)-1,1'biphenyl-4,4'-diamine(TPD)/tris(8-hydroxyquinoline)aluminum($Alq_3$)/Al, we divided the conductive mechanism by four region according to applied voltage. We have obtained a coefficient of ${\beta}_{ST}$ in schottky region (I) is $4.14{\times}10^{-24}$ at the electric field of $3.2{\times}10^5$ V/cm, a slope in negative resistance region (II) appears negative properties decreasing the current density J for proportional in -1.58 square at a electric field of $7.3{\times}10^5$ V/cm. A coefficient of ${\beta}_{PF}$ in Poole-Frenkel region (III) is $8.28{\times}10^{-24}$ at the electric field of $8.4{\times}10^5$ V/cm, it was confirm어 that ${\beta}_{PF}$ is agrees with a value that relates with ${\beta}_{ST}$ such as ${\beta}_{PF}=2{\beta}_{ST}$ as the ${\beta}_{PF}$ and 2 ${\beta}_{ST}$ satisfied a theoretical prediction. And it was obtained a potential barrier of ${\Phi}_{FN}$ in Fower-Nordheim region(IV) is 0.3 eV at the electric field of $11.2{\times}10^5$ V/cm.

• The KIPS Transactions:PartB
• /
• v.18B no.5
• /
• pp.265-270
• /
• 2011

In this paper, we propose a method for intensity correction using binarization-based region segmentation in 3D stereoscopic images. In the proposed method, 3D stereoscopic right image is segmented using binarizarion. Small regions in the segmented image are eliminated. For each region in right image, a corresponding region in left image is decided through region matching using correlation coefficient. When region-based matching, in order to prevent overlap between regions, we remove a portion of the area closed to the region boundary using morphological filter. The intensity correction in left and right image can be performed through histogram specification between the corresponding regions. Simulation results show the proposed method has the smallest matching error than the conventional method when we generate the right image from the left image using block based motion compensation.

• Journal of Advanced Marine Engineering and Technology
• /
• v.14 no.2
• /
• pp.48-65
• /
• 1990

Numerical solutions of the Navier-Stokes equations, governing 2-dimensional, time-dependent, viscous, incompressible fluid flow past a square cylinde in an infinite region, are presented for Reynolds numbers $10^2$, $10^3$and $10^4$. Finite-difference scheme, based on SOLA-VOF is adopted and a discretization of the convection term for irregular grid is newly suggested by altering the original nonconservation form into conservation one. Distribution of finer grids around the body reveals fairly reasonable consistency with the experimental variables : drag coefficient, lift coefficient, Strouhal number, fluctuating pressure coefficient, etc.