• Magazine of the Korean Society of Agricultural Engineers
• /
• v.45 no.5
• /
• pp.133-139
• /
• 2003

Dredged soil from sea has much higher water content than liquid limit of clay and even if small loads apply, it will suffer a great settlement. Therefore it is very difficult to perform a consolidation test with general consolidation apparatus because of high water content. In this study Rowe Cell Apparatus consolidation tests have been performed with 1 remolding clay of water content 56% and 4 slurry clays of a water content of 100%, 120%, 133% and 150%. From the test results the consolidation characteristics such as compression index, secondary compression index and consolidation coefficient have been investigated with a variation of water content of dredged soil. The equations to get consolidation constants such as a compression index, a consolidation coefficient have been proposed with the field water content.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2010.09a
• /
• pp.1156-1167
• /
• 2010

The constant rate of strain (CRS) consolidation test has been widely used to evaluate consolidation characteristics of soils instead of the standard Incremental Loading Test. In practical problems, after the ground improvement, the condition of the soil is over-consolidated. Therefore, it is important to determine the recompression indices and the coefficient of consolidation(or the coefficient of swelling) of unloading-reloading cycle to predict the settlement behavior. However, since standard testing procedures or studies related with strain rate are insufficient especially in unloading-reloading cycle, it is difficult to predict the settlement field behavior accurately from the CRS consolidation test results in spite of its lots of strengths. The several CRS consolidation tests were performed changing the unloading strain rate from 0.2%/hr to 20%/hr with vertical drainage condition using the reconstituted kaolinite sample. For the reconstituted kaolinite sample in CRS consolidation test, the recompression indices are insensitive to the strain rate. It is revealed that the coefficient of consolidation of reloading is affected by the developed pore pressure during unloading. Additionally, the test should be conducted in the positive pore pressure ratio range (3~15%) to obtain the reasonable coefficient of consolidation in the whole range(loading, unloading and reloading).

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.10a
• /
• pp.1109-1114
• /
• 2008

To investigate the effect of sample size on coefficient of consolidation of non-homogeneous soil, the result of a large size consolidation test using a huge undisturbed sample with $1200mm(D){\times}2000mm(H)$ in dimension is compared with that of oedometer test using undisturbed small sample. In addition, test results are compared with those of same test using remold sample. Experimental results show that, due to the lump of sand/silt was mixed in sample, the coefficient of consolidation of undisturbed samples have a difference for each tests. Whereas, the difference of coefficient of consolidation between remolded large and small samples is not found. Because sample size affects the test results, sample must be carefully selected for non-homogeneous soil.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2004.03b
• /
• pp.672-677
• /
• 2004

This paper is on determination method of preconsolidation pressure and consolidation coefficient using Kores University Calibration Chamber System(KUCCS). High-quality, large-size cohesive soil specimen was prepared by using two-stage slurry consolidation technique, which has many advantage for research and calibration purpose. The result from consolidation stage in KUCCS was compared with results of oedometer test. The results by Casagrcnde method gave very good agreement with preconsolidation pressure in slurry consolidometer. And, the predicted consolidation coefficient by log t method showed agreement with the experimental results in KUCCS.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.31 no.1
• /
• pp.106-116
• /
• 1989

This study aims at scrutinizing the long4errn consolidation characteristics of peats sampled at three different regions of Chonbuk province. The standard consolidation test and the single load consolidation test were performed about these samples and especially in case of the latter the loading period was 350 days. The main condusions analyzed are as follows. 1. Void ratio showed much greater values than that of the general clay and was decresed greatly according to the increase of the load. 2. In case of the relationship between the sefflement and the long-term settlement time the rate of settlement increment became great according to the increase of the load step and the long4erm settlement became linely proportional to the logarithm of time alter 10 minutes. 3. The linear correlation was showed between the long4erm settlement time and the void ratio and therefore equations by regression analysis were derived in order to estimate the long-term settlement The slope of straight lines increased according th the increase of the load step and secondary consolidation coefficients ranged from 0.04-0.27. 4. The secondary consolidation coeffcient became linealy proportional to the compression index and the ratio of Ca to CC was 0.072. 5. The period required in ending the primary consolidation was about 10 minutes and alter that the secondary consolidation coefficient appeared to have constant value. Therefore the secondary consolidation coefficient was judged to be used as a significant factor in estimating the long4erm settlement. 6. In case of the single load consolidation test the secondary consolidation coefficient showed the tendancy increasing according to the increase of the consolidation pressure.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.56 no.1
• /
• pp.101-107
• /
• 2014

It has been known that Terzaghi's consolidation theory is not well consistent with the consolidation phenomenon on the soft clay ground, but this theory has still been adopted normally in practice because there is no method for estimating the consolidation settlement and rate easier than Terzaghi's theory. It is impossible to map whole part of consolidation settlement vs time curve to the curve of Terzaghi'z average degree of consolidation. If the primary consolidation and the secondary compression are happened same time, it would be useless of trying to find the end of primary consolidation, but it is needed for using Terzaghi's theory that the end of consolidation is determined to the time of beginning consistency between the final settlement analyzed with curve fitting and the experimented consolidation settlement.

• Journal of the Korean Geotechnical Society
• /
• v.23 no.8
• /
• pp.129-135
• /
• 2007

In order to analyze the effect of fines content on sedimentation and self-weight consolidation characteristics of dredged soil, a series of self-weight consolidation tests with different fines content were conducted. From the experimental test results on dredged soils, it was found that the coefficient of sedimentation and consolidation is correlated with water content. And it is related to fines content as well. So, in this study, correlation between fines content and the coefficient of sedimentation and consolidation has been proposed. And it is expected that the coefficient of sedimentation and consolidation can be estimated by the percentage of fines content.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2009.03a
• /
• pp.715-719
• /
• 2009

In this study, a method to predict the consolidation behavior of soft clays and marine clays was developed by combining the equation of Terzaghi's 1-dimensional consolidation and CPTu dissipation. The special attention was given to the consolidation anisotropy due to the difference between 1-D consolidation and radial consolidation of CPTu dissipation. The analysis combining two equations enables direct application of CPTu results. And above all it doesn't require to sample undisturbed specimens and determine consolidation coefficient which is both costly and time consuming and often contains measuring error. It is also advantageous that CPTu test can be carried out any position and any depth. Clays typically have a greater horizontal permeability, $k_h$, than vertical permeability, $k_v$, and the coefficient of consolidation in the horizontal direction is generally higher than the vertical direction. Various data of horizontal and vertical consolidation coefficient ratio were collected and analyzed to develop and verify the method.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.33 no.4
• /
• pp.96-104
• /
• 1991

The research effort has been focused on better calculation methods for the coefficient of consolidation under the theory of one dimensional consolidation. This research has been made available to engineers in the form of the computer program COMCv. The following conclusions can be drawn from the result of the engineering analysis, programming, and field observations. 1.Performing comparative study on six mehods(Taylor, Casagrande, Sivaram & Swamee,Su, Cour, and Scott) which can find out the coefficient of consolidation, the computer program COMCv is developed for each method. 2.Comparing the observed settlement and computed one in use of the coefficient of consolidation computed with COMCv, the result by the method of Sivaram & Swamee, Taylor, and Su is closer to the observed settlement.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2003.03a
• /
• pp.365-368
• /
• 2003

Despite of the simple equipment and operation, DMT has been widely used to obtain various soil parameters and those parameters have been successfully applied to geotechnical design practice. Among them, the estimation of horizontal coefficient of consolidation is so useful that many researchs recently have been carried out. However, simulation of the penetration of the DMT blade is complex due to the inherent difficulty on analyzing a plane strain deformation of the soil around blade. Therefore, empirical and semi-empirical methods that use the theoretical solution developed fur piezocone with some assumptions have been used to estimate the coefficient of consolidation from Dilatometer dissipation test. In this paper, coefficients of consolidation c$\_$h/ which were obtained using equivalent radius that is same area with the DMT blade and optimization technique are compared with those obtained from Oedometer test and other interpretation methods. It was found that a new method used in this study can give more precise horizontal coefficient of consolidation than other methods do.