• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.9
• /
• pp.2074-2079
• /
• 1997

Much recent work has been done in the two related areas of source coding for data compression, and channel coding for data storage, respectively. We propose two (0, k) run-lengh limited(RLL) data compression codes for the storage that combine source and channel coding. It was shown that the propsoed codes approach the maximum code rate of (0, k) code as k increase. Thus, the overall code rate of storage system can be increased by using the combined source/channel coding as compared to the conventional 8/9 code which is popular in hard drive systems Functhermore, one can also reduce the complexity of modulation coding procedure by using already RLL constrained data.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.4
• /
• pp.830-837
• /
• 2009

In this thesis, Multi-code/Multi-carrier CDMA(MC/MC CDMA) system which is combination of Multi-code CDMA and Multi-carrier CDMA is analyzed. This system is suitable fur multi-rate services that use multi-codes and high data rate transmission that employ multi-carriers. In addition, the MC/MC CDMA system is robust against frequency selective fading, is good for narrowband interference rejection, and has higher spectral efficiency. In this paper, The users are assigned OVSF codes as a spreading code according to their data rates and divides the active users having different representative code split into a number of groups for effective cancellation. At the receiver, The code grouping interference canceller performs cancellation between the groups. The proposed receiver does not require any information about interference users, such as code, data and amplitude, and has relatively low complexity. The results show the large improvement in performance that can be attained by cancellation scheme.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.10A
• /
• pp.807-815
• /
• 2003

MultiCode-CDMA (MC-CDMA) system of chip level MPSK incorporating with clipper (MP-CDMA)[l] shows constant envelope signal which can mitigate the performance degradation due to nonlinear transmit amplifier. In this paper, modulation is modified to carry out differential encoded MPSK rather than MPSK. The modified system is called DMP-CDMA. DMP-CDMA using differential detection has advantages on receiver complexity and pilot overhead. However, it is inferior to coherent detection by about 4.0dB due to inherent power inefficiency of noncoherent detection and the error propagation. Multiple symbol differential detection is employed in order to improve DMP-CDMA using differential detection. As the result, the performance of DMP-CDMA system is improved about 3.6dB compared to differential detection.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.9
• /
• pp.1095-1102
• /
• 2016

In this paper, we propose a decoding scheme that can apply to a three dimensional turbo product code(TPC) with a single parity check code(SPC). In general, SPC is used an axis with shortest code length in order to maximize a code rate of the TPC. However, SPC does not have any error correcting capability, therefore, the error correcting capability of the three-dimensional TPC results in little improvement in comparison with the two-dimensional TPC. We propose two schemes to improve performance of three dimensional TPC decoder. One is $min^*$-sum algorithm that has advantages for low complexity implementation compared to Chase-Pyndiah algorithm. The other is a modified serial iterative decoding scheme for high performance. In addition, the simulation results for the proposed scheme are shown and compared with the conventional scheme. Finally, we introduce some practical considerations for hardware implementation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.11A
• /
• pp.1244-1252
• /
• 2004

In this paper, we derive some properties of linear detectors (zero forcing or minimum mean square error) at spatial multiplexing systems with alamouti's space-time block code. Based on the derived properies, this paper proposes low-complexity receivers. Implementing MMSE detector adaptively, the number of weight vectors to be calculated and updated is greatly reduced with the derived properties compared to the conventional methods. In the case of recursive least square algorithm, with the proposed approach computational complexity is reduced to less than the half. We also identify that sorted QR decomposition detector, which reduces the complexity of V-Blast detector, has the same properties for unitary matrix Q and upper triangular matrix R. A complexity reduction of about 50%, for sorted QR decomposition detector, can be achieved by using those properties without the loss of performance.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.10 s.101
• /
• pp.965-972
• /
• 2005

In this paper, we first review LDPC codes in general and a belief propagation algorithm that works in logarithm domain. LDPC codes, which is chosen for second generation digital video broadcasting standard, are required a large number of computation due to large size of coded block and iteration. Therefore, we presented two kinds of low computational algorithm for LDPC codes. First, sequential decoding with partial group is proposed. It has same H/W complexity, and fewer number of iteration's are required at same performance in comparison with conventional decoder algerian. Secondly, early detection method for reducing the computational complexity is proposed. Using a confidence criterion, some bit nodes and check node edges are detected early on during decoding. Through the simulation, we knew that the iteration number are reduced by half using subset algorithm and computational complexity of early detected method is about $50\%$ offs in case of check node update, $99\%$ offs in case of check node update compared to conventional scheme.

• ETRI Journal
• /
• v.38 no.4
• /
• pp.612-621
• /
• 2016

A new time-domain decoder for Reed-Solomon (RS) codes is proposed. Because this decoder can correct both errors and erasures without computing the erasure locator, errata locator, or errata evaluator polynomials, the computational complexity can be substantially reduced. Herein, to demonstrate this benefit, complexity comparisons between the proposed decoder and the Truong-Jeng-Hung and Lin-Costello decoders are presented. These comparisons show that the proposed decoder consistently has lower computational requirements when correcting all combinations of ${\nu}$ errors and ${\mu}$ erasures than both of the related decoders under the condition of $2{\nu}+{\mu}{\leq}d_{\min}-1$, where $d_{min}$ denotes the minimum distance of the RS code. Finally, the (255, 223) and (63, 39) RS codes are used as examples for complexity comparisons under the upper bounded condition of min $2{\nu}+{\mu}=d_{\min}-1$. To decode the two RS codes, the new decoder can save about 40% additions and multiplications when min ${\mu}=d_{min}-1$ as compared with the two related decoders. Furthermore, it can also save 50% of the required inverses for min $0{\leq}{\mu}{\leq}d_{\min}-1$.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.8
• /
• pp.1839-1844
• /
• 2015

The low-density parity-check(LDPC) code has been adopted in many communication standards due to its error correcting performance, and the quasi-cyclic LDPC(QC-LDPC) is widely used because of implementation easiness. In the QC-LDPC decoder, a cyclic-shifter is required to rotate data in various sizes. This kind of cyclic-shifters are called multi-size circular shifter(MSCS), and this paper proposes a low-complexity structure for MSCS. In the conventional serially-placed two barrel-rotators, the unnecessary multiplexers are revealed and removed, leading to low-complexity. The experimental results show that the area is reduced by about 12%.

• Journal of Communications and Networks
• /
• v.17 no.4
• /
• pp.339-345
• /
• 2015

In this paper, we present an iterative reliability-based modified majority-logic decoding algorithm for two classes of structured low-density parity-check codes. Different from the conventional modified one-step majority-logic decoding algorithms, we design a turbo-like iterative strategy to recover the performance degradation caused by the simply flipping operation. The main computational loads of the presented algorithm include only binary logic and integer operations, resulting in low decoding complexity. Furthermore, by introducing the iterative set, a very small proportion (less than 6%) of variable nodes are involved in the reliability updating process, which can further reduce the computational complexity. Simulation results show that, combined with the factor correction technique and a well-designed non-uniform quantization scheme, the presented algorithm can achieve a significant performance improvement and a fast decoding speed, even with very small quantization levels (3-4 bits resolution). The presented algorithm provides a candidate for trade-offs between performance and complexity.

• Journal of Korea Society of Digital Industry and Information Management
• /
• v.12 no.4
• /
• pp.33-40
• /
• 2016

Previous works for detecting arrhythmia have mostly used nonlinear method to increase classification accuracy. Most methods require accurate detection of ECG signal, higher computational cost and larger processing time. But it is difficult to analyze the ECG signal because of various noise types. Also in the healthcare system based IOT that must continuously monitor people's situation, it is necessary to process ECG signal in realtime. Therefore it is necessary to design efficient algorithm that classifies different arrhythmia in realtime and decreases computational cost by extrating minimal feature. In this paper, we propose R wave detection considering complexity and arrhythmia classification based on binary coding. For this purpose, we detected R wave through SOM and then RR interval from noise-free ECG signal through the preprocessing method. Also, we classified arrhythmia in realtime by converting threshold variability of feature to binary code. R wave detection and PVC, PAC, Normal classification is evaluated by using 39 record of MIT-BIH arrhythmia database. The achieved scores indicate the average of 99.41%, 97.18%, 94.14%, 99.83% in R wave, PVC, PAC, Normal.