• Korean Chemical Engineering Research
• /
• 제50권6호
• /
• pp.960-968
• /
• 2012

In this study, the measurement of physical properties of 3 different ethylene oxide adducted zwitterionic surfactants were measured such as critical micelle concentration, surface tension, interfacial tension, contact angle, viscosity and foam stability. Also, the dual function characteristics of the zwitterionic surfactants were investigated by determining an isoelectric point, which were obtained using zeta potential measurement and QCM (quartz crystal microbalance) experiments. The isoelectric point of the synthesized zwitterionic surfactant determined by zeta potential measurement was close to that obtained by QCM experiment and both results have shown almost the same trend as that determined by the frictional property measured using an automated mildness tester. In particular, it has been observed that all three surfactants used during this study provide better softening effect at a pH of neutral condition than at an acidic or an alkaline condition. This result indicates that the synthesized surfactants act as a cationic surfactant at a pH of neutral condition and thus provide good softening effect during a rinsing cycle in the detergency process.

• Korean Chemical Engineering Research
• /
• 제52권2호
• /
• pp.219-225
• /
• 2014

In this study, effect of cosurfactant on the solubilization rate of n-octane, n-decane and n-dodecane oil was performed by micellar solutions of polymeric nonionic surfactant Pluronic L64($EO_{13}PO_{30}EO_{13}$) at room temperature. It has been found that the solubilization rate of a hydrocarbon oil was enhanced with an increase in both chain length and amount of alcohol added. In case of addition of a short chain alcohol such as 1-butanol, the solubilization rate of a hydrocarbon oil was slightly increased since most of alcohol molecules remained in an aqueous surfactant solution. On the other hand, the addition of a relatively long chain alcohol such as 1-hexanol and 1-octanol produced a big increase in solubilization rate of a hydrocarbon oil mainly due to incorporation of alcohol molecules into micelles and thus producing more flexible micellar packing density. Dynamic interfacial tension measurements showed the same trend found in solubilization rate measurement. Both interfacial tension value at equilibrium and time required to reach equilibrium decreased with an increase in chain length of an alcohol.

• Journal of the Korean Chemical Society
• /
• 제55권3호
• /
• pp.379-384
• /
• 2011

The critical micelle concentration (CMC) and the counter ion binding constant (B) for the mixed micellizations of DBS (sodium dodecylbenzenesulfonate), SDS (sodium dodecylsulfate), and Brij 30 (polyoxyethylene(4) lauryl ether) at $25^{\circ}C$ in pure water were determined by the use of electric conductivity and surface tension measuring methods. Various thermodynamic parameters ($X_i,\;{\gamma}i,\;C_i,\;a_i^M,\;{\beta}$, and ${\Delta}H_{mix}$) were calculated and compared with each other mixed surfactant system by means of the equations derived from the nonideal mixed micellar model. The results show that the SDS molecule interacts more strongly with Brij 30 molecule than DBS molecule and that the SDS/Brij 30 mixed surfactant system has the greatest negative deviation from the ideal mixed micellar model and the SDS/DBS mixed system has followed almost the ideal mixed micellar model.

• Journal of the Korean Chemical Society
• /
• 제51권2호
• /
• pp.129-135
• /
• 2007

The critical micelle concentrations (CMC) and the counter ion binding constants (B) in a micellar state of the mixed surfactant systems of Tetradecyltrimethylammonium bromide (TTAB) with Polyoxyethylene(23) lauryl ether (Brij 35) in water were determined as a function of α1 (the overall mole fraction of TTAB) by the use of electric conductivity method and surface tensiometer method from 15 oC to 35 oC. Values of thermodynamic parameters (ΔGom, ΔHom, and ΔSom) for the micellization of TTAB/Brij 35 mixtures were calculated and analyzed from the temperature dependence of CMC values. The results say that the measured values of ΔGom are all negative at the whole measured condition but the values of ΔSom and ΔHom are positive or negative, depending on the measured temperature and α1.

• Journal of the Korean Chemical Society
• /
• 제43권2호
• /
• pp.172-181
• /
• 1999

To develop the manufacturing technique for the powder builder of amorphous solid types, the water glass mixed with caustic soda dispersed into the methanol. Thus soluble sodium silicate was made a form of amorphous solid powder. In order to examine characteristics of water soluble sodium silicate $SiO_2/Na_2O$ mol ratio, we investigated solubility, thermogram, SEM, and BET analysis. pH buffering capacity, calcium-ion binding capacity as temperature change, and surfactant loading capacity were examined for characteristics as laundry detergent builder. $SiO_2/Na_2O$ molar ratio of soluble sodium silicate was 1.0, 2.4, 2.8, and zeolite was used in order to investigate basic characteristics of laundry detergent builder. Silicate used with laundry detergent was good for pH buffering capacity and solubility. But calcium-ion binding capacity and surfactant adsorption ability were lower. $SiO_2/Na_2O$ mol ratio became higher, pH buffering capacity and ion exchange ability were lower and surfactant adsorption ability was a little higher.

• Clean Technology
• /
• 제9권1호
• /
• pp.9-21
• /
• 2003

CFC-113 and 1,1,1-TCE which are ozone destruction substances are not used any more in the advanced countries because of Montreal protocol. MC and TCE are now used restrictively at small part of industrial fields in most of countries since they are known to be hazardous or carcinogenic materials. Thus, it is indispensible that the alternative cleaning agents which are environmental-friendly and safe, and show good cleaning ability should be developed or utilized for replacement of the halogenated cleaning agents. Aqueous cleaning agents are evaluated to be promising alternative ones among various alternatives in environmental and economical view point. This study has been carried out as a part of development program of aqueous cleaning agent. First of all, several types of surfactants which are the most important component in aqueous cleaning agents were chosen, and the physical properties, foaming ability, cleaning ability and oil-water separation efficiency of their aqueous solutions were measured and compared for selection of proper type of surfactant in aqueous cleaning agents.

• Applied Chemistry for Engineering
• /
• 제20권1호
• /
• pp.15-20
• /
• 2009

In this study, solubilization experiments of n-octane oil were performed by micellar solutions of polymeric nonionic surfactant Pluronic L64 ($EO_{13}PO_{30}EO_{13}$) at room temperature. A single spherical drop of n-octane was injected into aqueous surfactant solution using an oil drop contacting technique and solubilization rate of n-octane was measured by observing the size of oil drop with time. It was found that solubilization rate was independent of initial oil drop size but inversely proportional to the initial surfactant concentration. These results revealed that solubilization of n-octane oil by L64 micellar solution is controlled by interface-controlled mechanism rather than diffusion-controlled mechanism. Dynamic interfacial tension measurements showed that interfacial tension decreases such as from $2.59{\times}10^{-2}$ to $2.45{\times}10^{-2}$, and further to $2.13{\times}10^{-2}mN/m$ as surfactant concentration increases from 8 to 9 and further to 10 wt% respectively. The equilibration time was also found to decrease slightly with an increase in surfactant concentration. All three systems reached an equilibrium within 7 minutes.

• Journal of the Korean Applied Science and Technology
• /
• 제31권4호
• /
• pp.612-622
• /
• 2014

In this study, we investigated the solubilization 4-chlorobenzoic acid in a wide range of temperature using a zwitterionic surfactant of lauryl sulfobetaine(LSB) and mixed surfactant systems. The effects of temperature and alkyl-group's length of surfactant molecule on the solubilization of 4-chlorobenzoic acid have been measured. The solubilization constants ($K_s$) were taken by the UV/Vis spectrophotometric method, plotting the total absorbance of the solution versus the surfactant concentration. The results show that the values of ${\Delta}G^o_s$ are all negative within the measured temperature range and decrease by increasing temperature, And also the measured values of ${\Delta}H^o_s$ and ${\Delta}S^o_s$ are all positive and increase by increasing temperature. The values of $K_s$ and thermodynamic parameters are simultaneously dependent on the temperature and the kinds of surfactant molecules. From the results we can postulate the solubilization site of 4-chlorobenzoic acid within the micelle.

• Journal of the Korean Applied Science and Technology
• /
• 제37권3호
• /
• pp.438-447
• /
• 2020

The critical micelle concentration (CMC) values of the mixed surfactant systems and the solubilization conatant (K_s) values of 4-ethylaniline in those solutions were measured and analyzed by the UV-Vis method. As a result, the mixed surfactant systems of TTAB/LSB and TTAB/TX-100 did not deviate significantly from ideal mixed micellization. However, the mixed systems of SDS/LSB and SDS/TX-100 showed great negative deviations from ideal mixed model. These differences showed that the intensity of the interaction between two components in the mixed micelle was different for each mixed system and that these differences greatly influenced the solubilization of 4-ethylaniline by a mixed surfactant system. Among pure surfactants, an anionic surfactant such as SDS showed a greater K_s value than other ionic surfactants, and the K_s value by each surfactant system decreased in the order of SDS≫TTAB≧LSB>TX-100. In addition, the K_s values of all the mixed surfactant systems were higher than those of the pure surfactants constituting the mixed systems.

• Journal of Environmental Science International
• /
• 제19권5호
• /
• pp.549-563
• /
• 2010

The environmental behaviors of polycyclic aromatic hydrocarbons (PAHs) are mainly governed by their solubility and partitioning properties on soil media in a subsurface system. In surfactant-enhanced remediation (SER) systems, surfactant plays a critical role in remediation. In this study, sorptive behaviors and partitioning of naphthalene in soils in the presence of surfactants were investigated. Silica and kaolin with low organic carbon contents and a natural soil with relatively higher organic carbon content were used as model sorbents. A nonionic surfactant, Triton X-100, was used to enhance dissolution of naphthalene. Sorption kinetics of naphthalene onto silica, kaolin and natural soil were investigated and analyzed using several kinetic models. The two compartment first-order kinetic model (TCFOKM) was fitted better than the other models. From the results of TCFOKM, the fast sorption coefficient of naphthalene ($k_1$) was in the order of silica > kaolin > natural soil, whereas the slow sorbing fraction ($k_2$) was in the reverse order. Sorption isotherms of naphthalene were linear with organic carbon content ($f_{oc}$) in soils, while those of Triton X-100 were nonlinear and correlated with CEC and BET surface area. Sorption of Triton X-100 was higher than that of naphthalene in all soils. The effectiveness of a SER system depends on the distribution coefficient ($K_D$) of naphthalene between mobile and immobile phases. In surfactant-sorbed soils, naphthalene was adsorbed onto the soil surface and also partitioned onto the sorbed surfactant. The partition coefficient ($K_D$) of naphthalene increased with surfactant concentration. However, the $K_D$ decreased as the surfactant concentration increased above CMC in all soils. This indicates that naphthalene was partitioned competitively onto both sorbed surfactants (immobile phase) and micelles (mobile phase). For the mineral soils such as silica and kaolin, naphthalene removal by mobile phase would be better than that by immobile phase because the distribution of naphthalene onto the micelles ($K_{mic}$) increased with the nonionic surfactant concentration (Triton X-100). For the natural soil with relatively higher organic carbon content, however, the naphthalene removal by immobile phase would be better than that by mobile phase, because a high amount of Triton X-100 could be sorbed onto the natural soil and the sorbed surfactant also could sorb the relatively higher amount of naphthalene.