• Proceedings of the IEEK Conference
• /
• 1998.10a
• /
• pp.43-46
• /
• 1998

The performance of a receiver that empolys a multi-stage inter-ference cancellation scheme for uplink fading channel is analyzed when there is carrier frequency offset. And the conditions to permit the performance improvement are analytically obtained. Numerical results show the effectiveness of the proposed system under Rayleigh fading channel assuming that carrier frequency offset is present.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2000.10a
• /
• pp.235-238
• /
• 2000

In this paper the MUD(Multi-User Detection) schemes and turbo codes are utilized in DS-CDMA mobile communication systems. Theses schemes effectively mitigate the effects of MAI(Multiple Access Interference) and Rayleigh fading. Using Monte Carlo simulation, the performance of the proposed schemes is analyzed for various channel conditions.

• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.2 no.3
• /
• pp.17-23
• /
• 2003

Turbo decoding in combination with detection strategy for Multi Access Interference (MAI) cancellation has been shown to be very effective for MC-CDMA system in Rayleigh multi-path fading environment. This paper reports new simulation results on the efficacy of joint decoding and detection for MC-CDMA in nonlinear and fading channel.

• Proceedings of the IEEK Conference
• /
• 2002.06a
• /
• pp.41-44
• /
• 2002

Alamouti proposes a two branch transmit diver-sity scheme that provides the same diversity order as maximal ratio combining at the receiver. It has many advantages of no bandwidth expansion, not requiring channel information at the transmitter and simple maximum likelihood decoding at the receiver. Papadias and Foschini extend this sch-eme to four transmit antennas and suggest several schemes to decrease the interference component and allow the attainment of the open-loop capacity. This paper shows the performance of ZF and MM-SE schemes comparing with ideal case on 4xl sy-stem over BER and 10% outage capacity.

• Journal of Korea Multimedia Society
• /
• v.10 no.12
• /
• pp.1632-1644
• /
• 2007

Wireless Mesh Networks aim to attain large connectivity with minimum performance degradation, as network size is increase. As such, scalability is one of the main characteristics of Wireless Mesh Networks that differentiates it from other wireless networks. This characteristic creates the need for bandwidth efficiency strategies to ensure that network performance does not degrade as the size of the network increase. Several researches have been done to realize mesh networks. However, the researches conducted were mostly focused on a per TCP/IP layer basis. Also, the studies on bandwidth efficiency and bandwidth improvement are usually dealt with as separate issues. This paper aims to simultaneously study bandwidth efficiency and improvement. Aside from optimizing the bandwidth given a fixed capacity, the capacity is also increased using results of physical layer studies. In this paper, the capacity is improved by using the concept of non-overlapping channels for wireless communication. A channel allocation scheme is conceptualized to choose the transmission channel that would optimize the network performance parameters with consideration of chosen Quality of Service (QoS) parameters. Network utility maximization is used to optimize the bandwidth after channel selection. Furthermore, a routing scheme is proposed using the results of the network utilization method and the channel allocation scheme to find the optimal path that would maximize the network gain.

• Journal of Power Electronics
• /
• v.16 no.2
• /
• pp.805-814
• /
• 2016

Electric-field coupled power transfer (ECPT) systems have been proposed as an alternative wireless power transfer (WPT) technology in recent years. With the use of capacitive plates as a coupling structure, ECPT systems have many advantages such as design flexibility, reduced volume of the coupling structure and metal penetration ability. In addition, wireless communications are effective solutions to improve the safety and controllability of ECPT systems. This paper proposes a power and signal shared channel for electric-field coupled power transfer systems. The shared channel includes two similar electrical circuits with a band pass filter and a signal detection resistor in each. This is designed based on the traditional current-fed push-pull topology. An analysis of the mutual interference between the power and signal transmission, the channel power and signal attenuations, and the dynamic characteristic of the signal channel are conducted to determine the values for the electrical components of the proposed shared channel. Experimental results show that the designed channel can transfer over 100W of output power and data with a data rate from 300bps to 120 kbps.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.6
• /
• pp.630-639
• /
• 2008

In this paper, we investigate the cause of throughput degradation on the wireless local area network(WLAN) and the reason of interference level change attributed to the spanned frequency in the presence of electromagnetic interference. We also measured and quantified the electric field strength of interference which yields the abrupt change of the throughput. Two units of WLAN and one unit of AP(Access Point) are configured to maintain the radio link. As the sources of interference, both the co-channel and adjacent-channel interference are considered and the critical values of electric field are provided for each case. Our experimental observations show that the signal strength generated from these interference sources is at most less than 54 dBuV/m @3 m in order to coexist between WLANs and other low power radio devices without any noticeable throughput decreases. Based on our empirical results, as far as 802.11b WLAN is concerned, we believe that the current domestic limit of the signal strength for an extremely low power radio device, 30.9 dBuV/m @3 m, can be increased as much as 23.1 dB.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.4
• /
• pp.1-7
• /
• 2009

In this paper, the author presents the MIMO(Multi-Input Multi-Output) receiver algorithm with the capability of inter-cell or inter-sector interference cancellation over multi-antenna OFDM(Orthogonal Frequency Division Multiplexing) systems. As contrast with the previous research dealing with the filtering scheme at the time domain, the proposed algorithm is presented as the pre-filtering scheme which can be applicable to the frequency domain. Note that the proposed one can be implemented only by pilot symbols which are used in the channel estimation. In addition, it is analytically confirmed that the proposed scheme can be applied for either MIMO( C-SM(Collaborative-Spatial Multiplexing)) interference or SIMO(Single-Input Multi-Out) interference. The proposed receiver algorithm is verified by simulations over UL-PUSC SR off in IEEE 802.16e standard. From simulation results, it is confirmed that the proposed one can be applicable regardless of the kind of interference. Furthermore, it is verified that the performance is guaranteed even under Ole severe effect of interference and the improvement of system throughput is guaranteed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.6A
• /
• pp.573-587
• /
• 2007

In this paper, we analyze the adjacent interference between WCDMA and M-WiMAX systems in the 2.6GHz Band under the SISO (Single Input Single Output) configuration. The interference scenarios are characterized into 8 scenarios with different victim and interfering links. Among the 8 scenarios, we find that the most performance loss is observed in the scenarios of victim uplink suffering interference from downlink in both systems. Besides, guard band is applied to mitigate the adjacent interference in all the scenarios. Especially, we reveal that M-WiMAX system is much more sensitive to adjacent interference than WCDMA system due to the lower transmission power. In this paper, we consider the worst interference environment, where interferers always transmit with the maximum power, a loose spectrum mask is adapted, and no additional channel fitters are equipped in both systems.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.14 no.12
• /
• pp.4946-4960
• /
• 2020

In a device-to-device (D2D) underlaid cellular network, there exist two types of co-channel interference. One type is inter-layer interference caused by spectrum reuse between D2D transmitters and cellular users (CUEs). Another type is intra-layer interference caused by spectrum sharing among D2D pairs. To mitigate the inter-layer interference, we first derive the interference limited area (ILA) to protect the coverage probability of cellular users by modeling D2D users' location as a Poisson point process, where a D2D transmitter is allowed to reuse the spectrum of the CUE only if the D2D transmitter is outside the ILA of the CUE. To coordinate the intra-layer interference, the spectrum sharing criterion of D2D pairs is derived based on the (signal-to-interference ratio) SIR requirement of D2D communication. Based on this criterion, D2D pairs are allowed to share the spectrum when one D2D pair is far from another sufficiently. Furthermore, to maximize the energy efficiency of the system, a resource allocation scheme is proposed according to weighted graph coloring theory and the proposed ILA restriction. Simulation results show that our proposed scheme provides significant performance gains over the conventional scheme and the random allocation scheme.