• Journal of Acupuncture Research
• /
• v.26 no.5
• /
• pp.117-125
• /
• 2009

Objectives : This study is to research the trend of the Moxibustion-related studies and to establish the hereafter direction for the study on Moxibustion. Methods : We reviewed the domestic articles published last ten years(2000~2009). Results : We have searched 45 articles in 4 journals of Korean Acupuncture & Moxibusion, Korean Oriental Medicine, Korean Meridian & Acupoint, Korean Oriental Internal Medicine. 1. There were the most research done 2003, 2008. Both of them have 8 articles. In other years there were 2 or more articles. 2. The pattern of study was as follow: the clinical studies were 23, studies of phisical Characteristics and new moxibustion method were 9, the philological study were 5, the reviewed studies were 3, the experimental studies were 2 and the others were 5. The rate of clinical studies was increased. 3. In the clinical studies, the case-control study and non case-control study were more than case study. The disease after stroke were the most predominant. The rates of direct moxibustion and indirect moxibusion were similar. 4. After beginning 2000s, there were more studies of thermodynamic Characteristics. In the mid 2000s, there were more studies of new moxibustion method appearing. Conclusions : We need more studies about various kinds of diseases, side effect and aftereffects. There should be convenient and useful methods of moxibustion.

• 제어로봇시스템학회:학술대회논문집
• /
• 1994.10a
• /
• pp.232-237
• /
• 1994

An extended study of optimal thruster combination for simultaneous attitude and orbital maneuvers of a jet-controled spacecraft is conducted. In this case, the spacecraft has not enough number of thrusters to control the rotation and translation separately. Therefore, thrusters are employed by combining to eliminate their coupling effects. The combinations are determined to minimize the fuel consumption. The redundancy study for some thruster failure cases is also presented.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.45 no.4
• /
• pp.1-10
• /
• 2017

This study investigated indoor temperature and humidity control and PM1 and PM10 mitigation effects of a single green wall (Case 1), two green walls (Case 2), and two green walls plus a waterfall (Case 3) in comparison with a control without either a green wall or waterfall. Experiments were conducted in the office of Chungbuk National University from August to September, 2015. Experiments were carried out sequentially in the order of control, Case 1, Case 2, and Case 3. Data collected from August 17 to August 20, 2015 (Experiment 1), and from August 31 to September 3, 2015 (Experiment 2), when outdoor temperature was relatively constant, were analyzed. Plant volume ratios by indoor landscaping of the control, Case 1, Case 2 and Case 3 were 0.0, 0.6, 1.2, and 1.4%, respectively. Compared to the control, average temperatures of Case 1, Case 2 and Case 3 were decreased by 0.3~0.7, 0.7~0.9 and $1.0^{\circ}C$, respectively, and relative humidity was increased by 1.8~8.7, 9.2~14.6 and 14.8~21.9%, respectively. Three hundred minutes after exposure to mosquito repellent incense particles, the ratio of the remaining PM1 of the control, Case 1, Case 2 and Case 3 were 25.0, 22.0%, 21.2%, 17.3%, respectively, in Experiment 1 and 42.3, 28.9, 23.1, and 30.9%, respectively, in Experiment 2. As indoor greening increased the effect of indoor temperature, PM1 and PM10 mitigation were greater, and temperature and humidity were lower. The greater the relative humidity was, the faster PM1 and PM10 mitigation tended to be.

• Journal of The Korea Institute of Healthcare Architecture
• /
• v.24 no.3
• /
• pp.17-27
• /
• 2018

Purpose: This study aims to examine spatial characteristics of emergency department Chronologically through case studies; and to consider the social implication of these spatial changes. Methods: In this study, a total of eight emergency departments, one for each period, were selected in order to analyze the spatial characteristics. The spatial maps of Space Syntax were employed for analyzing case studies. Results: The spatial configuration of emergency department has been changed from five or more emergency department specialties to four or less specialties such as psychiatric, pediatrics, emergency, and trauma. In the case of care initiation area, the concentrated arrangement mode was switched from the distributed arrangement mode. The spatial maps indicate that it can be seen that the tree structure changes to an annular structure emphasizing the connection between the spaces in the emergency department. This shows that the space efficiency, safe, visual control and flexibility in the planning of the emergency department are important factors affecting the spatial structure of the emergency department. Implications: In the future, it is expected that Korean emergency department will be more focused on efficiency, safe, visual control, and flexibility in the planning as in the case studies of the United States.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.20 no.3
• /
• pp.163-169
• /
• 2016

In the case where a MR-damper is employed for vibration control, it is important to decide on how much control capacity should be assigned to it against structural capacities (strength and load, etc). This paper aims to present a MR-damper's control capacity suitable for the capacities of the structure which needs to be controlled. First, a two span bridge was built equipped with a MR-damper, which constitutes a two-span MR-damper control system. Then, inflicting an earthquake load on the system, a basic experiment was performed for vibration control, and a simulation was also carried out reflecting specific control conditions such as MR-damper and rubber bearing. The comparison of the results against each other proved their validity. Then, in order to calculate an optimal control capacity of the MR-damper, structural capacity was divided into eleven cases in total and simulated. For each case, an additional load of 30 KN was inflicted everytime, thereby increasingly strengthening structural capacity. As a result of the study, it was found that the control capacity of MR-damper of 30 KN was safely secured only with lumped mass of more than 150 KN(case 6). Therefore, it is concluded the MR-damper showed the best performance of control when it exerted its capacity at around 20% of structural capacity.

• Journal of Information Technology Applications and Management
• /
• v.26 no.6
• /
• pp.103-117
• /
• 2019

Demand for high power motors is rapidly increasing as the 4th industry and convergence technology has recently emerged. In order to produce high-strength permanent magnets, the magnets used for magnetization have been increased from DC 300V in the 1970s to DC 2.5kV in the 2010s, Up to DC 10kV in the 2030s, It is expected that higher voltage will be used to magnetize. However, in the case of a magnetizer using an existing electric signal control device, it is necessary to use a control device with a high-voltage insulation function in case a high voltage used for magnetization is leaked to the control device. If a short circuit accident occurs, the controller must be shut down and serious problems such as excessive repair costs arise. In this study, a control system adopting optical communication method instead of electric signal control method is proposed to prevent leakage currents in high-voltage magnetizer. We design a transmitter(Tx) and a receiver(Rx) device for the optical communication control device and implemented a prototype connecting the optical cable. In order to demonstrate the utility of high-voltage magnetizer using the optical communication control device, we analyzed the initial cost and the yearly cost for the years to analyze the net present value. As a result, In the case of the low-voltage magnetizer, the electric signal control method cost less, As the operating voltage of the magnetizer becomes higher. It is confirmed that it takes less cost when the optical communication control device is used.

• Journal of Korean Society for Quality Management
• /
• v.27 no.4
• /
• pp.143-152
• /
• 1999

In Shewhart control chart, the average run length(ARL) is calculated using the mean of a conventional geometric distribution(CGD) assuming a sequence of identical and independent Bernoulli trials. In this, the success probability of CGB is the probability that any point exceeds the control limits. When the process is in-control state, there is no problem in the above assumption since the probability that any point exceeds the control limits does not change if the in-control state continues. However, if the out-of-control state begins and continues during the process, the probability of exceeding the control limits may take two forms. First, once the out-of-control state begins with exceeding probability p, it continues with the same exceeding probability p. Second, after the out-of-control state begins, the exceeding probabilities may very according to some pattern. In the first case, ARL is the mean of CGD with success probability p as usual. But in the second case, the assumption of a sequence of identical and independent Bernoulli trials is invalid and we can not use the mean of CGD as ARL. This paper concentrate on that point. By adopting one generalized binomial distribution(GBD) model that allows correlated Bernoulli trials, generalized geometric distribution(GGD) is defined and its mean is derived to find an alternative ARL when the process is in out-of-control state and the exceeding probabilities take the second form mentioned in the above. Small-scale simulation is performed to show how an alternative ARL works.

• Culinary science and hospitality research
• /
• v.22 no.1
• /
• pp.126-134
• /
• 2016

This study examines effect in customer satisfaction of the emotional intelligence of members at service providing department in the hotel; A case of five star hotels in Dajeon Research hypotheses were developed based on previous literature, and data were collected from 350 employees working at the hotel restaurant service business located in Daejeon, ROK, were investigated herein The collected data were then analysed using frequence reliability For this research analysis, a self-recording method was used where and examiner explains the survey and respondents writhen down their answers to survey questions Statistical processing in this study was done through data cidubg and data cleaning then with the SPSS(Statistical Package for Social Science)v. 18.0. This result the emotional intelligence of service-providing employees at food service department of hotel was found to have a positive effect on customer satisfaction via understanding of others and emotional control. And the understanding of oneself, understanding of others and emotional control in emotional intelligence had a positive effect on job satisfaction. Emotional control, and emotioal use were found to affect organizational commitment positively.

• Proceedings of the Korean Society of Machine Tool Engineers Conference
• /
• 2002.04a
• /
• pp.272-278
• /
• 2002

At present most mechanical design engineers use the techniques that perform shape modeling, force analysis and DMU(Digital Mok-Up). This kind of design methods shorten the time of manufacturing prototypes and have a merit that decreases development cost. But a hydrauric system has inconvenience that engineers have to modify, and complement whenever needed, because simulation-based approaches are not ubiquitous compared to the case of general mechanical parts. This paper presents a case study of efficient application to hydrauric system for designing VRCS(Valve Remote Control System) using a Hycdraulic system design and analysis software.

• 한국전산유체공학회:학술대회논문집
• /
• 2005.10a
• /
• pp.207-212
• /
• 2005

In designing a ventilation system of a road tunnel, a possibility of using the system as a smoke control system in case of a tunnel fire has to be considered. In the present study, a numerical simulation on ventilation system is performed considering jet fan operations and moving traffic. A fire-mode operation by reversing some fan operations in case of a tunnel fire is also simulated. The results show that ventilation operation can control the pollutants effectively, and fire-mode operation can control smoke and temperature effectively to prevent a disaster.