• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.11a
• /
• pp.41-42
• /
• 2005

The characteristics of ZnO films are reported depending on different deposition conditions for film bulk acoustic resonators (FBARs). The ZnO films have been deposited on Al films evaporated on p-type (100) silicon substrate by pulsed laser deposition (PLD) technique using a Nd:YAG laser. These films exhibit an electrical resistivity higher than $10^7$ $\Omega$m. X-ray diffraction measurements have shown that ZnO films are highly c-axis oriented with full width at half maximum (FWHM) below $0.5^{\circ}$. These results show the possibility of FBAR devices using by PLD.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.05d
• /
• pp.61-64
• /
• 2003

This paper presents Bi thin films have been fabricated by atomic layer-by-layer deposition and co-deposition at an IBS method. The growth rates of the films was set in the region from 0.17 to 0.27 nm/min. Mg(100) was used as a substrate. In order to appreciate stable existing region of Bi 2212 phase with temperature and ozone pressure, the substrate temperature was varied between 655 and $820^{\circ}C$ and the highly condensed ozone gas pressure$(PO_3)$ in vacuum chamber was varied between $2.0{\times}10^{-6}$ and $2.3{\times}10^{-5}$ Torr. Bi 2212 phase appeared in the temperature range of 750 and $795^{\circ}C$ and single phase of Bi 2201 existed in the lower region than $785^{\circ}C$. Whereas, $O_3$ dependance on structural formation was scarcely observed regardless of the pressure variation. And high quality of c-axis oriented Bi 2212 thin film with $T_c$(onset) of about 90 K and $T_c$(zero) of about 45 K is obtained. Only a small amount of CuO in some films was observed as impurity, and no impurity phase such as $CaCuO_2$ was observed in all of the obtained films.

• Progress in Superconductivity
• /
• v.3 no.1
• /
• pp.23-27
• /
• 2001

We have investigated the mixed-state magnetoresistance of high quality c-axis-oriented MgB2 thin film for magnetic field from 0.5 T to 5.0 T, applied normal to ab-plane. The temperature dependence of magnetoresistance was well described by vortex glass and fluctuation theories for different temperature regimes. We observed glassy exponent of v(z-1)~3 and upper critical field of $H_{c2}$(0)~35 T, which is consistent with previous data obtained from direct $H_{c2}$(0) measurements. Interestingly, the thermally activated flux flow region was observed to be very narrow, suggesting that the pinning strength of this compound is very strong. This finding is closely related to the recent reports that the bulk pinning is dominant in $MgB_2$and the critical current density of $MgB_2$ thin film is very high, comparable to that of cuprate superconductor. The present results further suggest that $MgB_2$is beneficial to technical applications.ons.

• Korean Journal of Materials Research
• /
• v.15 no.8
• /
• pp.491-495
• /
• 2005

(Zn,Mg)O (ZMO) thin films doped with Ga $(0\~0.03mol\%)$ in the target source were prepared by pulsed laser deposition on c-plane sapphire substrates at $500^{\circ}C$, and the effect of Ga contents on the properties of the electrical, optical and crystal properties of the deposited films was investigated. From X-ray diffraction patterns, ZMO film doped with $0.02 mol\%$ Ga showed crystal structure with c-axis preferred orientation, showing only the (0002) and (0004) diffraction peaks. In contrast, ZMO film doped with $Ga=0.03 mol\%$ showed a randomly oriented crystal structure. All the samples were highly transparent, showing the transmittance values of above $85\%$ in the visible region. For all the Ga doped ZMO films, the value of energy band gap was found to be about 3.5 eV, regardless of their Ga contents. From the Hall measurements, the resistivity and the carrier density for the ZMO film doped with $0.01 mol\%$ Ga were about $5\times10^{-4}\Omega-cm$ and $2\times10^{21}cm^{-3}$, respectively.

• Progress in Superconductivity and Cryogenics
• /
• v.6 no.1
• /
• pp.12-17
• /
• 2004

High critical current density. $J_c$ over $1MA/cm^2$ at 77 K in a self field was successfully achieved from the YBCO film prepared on (100) $SrTiO_3$ single-crystal substrates by the TFA-MOD process. Unlike a normal TFA-MOD process, we prepared the TFA precursor solution by dissolving YBCO powder into the trifluoroacetic acid. A significant amount of the second phases, including $BaF_2$, was observed in the films fired at $700-725^{\circ}C$ for 2 h under $P(O_2)=10^{-3}$ atm and $P(H_2O)=4.2%$, most probably due to an insufficient reaction time, and hence $T_c$ was greatly degraded. However the films fired at $750-800^{\circ}C$ for 2 h were composed of strongly c-axis oriented YBCO grams without any second phases. and exhibited the $T_c$ values of 89.5 ~ 91 K with a sharp transition. With increasing the firing temperature from 750 to $800^{\circ}C$ average grain size of YBCO was increased and grain connectivity was enhanced. The highest $J_c$ value of $1.1MA/cm^2$ was obtained from the YBCO film fired at $800^{\circ}C$.

• Journal of Sensor Science and Technology
• /
• v.6 no.1
• /
• pp.56-62
• /
• 1997

Using a rf-magnetron sputtering method, highly c-axis oriented La modified $PbTiO_{3}$ (PLT) ferroelectric thin films with compositions of $(Pb_{1-x}La_{x})Ti_{1-x/4}O_{3}$, where x=0.05, x=0 and x=0.15, have been obtained on (100)MgO single crystal substrate under conditions of low gas pressure. The degree of c-axis orientation of PLT films decreases with increasing gas pressure and with increasing La contant. These films were characterized by X-ray diffraction and SEM. PLT thin films of x=0.05, 0.1 and 0.15 show a low dielectric constant of 218, 246 and 361 at 1 kHz and remanent polarization(Pr) of $9{\mu}C/cm^{2}$, $8{\mu}C/cm^{2}$ and $7{\mu}C/cm^{2}$.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2003.05a
• /
• pp.518-521
• /
• 2003

Bi$_2$Sr$_2$Ca$_{n-1}$Cu$_{n}$O$_{x}$ superconducting thin films have been fabricated by atomic layer-by-layer deposition using IBS(Ion Beam Sputtering) method. During the deposition, 90 mol% ozone gas of typical pressure of 1~9 $\times$ 10$^{-5}$ Torr are supplied with ultraviolet light irradiation for oxidation. XRD and RHEED investigations reveal out that a buffer layer with some different compositions is formed at the early deposition stage of less than 10 units cell and then Bi-2201 oriented along the c-axis is grown.grown.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.613-616
• /
• 2001

Bi$_2$Sr$_2$CuO$_{x}$ thin films have been fabricated by atomic layer-by-layer deposition using ion beam sputtering(IBS) method. During the deposition, 10 and 90 wt%-ozone/oxygen mixture gas of typical pressure of 1~9$\times$10$^{-5}$ Torr are supplied with ultraviolet light irradiation for oxidation. XRD and RHEED investigations reveal out that a buffer layer with some different compositions is formed at the early deposition stage of less than 10 units cell and then Bi-2201 oriented along the c-axis is grown.n.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.11a
• /
• pp.259-260
• /
• 2006

$Bi_2Sr_2Ca_{n-1}Cu_nO_x$ superconducting thin films have been fabricated by atomic layer-by-layer deposition using IBS(Ion Beam Sputtering) method During the deposition, 90 mol% ozone gas of typical pressure of $1{\sim}9{\times}10^{-5}$ T orr are supplied with ultraviolet light irradiation for oxidation. XRD and RHEED investigations reveal out that a buffer layer with some different compositions is formed at the early deposition stage of less than 10 units cell and then Bi-2201 oriented along the c-axis is grown.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.11a
• /
• pp.329-330
• /
• 2005

Bi-Sr-Ca-Cu-O thin films have been fabricated by sputter deposition method. During the deposition, 10 and 90 wt%-ozone/oxygen mixture gas of typical pressure of $1\sim9\times10^{-5}$ Torr are supplied with ultraviolet light irradiation for oxidation. XRD and RHEED investigations reveal out that a buffer layer with some different compositions is formed at the early deposition stage of less than 10 units cell and then Bi-2201 oriented along the c-axis is grown.