• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.4B
• /
• pp.365-371
• /
• 2002

In this paper, the fabricated power PHEMT devices for millimeter-wave that is below a gate-length of 0.2 $\mu\textrm{m}$ using electronic beam lithography technologies, and the DC and frequency characteristics and an output power characteristics were Measured at the various bias conditions. The unit process that is used in PHEMT's manufacture used that low-resistance ohmic contact, air-bridge and back-side lapping process technologies, and so on. The fabricated power PHEMT have an S521 gain of 4 dB and a maximum transconductance(gm) of 317 mS/mm, an unilateral current gain(fT) of 62 GHz, a maximum oscillation frequency(fmax) of 120 GHz at 35 GHz, and a maximum power output(Pmax) of 16 dBm, a power gain(GP) of 4 dB and a drain efficiency(DE) of 35.5 %.

• Journal of the Korea Society of Computer and Information
• /
• v.6 no.2
• /
• pp.8-13
• /
• 2001

We demonstrate a pulsed CO$_2$laser with long pulse duration of millisecond order in the low pressure less than 30 Torr. A new power supply for our laser system switches the voltage of AC power line(60㎐) directly. The power supply doesn't need elements such as a rectified bridge, energy-storage capacitors. and a current-limiting resistor in the discharge circuit. In order to control the laser output power, the pulse repetition rate is adjusted up to 60㎐ and the firing angle of SCR gate is varied from 30˚ to 150˚. A ZCS(Zero Crossing Switch) circuit and a PIC one-chip microprocessor are used to control the gate signal of SCR precisely. The maximum laser output is 23W at the total pressure of 18 Torr, the pulse repetition rate of 60㎐, and SCR gate firing angle of 90˚. In addition, the obtained laser pulse width is approximately 3㎳(FWHM)

• Journal of the Korean Association of Geographic Information Studies
• /
• v.12 no.1
• /
• pp.36-43
• /
• 2009

In this study, the impact of the covariance between the baselines on the network-based GPS positioning is analyzed. For the analysis, the multi-baseline solutions with properly modeled covariance between the baselines and the combined solutions from the single-baseline solutions are obtained, respectively. Then, the accuracies of both solutions are evaluated in terms of coordinate residuals, i.e., the differences between the positioning solutions and the published stations' coordinates. The results indicate that the positioning accuracy in static mode depends much on the geometry of GPS satellites rather than the proper modeling of covariance between the baselines. Also, slight but negligible improvement in positioning accuracy is observed in static solutions. Therefore, one may use combined solutions as an alternative to multi-baseline solutions for the network-based GPS positioning. However, multi-baseline solution with properly modeled covariance between the baselines is recommended to use especially for the applications to detect very small displacement, i.e., deformation of the building or bridge.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.9
• /
• pp.3451-3457
• /
• 2010

Cyber security assessment is the process of determining how effectively an entity being assessed meets specific cyber security objectives. Cyber security assessment helps to measure the degree of confidence one has and to identify that the managerial, technical and operational measures work as intended to protect the I&C systems and the information it processes. Recently, needs for cyber security on digitalized nuclear I&C systems are increased. However the overall cyber security program, including cyber security assessment, is not established on those systems. This paper presents the methodology of cyber security assessment which is appropriate for nuclear I&C systems. This methodology provides the qualitative assessments that may formulate recommendations to bridge the security risk gap through the incorporated criteria. This methodology may be useful to the nuclear organizations for assessing the weakness and strength of cyber security on nuclear I&C systems. It may be useful as an index to the developers, auditors, and regulators for reviewing the managerial, operational and technical cyber security controls, also.

• Journal of the Korean earth science society
• /
• v.31 no.7
• /
• pp.673-680
• /
• 2010

A steel pile often utilized to bear heavy loads of the upper sub-structure, e. g., bridge constructions and tall buildings. As the steel piles are driven in the underground, it is not easy to detect the depth of the existing pile foundation when there is no detailed foundation information available. However, accurate informations of the depths of piles becomes critical required when reinforcing the existing structures or constructing new ones at the adjacent stage to assure the safety of existing structures. In this study, we tested the applicability of the three components borehole fluxgate magnetometer for detecting the depths and locations of steel piles which are commonly used in civil engineering. Results showed that the information of location as well as the depth of steel piles could be obtained by using data from the three components borehole fluxgate magnetometer.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.45 no.3
• /
• pp.177-187
• /
• 2009

This paper describes a automatic video surveillance system(AVSS) with long range and 360$^{\circ}$ coverage that is automatically rotated in an elevation over azimuth mode in response to the TTM(tracked target message) signal of vessels tracked by ARPA(automatic radar plotting aids) radar. This AVSS that is a video security and tracking system supported by ARPA radar, CCTV(closed-circuit television) camera system and other sensors to automatically identify and track, detect the potential dangerous situations such as collision accidents at sea and berthing/deberthing accidents in harbor, can be used in monitoring the illegal fishing vessels in inshore and offshore fishing ground, and in more improving the security and safety of domestic fishing vessels in EEZ(exclusive economic zone) area. The movement of the target vessel chosen by the ARPA radar operator in the AVSS can be automatically tracked by a CCTV camera system interfaced to the ECDIS(electronic chart display and information system) with the special functions such as graphic presentation of CCTV image, camera position, camera azimuth and angle of view on the ENC, automatic and manual controls of pan and tilt angles for CCTV system, and the capability that can replay and record continuously all information of a selected target. The test results showed that the AVSS developed experimentally in this study can be used as an extra navigation aid for the operator on the bridge under the confusing traffic situations, to improve the detection efficiency of small targets in sea clutter, to enhance greatly an operator s ability to identify visually vessels tracked by ARPA radar and to provide a recorded history for reference or evidentiary purposes in EEZ area.

• Journal of the Korean Society of Safety
• /
• v.27 no.1
• /
• pp.76-85
• /
• 2012

This paper proposes a robust damper design technique for adjacent structures against model uncertainty. This approach introduces multi-objective optimization based system identification using measurement information which enables reasonable selection of the perturbation range in the robust design. Moreover, in order to improve the numerical efficiency in sampling the structural models required for the robust design of large structures, we define new objective functions which enable us to minimize the number of candidate models suitable to the purpose of the robust design. In addition, the performance index is newly employed to evaluate the robust performance of the sampled structural models, and the robust design has been performed according to the performance index. As a numerical example to demonstrate the efficiency of the proposed method, 5-story and 10-story two adjacent buildings are taken into account, and the existing and newly proposed robust design approaches are compared with each other. The results demonstrate that the proposed approach can guarantee more robust damper system only using small number of samples of the structural models because of using the measurement information which leads to improvement in the numerical efficiency, compared with the existing robust design methods.

• Journal of Korea Multimedia Society
• /
• v.15 no.3
• /
• pp.388-397
• /
• 2012

Recently, one of the received attraction fields in web based service is 'Human Relationship Service' that is called SNS. This relationship map service is able to deliver information to user more easily and visually because it is intuitive data that is linked with offline real world. While past map service put physical real information in the map, present map service is evolving into new communicative platform that expresses social relationship beyond simple search platform that shows real world. In this paper, we propose smart social grid system using sketch map that is based on online map service structure. This system has features such as standardized interface provision for various SNS, use to governance hub tool in case of establishing a personal network through expanded social grid, a role of bridge to mashup software linked with other SNS, user environment construction that reproduces social grid data, and the faster service setup by improved search technology.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.11
• /
• pp.2473-2478
• /
• 2009

The latest, Digital art is attempt new field's Art, that is utilize variously digital media image, sound, simulation, 3D holography. A large number of Digital Art is contact with the audience in pavilion(limit place and limit period). However, It will be possible, Digital Art can use place digital form media even there are indoor, outdoor, anywhere. Prior to study, I was to analyze the feature of Digital Art in order to using Digital Art, Interactivity make communication between humans and the art as well as cause audience participation, and take a role of bridge between human and space. A study was base on the relationship between human and space, space and Digital Art, Digital Art and human taken the focus interaction between human and space, and Interactivity of Digital Art. This paper analyze reciprocal action for utilize Digital Art in indoor space design, and this paper study expression about indoor design base of interactive.

• Journal of Information Processing Systems
• /
• v.3 no.2
• /
• pp.43-53
• /
• 2007

The use of agent paradigm in today's applications is hampered by the security concerns of agents and hosts alike. The agents require the presence of a secure and trusted execution environment; while hosts aim at preventing the execution of potentially malicious code. In general, hosts support the migration of agents through the provision of an agent server and managing the activities of arriving agents on the host. Numerous studies have been conducted to address the security concerns present in the mobile agent paradigm with a strong focus on the theoretical aspect of the problem. Various proposals in Intrusion Detection Systems aim at securing hosts in traditional client-server execution environments. The use of such proposals to address the security of agent hosts is not desirable since migrating agents typically execute on hosts as a separate thread of the agent server process. Agent servers are open to the execution of virtually any migrating agent; thus the intent or tasks of such agents cannot be known a priori. It is also conceivable that migrating agents may wish to hide their intentions from agent servers. In light of these observations, this work attempts to bridge the gap from theory to practice by analyzing the security mechanisms available in Aglet. We lay the foundation for implementation of application specific protocols dotted with access control, secured communication and ability to detect tampering of agent data. As agents exists in a distributed environment, our proposal also introduces a novel security framework to address the security concerns of hosts through collaboration and pattern matching even in the presence of differing views of the system. The introduced framework has been implemented on the Aglet platform and evaluated in terms of accuracy, false positive, and false negative rates along with its performance strain on the system.