• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.15 no.2
• /
• pp.157-164
• /
• 1997

This study deals with GPS-photogrammetry practicability by C/A-code reception. It allows data to be acquired and analyzed fast. Combined block adjustment method was applied at the topographical map production of coast-land. And we compared it that of conventional block adjustment. As a result, it was found that accuracy was very sensitive to the arrangement and number of control points. The accuracy in the horizontal and vertical was $\pm{2cm}$ if all of the control points was available. however accuracy was not affected at additional parameters for systematic errors' elimination and it leads to bad results when the number of control points was few and arrangement of control points was not stabilized. GPS observations were added in block adjustment, but the accuracy of block was not upgraded due to the low accuracy of C/A-code reception. So relative positioning method with carrier phases was required for high accuracy and it is expected that CPS photogrammetry with C/A-code will be used widely according to the improvement of observation methods and the development of receiver.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.1
• /
• pp.189-195
• /
• 2008

The OFDMA Physical layer in the WiMAX standard of IEEE 802.16e adopts 114 LDPC codes with various code rates and block sizes as a channel coding scheme to meet varying channel environments and different requirements for transmission performance. In this paper, the performances of the LDPC codes are evaluated according to various code rates and block-lengths throueh simulation studies using min-sum decoding algorithm in AWGN chamois. As the block-length increases and the code rate decreases, the BER performance improves. In the cases with code rates of 2/3 and 3/4, where two different codes ate specified for each code rate, the codes with code rates of 2/3A and 3/4B outperform those of 2/3B and 3/4A, respectively. Through the statistical analyses of the number of decoding iterations the decoding complexity and the word error rates of LDPC codes are estimated. The results can be used to trade-off between the performance and the complexity in designs of LDPC decoders.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.18 no.3
• /
• pp.495-508
• /
• 2023

This paper proposes a method to find out the type and location information of Pauli X, Y, Z errors generated in quantum channels using only the quantum information processing part of the multiple-rate quantum turbo short-block code without external help from the classical information processing part. In order to obtain the location information of the Pauli X,Y error, n-auxiliary qubits and n-CNOT gates were inserted into the C[n,k,2] QSBC-QURC encoder. As a result, the maximum coding rate is limited to about 1/2 as the trade-off characteristics. The location information of the Pauli Z error for C[n,k,2] QSBC-QURC was obtained through the Clifford-based stabilizer measurement. The proposed method inherits all other characteristics of C[n,k,2] QSBC-QURC except for the coding rate.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2011.11a
• /
• pp.255-257
• /
• 2011

본 논문에서는 지상파 3D HDTV 방송 서비스를 제공하기 위하여 기존의 유럽형 HDTV 방송 서비스인 DVB-T2 전송 시스템의 채널 부호군 중 외부부호로 쓰이는 BCH 부호를 연판정 복호가 가능한 Block Turbo Code로 대체함으로써 생기는 성능 이득과 높은 부호율을 달성하기 위한 방법을 제안하였다. 기존의 DVB-T2 시스템에서 외부부호로 쓰이는 BCH 부호의 부호율의 경우 0.994정도의 높은 부호율을 가진다. 따라서 이에 준하는 높은 부호율을 가지면서 연판정 복호가 가능한 BTC 부호를 제안하고, 기존의 BTC 보다 더 높은 부호율을 가지는 BTC 부호를 설계한다. 모의 실험을 통하여 새롭게 제안된 BTC 에서도 반복복호의 이득이 생기는 것을 확인하고 기존 DVB-T2 시스템의 BCH 부호보다 성능이 우수함을 확인하였다.

• Journal of Ocean Engineering and Technology
• /
• v.13 no.1 s.31
• /
• pp.11-17
• /
• 1999

A three dimensional finite element generation code has been developed attaching simple blocks. Block can be either a quadrature or a cube depending on the dimension of a subject considered. Finite element serendipity basis functions are employed to map elements between the computational domain and the physical domain. Elements can be generated with wser defined progressive ratio for each block. For blocks to be connected properly, a block should have a consistent numbering scheme for vertices, side nodes, edges and surfaces. In addition the edge information such as the number of elements and the progressive ratio for each direction should also be checked for interfaces to have unique node numbers. Having done so, user can add blocks with little worry about the orientation of blocks, Since the present the present code has been written by a Visual Basic language, it can be developed easily for a user interactive manner under a Windows environment.

• Journal of Electrical Engineering and Technology
• /
• v.6 no.5
• /
• pp.723-730
• /
• 2011

The GPS modernization program offered a new civil signal on the L2 band, and the first modernized GPS Block IIR satellite was launched in September 2005. Currently, eight GPS Block IIRM satellites and two Block IIF satellites transmit L2C signal. The L2C signal contains two codes of CM and CL that are much longer than the L1 C/A code. Thus, the acquisition of the CM and CL codes takes more time compared with that of L1 C/A code. Under the assumption that the L2C signal is strong enough for detection, this paper suggests rapid acquisition methods for the GPS L2C signals for software receivers and compares its performance with that of other methods.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.7
• /
• pp.165-168
• /
• 2015

In this paper, we analyze a SFBC-OFDM(Space Frequency Block Code-Orthogonal Frequency Division Multiplexing) system with antenna selection method using pilot symbols. An antenna selection criterion is based on channel coefficients estimated from pilot symbols. At each frequency, the channel coefficients is arranged and the best is selected, and then data is sent to those antenna with the best coefficients. Also, The coding and diversity gain of the proposed system are analyzed.

• Proceedings of the IEEK Conference
• /
• 2000.09a
• /
• pp.41-46
• /
• 2000

In this paper, we analyze the performance of W-CDMA systems using turbo code in the wideband multipath channel. The strength of each multipath component is assumed to be Rayleigh distributed. Turbo codes of long block sizes have been known to show very good performance in a AWGN channel. Recently, turbo codes of short block sizes suitable for real time communication systems have attracted a lot of attention. Thus, in this paper we consider the turbo code of 1/3 code rate and short frame size of 192 bits in wideband mobile multipath channel. We analyze the performance of W-CDMA systems with 10MHz bandwidths in the case of employing RAKE receiver with not only MRC diversity but also turbo code.

• Nuclear Engineering and Technology
• /
• v.54 no.11
• /
• pp.4280-4295
• /
• 2022

In this paper, a new multi-group neutron-gamma transport calculation code system STRAUM-MATXST for complicated geometrical problems is introduced and its development status including numerical tests is presented. In this code system, the MATXST (MATXS-based Cross Section Processor for S_N Transport) code generates multi-group neutron and gamma cross sections by processing MATXS format libraries generated using NJOY and the STRAUM (S_N Transport for Radiation Analysis with Unstructured Meshes) code performs multi-group neutron-gamma coupled transport calculation using tetrahedral meshes. In particular, this work presents the recent implementation and its test results of the Krylov subspace methods (i.e., Bi-CGSTAB and GMRES(m)) with preconditioners using DSA (Diffusion Synthetic Acceleration) and TSA (Transport Synthetic Acceleration). In addition, the Krylov subspace methods for accelerating the energy-group coupling iteration through thermal up-scatterings are implemented with new multi-group block DSA and TSA preconditioners in STRAUM.

• ETRI Journal
• /
• v.46 no.2
• /
• pp.175-183
• /
• 2024

Recently, polar code has attracted the attention of many scholars and has been developed as a code technology in coded-cooperative communication. We propose a polar code scheme based on Plotkin structure and quasi-uniform punching (PC-QUP). Then we apply the PC-QUP to coded-cooperative scenario and built to a new coded-cooperative scheme, which is called PCC-QUP scheme. The coded-cooperative scheme based on polar code is studied on the aspects of codeword construction and performance optimization. Further, we apply the proposed schemes to space-time block coding (STBC) to explore the performance of the scheme. Monte Carlo simulation results show that the proposed cooperative PCC-QUP-STBC scheme can obtain a lower bit error ratio (BER) than its corresponding noncooperative scheme.