• 대한기계학회논문집B
• /
• 제20권8호
• /
• pp.2670-2680
• /
• 1996

Effeccs of porous wind fence on surface-pressure around 2-dimensional prism model of triangular cross-section were investigated experimentally. The pressure data were obtained at a Reynolds number based on the model height of Re=2.1*10$^{5}$ . Flow visualization also carried out to investigate the flow structure qualitatively. The mean velocity and turbulent intensity profiles measured at fence location were well fitted to the neutral atmospheric surface boundary layer over the open terrain. Various fences with different porosity and height were tested to investigate their effects on the surface pressure acting on a prism model at different locations. As the results, porous fence with porosity 40 ~ 50% is most effective for abating wind erosion. With decreasing porosity of the fence, pressure fluctuations on the model surface are increased. The mean pressure coefficients are decreased only when the fence height is greater than the model height. The effect of distance between wind fence and triangular prism was not significant, compared to that of the fence porosity and height.

• 한국자동차공학회논문집
• /
• 제22권3호
• /
• pp.228-233
• /
• 2014

Reduction of the atmospheric pressure in high altitude affects brake booster system which was operated by the difference between the intake pressure and the atmospheric pressure. So, braking system can not stably perform due to decrease of brake boost pressure. In this study, effects of altitude change on engine intake pressure was analyzed by prediction model of engine intake pressure which was studied previously. And engine intake pressure was simulated by simulation model in various driving conditions and environmental conditions.

• 대한기계학회논문집A
• /
• 제32권4호
• /
• pp.354-361
• /
• 2008

Cold rolled steel sheet for automotive was treated by Ar/$O_2$ atmospheric pressure plasma to improve the adhesive bonding strength. Through the contact angle test and calculation of surface free energy for cold rolled steel sheet, the changes of surface properties were investigated before and after plasma treatment. The contact angle was decreased and surface free energy was increased after plasma treatment. And the change of surface roughness and morphology were observed by AFM(Atomic Force Microscope). The surface roughness of steel sheet was slightly changed. Based on Taguchi method, single lap shear test was performed to investigate the effect of experimental parameter such as plasma power, treatment time and flow rate of $O_2$ gas. Results shows that the bonding strength of steel sheet treated in Ar/$O_2$ atmospheric pressure plasma was improved about 20% compared with untreated sheet.

• 대기
• /
• 제19권1호
• /
• pp.67-78
• /
• 2009

A strong negative correlation has been detected between the North Pacific Oscillation Index (NPI) and the Effective Drought Index (EDI) in May over Korea. In May of positive NPI year, anomalous patterns caused a drought in Korea as follows: the anomalous south-low, north-high low-level pressure patterns in the northeast and southeast of Korea have strengthened the anomalous northerlies to Korea. In addition, these anomalous northerlies have prevented western North Pacific (WNP) high from moving northward. As a result, anomalous descending flows have strengthened in the mid-latitude region in East Asia. In the WNP, the anomalous south-high, north-low sea surface temperature (SST) has been widely distributed, which has strengthened anomalous south-low, north-high low-level pressure patterns. These anomalous characteristics of pressure and SST patterns observed in May of positive NPI years have already been detected in previous winter (December-February) and early spring (March, April). In addition, the anomalous negative sea ice concentration in the North Pacific during two seasons has strengthened the anomalous anticyclonic circulation in the same region and in turn made a contribution to formation of anomalous south-low, north-high pressure patterns in May.

• Composites Research
• /
• 제23권5호
• /
• pp.1-7
• /
• 2010

NBR과 강판의 접착특성을 향상시키기 위해 대기압 화염 플라즈마(APFP) 처리 장치가 사용되었다. 가장 우수한 접착특성을 나타내는 최적 조건을 찾기 위해 다양한 처리 조건(처리속도, 거리)에 따른 효과에 대한 실험적 연구를 하였다. 주어진 조건에서 버너 포트와 강판의 최적 거리는 40mm, 버너 포트의 최적 처리속도는 50m/min였다. APFP 처리 후 접착제를 두 번 도포한 강판의 접착강도는 접착제만 도포한 경우보다 20.5% 증가하였다. 본 연구를 통해서 대기압 화염 플라즈마 처리에 의한 강판의 표면개질이 고무와 강의 접착강도를 증가시키는 적절하면서도 응용이 가능한 방법임을 확인하였다.

• 한국축산식품학회지
• /
• 제33권3호
• /
• pp.317-324
• /
• 2013

Radio-frequency driven atmospheric pressure plasma using argon gas was studied in the inactivation of Campylobacter jejuni in order to investigate its applicability. First, the inactivation study was conducted on an agar surface. C. jejuni NCTC11168 was reduced by more than 7 Log CFU after an 88 s treatment. Another strain, ATCC49943, was studied; however, the inactivation was less efficient, with a 5 Log CFU reduction after a 2 min treatment. Then, chicken breast ham was studied at the $10^6$ CFU inoculation level. The inactivation efficiency was much lower for both strains compared to that on the agar plates. C. jejuni NCTC11168 and ATCC49943 were reduced by 3 Log CFU after a 6 min treatment and by 1.5 Log CFU after a 10 min treatment, respectively. The scanning electron microscopy analysis indicated that C. jejuni cells were deformed or transformed into coccoid form under the plasma treatment. During the plasma treatment, the temperature of the samples did not rise above $43^{\circ}C$, suggesting that heat did not contribute to the inactivation. Meanwhile, water activity significantly decreased after a 10 min treatment (p<0.05). This study conveyed that radio-frequency atmospheric pressure plasma can effectively inactivate C. jejuni with strain-specific variation.

• 대한원격탐사학회지
• /
• 제16권2호
• /
• pp.117-133
• /
• 2000

We studied the sea level variations at Kerguelen island in the South Indian Ocean with ARGOS data and meteorological data during about 1 year(May 1993~April 1994) through using filter, spectral analysis, coherency and phase, and found characteristics for the two oceanic signal levels(detided oceanic signal level, h$_{detided}$ and seasonal oceanic level, h$_{corr.ib}$). The forms of atmospheric pressure variations are good agreed to between ARGOS data and meteorological data in the observed periods. This Kerguelen area shows the inflow of an air temperature(gain of a radiant heat) into the sea water and the stagnation of high atmospheric pressure bands in summer, and the outflow of a sea water temperature(loss of sensible and latent heat) toward the atmosphere and the stagnation of low atmospheric pressure bands in winter. The seasonal difference of sea level between summer and winter is about 1.6cm. Both the detided oceanic signal level(h$_{detided}$) variation and the inverted barometer level(h$_{ib}$) variation have a strong correlation for T>1day period bands. The characteristics of h$_{detided}$ variation are not decided by the influence of any meteorological distributions (atmospheric pressure), but the influence of other factors(bottom water temperature) for T>2days periods bands. h$_{corr.ib}$ plays a very important role of sea level variation in the observed periods (especially T>about 180days period bands).

• 반도체디스플레이기술학회지
• /
• 제16권4호
• /
• pp.59-62
• /
• 2017

In this paper, atmospheric pressure plasma treatment was proposed for high performance indium gallium zinc oxide thin film transistor (IGZO TFT). RF Ar plasma treatment is performed at room temperature under atmospheric pressure as a simple and cost effective channel surface treatment method. The experimental results show that field effect mobility can be enhanced by $2.51cm^2/V{\cdot}s$ from $1.69cm^2/V{\cdot}s$ to $4.20cm^2/V{\cdot}s$ compared with a conventional device without plasma treatment. From X-ray photoelectron spectroscopy (XPS) analysis, the increase of oxygen vacancies and decrease of metal-oxide bonding are observed, which suggests that the suggested atmospheric Ar plasma treatment is a cost-effective useful process method to control the IGZO TFT performance.

• 한국과학교육학회지
• /
• 제22권3호
• /
• pp.560-570
• /
• 2002

이 연구에서는 대기압의 정의와 기압에 관련된 현상들에 대한 원리를 묻는 설문지를 개발하여 H대학교 석사 과정에 있는 94명의 과학 교사들에게 투입하여 일관되고 통합된 설명 체계를 갖고 있는 지를 알아보았다. 전공별로 구분하여 응답률을 비교하고 중등학교 과학 교과서, 대학 교재의 서술 방식과 교과들의 응답을 비교하였다. 연구 결과 첫째, 교과서와 대학 교재의 공기의 무게에 의한 압력이란 대기압의 정의에도 불구하고 화학 전공의 중학교 교사 지구과학 전공의 고등학교 교사는 중력과 분자 운동에 의한 압력으로, 화학 전공의 고등학교 교사는 기체의 분자 운동에 의한 압력이란 응답률이 상대적으로 높았다. 또한 고도에 따른 대기압의 변화를 공기 기둥의 무게로 설명하는 대부분의 교재에도 불구하고 이러한 응답을 한 교사는 절반에 불과하였다. 둘째, 대다수의 중등 교과서에서 저기압의 형성에 대해 대기압의 정의인 공기의 무게 개념을 적용하지 않고 가열되면 팽창하고 상승하여 밀도가 작아져 형성된다는 정확하지 않은 서술을 하고 있으며 대부분의 교사들도 밀도 개념으로 저기압의 형성을 설명하였다. 셋째, 교사들이 기압과 관련된 현상들을 교육과정에 의한 학생들의 선개념을 고려하여, 원리보다 현상만을 제시한 교과서의 서술 방식대로 응답하였다. 이러한 결과로부터, 대기압의 올바른 개념 형성을 위해서는 교과서의 내용 전개가 분자 운동, 중력, 힘의 평형, 대기압의 연계되어 구성되어야 할 것이며, 설명 체계 또한 명확하여야 할 것이다. 교사들의 기압에 관련된 개념들이 통합적으로 구성되어 있지 않은 것은 교과서나 교재의 영향이 크며 점진적이고 체계적인 개념 구조를 가지고 자연 현상을 통합적인 사고 과정으로 탐구하는 태도를 가질 수 있는 교사 교육이 필요함을 보여준다.

• 한국진공학회지
• /
• 제18권5호
• /
• pp.337-345
• /
• 2009

패키지 기판의 지름 $100{\mu}m$ 이하 미세 드릴 구멍의 경우 습식 디스미어 공정만으로는 구멍 내부의 스미어를 효과적으로 제거할 수 없다. 본 연구에서는 습식 디스미어 공정의 이전 단계에서 대기압 플라즈마를 처리하여 소수성의 기판 표면을 친수성으로 개질하고자 하였다. 대기압 플라즈마 공정은 리모트 DBD 방식의 전극을 이용하여 패키지 제조 공정에 적합한 인라인 형태의 장비로 구성되었다. 대기압 플라즈마를 처리한 결과 접촉각 기준으로 $71^{\circ}$의 소수성 절연 필름 표면이 $30^{\circ}$ 정도의 친수성 표면으로 개질되었다. 대기압 플라즈마 처리 유무에 따른 습식 디스미어 공정의 특성을 평가하기 위하여 절연 필름의 두께, 드릴 구멍 지름, 표면 조도의 변화를 측정하였는데, 대기압 플라즈마 처리 시 기판 전면에서 공정 특성의 균일도가 향상되는 것을 확인하였다. 또한 대기압 플라즈마 처리 유무에 따른 드릴 구멍의 SEM 사진 분석 결과 대기압 플라즈마 처리 시 구멍 내부의 스미어가 효과적으로 제거됨을 실험적으로 확인하였다.