• 대한공간정보학회지
• /
• 제23권4호
• /
• pp.11-16
• /
• 2015

시공간적 기온정보는 지구온난화와 기후변화의 이해에 있어서 중요한 기상요소이다. 본 연구에서는 인공위성 원격탐사로부터 획득된 공간적으로 균질한 지표면 정보를 이용하여 우리나라 지상기온 평가 알고리즘을 개발하였다. LST(Land Surface Temperature), NDWI(Normalized Difference Water Index), NDVI(Normalized Difference Vegetation Index)를 독립변수로 하는 지상기온 추정을 위한 다중회귀모형을 제안하고, 우리나라의 지역기후변화를 고려하기 위하여 온난시즌과 한랭시즌에 대한 모형의 회귀상수 및 회귀계수를 도출하였다. 개발된 기온 추정 알고리즘에 의해 산출된 온난 및 한랭시즌의 기온정보는 지상관측기온과 비교하여 우수한 상관관계를 보였고, $3^{\circ}C$ 미만의 RMSE와 거의 0에 가까운 BIAS로 매우 높은 일치성을 보였다. 따라서 인공위성 지표면 원격탐사자료를 활용하고 온난 및 한랭시즌의 구분을 적용한 기온 평가 알고리즘은 우리나라의 지역기후를 평가하는데 있어서 간략하고 유용한 수단이 될 수 있으리라 기대된다.

• 한국농공학회지
• /
• 제38권5호
• /
• pp.116-124
• /
• 1996

The purpose of The work described in this paper is to clear up the initial moisture content, specific surface, air drying and freezing-thawing process on liquid limit of clayey soils distributed widely at estuary of three main rivers in the west coast. To this end, a series of tests were conducted on clayey soils samples with natural state and treated state. From the test results, the liquid limit was decreased with decrement of initial moisture content, air drying process, and freezing-thawing cycles and increased with increment of specific surface. The specific surface which influenced on the liquid limit is over $25 m^2$m$^2$/g, and their relationships are well formulated. Air drying process is expected to improve the engineering properties of the soils such the pro-water properties were changed to anti-water proper-ties through lowering of water holding as resulted to incline from A-7-5 to A-5 on the soil classificaction plastic chart. The freezing-thawing process decreased 20% of liquid limit, especially under the first cycle of the behavious, as a result of above mentioned reasons, phase change of soil-water system brought the decrement of specific surface and affected to the liquid limit.

• 설비공학논문집
• /
• 제22권12호
• /
• pp.828-836
• /
• 2010

The drying is a process that involves coupled and simultaneous heat and mass transfer. When a wet solid is subjected to thermal drying, two processes occur simultaneously. Drying is classified according to heat transfer characteristics in terms of conduction, convection and radiation. In thermal drying, radiation is easier to control than conduction and convection drying and involves a relatively simple structure. In this study, we measured energy consumption, surface hardness of paint and surface gloss with variation of surface temperature of drying materials and drying time. Drying characteristics and energy consumption between heating panels and hot air heating have been presented. The present study shows that a dryer using heating panels is more effective than a hot air dryer from the viewpoint of energy conservation. The hot air dryer, however, was not optimized and more studies on various parameters related to drying will need to be investigated for definite comparison of drying characteristics of the dryers. The result, even if limited, would present the effective availability of paint drying.

• The Journal of Advanced Prosthodontics
• /
• 제9권5호
• /
• pp.364-370
• /
• 2017

PURPOSE. To explore the influence of different surface conditionings on surface changes and the influence of surface treatments and aging on the bond strengths of composites to non-aged and aged resin nanoceramics. MATERIALS AND METHODS. Rectangular-shaped non-aged and aged (5000 thermocycles) resin nanoceramic specimens (Lava Ultimate) (n=63, each) were divided into 3 groups according to surface treatments (untreated, air abrasion, or silica coating) (n=21). The surface roughness was measured and scanning electron microscopy was used to examine one specimen from each group. Afterwards, the specimens were repaired with a composite resin (Filtek Z550) and half were sent for aging (5000 thermocycles, n=10, each). Shear bond strengths and failure types were evaluated. Roughness and bond strength were investigated by two- and three-way analysis of variance, respectively. The correlation between the roughness and bond strength was investigated by Pearson's correlation test. RESULTS. Surface-treated samples had higher roughness compared with the untreated specimens (P=.000). For the non-aged resin nanoceramic groups, aging was a significant factor for bond strength; for the aged resin nanoceramic groups, surface treatment and aging were significant factors. The failures were mostly adhesive after thermal cycling, except in the non-aged untreated group and the aged air-abraded group, which had mostly mixed failures. Roughness and bond strength were positively correlated (P=.003). CONCLUSION. Surface treatment is not required for the repair of non-aged resin nanoceramic; for the repair of aged resin nanoceramic restorations, air abrasion is recommended.

• 구강회복응용과학지
• /
• 제26권3호
• /
• pp.339-347
• /
• 2010

이전에 존재하던 컴포지트와 새로운 컴포지트 사이의 결합강도의 강화는 미세 기계적 유지를 증진하기 위한 표면 거칠기의 증가가 필요하다. 이 연구는 시효처리 후의 레진 컴포지트의 repair 결합강도에 다른 표면처리의 효과를 평가하는 것이다. 알루미늄 옥사이드를 이용한 air abrasion, chair-side silica coating한 그룹들에서 대조군과 불산 적용에 비하여 유의하게 높은 결합강도를 보였다. 레진 수복물의 repair시에 air abrasion의 사용은 필요한 것으로 보이며 부가적으로 silane의 적용은 결합강도에 긍정적 영향을 미치는 것으로 보인다.

• 한국표면공학회지
• /
• 제50권3호
• /
• pp.147-154
• /
• 2017

This research was conducted to investigate the electrochemical properties of the thin air-formed oxide film-covered AZ31 Mg alloy. Native air-formed oxide films on AZ31 Mg alloy samples were prepared by knife-abrading method and the changes in the electrochemical properties of the air-formed oxide film were investigated in seven different electrolytes containing the following anions $Cl^-$, $F^-$, $SO{_4}^{2-}$, $NO_3{^-}$, $CH_3COO^-$, $CO{_3}^{2-}$, and $PO{_4}^{3-}$. It was observed from open circuit potential (OCP) transients that the potential initially decreased before gradually increasing again in the solutions containing only $CO{_3}^{2-}$ or $PO{_4}^{3-}$ ions, indicating the dissolution or transformation of the native air-formed oxide film into new more protective surface films. The Nyquist plots obtained from electrochemical impedance spectroscopy (EIS) showed that there was growth of new surface films with immersion time on the air-formed oxide film-covered specimens in all the electrolyte. The least resistive surface films were formed in fluoride and sulphate baths whereas the most protective film was formed in phosphate bath. The potentiodynamic polarization curves illustrated that passive behaviour of AZ31 Mg alloy under anodic polarization appears only in $CO{_3}^{2-}$, or $PO{_4}^{3-}$ ions containing solutions and at more than $-0.4V_{Ag/AgCl}$ in $F^-$ ion containing solution.

• 한국건축시공학회지
• /
• 제9권1호
• /
• pp.49-55
• /
• 2009

In this study, reduction methods of surface air void were examined for high performance concrete having high viscosity. The effects of assumed influencing factors such as form types, form-coating materials, tamping equipments and methods were examined based on the tests on mock-up specimens made of high performance concrete. The test results can be summarized as follows: As for form types, the most favorable results were obtained when coated plywood form was used with panel-shape tamping equipments at the contact region with concrete, the second and the third being the water/air-permeable sheets and steel with coated plywood, respectively. As for tamping equipments, a vibrator with 6.5cm diameter was most effective. Finally, the shorter the tamping intervals, the better the reduction effect of surface air void. As a conclusion, an improved method was proposed to reduce surface air void and it was verified with the test result that only four air voids as large as $5{\sim}10mm$ are found in the are of $1m^2$.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2006년도 춘계학술대회
• /
• pp.442-444
• /
• 2006

On long time scale and over large areas ground surface temperatures (GSTs) track surface air temperatures (SATs). Additionally, GST changes penetrate into the subsurface and are recorded as transient temperature perturbation to the background thermal filed. Therefore, climate change can be reconstructed from borehole temperature measurements We present GST hi story reconstructed from temperature measurements in a borehole at Pocheon The result shows that GST cold period in the late 19th century and then increased by about 2K to 1990. GST history matches well with surface air temperatures measured from 1907 to 2001 at the Seoul Meteorological Station and GST history reconstructed from temperature measurements in three boreholes at Ulsan.

• 설비공학논문집
• /
• 제21권4호
• /
• pp.229-235
• /
• 2009

In a domestic construction field, floor surface must be covered not to be scratched and polluted by protector until resident comes in. However this protector restricts the contaminant to leave from floor surface. So when the protector is removed, much contaminant is emitted from the floor surface to inside and makes a bad influence on the indoor air quality, In this research, it will be tested the reduction performance of contaminant between a normal protector and a contaminant absorption protector using charcoal powder.

• 한국공작기계학회논문집
• /
• 제16권5호
• /
• pp.55-62
• /
• 2007

With the developments in knitting, manufacturing, and polymers, coated gloves have been evolved in a way to maximize occupational safety and functionality. In this paper, we have considered the PU-coating process for the glove knitted by Dyneema to reduce the occurrence of the defects due to air bubble. This paper classifies the types of defect due to air bubble and traces their forming mechanisms. The air between coating layer of glove and mold's surface forms the defects if it is not evacuated fully in the process of submerging into water. The defects can be suppressed or avoided by forming air-evacuating path on the surface of the molds.