• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.1
• /
• pp.88-91
• /
• 2016

In this paper, we have proposed the frequency interference analysis system using both LabVIEW and Universal Software Radio Peripheral(USRP) for performance degradation analysis of Multi Input Multi Output-Orthogonal Frequency Division Multiplexing(MIMO-OFDM) Wireless Local Area Network(WLAN) due to Wireless Local Area Network(WPAN) interferer. The proposed system consists of three part, i.e., victim, channel, and interferer. Both victim and interferer are implemented by LaBVIEW and a USRP board. Then interfering signal and additive white Gaussian noise are combined with the wanted signals of a victim. Measured Bit Error Rate(BER) at the victim receiver is compared with theoretical BER according to various signal to interference plus noise power ratio (SINR) values. Measured and theoretical BER curves show good agreement.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.2
• /
• pp.19-25
• /
• 2008

When there are numerous wireless communication systems co-existing in the limited available frequency resource, an unexpected time delay can be caused during the system switching. So, in order to reduce this time delay, a mode selection method is required. In this paper, we propose a mode selection method to minimize the time delay for multi-system wireless communication systems. For the sake of efficiency, the mode selection method is designed by analyzing the preamble characteristics of different standards. Instead of performing a full search, we propose the preamble partial search to reduce the time delay to a minimum. Simulated with Matlab in an additive white Gaussian noise(AWGN) environment with a signal to noise ratio(SNR) of 10dB and bit error rate(BER) of $10^{-6}$, we evaluated and showed the performance improvement gained by using our proposed mode selection method.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.10A
• /
• pp.969-979
• /
• 2002

This paper proposes an novel method of minimizing Interference which causes data decision error in digital wireless communications. In this method, in order to suppress ISI which is caused by the phase difference between the transmitted and received signal phases, the transmitted and received signals are always kept orthogonal by compensating the transmitted signal for detecting the phase noise and the delay of the received signal was implemented by MOS circuits. To delay the phase of the signal, additive white Gaussian noise (AWGN) environment was used. The phase and delay of the signal transmitted through AWGN channel were compensated in the modulator of the transmitter and the compensated signal was demodulated using quasi-direct conversion receiver and QPSK demodulator. ISI suppression was achieved by keeping the orthogonality between the compensated transmitted signal and the receive signal. The error probability of data decision was compared. By simulation the proposed system was proved to be effective in minimizing the ISI.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.5C
• /
• pp.556-564
• /
• 2007

This paper proposes an efficient scheme to track a time variant channel induced by multi-path Rayleigh fading in mobile MIMO-OFDM systems with null sub-carriers. The proposed adaptive channel tracking scheme removes in the frequency domain the interfering signals of the other transmit (Tx) antennas by using a predicted channel frequency response before starting the channel estimation. Time domain channel estimation is then performed to reduce the additive white Gaussian noise (AWGN). The simulation results show that the proposed method is better than the conventional channel tracking method [3] in time varying channel environments. At a Doppler frequency of 300 Hz and bit error rates (BER) of 10-3, signal-to-noise power ratio (Eb/N0) gains of about 2.5 dB are achieved relative to the conventional channel tracking method [3]. At a Doppler frequency of 600 Hz, the performance difference between the proposed method and conventional one becomes much larger.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.17 no.9
• /
• pp.939-950
• /
• 1992

The performance of common spreading code scheme employing multiple-capture receiver is compared to that of transmitter-oriented (T/O) code division multiple access (CDMA) scheme in view of the possibility of collision-free transmissions and the effect of secondary multiple-access interference. For performance comparisons, secondary multiple-access interference is characterized for the common code scheme and the T/O CDMA scheme that assures perfectly collision-free transmissions. Throughput performance is then evaluated for these two schemes with direct-sequence spread-spectrum/differential-phase-shift-keying (DS-SS/DPSK) data modulation and forward-error-control coding (BCH codes) in the presence of an additive white Gaussian noise (AWGN). It is shown that when the number of radios is relatively large, the maximum normalized throughput is greater for the common code scheme than for the T/O CDMA scheme at a moderate signal-to-noise ration(SNR).

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.2
• /
• pp.15-22
• /
• 2006

This paper presents a novel signal tracking algorithm for GNSS receivers using a MLE technique. In order to perform a robust signal tracking in severe signal environments, e.g., high dynamics for navigation vehicles or weak signals for indoor positioning, the MLE based signal tracking approach is adopted in the paper. With assuming white Gaussian additive noise, the cost function of MLE is expanded to the cost function of NLSE. Efficient and practical approach for Doppler frequency tracking by the MLE is derived based on the assumption of code-free signals, i.e., the cost function of the MLE for carrier Doppler tracking is used to derive a discriminator function to create error signals from incoming and reference signals. The use of the MLE method for carrier tracking makes it possible to generalize the MLE equation for arbitrary codes and modulation schemes. This is ideally suited for various GNSS signals with same structure of tracking module. This paper proposes two different types of MLE based tracking method, i.e., an iterative batch processing method and a non-iterative feed-forward processing method. The first method is derived without any limitation on time consumption, while the second method is proposed for a time limited case by using a 1st derivative of cost function, which is proportional to error signal from discriminators of conventional tracking methods. The second method can be implemented by a block diagram approach for tracking carrier phase, Doppler frequency and code phase with assuming no correlation of signal parameters. Finally, a state space form of FLL/PLL/DLL is adopted to the designed MLE based tracking algorithm for reducing noise on the estimated signal parameters.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.24 no.4
• /
• pp.501-507
• /
• 2020

This paper proposes a new frame synchronization technique based on convolutional neural network (CNN). The conventional frame synchronizers usually find the matching instance through correlation between the received signal and the preamble. The proposed method converts the 1-dimensional correlator ouput into a 2-dimensional matrix. The 2-dimensional matrix is input to a convolutional neural network, and the convolutional neural network finds the frame arrival time. Specifically, in additive white gaussian noise (AWGN) environments, the received signals are generated with random arrival times and they are used for training data of the CNN. Through computer simulation, the false detection probabilities in various signal-to-noise ratios are investigated and compared between the proposed CNN-based technique and the conventional one. According to the results, the proposed technique shows 2dB better performance than the conventional method.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.5
• /
• pp.493-502
• /
• 2009

In this paper, we compare the performance of initial timing acquisition in direct sequence ultra-wideband(DS-UWB) systems with different transmit pulse shaping filters through extensive computer simulations. Simulation results show that the timing acquisition performance of the DS-UWB system, whose chip rate is 1.32 Gchip/s, employing a rectangular transmit filter is similar to that employing a square root raised cosine(SRRC) filter with an interpolation factor of 4 in the realistic UWB channels(CM1 and CM3) as well as the additive white Gaussian noise(AWGN) channel. Additionally, we present both a 24-parallel digital correlator structure and a 24-parallel processing searcher operating at a 55 MHz system clock, and then briefly discuss the initial timing acquisition procedure. Because we can adopt an 1.32 Gsample/s digital-to-analog(D/A) converter and an 1.32 Gsample/s analog-to-digital(AID) converter in the DS-UWB system by employing the rectangular transmit filter, we have a realistic solution for the DS-UWB chipset development.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.4 s.119
• /
• pp.351-357
• /
• 2007

In this paper, we propose a new cooperative signaling structure based on CDMA to overcome both 2/3 spectrum efficiency and low diversity gain of conventional cooperative signaling through continuous overlapping of signal that each user wants to transmit. Proposed signal structure can achieve the spectrum efficiency nearly "1" by receiving additional data for next time as well as maximum diversity gain to detect data continuously at both base station and each user. The orthogonality of CDMA's spreading codes can improve performance of optimal detector by reducing inter-user channel environment and distinguishing each user. We perform the computer simulation to verify the proposed system through comparing cooperative mode and non-cooperative mode under Rayleigh fading channel plus AWGN (Additive White Gaussian Noise).

• Journal of Broadcast Engineering
• /
• v.11 no.1 s.30
• /
• pp.100-106
• /
• 2006

In this paper, we proposed a TxID(Transmitter Identification) system using ZCD (Zero Correlation Duration) code as interference-cancelled spread codes for single frequency network of ATSC terrestrial DTV broadcasting. ZCD codes are simply implemented and have ZCD characteristics. Then, Proposal system can fundamentally solve interference problems caused by ICI(Inter Code Interference) and MPI(Multi-Path Interference) which happens in TxID system using spread coding method. Also, those can cancel truncated error which happens at watermarking for TxID since those can remove its period. In this paper, we identified the availability of TxID system applying interference-cancelled ZCD codes by analyzing DER (Detection Error Rate) which is simulated in various interference environments such as AWGN, ICI, and MPI.