• Journal of Environmental Science International
• /
• v.19 no.6
• /
• pp.665-670
• /
• 2010

Pollutants from urban pavement consists various kinds of substances which are originated from dry deposition, a grind out tire, corrosive action of rain to pavement and facilities and raw materials of the road etc.. These are major pollutants of urban NPS (Non-point source) during rainfall period. However there is not enough information to control such pollutants for appropriate management of natural water quality. In this study of transportation areas, three monitoring stations were set up at trunk road, urban highway and national road in Gyeongnam province. Runoff flow rate was measured at every 15minutes by automatic flow meters installed at the end of storm sewer pipe within the road catchment area for water quality analysis. Data was collected every 15 minutes for initial two hours of rainfall. Additional samples were collected 1-4 hours interval till the end of rainfall. The monitoring parameters were $COD_{Mn}$, SS, T-N & T-P and heavy metals. The average EMCs of TSS and $COD_{Mn}$ were 62.0 mg/L and 24.2 mg/L on the city trunk road, which were higher than those of urban highway and national road, indicating higher pollutant loads due to activities in the city downtown area beside the vehicle. On the other hand, the average EMC of T-N and T-P were in the range of 2.67-3.23 mg/L and 0.19-3.21 mg/L for all the sampling sites. Heavy metals from the roads were mainly Fe, Zn, Cu and Mn, showing variable EMCs by the type of road. From the TSS wash-off analysis in terms of FF(first flush) index, first flush phenomenon was clearly observed in the trunk road(FF : 0.89-1.43). However, such mass delivery behavior was not apparently shown in urban highway(FF : 0.90-1.11) and national road(FF : 0.81-1.41).

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.5
• /
• pp.448-454
• /
• 2009

Hydrogen was produced from water plasma excited in high frequency (HF) inductively coupled tubular reactor. Mass spectrometry was used to monitor gas phase species at various process conditions, Water dissociation rate depend on the process parameters such as ICP power, $H_{2}O$ flow-rate and process pressure, Water dissociation percent in ICP reactor decrease with increase of chamber pressure, while increase with increase of ICP power and $H_{2}O$ flow rate. The effect of $CH_4$ gas addition to a water plasma on the hydrogen production has been studied in a HF ICP tubular reactor. The main roles of $CH_4$ additive gas in $H_{2}O$ plasma are to react with 0 radical for forming $CO_x$ and CHO and resulting additional $H_2$ production. Furthermore, $CH_4$ additives in $H_{2}O$ plasma is to suppress reverse-reaction by scavenging 0 radical. But, process optimization is needed because $CH_4$ addition has some negative effects such as cost increase and $CO_x$ emission.

• KSBB Journal
• /
• v.17 no.1
• /
• pp.20-25
• /
• 2002

We performed a basic experiment for rapid, on-line, real-time measurement of HBsAg by using a surface plasmon resonance biosensor to quantify the recognition and interaction of biomolecules. We immobilized the anti-HBsAg polyclonal antibody to the dextran layer on a CM5 chip surface which was pre-activated by N-hydroxysuccinimide for amine coupling. The binding of the HBsAg to the immobilized antibody was measured by the mass increase detected by the change in the SPR signal. The binding characteristics between HBsAg and its antibody followed typical monolayer adsorption isotherm. When the entire immobilized antibody was interacted, there was no additional, non-specific binding observed, which suggested the biointeraction was very specific as expected and independent of the ligand density. No significant steric hindrance was observed at 17.6 nm/$mm^2$ immobilization density. The relationship between the HBsAg concentration in the sample solution and the antigen bound to the chip surface was linear up to ca. $40\mu\textrm{g}$/mL, which is much wider than that of the ELISA method. It appeared the antigen-antibody binding was increased as the immobilized ligand density increased, but verification is warranted. This study showed the potential of this biosensor-based method as a rapid, simple, multi-sample, on-line assay. Once properly validated, it can serve as a more powerful method for HBsAg quantification replacing the current ELISA method.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.21 no.6
• /
• pp.83-90
• /
• 2017

Performance analysis of the turboshaft engines for combined rotorcraft was executed. A tip jet and a ducted fan aircraft were selected for combined rotorcraft application. Gasturb 12 software was used for turboshaft engine performance analysis. In the results, maximum required power for the tip jet engine is about 1,600 hp class and maximum required power for the ducted fan engine is about 1,000 hp class at the required aircraft mission. This is due to the additional power of the auxiliary compressor to get a bleed air mass flow rate for the tip jet operation. At the same time, fuel consumption of the tip jet aircraft is 2.8 times larger than ducted fan case. Therefore ducted fan type aircraft is more efficient than tip jet aircraft in terms of fuel economy.

• International Journal of Industrial Entomology and Biomaterials
• /
• v.25 no.1
• /
• pp.93-98
• /
• 2012

Nutrition value of mealworm, Tenebrio molitor was analyzed due to increasing demand of usage as a protein source for domestic animals and even further for human consumption. The purpose of the present work was to determine the chemical compostion of the Tenebrio molitor larvae, adult that were maintained under standard condition for further usage of mass-rearing system and its exuvium, and excreta. Tenebrio molitor, larvae, adult, exuvium and excreta contained 46.44, 63.34, 32.87, and 18.51% protein respectively, suggested that even excreta could be used as an additional supplement in food recycling process. This protein was also rich in amino acids such as Isoleucine, leucine and Lysine which all met the nutritional value recommended by the Food and Agriculture Organization. Fatty acid composition was detected with high component of oleic acid (C18:1), along with linoleic acid (C18:2) and palmitic acid (C16) in all adult, larvae, exuvium and excreta. These oleic acid (C18:1), linoleic acid (C18:2) and palmitic acid (C16) components were the same or even highly contained in excreta of mealworm 22.29, 47.19 and 19.17% respectively. Longer chains of unsaturated fatty acids consisted of two to three double bonds are known as healthy product was recognized in large amount. These results show new ways to consume mealworms and its waste for animal and human consumption.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.7
• /
• pp.2207-2212
• /
• 2012

Dimethylaluminum isopropoxide (DMAI, $(CH_3)_2AlO^iPr$) as a single precursor, which contains one aluminum and one oxygen atom, has been adopted to deposit non-stoichiometric aluminum oxide ($AlO_x$) films by low pressure metal organic chemical vapor deposition without an additional oxygen source. The atomic concentration of Al and O in the deposited $AlO_x$ film was measured to be Al:O = ~1:1.1 and any serious interfacial oxide layer between the film and Si substrate was not observed. Gaseous by-products monitored by quadruple mass spectrometry show that ${\beta}$-hydrogen elimination mechanism is mainly contributed to the $AlO_x$ CVD process of DMAI precursor. The current-voltage characteristics of the $AlO_x$ film in Au/$AlO_x$/Ir metalinsulator-metal (MIM) capacitor structure show high ON/OFF ratio larger than ${\sim}10^6$ with SET and RESET voltages of 2.7 and 0.8 V, respectively. Impedance spectra indicate that the switching and memory phenomena are based on the bulk-based origins, presumably the formation and rupture of filaments.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.11
• /
• pp.1958-1962
• /
• 2007

The title complex, Ir(H)(CO)(PEt3)2(η 2-C60) (2), has been prepared by the reaction of excess C60 (4 equiv) with a tetrairidium complex Ir4(CO)8(PEt3)4 (1) in refluxing chlorobenzene in 40% yield as green crystals. Compound 2 has been characterized by cyclic voltammetry (CV), spectroscopic methods (mass, IR, 1H and 31P NMR), and a single crystal X-ray diffraction study. The molecular structure reveals that the iridium atom of 2 is coordinated by two axial ligands of a hydrogen atom and a carbonyl group, and three equatorial ligands of two phosphorus atoms and an η 2-C60 moiety. The CV study exhibits three reversible one-electron redox waves for the successive reductions of 2, together with additional four redox waves due to free C60 reductions, which was formed by decomposition of 2 in the reduced states. The three reversible redox waves of 2 are shifted to more negative potentials by ca. 270 mV compared to free C60, reflecting both metal-to-C60 π-back-donation and the electron-donating nature of the two phosphorus ligands.

• Publications of The Korean Astronomical Society
• /
• v.30 no.2
• /
• pp.139-143
• /
• 2015

We describe a survey of nearby core-collapse supernova (SN) explosion sites using integral field spectroscopy (IFS) techniques, which is an extension of the work described in Kuncarayakti et al. (2013). The project aims to constrain SN progenitor properties based on the study of the immediate environment of the SN. The stellar populations present at the SN explosion sites are studied by means of integral field spectroscopy, which enables the acquisition of both spatial and spectral information of the object simultaneously. The spectrum of the SN parent stellar population gives an estimate of its age and metallicity. With this information, the initial mass and metallicity of the once coeval SN progenitor star are derived. While the survey is mostly done in optical, the additional utilization of near-infrared integral field spectroscopy assisted with adaptive optics (AO) enables us to examine the explosion sites in high spatial detail, down to a few parsecs. This work is being carried out using multiple 2-8 m class telescopes equipped with integral field spectrographs in Chile and Hawaii.

• Journal of the Korean GEO-environmental Society
• /
• v.7 no.2
• /
• pp.25-32
• /
• 2006

The deformation modulus of rock masse is a very important design factor for the computation of stability of tunnels and their support systems. Several empirical formulas to estimate the deformation modulus using simple rock classification methods such as RQD or RMR are widely used because field tests to evaluate the deformation modulus are very expensive and time consuming work. However, these formulas can be depended on experiences from the characteristics of local sites in each country. Therefore, in this study, the applicability of empirical formulas was analyzed by comparing estimated value with the measured value from eight sites in South Korea. The results show that the estimated value based on the empirical formulas partially have tendency to overestimate. Especially, in case of sedimentary rocks, it was too difficult to apply to the empirical formulas because there was no relationship between estimated value and measured value. For these reasons, additional data from many tests and accurate analyses are necessary to evaluate the estimation method for the deformation modulus considering the local characteristics of rock masse.

• Korean Journal of Food Science and Technology
• /
• v.46 no.4
• /
• pp.418-424
• /
• 2014

High-acidity vinegar was manufactured using pear concentrate by fed-batch fermentation without additional nutrients, and the physicochemical properties and volatile components were investigated at different fermentation stages (Stages 1-4) and at various initial alcohol concentrations (IAC; 6-9%). The levels of reducing sugar, free amino acids, total phenolic content, total flavonoid content, and radical scavenging ability increased slightly during Stage 4 (high-acidity vinegar), which was affected by alcohol feeding. The contents of approximately 20 types of volatile compounds differed between the moderate- and high-acidity vinegar samples, as determined by solid-phase microextraction/gas chromatography-mass spectroscopy. The level of acetic acid in high-acidity vinegar increased according to the initial alcoholic content applied. The high-acidity vinegar produced by fed-batch culture at an IAC of 6-7% showed improved physicochemical and volatile properties as compared to the moderate-acidity vinegar.