• International journal of advanced smart convergence
• /
• v.4 no.1
• /
• pp.64-70
• /
• 2015

This paper proposes fluorescent electronic ballast with high power factor and low line input current harmonics. The system performance can be improved by a charged pump circuit. Details of design and circuit operation are described. The proposed electronic ballast is modified from single-stage half bridge class D electronic ballast by adding capacitor parallel with each power switch and setting the circuit parameter to operate under class DE inverter condition. By using this proposed method the DC bus voltage can be reduced around by 50% compare with conventional class D inverter circuit. Because the power switches are operated at zero voltage switching condition and low dv/dt of class DE switching. The experimental results show that the proper frequency of the prototype is around 50 kHz with input power factor of 0.982, $THD_i$ 10.2% at full load and efficiency of more than 90%.

• Journal of Power Electronics
• /
• v.17 no.2
• /
• pp.464-475
• /
• 2017

This study examines a P+multi resonant-based voltage control for voltage harmonics compensation under the islanded mode of a microgrid. In islanded mode, the inverter is defined as a voltage source to supply the full local load demand without the connection to the grid. On the other hand, the output voltage waveform is distorted by the negative and zero sequence components and current harmonics due to the unbalanced and nonlinear loads. In this paper, the P+multi resonant controller is used to compensate for the voltage harmonics. The gain tuning method is assessed by the tendency analysis of the controller as the variation of gain. In addition, this study analyzes the slight voltage magnitude drop due to the practical form of the P+multi resonant and proposes a counter method to solve this problem by adding the PI-based voltage restoration method. The proposed P+multi resonant controller to compensate for the voltage harmonics is verified through the PSIM simulation and experimental results.

• Proceedings of the Korea Water Resources Association Conference
• /
• 1983.07a
• /
• pp.78-79
• /
• 1983

It is well known that small amplitude wave theory, a first approximation to the complete theoretical description of wave behavior, yields a maximum investment in mathematical endeavor. But, if the wave amplitude is large, the small amplitude considerations are not valid, and finite amplitude wave theory which retains higher-order terms to obtain an accurate representation of the wave motion is numercal theory. The Stream function wave theory, one of the numerical methods, was developed by Dean for use with asymmetric measured wave profiles and with symmetric theoretical wave profiles. Dalrymple later improved the comjputational procedure by adding two Lagrangian constraints so that more efficient convergence of the iterative numerical method to a specified wave heigh and to a zero mean free surface displacement resulted. This paper introduces in details the Dean and Darlymple Stream Function Method in case of the symmetric theoretical wave, because in design purposes, wave height and wave period are given.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2002.11a
• /
• pp.287-291
• /
• 2002

This paper presents active-clamp class-E high frequency resonant inverter with single-stage. The proposed circuit is integrated active-clamp class-E circuit to boost converter with the function of power factor correction. Boost converter is operated in positive and negative half cycle respectively at line frequency(60Hz), Such a operating in discontinuous conduction mode(DCM) of boost converter performs high power factor. By adding active-clamp circuit in class-E inverter, main switch of inverter part is operated not only ZVS(Zero Voltage Switch) but also reduced the switching voltage stress of main switch. This paper shows that simulation result using Psim 4.1 prove the validity of theoretical analysis. This proposed inverter will be able to be practically used as a power supply in various fields as induction heating applications, DC-DC converter etc.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.5
• /
• pp.2077-2082
• /
• 2015

Based on Deutsch assumption, a calculation method on the electric field over the ground surface under HVDC transmission lines in the wind is proposed. Analyzing the wind effects on the electric field and the space charge density the existing method based on Deutsch assumption is improved through adding the wind speed to the ion flow field equations. The programming details are illustrated. The calculation results at zero wind speed are compared with available data to validate the code program. Then the ionized fields which resulted from corona of ±800kV HVDC lines are analyzed. Both the electric field and the current density on the ground level are computed under different wind direction and speed. The computation results are in good agreement with measurements. The presented method and code program can be used to rapidly predict and evaluate the wind effects in HVDC transmission engineering.

• Proceedings of the KIPE Conference
• /
• 2014.11a
• /
• pp.25-26
• /
• 2014

Renewable energy sources such as wind and solar power are free and can be easily harvested everywhere. However, one of the biggest problems when using this kind of energy source is how to increase the efficiency of power conversion system. This paper introduces a modified 3-phase inverter in order to increase the power conversion efficiency. By adding 3 bi-directional switches at output of the inverter, the current flow back DC source during zero state is prevented to minimize leakage current, so that the efficiency of whole system is increased. The proposed topology also improves the power quality to satisfy the total harmonics distortion (THD) requirement. In order to verify the effectiveness of the proposed topology, simulation results are carried out using Simulink in MATLAB.

• ETRI Journal
• /
• v.42 no.3
• /
• pp.399-410
• /
• 2020

Detecting visual relationships in an image is important in an image understanding task. It enables higher image understanding tasks, that is, predicting the next scene and understanding what occurs in an image. A visual relationship comprises of a subject, a predicate, and an object, and is related to visual, language, and spatial cues. The predicate explains the relationship between the subject and object and can be categorized into different categories such as prepositions and verbs. A large visual gap exists although the visual relationship is included in the same predicate. This study improves upon a previous study (that uses language cues using two losses) and a spatial cue (that only includes individual information) by adding relative information on the subject and object of the extant study. The architectural limitation is demonstrated and is overcome to detect all zero-shot visual relationships. A new problem is discovered, and an explanation of how it decreases performance is provided. The experiment is conducted on the VRD and VG datasets and a significant improvement over previous results is obtained.

• Journal of the Korean Ceramic Society
• /
• v.27 no.2
• /
• pp.249-255
• /
• 1990

High Tc Supperconducting thin films were fabricated by rf magnetron sputtering method. We have successfully controlled the compositions of films by adding sintered CuO pellets on YBa2Cu3O7-x single target. High Tc thin films with large grian size and good crystal habit were obtained by rapid thermal annealing process. The films deposited on SrTiO3(100) single crystal substrate indicated the existence of c-axis prefered orientation confirmed by XRD and SEM analysis. The Tc, zero's of sharp resistive transition for rapid annealed films deposited on polycrystalline YSZ substrate and on SrTiO3(100) single crystal substrate were 79K and 88K, respectively.

• Proceedings of the KIPE Conference
• /
• 2002.07a
• /
• pp.525-528
• /
• 2002

A Novel Zero Current Switching(ZCS) Pulse Width Modulation(PWM) boost converter for reducing two rectifiers reverse recovery related losses Is proposed. The switches of the proposed converter are operating to work alternatively turn-on and turn-off with soft switching(ZVS, ZCS) condition. The reverse recovery related switching losses and EMI problems of the proposed converter eliminates the reverse recovery current of the freewheeling diode(D, Dl) by adding the resonant inductor Lr, in series with the switch S2. The voltage and current stresses of the components are similar to those in its conventional hard switching counterpats. As mentioned above, the characteristics are verified through experimental results.

• Structural Engineering and Mechanics
• /
• v.4 no.5
• /
• pp.569-586
• /
• 1996

A new three-dimensional 8-node solid element with rotational degrees of freedom is presented. The proposed element is established by adding rotational degrees of freedom to the basic 8-node solid element. Thus the element has three translations and three rotational degrees of freedom per node. The corner rotations are introduced by transforming the hierarchical mid-edge displacements which are parabolic shape along an edge. The derivation of the element is based on the mixed variational principles in which the rotations are introduced as independent variables. Several types of non-conforming modes are selectively added to the displacement fields to obtain a series of improved elements. The resulting elements do not have the spurious zero energy modes and Poisson's ratio locking and pass patch test. Numerical examples show that presented non-conforming solid elements with rotational degrees of freedom show good performance even in the highly distorted meshes.