• Speech Sciences
• /
• v.10 no.1
• /
• pp.15-25
• /
• 2003

A laryngograph was developed to measure the open and closed movements of vocal folds in our laboratory. This study attempted to evaluate its performance by comparing its glottal data with that of the original laryngograph. Ten normal Korean adults Participated in the experiment. Each subject produced a sustained vowel /a/ for about five seconds. This study compared f0 values, contact quotients of the duration of closed vocal folds over one glottal pulse, and area quotients of the closed over open vocal folds derived from glottal waves using both the original and new laryngographs. Results showed that the mean and standard deviation of the two laryngographs were almost comparable with a correlation coefficient 0.662 but minor systematic shift below those of the original laryngograph was observed. The absolute mean difference converged into 1 Hz, which indicates a possibility of adopting some threshold of rejecting inappropriate pitch values beyond a threshold value. The contact quotient of the normal subjects came out slightly over the 50% in a citation speech. Finally, the area quotient converged into 1. We will pursue further studies on the abnormal patients in the future.

• Journal of the Korean Chemical Society
• /
• v.14 no.4
• /
• pp.327-332
• /
• 1970

A simple and convenient device for deflection-type direct reading the variations in electrolytic conductance is described and applied to the analysis of sulfur by combustion-$H_2O_2$ oxidation method. The apparatus consisted of a high resistance-ratio bridge in which the other adjacent arms are the differential cells. By adopting unusually high a-c voltage source for the bridge excitation, the a-c method for unbalanced bridge is established, decreased sensitivity owing to reduced bridge factor, 0.01, is overcome and also the absolute sensitivity and linearity are greatly improved. Over 50% variations in impedance of the balanced cell, within 1% deviation from the linearity can be attained with a volt (rms)order of output which was detected directly with VTVM without further amplification. Analysis of the bridge shows that these useful features are natural result of the constant current character of the high source impedance generator and the performance of the device agreed with the theoretical predictions. A standard procedure for the rapid analysis of sulfur using the bridge is also given, the analytical accuracy was approximately 1%. A determination takes not more than 5 minutes.

• Journal of the Korean Society for Precision Engineering
• /
• v.24 no.6
• /
• pp.121-130
• /
• 2007

In this paper, we present the development of a new training system for equilibrium sense and postural control. This system consists of an unstable platform, a force plate, a computer, and training programs. The unstable platform provides 360 degrees of movement allowing for training in all directions. To evaluate the effects of the training system, we performed various experiments to train the ability of equilibrium sense and postural control of fifteen young healthy subjects. We measured the time a subject maintains his or her center of pressure on a target, the time a subject moves his or her center of pressure to a target, and the mean absolute deviation of the trace before and after the training. We analyzed these parameters obtained before and after the training using paried-sample T-test. The result shows that the subjects experienced distinctive enhancement in their ability of postural control through the training using our system.

• Journal of Navigation and Port Research
• /
• v.29 no.5 s.101
• /
• pp.409-413
• /
• 2005

The existing control techniques for the operation of a container crane satisfy the terminal condition of controlled variables, but the outcome of input computation is inadequate for the operation of the crane due to heavy movement of inputs. In this study, a new control technique employing a nonlinear model of the crane is proposed to compute the inputs approximated with the 4th-order Chevyshev function. The control objective of sum of absolute deviations is minimized, and the optimization is conducted with the simplex algorithm. The inputs and outputs computed from the proposed technique were compared with the results of the previous study to show that they give more stable crane operation than the existing control technique.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.6
• /
• pp.1122-1128
• /
• 2007

The denoising for image restoration based on the Wavelet Packet Transform with AA(Absolute Average) making-threshold is presented. The wavelet packet transform leads to be better in the part of high frequency than wavelet transform to eliminate noise. And the existing threshold determination is used standard deviation estimated results in increasing the noise and threshold, and damaging an image quality. In addition that is decreased image restoration PSNR by using the same threshold in spite of changing image because of installing a threshold in proportion of noise size. In contrast the AA thresholding method with wavelet packet is adapted by changing image to set up threshold by statistic quantity of resolved image and is avoided an extreme impact. The results on the experiment has improved 10% and 5% over than the denoising based on simple wavelet transform and wavelet packet respectively.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.18 no.11
• /
• pp.896-905
• /
• 2006

An optimal control of an air-conditioning system with slab thermal storage is investigated by making use of the Maximum Principle. An optimal heat input to a plenum chamber and an air-conditioned room is determined by minimizing a criterion function which is given as integral sum of two terms. The first term is the square of the deviation in the room air temperature from the set-point value, and the second is the absolute value of the heat input. The result indicates that it tries to keep a room air temperature in set-point value by heating as much as possible at the time of a setup of a room air temperature or just before that, in order to avoid a heat loss arising at the time of the non-air conditioning. The result is compared with that of the case when the square of the heat input is used as a criterion.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.11 no.5
• /
• pp.633-641
• /
• 1999

Experiments were carried out to investigate the condensation heat transfer characteristics for R22 and its alternatives, R407C (R32/125/134a, 23/25/52wt%) and R410A (R32/125, 50/50wt%). A concentric tube heat exchanger was made to conduct condensation heat transfer tests. Mass flux and saturation temperature of refrigerants at the test section inlet were varied to get the corresponding heat transfer coefficients. Serial and parallel input of secondary fluid (water) were applied to the test subsections. Compared with existing correlations of condensation heat transfer, experimental heat transfer coefficients obtained in this study were generally higher than the predicted values, and mean absolute deviations from several correlations were shown. Wall subcooling was introduced to get a new correlation for condensation heat transfer coefficients by modifying Shah's equation. The RMS deviation of the measured heat transfer coefficients from the new correlation in this study for R22 is 9.9% and that for R407C and R410A are 10.2% and 14.6%, respectively.

• Journal of Apiculture
• /
• v.33 no.4
• /
• pp.277-282
• /
• 2018

Ethanol extracted propolis (EEP) was mixed with honey (honeypolis) to dissolve well in water and in vitro skin irritation test was conducted. In vitro method is designed to predict and classify the skin irritation potential of a chemical by assessment of its effect on $EpiDerm^{TM}$, a reconstituted three-dimensional human epidermis model. Cytotoxicity is expressed as the reduction of mitochondrial dehydrogenase activity measured by formazan production from MTT after a 60 min exposure period. In this study under the given conditions honeypolis showed no irritant effects. Honeypolis meets acceptance criteria if: mean absolute OD 570 nm of the three negative control tissues is ${\geq}0.8$ and ${\leq}2.8$, mean relative tissue viability of the three positive control tissues is ${\leq}20%$, standard deviation of relative tissue viability obtained from each three concurrently tested tissues is ${\leq}18%$. Honeypolis is therefore classified as "non-irritant" in accordance with UN GHS "No Category".

• Clean Technology
• /
• v.26 no.4
• /
• pp.279-285
• /
• 2020

Laboratories and industrial processes typically involve the use of flammable substances. An important property used to estimate fire and explosion risk for a flammable liquid is the flash point. In this study, flash point data at 101.3 kPa were determined using a SETA closed cup flash point tester on the following solvent mixtures: {2,2,4-trimethylpentane + methylcyclohexane}, {2,2,4-trimethylpentane + ethylbenzene}, and {2,2,4-trimethylpentane + p-xylene}. The purpose of this work is to obtain flash point data for binary mixtures of 2,2,4-trimethylpentane with three hydrocarbons (methylcyclohexane, ethylbenzene, and p-xylene), which are representative compounds of the main aromatic hydrocarbon fractions of petroleum. The measured flash points are compared with the predicted values calculated using the GE models' activity coefficient patterns: the Wilson, the Non-Random Two-Liquid (NRTL), and the UNIversal QUAsiChemical (UNIQUAC) models. The non-ideality of the mixture is also considered. The average absolute deviation between the predicted and measured lower flash point s is less than 1.99 K, except when Raoult's law is calculated. In addition, the minimum flash point behavior is not observed in any of the three binary systems. This work's predicted results can be applied to design safe petrochemical processes, such as identifying safe storage conditions for non-ideal solutions containing volatile components.

• Communications for Statistical Applications and Methods
• /
• v.29 no.5
• /
• pp.591-601
• /
• 2022

In gene set analysis with microarray expression data, a group of genes such as a gene regulatory pathway and a signaling pathway is often tested if there exists either differentially expressed (DE) or differentially co-expressed (DC) genes between two biological conditions. Recently, a statistical test based on covariance estimation have been proposed in order to identify DC genes. In particular, covariance regularization by hard thresholding indeed improved the power of the test when the proportion of DC genes within a biological pathway is relatively small. In this article, we compare covariance thresholding methods using four different regularization penalties such as lasso, hard, smoothly clipped absolute deviation (SCAD), and minimax concave plus (MCP) penalties. In our extensive simulation studies, we found that both SCAD and MCP thresholding methods can outperform the hard thresholding method when the proportion of DC genes is extremely small and the number of genes in a biological pathway is much greater than a sample size. We also applied four thresholding methods to 3 different microarray gene expression data sets related with mutant p53 transcriptional activity, and epithelium and stroma breast cancer to compare genetic pathways identified by each method.