• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.53 no.11
• /
• pp.664-670
• /
• 2004

This paper presents a new velocity estimation strategy of a non-salient permanent magnet synchronous motor (PMSM) drive without high frequency signal injection or special PWM pattern. This approach is based on the d-axis current regulator output voltage of the drive system that has the information of rotor position error. The rotor velocity can be estimated through a rotor position tracking PI controller that controls the position error to zero. For zero and low speed operation, PI controller gains of rotor position tracking controller have a variable structure according to the estimated rotor velocity. In order to boost the bandwidth of PI controller around zero speed, a loop recovery technique is applied to the control system. The proposed method only requires the flux linkage of permanent magnet and is insensitive to the parameter estimation error and variation. The designers can easily determine the possible operating range with a desired bandwidth and perform the vector control even at low speeds. The experimental results show the satisfactory operation of the proposed sensorless algorithm under rated load conditions.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.47 no.6
• /
• pp.429-437
• /
• 2019

This paper deals with a ZEM (Zero-Effort-Miss) based guidance law for the interception of moving targets and characteristics of the guidance law according to time-to-go estimation methods. To derive the ZEM vector feedback guidance command, we introduce a polynomial function with unknown coefficient, and then we determine the coefficient to satisfy initial and terminal constraints. Since the directions of the guidance command and ZEM vectors are adjusted by the time-to-go, general time-to-go estimation methods are proposed, which can generate the vertical and horizontal guidance commands with respect to an arbitrary reference frame. By performing various numerical simulations, the performance and characteristics of the proposed methods are investigated.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.6A
• /
• pp.577-582
• /
• 2008

In this paper, we present a scheme to overcome the worst case complexity of the sphere decoder. If the number of visited nodes reaches the threshold, the detected symbol vector is determined between two candidate symbol vectors. One candidate symbol vector is obtained from the demodulated output of ZF receiver which is initial stage of the sphere decoder. The other candidate symbol vector consists of two sub-symbol vectors. The first sub-symbol vector consists of lately visited nodes running from the most upper layer. The second one contains corresponding demodulated outputs of ZF receiver. Between these two candidate symbol vectors, the one with smaller euclidean distance to the received symbol vector is chosen as detected symbol vector. In addition, we show the upper bound of symbol error rate performance for the sphere decoder using the proposed scheme. In the simulation, the proposed scheme shows the significant reduction of the worst case complexity while having negligible SER performance degradation.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.48 no.8
• /
• pp.15-26
• /
• 2011

In this paper, we present a new beamforming scheme for a downlink of multiuser multiple-input multipleoutput (MIMO) communication systems. Recently, a block-diagonalization (BD) algorithm has been proposed for the multiuser MIMO downlink where both a base station and each user have multiple antennas. However, the BD algorithm is not efficient when the number of supported streams per user is smaller than that of receive antennas. Since the BD method utilizes the space based on the channel matrix without considering the receive combining, the degree of freedom for beamforming cannot be fully exploited at the transmitter. In this paper, we optimize the receive beamforming vector under a zero forcing (ZF) constraint, where all inter-user interference is driven to zero. We propose an efficient algorithm to find the optimum receive vector by an iterative procedure. The proposed algorithm requires two phase values feedforward information for the receive combining vector. Also, we present another algorithm which needs only one phase value by using a decomposition of the complex general unitary matrix. Simulation results show that the proposed beamforming scheme outperforms the conventional BD algorithm in terms of error probability and obtains the diversity enhancement by utilizing the degree of freedom at the base station.

• Journal of Power Electronics
• /
• v.5 no.1
• /
• pp.29-35
• /
• 2005

This paper presents a novel prototype of an active auxiliary quasi-resonant snubber(Auxiliary Quasi-Resonant Commutation Block-Link; ARCB)-assisted three phase voltage source soft switching space voltage vector modulated PFC rectifier, which uses Zero Voltage Soft Switching (ZVS) commutation. The operating principles of this digitally-controlled three phase soft switching PWM-PFC rectifier system with an instantaneous power feedback scheme are illustrated and its steady-state performance is evaluated using computer-aided simulation analysis.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.7 no.2
• /
• pp.149-157
• /
• 2002

In this paper, a novel overmodulation strategy for space-vector PWM(SVPWM) inverters to utilize dc link voltage fully Is presented. The proposed strategy uses the concept of SVPWM based on the zero sequence signal(offset voltage) injection principle. So, by modifying the pole voltage simply, the linear control of inverter output voltage over the whole overmodulation range can be achieved easily The proposed strategy is so simple that its practical implementation is easy. The validity of the proposed strategy is confirmed by the experimental results.

• ETRI Journal
• /
• v.31 no.5
• /
• pp.565-575
• /
• 2009

This paper concerns the use of support vector regression (SVR), which is based on the kernel method for learning from examples, in identification of walking robots. To handle complex dynamics in humanoid robot and realize stable walking, this paper develops and implements two types of reference natural motions for a humanoid, namely, walking trajectories on a flat floor and on an ascending slope. Next, SVR is applied to model stable walking motions by considering these actual motions. Three kinds of kernels, namely, linear, polynomial, and radial basis function (RBF), are considered, and the results from these kernels are compared and evaluated. The results show that the SVR approach works well, and SVR with the RBF kernel function provides the best performance. Plus, it can be effectively applied to model and control a practical biped walking robot.

• Journal of Institute of Control, Robotics and Systems
• /
• v.2 no.2
• /
• pp.67-72
• /
• 1996

This paper presents a parameter adaptive control law that stabilizes and asymptotically regulates any single-input, linear time-invariant, controllable and observable, discrete-time system when only the upper bounds on the order of the system is given. The algorithm presented in this paper comprises basically a nonlinear state feedback law which is represented by functions of the state vector in the controllable subspace of the model, an adaptive identifier of plant parameters which uses inputs and outputs of a certain length, and an adaptive law for feedback gain adjustment. A new psedu-inverse algorithm is used for the adaptive feedback gain adjustment rather than a least-square algorithm. The proposed feedback law results in not only uniform boundedness of the state vector to zero. The superiority of the proposed algorithm over other algorithms is shown through some examples.

• Journal of Industrial Technology
• /
• v.21 no.B
• /
• pp.59-66
• /
• 2001

In this paper, a novel overmodulation strategy for PWM inverters to extend linearity region is presented. The proposed strategy uses the concept of space-vector PWM(SVPWM) based on the zero sequence signal(offset voltage) injection principle. So, by modifying the pole voltage simply, the linear control of inverter output voltage over the whole overmodulation range can be achieved easily. The proposed strategy is so simple that its practical implementation is easy. The validity of the proposed strategy is confirmed by the experimental results.

• Proceedings of the KIEE Conference
• /
• 1997.07f
• /
• pp.2043-2046
• /
• 1997

GTO 소자의 최소 턴온 시간(minimum turn-on time, Tmin)때문에 발생된 지령전압 오차를 보상하는 기법을 제안한다. 공간백터전압$(V_1)$의 턴온시간이 Tmin보다 작을 경우에는 전압오차를 PI 제어기로 보상한다. 또한, 지령전압벡터의 크기가 특정한 값(Vmin)보다 작은 경우, 영벡터(zero vector)가 PWM 추기에서 중간에 매치가 되도록 스위칭 순서를 바꿔준다. 시뮬레이션을 통해 이러한 지령전압 오차의 보상으로 펄스 누락(pulse dropping) 영역에서 출력전압의 대칭성이 향상되고 고조파 함유량이 감소한다는 사실을 보인다.